Accent RB (2012+) :: Radio Aux Input Not Working
Oct 3, 2016
When using any accessories plugged into the Aux port, either with the original iPod cable, aux jack or my bluetooth receiver plugged into the aux jack the audio comes out very staticky and even cuts in and out. The weird part is that it intensifies when I accelerate and usually at the top end of the RPM range before a gear shift. When I am really pushing the car during a merge or passing the audio eventually just gives out. When I am in a more constant RPM the audio just crackles. I have checked my fuses and dont seem to see any issues.
View 3 Replies
Advertisement
Why my fan wont turn off? If I pull the fuses under the hood it will stop, but once I put the fuses back in, it starts up again. I just installed a new radio, would this have anything to do with it?
View 1 Replies
I have a question around how turn my 2014 Hyundai Accent off to ACC mode?
Starting the car into ACC mode is OK.
Press the start/stop button without the foot on the pedal and it goes into ACC mode and the radio turns on.
Turning off the car into ACC mode. How does one do this?
Scenario - I am connected to Bluetooth on a phone call. I park the car and want to turn it off but keep the call going. Currently it turns it all off!
On my 2016 Hyundai Tucson - I have manage to figure out that if I put the car in P and press and hold the lever on the gearshift and press the start/stop button then it goes into ACC mode.
On my 2014 Hyundai Accent - There is no lever on the gearshift to do this.
If I turn car off in N - Neutral, it goes into ACC mode BUT it BEEPS continuously.
View 4 Replies
Noticed poor FM radio reception in 2012? Mine seems to just barely fade in and out. It's not terribly noticeable, but definitely happening. It's frustrating when streaming Bluetooth actually sounds better than the FM radio reception! I'm wondering if it's a problem specific to my car or if it's an issue everyone is experiencing.
View 16 Replies
question is, how to I get an AUX input into the radio? Looking at the Denison units, assuming I can find out exactly what unit I have. Also - the sound is not too bad. Plays 'louder' than I expected. Is there an amp somewhere? Looked in the rear panels, nothing spotted.
View 10 Replies
My dashboard lights and radio are not working. I checked the radio fuses and they are ok. I cant find why these aren't working.
View 3 Replies
So yesterday we removed the radio from the car to install an after market one, after realising the after market radio had different cable inputs we reinstalled the original radio that was in there. But now the radio won't turn on, the clock doesn't work and the interior light isn't working. What the issue could be?
View 2 Replies
Just picked up a 2006 Toyota Camry LE (Gen 5.5) and it has the basic single CD (no tape player) radio without any AUX input. This vehicle is going to be my new daily driver (supercharged Mustang isn't going to cut it) and I want AUX as I will be driving across the country.
Are there any new solutions to getting AUX in a gen 5.5? Not looking to replace the whole head unit because I like the stock simple controls.
View 8 Replies
I have a 2007 jetta city with the single DIN radio (stock). I would like to have an aux input or usb input. I would like to know what would be the better option? (I don't want to go aftermarket). I know that there is a lot of option but I don't know witch one will work on my radio. (no pre-wired cd changer, no satellite).
Also, on the bottom right of the radio there is two kind of blank plugs (circle and rectangular). It looks like a usb and aux input would fit right there. I saw a picture in witch someone as the exact same radio but with a usb input (instead of the rectangular thing).
View 2 Replies
i am having problem that all the buttons and the touch screen not working at al inspite the car is still new 2015
but the buttons on the steering can still control the colume and the radio !!
View 1 Replies
The Aux input on my 09 Corolla has started to malfunction.I plug my ipod into the auxiliary input and if the cable wobbles as i drive and hit bumps, the AUX mode switches over to RADIO mode and the radio starts to play, instead of the ipod. I have to wiggle the cable before i press the AUX button for it to start playing the ipod.
View 14 Replies
Turning the fan knob yields no results. The AC compressor does kick in as I can feel it when I turn it on when idling, so the knob appears to work. The blower does not move air.
I checked the fuse below the steering wheel and the fuse makes a complete circuit although the edge looks a bit darkened. Other fuses from working devices look the same and I took a spare 10A fuse from the designated area and inserted into the blower motor fuse location - still nothing.
I will also inspect the relays/fuses in the engine compartment to see if anything in there looks blown that's related to the blower motor. Hopefully it will be something simple, but probably not...
I will need to take it in to get it looked at and fixed, and this is probably not under warranty since vehicle has 56k miles... while I'm there I'll have a transmission fluid exchange done as well and I was planning on getting some body work done.
