I cannot find the location of the knock sensor in my 2012 Accent. I just replaced the radiator and had everything off up front unobstructed and couldn't find it. Looked in back, sides, but am completely stumped. I have found information on earlier models but not 2012+.
View 37 RepliesI need to change the knock sensor of 2011 Accent, don't know where it is.
View 7 RepliesI'm looking for the location of the knock sensor I can't find it?
View 4 Replies2012 Hyundai Accent. I am getting a po326 code. Wondering if it may be a faulty knock sensor. And po463 fuel level sensor code when I fill up with gas.
View 2 RepliesWhere the knock sensor is located on my 1997 Aurora. what does it do?
View 2 RepliesReplacing the knock sensor on a 2009-2010 Sonata with a 2.4l? Where exactly is it located and what has to be removed?
View 2 RepliesI have a 2012 hyundai accent. The check engine light came on. The code read knock sensor. Before I could get it into a shop, it went off. It didn't come back for 11 months. When it did come back, the same code was read. Again, it went off the following day before it could be looked at and hasn't been seen since. The shop says that even though there is a history code, it would be hard to diagnose since it isn't an active code. I noticed absolutely no difference in performance when the code was active. Both times it went on, the car was idling for several minutes with the ac on, and it came on as i accelerated onto a highway immediately afterwards. However, it has idled like that many other times without the light coming on as well.
View 11 RepliesI have upgraded my sound system in my car and sometimes i get a P0326 check engine light.
Now i was wondering if its possible that the Heavy bass ( 25/40 Hz, 1200 Watt RMS and 2500 watt Max) Subwoofers could cause the car to vibrate so much that it sets of the knock sensor?
I have read some things about it but i only found that several "Old" cars with OBDII would have this problem? Is that the same on this hyundai accent?
It only comes once in a while after long cruises and bumping.
Where the knocking sensor is located on a 2005 Accent. I am in need of finding it so that i can wire a controller into the signal wire?
View 2 Repliestrying to find the speed sensor on a 03 accent manual so I can fit cruise control
View 1 RepliesI'm trying to locate the MAF sensor on my 2001 LC accent. I can see the air cleaner box, the tube which T's off to the surge tank, and then it goes straight into the throttle body. On the hmaservice website, it shows a MAF sensor between the air cleaner box and the surge tank (or "resonator"). I don't have that! There's concertina tube going straight from the throttle body to the air cleaner box (with T off). Am I just missing a part?? There don't *seem* to be any unused harness connectors lying idly around the place!
View 2 Replies2009 accent, cant find its location. Picture would be nice...
View 4 RepliesI have a 2009 Hyundai accent. 2 cylinders misfire. I changed out the spark plugs after the misfiring began and the 2 cylinders that misfire don't follow any specific ignition coil, it's just 2 random ones.
Looking at the data with a reader points to fuel injector number 1 not working properly. The first few seconds the car is on the check engine light blinks and fuel injector 1 spray duration (fluctuates based on gas applied) changes just like all the others. However, when the check engine light goes solid (then the misfire code is thrown) fuel injector 1's spray duration is stuck (usually around 3.5 ms)
The cable going into the fuel injector powers those little troubleshooting lights like it should until you plug the cable into the fuel injector OR remove and replace the light a few times.
I don't know much about cars but someone told me to try cleaning out the Mass AirFlow sensor as they had the problem above and the MAF sensor was the cause. I can't find anything on where the MAF sensor is located though.
Where the ECT sensor is located? I would really like to have a diagram of the engine. Where I can find an engine diagram for a 2008 accent gls?
View 3 RepliesMy 2012 Accent's 1.6L GDI engine has developed an engine rattle when under load and warmed up.
View 38 RepliesWife's car threw a p0711 code. It says temp sensor failure or whatever. I found the part on rockauto for 22 bucks but that's not the issue. I've tried searching about this and I seem to find some stuff about elantras and sonatas. I can't seem to find anything specific to a accent. I've read that it's inside the transmission which is fine I've changed valves before and such on old rwd transmissions. But some things I find say it's on the bottom and some say the side. Also wiring is mentioned pretty often with service bulletins.
View 28 RepliesWhere the transmission temperature sensor is on a 2014 Camry 4 cylinder. I am contemplating unplugging it to improve shift points. I know it may affect gas mileage but the current shift points suck.
View 2 RepliesI am hearing a quiet knock from my 2013 accent, especially when accelerating or going uphill on low RPM. I am getting about 34 MPG after burning a tank of regular gas (87 octane rating) on my commute which is about 2/3rds 50-70mph freeway and 1/3rd stop and go traffic. I usually get more MPG than what the EPA rating is, so that number seems a little bit low to me, but I just got the car used, so I don't know what's "Normal" for it. Idle is pretty quiet though.
I would give a video where you can hear it, but honestly it is pretty hard to hear from inside the car. I generally have to be near a wall with the windows down or something to be able to hear it clearly.
2012 Accent 1.6L GDI Engine Rattle/Knock/Buzz
Also, there are no lights showing on the dashboard besides the ECO light since I have been running the car in that mode. Is it possible that there could be codes that might give more information even though nothing is showing on the dashboard?
Truck is 2012 F250XL single cab 6.2. Where is the pitch sensor on this truck? There are times the hill start assist will keep the brakes applied on level ground, and occasionally I will crest a hill onto a level stretch and the truck doesn't want to upshift. So I am thinking the pitch (incline) sensor needs recalibrated. Where it is?
View 7 RepliesI have a 2013 Accent and have installing driving lights. I am looking for the correct high beam wire on the driver's side on the headlight assembly. I will then run this to a relay so that when I turn on my highs, the driving lights will come on. I have tried to locate the correct wire but the one wire that is hot when the highs are on, is still hot when the car is off as well as the lights.
View 6 RepliesI need to know the Location of the turn signal relay, my left front bilnker is super dim, and the rear left blinker is normal brightness as well as they blink rapidly. I've replaced both front and back bulbs as well as the flasher and turn signal fuses, so I am assuming the last and final one is the turn signal relay.
View 2 Replies