Accord :: 1993 LX - Loud Belt Squealing When Start Cold / Engine Revs When Brakes Pressed
Dec 7, 2012
I just bought a used 93 accord. The engine is in good shape and runs smoothly most of the time, but I have two issues.
First, when I start the engine cold, there is a very loud belt squealing for about 3 or 4 seconds. Is this a common problem and, if I isolate the belt at fault, what should I do about it?
Second, the engine revs (both audibly and on the tach) when I press on the brakes. I've been told by a friend it might be a vacuum leak?
View 5 Replies
Advertisement
Ok, did an intake manifold cleaning on my 99 Accord the other day, and now I have problems...
Long story short, some time ago my car started to have a very rough idle. Took me awhile to find the problem. Turned out the air hose, between the filter and throttle body, had developed a big hole on the underside. So I replaced it and while I was at it used some throttle body cleaner, spraying into the intake manifold chamber. Lot of junk blew out the tailpipe. The car ran much better, but the idle could still be a little rough. I ran it that way for awhile, and finally the other day decided there was probably still some junk in there and it was time to really clean it out. So I took ff the throttle body and intake manifold housing. There was a lot of junk in there! The small intake on the passenger side was completely clogged shut. (I understand this isn't surprising on these cars.) I used a bunch of rags and 2 cans of Valvoline throttle body cleaner and a lot of elbow grease and cleaned it out. I was thinking to myself that whatever I didn't get with the rags flushed through OK, but I didn't want to take the whole intake manifold out.
So I put it all back together. (I took a video before I started, so I'm pretty sure it's all back together right.) But now I have problems. The car starts. It idles fine mostly, but can be a bit rough. But the trouble starts when I put the pedal down. If I do it in Park, well, if I push it quick the engine just dies. If I push it slow, the engine revs then quits, revs and quits, over and over. Similar if it's in gear. If I push it hard, the engine stalls. If I push it gentle, it revs up, but chugs along a bit.
I've run some seafoam through it, thinking it was clogged up with all that junk, and sure enough, lots of smoke comes out, but nothing is improving so far. What have I done wrong?
View 19 Replies
I have a belt in my engine that squealed every time I started the engine cold or got water on the engine (rain etc).
The belt itself has no cracks or fraying. I loosened the adjustment bolt on the alternator which raised the alternate up slightly and tightened the belt.
The squeal is completely gone even when starting from cold now.
Should I just conclude the belt was loose, or is there a precaution I should take?
View 2 Replies
I have a mkiv and before I got to work in the morning, I warm up my car for about 10 min. When I start it up the belt squeals. I do believe that it only does it in the morning. Should I have it checked out? i put belt dressing on it last night but it squealed when i started it up this morning so I don't think that worked......
View 10 Replies
I installed a new Goodyear alternator belt on our 07 Yaris couple months back and it started squealing after the first day and only during a cold start. My past experience has taught me that it's normally due to a loose belt (when belt is new) so I tightened it just a bit. After 3 days it started squealing again. I've increased the tension on the belt three times now and the squealing has not gone away. It's only on cold starts and only for about 1 minute. If memory serves me right there is no tensioner for the alternator belt. It would appear that it doesn't matter how tight the belt is, it still squeals on cold starts.
View 4 Replies
For a few months now every time I start the car with AC on the belt squeals really loud. It's been getting worse so I need to fix it now. I just don't know if it's just a belt change or something bigger like the actual AC unit. I got the car certified pre owned in 07 and have never changed an engine belt on it so it's probably due. Here is a video of the noise, first part of video is without AC then I turn it on to here the squeal. Is this simple belt change or a deeper issue with the AC? [URL] .....
View 14 Replies
Since the weather got colder I've been getting really loud, squealing belt noises. They happen mostly when I turn on the car. They sound like when I had an old Altima and turned on the A/C the belt would squeal. But the sound happens even with no air turned on or defogger turned on. And it happens sometimes when I make a really sharp turn around when I first start the car. After it's warmed up I generally don't hear it. Also, sometimes having my foot on the brake will change how long the sound lasts for. I'd like to know what belt this would be and if just WD-40 should be used for now (or some type of belt dressing) OR if it's detrimental not to get work done on it. Also let me know if I'm able to tighten it myself or if that's better left. I replaced a valve cover gasket a few months ago so that's about the extent of my abilities at this point.
It's a 2003 Hyundai Accent Automatic...
View 5 Replies
You know what I will never miss by have a Gen III Prius? I will never have to listen to my fan belt squealing on cold day after almost killing the battery hoping my car will start.
After our recent cold snap I was surprised how many cars were in my parking lot at work with people grinding away trying to get them to start and the nasty sounds the cars made once they did start. Everything from rough running, not firing on all cylinders, and/or belts squealing.
Now I will admit the Prius did act a little different that day. When the ICE started it did sound like it was working a little harder than it usually does when I first start it. But in all reality at -20degF the ICE started the same as it ever did.
View 16 Replies
I have a 2001 toyota prius. When I start the car and press on the gas pedal the engine rev's but nothing moves and there is some clatter from the engine. I can put it in B mode and drive it a short distance, but that's it.... The engine light has been coming off and on for a week now. It makes a loud audible tone and then I turn it off and back on and then it stops.
View 5 Replies
2007 GS 350. In the past 6 months i have changed my FRONT brake pads with two different pair. First was a generic pad(REMOVED), and did some research then went for Akebono(CURRENTLY) brake pads 2-months noise-free and now back to braking noise dilemma.
