It's been a while, but my clutch has been really stiff for a while now. I don't think it was always this stiff. My mother has the same car and her clutch is really "light" and is very easy to press in. While mine is about as stiff as my friends corvette.... Is it just normal in that all clutches feel different or could something be wrong?
View 2 RepliesI've been having some issues with my car lately, 2012 Accent 1.6 manual transmission 36,000km aprox. The RPM climbs after I release the clutch, for example I'm going from 1st gear to 2nd, or 2nd to 3rd or any change of gears around 2,500rpm and when I release the clutch the RPM climbs to 2,800 or so and stays like that a couple of seconds, today the RPM climbed from 2,500 to 3,000-3,200 and stayed like that again for a couple of seconds.
View 5 RepliesI bought my Hyundai new in late 2011. No problems with the car (other than no spare tire???) until just out of the warranty (63,000). Had a noticeable drop in power on the highway. No warning lights. Drove another 100 miles with power intermittently dropping. Next day engine light comes on. $800 later I have a new high pressure fuel pump. All seems well. after a few weeks, I notice that the car seems to be revving when I depress the clutch to change gears, like up to 4000 rpm's. If I leave the clutch in for a few seconds it will begin to decrease. But if I shift right into gear as I have done for the last 35 years of driving, it is not smooth, jerky. This seems to happen mostly going into 2,3, and 4th gear, always going up. It never happens when downshifting. I tried tapping the brakes when shifting up, and sometimes it does seems to drop the rpm's. What it might be. It probably is related to the work that was done, but I don't really trust the dealer and want to have a little info going in.
View 1 RepliesToday I started my car (in the garage so it wasn't too cold) and everything was fine. The car warmed up in a couple minutes and I was off.
As i was driving, I noticed that my shifting was horrible. It felt like i was burning the clutch and not releasing the clutch smoothly in general.
I then noticed that when i pressed in the clutch ready to take the next gear, the engine would raise the rpm's about 500-1000 revs before coming down.
I started to wait till the revs came down to shift and that seems to work.
Why would the engine be revving itself higher the second after i push the clutch in. My dealer can't take me until Wednesday so I don't know what to do.
On releasing the clutch pedal, a creaking noise can be heard, which:
- sounds and feels like a rusty spring being unloaded
- occurs for the entire range of pedal travel, but worse near the bottom
- is louder outside the car than inside
- happens not only when driving, but also when stationary with the engine off
I don't think anything is wrong with the clutch itself, or any bearings, or major components... It just feels like something needs to be lubed. I've lubed the spring above the pedal inside the car, with no real effect.
In most other manual tranny cars that I have ever driven, the clutch pedal engages/disengages within an inch of the floor. Not my accent. is it possible to adjust the clutch pedal so that engagement isn't so far away from the floor? it pretty much fully engages at the near top of the pedal.
View 2 RepliesI've been noticing that when I step on it some times my clutch pedal seems to get stiff and if I press on it a couple times its normal again. This has been going on for awhile now and I've just been driving it normal but when I do decide to get on it then the pedal will get stiff..
View 4 RepliesI have a 2002 Celica GTS with 80,000 miles. The clutch pedal pressure was very stiff. I had a 2001 GT, and it had a very soft and easy clutch. I just removed and rebuilt the clutch slave cylinder, using the CSK 2426 rebuild kit. The slave cylinders on 2000 to 2005 Celicas are all the same. After bleeding the cylinder, the pedal pressure is very much improved. It still takes some effort, but not like before.
View 1 RepliesJust bought a 1995 GMC Sonoma. Needs some TLC but the brake and clutch pedals are unusually hard. They are still 100% operable, but they are both pretty stiff. Any trial and error ideas I should try to attempt to resolve this issue? Yes, fluids are topped off.
View 1 RepliesI've test driven a used 2003 (155K) I'm considering purchasing. But the clutch is so stiff, especially compared to my 93 Accord. What makes a new clutch, pressure plate a throw out bearing so hard to engage?
View 9 RepliesThis morning I tried to put my car into reverse and I literally had to force it. It didn't grind or anything, no funny sounds that I have heard, just didn't want to go. It also felt like shifting was kind of "stiff" or tight... The car has 76K on it and I've never replaced the clutch, so it might just be due, but it kind of happened out of the blue. After the first incident of the reverse not cooperating, I didn't have any problems for the rest of the day, but shifting in general still kinda felt off... A coworker said that basically means I'll need a new clutch within a few weeks.
Is it just time for a new clutch? Or is there something I can do? And, so I don't get taken for everything, how to present this problem to my mechanic? I trust them, but I want to be as informed as possible when I go in to talk to them.