My bumper was torn off from the fact that it sits low enough that sometimes it would go over the parking stump. Well, it eventually got caught really bad and tore it off. Now the tab where the screw goes to secure the bumper has sheared off so it just hangs. Also, the tearing action from the parking stump caused the inner fender to come off and rub against my tire while driving, tearing it into shreds from the friction.
View 7 Replies
About 3 weeks ago, I purchased a 2001 Accent GL 4dr 5spd from a friend of mine. A few days later, the CEL came on. I went to O'Reilly and got the code pulled, it was for a cam sensor input LOW. I replaced the sensor and was on my way.
Yesterday after starting the car for the first time for a few days (I wasn't driving because it needed a clutch), the light came on. Has it gone bad again or is something causing the signal to be low? Maybe a low output on the alternator or low battery? The interior lights dim slightly when the brake pedal is applied while the car is running.
View 8 Replies
After lurking through the site and grabbing a hold off a copy of the RB's wiring diagram, I thought I'd put my basic electronics to good use. I managed to replace the stock alarm that came with my unit to a Passive Keyless Entry (PKE) with Start/Stop button.
After all the wirings, I managed to get it to work with one minor glitch: the instrument lights for the transmission level and manual A/C won't turn on as it used to whenever I turn on my park lights / head lights. I do *think* that it's still wired as the light for the air circulation comes off when I turn on the headlight knob. I also tried to re-insert the M17 ignition switch to see if that's the cause, but the lights still won't come on. Note that the reason the M17 ignition switch was removed is because I don't want the key (now cut and covered by the push start / stop button) to trigger anything when it's turned. I only need it there now just to disable the steering wheel lock.
Where I should start checking? I'm hoping it's just a busted fuse somewhere, but if I need to tap these instrument lights to another power source in replacement of whatever the ignition switch was originally used for.
View 5 Replies
My 1.5L 2000 Hyundai accent is reading p0342 code.(cmp sensor circuit low Input). I have changed out the sensor from a parts car and it's still reading this code. I've read it could be timing or an issue with the starter wiring.
View 3 Replies
So I just got my 07 camry se v6 and was so excited and hooked my ipod into the aux input and go to push disc/aux and it wont go to aux?? so i took it to the dealership and they said oh its prob a bad cable so i bought a new 3.5 cable and tried it and still nothing. it plays cds fine. they tried saying that i might need some adapter from toyota directly to hook it up but i find this hard to believe... Could I have a bad aux input jack? i tried searching but came up empty handed. Aux input does not work. got new cable. still nothing. ?
View 14 Replies
The MIL light came on and I noticed the shifting P-D or P-R was hard. Checked the Transmission Fluid and noticed it was low. Topped it up, but still MIL is on and shifting hard still. I bought a OBD2 Scanner and it returns P0707 "Transmission Range Sensor Circuit Low Input". Should I try clearing the DTC? It's a drag because it's my wife's car and she's driving mine.
View 1 Replies
A week ago my aux input stopped working (ipod plugged in but won't show up as an option on the audio console).
View 2 Replies
my timing chain slipped and had to have engine repaired - then when I picked up my car the display for the radio/clock didn't work and neither did the buttons. The knobs worked (to turn radio on/off and tuning) - but of course since the display is blank can't see what radio station I'm on.It worked perfectly when I dropped it off, but when I picked it up, it was non-functional. Mechanic says they didn't do anything with the dash - but how else would this have happened? Is this not the fault of the mechanic?
View 8 Replies
The rubber (insulator?) around the antenna mast was seriously compromised, I noticed, when it was removed for a car wash (an infrequent occurrence). The radio worked occasionally after that.
Then I had a minor water leak through the vent system due to a blocked drainage lip on the particulate filter. The floor was soaked, causing the alarm to go off without warning (now dried and working correctly), but the radio stopped altogether if i remember correctly.
Then the wipers stopped working when it rained (they worked when dry). Replaced the wiper motor, and lo and behold, the radio works again sometimes - when it's dry out. obviously, i need to replace the antenna mast. Will this correct it?
View 1 Replies
My radio hasn't worked for over a year. I've gotten used to driving with my headphones on, but now I want to get to the bottom of the problem.
I have an 06 Accent. The radio powers on and I am able to flip stations and put a cd in and out. I just get no sound.
I tried checking the audio fuses. I can't check one of the fuses because its connected to the yellow memory fuse. I can't get the fuse out without breaking the plastic case. Is there a way to remove the fuse without breaking the case?
Another thing I just noticed is when I turn on the radio I hear a pop coming from the left rear speaker. I don't know what that means. How to get sound back.
View 5 Replies
