Accent RB (2012+) :: Clicking Noise In Manual Mode In 1st Gear Coming From A Stop
Apr 5, 2016
I have the 12 Accent GL Auto, I have about 161,000 km, and recently say 3 months I've been hearing/feeling this click click noise come from under the car whenever I am in "manual" mode in 1st gear coming from a stop, now I`m 99% sure its not the brakes releasing because I just replaced both my caliper's in the rear and pads and rotors all the way around, And I know this sound because I've had the problem (twice) were my brakes stick so I'm very familiar with that sound this is something different, I want to say transmission because it only does this in 1st gear manual mode, but i know where the transmission is on this car, and this sound isn't coming from where the transmission is, more like under the firewall ( where the trans would be on a RWD car).
View 3 Replies
Advertisement
Just got a new 2013 Accent 6 speed manual. Love it but one thing concerns me. When I am disengaging the clutch and giving gas to get the car going, there is some vibration and feedback that just doesn't feel right. It is as if I learning to drive stick again and I am not shifting smoothly. This only happens going into 1st gear from a stop.
When I first drove the car I just assumed that I would get the feel of it but it seems like a little more than that. Is this normal?
View 22 Replies
Driving home today I was cruising along hwy about 50mph. I threw the shifter over to the manual mode and noticed immediately that it must put it into a lower gear than I was in when I was in automatic bc the rpm jumped up a little higher. I think it put me in 4th or 5th?? I put it back in auto mode and rpms went back to normal. I'm guessing it's the normal way it operates?
View 4 Replies
New to the board- sold my b6 passat for '12 GTI manual.
Its been a few years since i've owned a stick so I'm not sure if this noise is normal or just because the car as 100 miles on it OR just because I'm a freak when it comes to hearing every little noise.
But when i'm say in 5th or 6th gear on the highway and give it some gas I hears some noise like a fluttering vibration noise for a second or two and then it goes away? It sounds like its coming from right underneath me. Its not a huge deal but on my first brand new car, I'd rather just have someone tell me its normal or if it needs to be fixed or a bolt tightened or something.
View 12 Replies
I have a 2012 Cruze with a manual transmission. I have 43000 miles. When I down shift into 2nd gear I get a whining noise from under the car. I can shift it with no issues and no noise but when down shifting or turning in 2nd gear it whines.
View 19 Replies
I might buy a 2013 Accent tomorrow, but the only big question remaining is the ticking sound coming from the engine when I pop the hood.
When I hear ticking I think of valve issues, but is a ticking sound totally normal for that engine? Is it okay or should I be worried?
View 4 Replies
Had the Camry today and just messing around with the buttons. What is this eco mode "on" "off" feature? I accessed it from pressing and holding the odo button on the dash.
View 14 Replies
I have only driven my car a handful of times, but I noticed the past two times, that it sticks in 5th gear during the time that the oil temperature finally gets above the 1/4 mark until it finally settles.
It doesn't stick before reaching the quarter mark, and as far as I can tell, it doesn't stick in auto mode. This doesn't sound like something that should be normal, but what say you?
View 11 Replies
Driving in normal mode and the transmission in auto. Once the car gets up to temp, (usually at a stop), move the gear selector to manual mode. If you punch it, I have not issues shifting from 1st to 2nd gear, but sometimes, the up shift paddle will need to be hit multiple times in 2nd before the car will shift to 3rd.
It seems to only happen the first time I go from auto mode to manual mode during a drive cycle. It happens on my car and another car I test drove.
View 8 Replies
I was driving along today and my dash lit up light a Christmas tree. I got PCS, ABS, Brake and BSM lights and I was locked out of first gear in manual mode. Other than the lights and having to driving in auto mode, the car drove fine. When I got home I inspected the rear suspension and saw that the driver's side speed sensor's rubber shielding where it attaches to control arm was damaged. It was not completely severed, but there was a hole and some exposed copper wiring. I had SPC rear control arms and RSR coilovers installed and the car was lowered about 1.3 inches in rear. I was able to use extra copper wire and electrical tape to temporarily fix the problem. After all the wires where connected and shielded with electrical tape, I got zero lights when I started the car.
I'm not sure how it happened. Maybe the wire was damaged during install or it was pinched due to car being lowered. Whatever the case, make sure the wire is secured in a way to avoid being pinched during suspension travel. I ordered the new wire and will attempt to replace. Looks pretty straight forward except the wire goes into the interior of the car somewhere. I read that I will have to remove rear seats. If so, that should be pretty easy. Is there something I'm missing? Will any of the rear interior need to be removed? How to do this?
View 5 Replies
I have a metallic grey 2012 SE V6 Camry. While the car is in drive mode, not S mode, I accidentally pressed the paddle shifters while turning and the car went into manual mode. The blue lit display on the dash said D for drive, but it had the gear numbers next to it and I could down or upshift at will. In order to get out of manual mode I have to stop the car, put it in S mode and then back in drive, bc I heard u weren't supposed to shift bet drive and sport mode while the car is in motion. Is this normal?, How to take the car out of manual mode without putting it in S mode then back to drive?
