Just had 30,000 km service done and was told the rear disc brake pads are almost completely worn out. The front ones are hardly worn and I'm not a fierce type driver who jams on the brakes or one who leaves the handbrake on..
I asked the service manager how come the rears are worn yet the fronts aren't - his answer was sometimes this happens.
Well I had a flat today, but that turned out to be a good thing. I noticed the rear brake pads are worn out. They are not metal to metal, but close. I have been looking at Rockauto, Pepboys and others. The funny thing is they never prompt or list different pads for the SRW vs the dually.
Are they the same including the parking brakes shoes? I was going to go with the OEM material or should I go with a ceramic pad?
So my brake pads worn light came on recently on my 03 jetta...low and behold all 4 brake pads needed changing...funny though because upon buying pads with the sensor when I went to put new pads on the old ones didnt even have a sensor it was already cut at the harness and spliced together to keep the light off....so upon inspection one of the wires was black and the other copper....idk if one was supposed to be black or if its because its fried? Anyways i went as far up the wires as I could till they are harnessed in with the abs sensor wires...still one wire black....spliced together crimped and still the light comes and goes....I dont have access to the vcds or vagcom so can't turn it off that way..
View 2 RepliesThe brake pads worn symbol has lit up in the instrument cluster on my wife's 2008 Touareg V8. The car has 33K. Per Tom Bush VW in Jacksonville, both pads and rotors must be replaced. This is without even looking at it.
Per Osteen VW also in JAX, I might not have to replace the rotors. They stated that what they have seen is that usually the rotors don't get replaced until the second visit to replace pads.
I have about 50,000 miles on my pads, they look 50% gone, but couple days ago I've got short "beep" and light yellow came on(circle with several small parts of larger circle). What and why? Rotors, pads, other?
View 4 RepliesI'm thinking about buying a 98 Explorer that has an ABS light on. I haven't looked at it yet. In the ad, the seller claims it's due to worn brake pads in the rear. If that's true, then it's not a big deal. Can the ABS light be set by worn pads? Most of my cars are too old to detect this, but even if they did, I wouldn't know because I never let my pads get that low.
View 7 RepliesI start hearing sound when i hit brake, i haven't checked the pad yet but i think it is time to change the pad. BTW, i have 2012 Camry SE I4 with 36xxx miles. So should i go with toyota pad or aftermarket pad?
View 14 RepliesHow can you tell if it is time to change brake pads without taking off the wheels on the 2012 GX460 Premium?
View 14 RepliesI have a 1993 Regal Custom. The friction pads on the transverse spring had worn off. I replaced with the aftermarket isolator pads. These work well. The problem I am having is that after a few months they tend to shoot out. You will hear a large bang and then see the pad shoot out in the rear view mirror. This seems to happen when their is a load in the rear of the car. What can be done to prevent this.
View 4 RepliesThis started recently and suddenly during our recent snow. It sounds like the pads have worn down. Only happens at very low speed, not immediately at the point where the disc brakes cut in (>7mph?). Apart from the sound, the braking action feels normal and it stops fine.
The pads were only replaced a few months ago. Done 106,000 miles now, and no more than 2,000 since pads replaced.
I had thought it might be some grit caught between disc and pads but it would have cleared by now and there are now obvious signs on the disc of anything.
What would I be best to remove the wheels and take a closer look. Also, is there a wear sensor on the pads?
Just went to the dealership for 40k miles service and they told me my rear brake pads were low, around 20%. And they quote me $430 for replacement (Parts + labor). Should i go with it? or i better go buy parts from internet store and find some local mechanic install it for me?
View 9 RepliesMy car has about 37k on it; and while the front pads look to be about 50% worn; the rears look like they are closer to 90%. Is this normal? The car is also sluggish while braking especially when the engine is being auto-revved to keep the system voltage up (a known problem). It also seems that the car will step into ABS lock-up mode too soon in a panic stop situation; which might also indicate that the brake system is biasing too much power to the rears; too little to the fronts.
I've never had a car wear the rear brakes more rapidly than the fronts; usually the rears are much more lightly utilized to reduce the tendency to skid. Is there any way to adjust brake bias? I'm getting ready to change rear pads and flush brake fluid.
So my car has 36 or so thousands miles and well the rear brake pads and rotors were SHOT! The rear rotor was falling apart and huge chunks were coming off. The issue stands now that I can't spread the rear caliper for anything, the ebrake is off too. I tried to use the C-Clamp trick but it honestly didn't even budge. I also opened up the bleeder and master cylinders cap just to cross that off the list when trying to compress. This is the hardest caliper I've ever had the misfortune of dealing with and I fear that the passenger side is not going to be any better. Aside from spending more money or renting the "tool" is there anything else to check because the C-Clamp trick has work on mine and my father trucks calipers.
View 3 RepliesWhat's with the rear brake pads wearing out before the front brake pads. Took my '03 Passat in last week to the dealer for the recall and the service dept. guy said my brake pads were worn out. I took the car to my local mechanic who specializes in VW's. Sure enough, rears were almost gone but fronts still had plenty of meat left on them. Of course I had him replace the rears. But I always thought the fronts wore out first. Could this anomaly be due to ABS?
View 11 RepliesI am wanting to change my rear brake pads and . Looking for step by step instructions or photos.
View 1 RepliesAfter removing the tires, I can't figure out how to remove the brake pads to change them. How to do it? Does the caliper have to come off? These are on the rear. 2001 F150 4X4...
View 1 RepliesI bought new pads for my truck and the fronts went on with no problem at all, but when I got to the rear the tabs/ears on the pads are about 1/8 inch wider than the notch they are supposed to fit in. I bought part number BR-1067, which is supposed to fit but obviously doesn't. What part number should I have bought? My truck is a 2007 F250 Super Crew Lariat FX4.
View 9 RepliesI'm gonna replace my front and rear brake pads. Any tips? Do I need to pull the rotor off and clean the axel? I've watched a couple of youtube videos but they leave me with a few answers. I have all the tools, what kinda lubricants will i need? Any recommendations? I hoping I can do a flawless job without and squealing...
View 13 RepliesIs there a secret to this? I've tried everything. I have the proper tools, I've dried bleeding the brake fluid as I compress, but nothing is working! This is the first time I've changed my brakes, but everything online looks straight forward enough. Is there anything I could be missing or does it seem that my piston is legit stuck?
View 9 RepliesI just notice that two of my tires, all of them Michelin Energy™ Saver A/S tires, seems to be worn out after 10K mile usage. However, when I look these tires at the Michelin web site, it states that these tires have a 64K mile warranty. Also if I decided that two of my tires, all Michelin Energy™ Saver A/S tires, need replacement, could I just replace the two worn out tires or all 4 tires?
View 14 RepliesI have a 2012 Kia Soul with 27,000 miles and the clutch needs replacing. I've driven standard transmission vehicles for 45 years (sad to say) and have never had a worn clutch. How can I tell if the original clutch truly is worn or is defective? This is rather critical if it's the former (i.e. worn), I'm out $1400.00; if it's defective, the manufacturer pays.
View 1 Replies