My 1970 Nova has a very stiff clutch pedal. Is it possible to adjust the tension on it? It's getting to the point where it makes my foot sore to drive the thing- very annoying. It has a 3 speed on the floor gear-shift.
View 11 RepliesI just purchased a 2002 2 door manual Echo. Car has 70K miles. I noticed that there isnt much travel for the clutch pedal (at least compared to my SX4), I have to push the clutch pedal all the way to the floor to get it to engage and it seems pretty stiff shifting between gears. Is this normal for this car? Only my second Toyota owned and the first was an auto trans.
View 14 RepliesI have a 2003 1.3 Yaris T Spirit VVTi.
I am told I need a new clutch. First and second gear can be stiff to select, especially in cold weather, and the pedal has to be floored to change gear. The bite point is very high, and the clutch can judder before engaging but we are so used to it this only occurs occasionally at slow speeds.
However, the clutch does not slip in any gear and as I say it doesn't cause us any real problems because we are so used to it. The car has done 107,000 miles and has the original clutch (as far as I know).
Should the clutch be replaced?
I own an Accent 2000 model Manual Transmission. When the motor gets hot , the gear lever become increasingly hard to move and eventually locks. i.e., after say 10 minutes.
If I stop the car, turn the motor off, the gear lever moves freely. Start the car up again and the gears seem to work for a while.. then it locks up again.
This happened about 2 months ago.... seemed to fix up for a while.. now its back permanently. I changed the trans oil.. it made no difference..
The cable to the trans seems ok.. When the motor is 'off' it never jams. BUT i am not using the clutch then !! Could it be clutch.??
I've got a 2000 F250, 5.4L 4x4 with the ZF5 5-speed transmission. Three years ago I replaced the complete clutch assembly, pressure plate, throw-out bearing, etc, and had the flywheel re-machined. Put it back in and all has been well. Only has about 15k miles on it. Earlier this week I went to drive it and all of the sudden it started getting harder to shift and by the end of the trip the clutch will not disengage at all when I push the pedal in.
Furthermore the pedal is much harder to push than it always has been. Checked the reservoir and it's fine. After some searching it seems to most likely be an issue with the master and/or slave cylinder either needing to be bled or replaced. Further reading revealed that bleeding and recommends just replacing the whole system, so I've priced that out. Was it a master/slave issue? Anything else I should check in case it isn't?
My 2001 Hyundai accent hatchback with around 135000 miles is having problems with the gas pedal. I start my car and can't really push down the gas pedal smoothly. It is initially hard where I have to slightly kick the pedal to move it. Otherwise if I rest my foot on the pedal and try to press it down I end up press it down too much where my car goes flying. Every time I come to a stop I have to do that to get the pedal to move. Its not stiff once I get the pedal to push down some but once I take my foot off the pedal I have to slightly kick it back down.
View 4 RepliesI have a Hyundai Accent 2001 and today while driving the battery light and brake light both went on and the steering wheel became "stiff" - hard to turn - although driving in a straight line seemed to be as usual.
I would just take it to the garage, but although it still starts as usual, it seems hard and probably a bad idea to drive it there in its current condition.
I have a 2012 Camry LE with about 85K KM and had my alignment done and noticed that my steering feels very stiff. When i turn it left or right I can feel it very stiff. I never thought much about it until I drove my dad's 2014 Camry which has 10K KM on it and the steering is much smoother and feels lighter. We both have the Michelin Primacy MXV4 tires and my tire pressure is around 35 psi or slightly less.
Is it normal for the steering to feel tight? When I drive the car, there is no vibration and is very smooth. I don't feel like it pulls (it never did even without it). Should I take it back to the dealer to have it looked at?
I've got an unknown issue with my 07 Accent (1.6L):
There is a low tone noise coming from near the upper area of the engine. It sounds like air or fluid traveling through a hose. The tone of the noise has recently become progressively louder, so that it is noticeable over normal road noise when driving. The noise does not fluctuate in tone or intensity with changes in RPM. However, the tone changes to a higher pitched frequency, almost like a hiss, when the clutch is fully engaged and held to the floor, both when in gear and when not in gear.
What the cause may be? And potentially required maintenance?
I picked up a 2014.5 SE V6 a month ago and the car has been great overall. But the suspension is stiff especially over rough roads as many of you already know.
I've searched around and there's talk about swapping strut/shock parts with an LE/XLE or different tires but I can't find how much of a difference it made.
BTW, the tires are new Yokohama Avid Envigors.