View 4 Replies
Got in the car today and moved the gear selector into the manual shift mode. Usually there is no play forwards or backwards. Today there was about 3/8 of an inch travel forward before the spring tension started. I'm taking the car in tomorrow to have the console latch replaced but was wondering why encountered this anomaly in the shift mechanism?
View 2 Replies
I bought a 2012 Hyundai Accent GLS just two days ago. It has about 38,000 miles on it. It's an automatic as well. I drove it home on the highway and was averaging about 44 mpg the entire time. Even while driving in town, it's got pretty good fuel economy. Everything about the car is great.
However, last night, I was driving around. When I came to a stop at a stop sign/red light/etc. and then proceeded to accelerate, I would hear this weird squeaking / creaking sound. I've heard it multiple times now since then. It doesn't do it every single time I accelerate, but when it does, it lasts for about 3 seconds and then stops. I've also noticed it does it sometimes when I make a turn and then accelerate. It's just a squeaking sound.
Is this something I should be concerned about? It doesn't do it every single time I accelerate, but when it does, it will last for about 3 seconds. I should also note that the car made the noise the first night after I had been driving for a while, so the engine wasn't cold or anything.
View 15 Replies
The other day, I changed my front brakes just the pads. Everything came out smooth but then later that day i started to notice a clicking noise coming from the passenger side brake I suppose. You can't hear it when you drive or when braking early but you start to hear it when the car slows down and your coming to a stop. Its a constant clicking noise within like 1 or 2 seconds of each other. Its not loud, but its very noticeable with music off. And not to mention, very annoying.
I'm about to take everything apart and reinstall everything to see whats up. BTW its a 2006 GS300 Front brakes. Finding a picture of the wheel off with rotors and whole brakes on. I think I might of put on a clip wrong.
View 11 Replies
I noticed recently that my car started this popping noise when braking in reverse gear. I never ran over anything and babied it for all the 6000 miles it has on the ODO. 2015 Camry
View 4 Replies
My gfs car (2012 accent) makes a rattle but more specifically it makes this rattle in about 3 gear under acceleration but not heavy acceleration (slow accelerate in a higher gear) at about 1500-2k rpm it makes a rattle and if i really get on it in the gear it keeps going, the second i let off then get back on (lightly) no noise but when you depress the pedal a little hard it does it again (auto trans by the way) I've heard of this before only issue is I don't remember where or who (useless, and wasn't a hyundai accent) anyway anything would be useful, car isn't under warranty so trying to stay out of dealership...
View 2 Replies
2013 accent auto My car rolls noticeably after parking unless the ground is completely flat. Parking brakes prevents it from rolling but I don't use parking brakes every time. Another brake problem I have is thump or clunk noise I get whenever I release a brake from stop.
View 12 Replies
I've noticed a bit of noise when the R is in manual mode, upshifting from 1st to 2nd. It can hear a bit of a clunk with the windows up or down (obviously a bit more pronounced windows down). It never makes the noise in "D", and maybe 50% of the time in "M".
No other noises that I can tell, from upshifts to downshifts in any other gear. Just the manual 1st to 2nd shift. Trans seems smooth, already had a Mech replacement.
Should I be concerned, or even take it to the dealer? I'd take a video, but I dont' think the mic on my phone would even pick up the sound. It's definitely there though...
View 2 Replies
I have a 2010 accent blue model with stick shift. been fine for 50k miles. Lately i have noticed an issue where i am in first gear and then when i push clutch in to go into second, the lever won't budge. it does eventually go in but it just isn't like it used to be. it happens say about 25% of the time. Since at higher rpms it won't do it but normal rpms it will.
Also, i just had a new short block installed, perhaps something is binding? If I sit in the car, stopped, i can shift into and out of all the gears perfectly. Maybe my 1st gear synchros are going?
View 2 Replies
I just got a 2000 accent. The problems is that sometimes when I shift into 2nd and 3rd is notches sometimes. But it does not do it when i shift down. Also if I shift fast it will occur less often as when I shift low. When my friend drove the car it didnt do it for him. So maybe it is how i drive or something. I make sure the clutch is down all the way.
View 7 Replies
After lurking through the site and grabbing a hold off a copy of the RB's wiring diagram, I thought I'd put my basic electronics to good use. I managed to replace the stock alarm that came with my unit to a Passive Keyless Entry (PKE) with Start/Stop button.
After all the wirings, I managed to get it to work with one minor glitch: the instrument lights for the transmission level and manual A/C won't turn on as it used to whenever I turn on my park lights / head lights. I do *think* that it's still wired as the light for the air circulation comes off when I turn on the headlight knob. I also tried to re-insert the M17 ignition switch to see if that's the cause, but the lights still won't come on. Note that the reason the M17 ignition switch was removed is because I don't want the key (now cut and covered by the push start / stop button) to trigger anything when it's turned. I only need it there now just to disable the steering wheel lock.
Where I should start checking? I'm hoping it's just a busted fuse somewhere, but if I need to tap these instrument lights to another power source in replacement of whatever the ignition switch was originally used for.
View 5 Replies
