Accent RB (2012+) :: Sound On Applying Brakes When Going Down On Sloppy Roads
Jun 10, 2016
I have 2012 accent. I purchased it in May 2014 when it had 35,000 miles. Now it has 75,000 miles.
Sometimes I hear sounds when brakes are applied..this happens mainly when going down on sloppy roads with pot holes. lets say if i see a signal turning orange and I apply brakes intermittently to stop vehicle, i hear rough sounds like 2 metals hitting when car goes over those pot holes. hope i made sense. sometimes it comes when its raining heavily and brakes are applied. other than that, this sound doesn't come during normal ride and normal breaking.
What could this be? Firestone does inspection during every oil change and they said all is good. I don't know if they check brake system.
View 2 Replies
Advertisement
I haven't noticed it before but applying the brakes after driving thru snow I get an awful crunch sound. I have stopped the car a few times to look and it appears the wheel wells are clogged with slush but I don't know if that's whats causing it. After the crunching sound if I'm driving on a clear road there is no noise if I brake. Its much worse than say the crunch you get if the brakes are wet. Whats up with this?
View 3 Replies
I am having a issue with my 07 accent. Had front rotors and pads replaced because they needed to be. Clicking continued. Had drums and shoes replaced last month. Clicking went away for a few weeks. Recently started back up just the other day. The clicking is only when applying the brake and it sounds like it is coming from the right rear drum. It doesn't interfere with stopping, but it s so annoying and brakes shouldn't make that kind of noise anyway.
View 7 Replies
Great car, Love it! It's a big improvement from the 2006 Prius.
When applying the brakes and holding the pedal down, I notice that the indicator for slippery/traction yellow icon appears in my dash when completely stopped.
There is no map option on the steering wheel that allows you to switch back to the Nav/Map system on the HD display. Is there a voice command?
View 16 Replies
Okay, I never experienced this on my Prius C, but now that's I've upgraded to a 2013 Prius Plug-In, I can duplicate it:
When traveling on the highway (at like 60MPG) and I brake a little hard (but not pedal fully to the floor), I hear and feel a 'click' through the brake pedal as it slows through 25MPH. A car pulled out in my lane, and I had to brake suddenly and felt/heard this 'click' at that speed. Did some testing on an off-ramp with the same situation (50MPH - heavy breaking - feel/hear click at 25MPH).
I think this is the transition from the regen braking to the brake pads, but I'm unsure. Not sure if it's ABS either. I've looked at a ton of Gen3 braking threads here on PC, but I was unable to find my exact issue. The car only has 3000 miles on it,
Loving my upgrade so far (but having weird fueling problems - doesn't seem like I can 'fill' the tank, always lose the first 'blip' too fast), and enjoy the freedom of being able to charge for local driving.
View 2 Replies
I am getting a ticking sound when i am slowing down (applying my brakes) at say 35/30mph. The sound stops when I stop. This problem starts after my car warms up; doesn't do it when I first start up.
I've taken the car to 2 Hyundai dealerships and a certified mechanic and the problem continues. I first noticed this about a month ago.
So far no one seems to be able to find the problem. The mechanic did try by replacing the front brake pads. He said something about a "shims piece " and thought if we replace the front pads that would take care of the problem. The rear brakes or ok.
I'm still having the problem and I wonder if it's the rear brakes after all. I don't know what I can try now. Someone suggested going to Brake Check. I have about 1000 miles left on the original warranty.
View 1 Replies
When I apply the brakes at speeds of 30 mph and under I hear a ticking noise. (The noise might still be there above 30 mph , but due to road noise I cant hear it)
I believe it is the front drivers side but after taking wheel off and taking it to the dealership. I can not find the problem. The dealership states they can't hear it while on several road test, but I have showed them the video clip and they have no idea what it is.