Issues:
-In the morning, first 3-5 pressed brakes makes loud(REALLY LOUD!) humming noise then goes away. Feels like the brakes are rusty but it continually does it everyday. I just got the car serviced so assuming all my fluids are filled.
-Randomly, on a fully stopped brake i hear a whistle noise from the front brake. NOT as loud described above.
-I noticed the noise happened the most on HOT weather, and occasionally on COLD weather.
Longo Lexus advice me to buy an OEM brake pads and should resolve this problem. I'm also thinking of just getting it done at the dealership and pay that extra cash plus warranty.
View 8 Replies
I have 2013 GS350 I bought in October with 5k miles. Currently I have 14,500 miles on it today.
Every time I have a cold start on the car, When driving at low speeds and braking, it has a loud squealing noise. Once the car has been running and driving, it goes away and doesn't came back unless I park the car and get back in an hour or so later. I went to the dealer and the guy said it's "normal", said moisture gets in and needs a few minutes break apart and that's how Lexus designs their cars. Which is believe is BS.
Here is a video of the noise. This isn't as loud as I've heard it before. [URL] ....
View 14 Replies
My car started making a loud, high pitched "whooping" and "whining" noise when making corners. The pitch is medium to high and variable. It kind of sounds like wet rubber on glass (like a squeegee). The first time it happened I thought it was a police siren, like when they sound the siren in short bursts "whoop! whoop!". But now the sound is more like a prolonged whine/groan. The sound might be coming from the steering column, but I can't be sure. Its definitely on the driver's side and in the front.
The sound is not related to braking. It doesn't happen on every turn. It can happen when starting from a stop or when already in motion. It happens on both flat ground and hills. At first it seemed to happen on cold days and only in the morning. I think this might have been a coincidence since now it happens throughout the day, every day.
My car is a 1993 honda accord with approximately 315,000 miles.
View 3 Replies
I'm the loudest Prius in CT right now. My brakes doing that loud scraping sound. Is it normal to need brakes this soon?
View 6 Replies
I have recently replaced my stock pads with pbr ceramics,front and rear. now my rear brakes are squeeling loud everytime i back up. i have tried to file the edges, did not work. What to do? change pads?
View 6 Replies
I have a 06 accent sedan and I have been having some issues with the back brakes that were just replaced prior to the motor vehicle being done the end of June. I had the brakes replaced and everything was working fine up until the middle of last week; now the brakes in the back are squealing like the warning plates are rubbing together again (loud high pitch squealing) what could be causing this...I took it back to where I had the brakes replaced and they did a check and said that it did not look like anything was wrong and they asked me when my front brakes were replaced, I told him they were replaced last August when I have a issues with a caliper freezing up and had to replace everything in the front (brakes, caliper etc). So long story short he said to keep driving and see if you can tell if the squealing is coming from the front or the back and come back when its happening or if you can determine which one it is..
View 13 Replies
What's going on with my '93 240. When I first go out to start my car in the morning, it starts up fine. After that, however, is when the trouble begins. If it's hot out, or if I've driven the car that day, there's a 50% I'll have trouble keeping the engine running. The engine will run rich, and chugs on startup, eventually stalling out after a few revolutions. During this time, the engine revs low, don't have a tac so I can't say how low, but definitely below idle.
If hold the accelerator to increase the RPM, the engine will run fine, but once I let off the gas, chances are it will stall out again. Eventually, after doing this a few times, something seems to catch the car as it begins to stall again, as in, just before the car is about to stall, the idle speed kicks up to normal. After that, the car runs fine.
I've had a code for the MAF for a long time. I tested the resistance across the meter, and it indicates the wire is still good. Even at that, I've replaced the MAF, but nothing has changed. Still have the same problem. What could be causing this?
View 1 Replies
I thought it was the power steering pump & replaced it and still get the noise. A friend did squirt belt dressing on the belt while running and the sound disappeared for a short period of time, so now my guess is its the belt which is not loose, I went and loosened the four bolts on the power steering pump trying to move it thinking there was a crooked connection between the two pulleys maybe, but no. I start up my car and get a squeal that wiould wake the dead for a minute or two, then all is fine driving. If I drive to the store shut it off for 10 minutes usually starts w/ no noise, looks like I made a charitable donation on the new pump,...also the the power steering fluid is correct
View 8 Replies
I have a 2014 2.0T and have noticed that my car is making a noise that sounds like a belt squealing. I thought the sound was being produced by the brakes. I only notice when I drive the car from a cold start.
View 1 Replies
My '93 Honda Accord has developed a problem with starting and holding its idle. After the car has sat overnight or for several hours, it may be hard to start. (Sometimes it starts right away!)
It can take several minutes to start idling well or it may be fine in seconds. It's all very inconsistent.
View 2 Replies
The serpentine belt starting squeaking on cold and damp mornings about 18 months ago at about 60K. I replaced it with a Dayco belt, and the noise went away for about 6 months. When the weather turned cold last winter, the noise came back. So I changed the tensioner with both idler pulleys right about when the weather warmed up, and it was fine all summer. Now that it has gotten cold again, the squeak is back yet again and as before it goes away when the car warms up. I know it is the serpentine belt because when I spray it with water the noise immediately stops. I checked all the pulleys with the belt off and when I spin them I hear no noise. Is there something else it could be?
View 1 Replies
We have a 2004 Honda Accord V6 with 178,000 miles and the car is giving us some issues. We can drive the car for 10-15 minutes with no issues. Then when we push on the gas pedal, the car will not go any farther and the engine just revs. If we turn the car off and restart it, the car will continue to drive. There are no check engine lights on the car. Could these be a transmission issue?
View 5 Replies