View 19 Replies
Just got a new to me 02 Limited v8 - 128k on the clock
Noticed today while at a stop light that when I depress the brake pedal (after being stopped) it makes a squishy sound - the pedal feels different, but I don't know if spongy/squishy is the right way to describe it, it just sounds like you stepped on a waterlogged sponge.
Now the brakes definitely don't feel as good as my XLT brakes (recently replaced it due to rod knock - 02 XLT v6). It still stops but seems like it requires more effort and almost fades a little. I initially chalked up the difference in performance to me putting new rotors/pads on the XLT - Thermo-quiet semi's with Raybestos rotors.
However it appears after some brief reading this could be the master cylinder on its way out....is that accurate? I planned on taking my pads/rotors off the XLT before I ship it to the junkyard (less than 3k on that setup), but if its the master cylinder, I'd like to do that while I'm doing all my other tune up stuff this weekend
I'm gonna put it on the lift this weekend and see if there's any brake fluid stains to see if air is getting into the system, but looking at the reservoir over the past week I haven't noticed really any decline in fluid level.
View 4 Replies
I took delivery last week of a new 2012 F250 with a 6.7 Power Stroke Diesel. This is my third F250 with a Power Stroke Diesel. My first one was a 1997 w/7.3 PSD and my last one was 2001 w/7.3 PSD which I traded in for the 2012.
Now for my problem. The brakes seem spongy to me. When I am applying the brakes I get what seems like a longer than normal pedal travel (to me anyway) and soft. The braking isn't as good as my last two F250's. If I pump the brakes, the brake pedal firms up and the braking really improves. I have not contacted my dealer yet.
View 14 Replies
My 2009 Accent (hatch) has for some time now made a very noticeable clunking sound from the rear passenger side when going over rough roads (minor bumps). I sat in the back at one point and it is definitely coming from the area of the shock and not from the trunk. It has persisted through all temperatures and seems worse now (February in New England). I found a lot of conversation of this issue related to Elantras, but not so much for Accents. My spouse thinks it is the shock dust cover rattling, and in fact you can make it rattle, but I'm not convinced that it could make that much of a clunk - it's just what looks like a thin plastic.
View 9 Replies
I have a 2002 ford f350 sd crew cab, i have changed the front and rear brakes, since then the steering has gotten sloppy. I was driving around 30-40mph and making a sweeping right turn and the front end was wobbly at a low speed it is fine and on a left turn it is fine. It feels like it is the drivers side tire that is the problem. I have to change the tie rod that is attached to the pitman arm. I don't want to bring it to a shop.
View 7 Replies
Getting a lot of vibration and noise when slamming on the brakes. Not like my last vehicle which was very quiet. Want to bring it in to have it checked, but if there is nothing wrong and its normal, I will have to pay them for looking at it. Always scares the crap out of me when it happens.
View 18 Replies
Lately almost every morning my brakes have been seized. After releasing the parking brake the car won't budge without a bit of gas and a loud BANG from all four wheels as they become unstuck. And I don't mean a small bang, it sounds like someone whacked the wheel with a sledgehammer. It has been cold, snowy, icy, wet, and very salty here lately, but the car is parked in an underground garage overnight where the temperature is above freezing.
After becoming unstuck the brakes are noisy and very rough. They'll also re-seize at each stoplight, but with just a small bang. This slowly gets better as I use them, until the next time. Is this normal?
I can't imagine it's good for the health of the brakes for this to be happening. I've heard of this happening if a car is left sitting in wet conditions for a couple weeks, but only after 12 hours, and again at each light? I also had the dealer take apart and clean the brakes about 4 months ago.
View 5 Replies
I have a 2003 Camry LE 4cly. Approx 150k miles. Car has been a good Camry. About 6 months ago it started to shudder when applying brakes. At first I thought rotors, but it seemed speed dependent. When over 40 it happens more often and more strongly. After the car gets below 10 to 20 the shudder ceases. Front pads are in reasonable shape. Rotating tires does not affect the shudder. Has never effected handling of vehicle. Brakes work without fail, just shudder in front end and steering wheel. I tried flushing the system, had not done that previously. Fluid was yellow, but not black. After the flush, the system seemed to shudder less, but still have the intermittent shudder. There are no error code for ABS, and the light is not on and does not come on.
View 5 Replies
So having done a single track day, I feel like my rotors must have warped, as there is now a slight vibration when applying the brakes. This is very surprising as I don't do anything out of the ordinary, and tried to use brakes intelligently, including a proper cool down lap and so on. Is this normal? What are my options for making life better? Is there some set of rotors I should get that wouldn't be prone to warping like this? Is it a question of pads?
View 18 Replies
1998 base model, 3.1, about 232,000 miles on it.
purchased at about 45,000 miles and always had a slight "hissing " noise when I apply the brake.
Yesterday the car was parked on a very slight incline. Emergency brake was applied. a/c was on . I returned about 5 minutes later and heard a "hissing" type of sound. It seemed to be coming from under the dash on drivers side.
As I put my foot on the brake and shifted into reverse the noise stopped. Today at various times I have the same noise.
I've owned at least 40 cars in the last 50 years and this car has the very worse brakes of all . I've tried all types of pads, etc. The rear cylinders rebuilt about 150,000 miles ago. Master cylinder is original.
View 1 Replies
I had been hearing bang noise from my front suspension at certain times like when reversing car and applying brakes. It was happening since I bought my car and every time I have complained about it to local VW service guys, I was told by them that they cannot replicate the noise so there is nothing wrong. I even told them to have a look at front suspension bushings but again they said everything is fine.
Last week I went for 45.000KM Service and I complained about the same issue again and luckily this time service advisor heard the noise himself. Next day, they called me to inform that my front lower arm bushings needs to be replaced, front brake pads and discs, and front wheel bearings as well. In my response I told them that bushings were bad for long time and no one figured it out earlier and due to this my front brake discs had abnormal wear along with the wheel bearings.
I am still trying to relate that it is technically possible for brake discs at least to wear off earlier if the suspension bushings are bad as when you apply brakes, the brake discs are stressed heavily as the bushing are not absorbing any stress.
I would like to have thoughts on this matter. Just let me know if my understanding is correct or it does not makes any sense and technically would not be proved.
Just to let you know that it is 3.2 4motion model. My driving is average within 120 KM speed and never hit any potholes etc. Plus my brake pads indicator never went on.
View 10 Replies
2002 Santa Fe has Shimmy when applying brakes. Had tire balanced and rotated-no change. New brakes with life time pads one year ago. Rotors were turned. Should I replace the rotors and pads or just rotors? Am I on the right track for repairs?
View 2 Replies
I have a 98 chevy tahoe and the truck seems to make a strange noise sometimes when applying the brakes. I can feel (sorta) the noise in the brake pedal. Is this something that needs a scan to find out where it's coming from?
View 11 Replies
Just got the Tiguan SE- love it! We have had it for about 3 weeks. I noticed sometimes while applying the brakes, the RPM's will go up as I am slowing down. I know the car has to move between gears when slowing down or speeding up, but it almost as if it gets "stuck" in a gear when the car is slowing down. Any thoughts, input? We don't drive fast, we apply the brakes and gas slowly to ease the car in. This just seems odd as my past car (2005 Maza 3) did not do this. I am new the VW family so maybe I am just not used this.
View 6 Replies
2014 Passat... I've got a little over 2,000 miles on mine now and I really do like the car. However, one thing that is really bothersome to me is----the brakes.
I'm not sure if it is specific to my car or to the passat in general. Here's the issue:
When applying the brakes, the pedal feels almost loose, as though the is no pressure on it, but once you push the pedal down far enough the brakes come on heavy, hard and fast. It's like turning on a light switch.
I am wondering if this is an adjustment that I can have done at the dealer to put more feel into the brakes or if this is just something that we all have to live with, of if maybe there could be something wrong with the brakes on my car.
View 4 Replies
