So sometime last week my check engine light came on. Took my 13 Accent to the dealership and they said the purge valve is to be replaced. Now my Accent pings when running 87 gas and I read that others (not necessarily Accent owners) who changed their purge valve noticed the pinging go away.
View 5 RepliesI only have 2200 miles on my new 2012 Passat SE V6 and the check engine light came on the other morning. I took it in to the dealer and they found codes P0442 (EVAP Emission Control System Small Leak Detected) and P0456 (EVAP Emission Control System Very Small Leak Detected). The tech says on the work order that he removed and tested the EVAP Purge Valve with a vacuum pump and the valve would not hold a vacuum. The dealer replaced the EVAP Purge Valve under warranty. They say this is the first 2012 passat V6 they've seen with this issue. I've only had the car for 4 weeks.
View 5 RepliesMy 06 accent GLS has become difficult to start only after refueling, which I'm guessing is related to a bad purge control valve from what I've read. Where exactly is the valve located, and is this something that someone with relatively little automotive repair experience could do on their own? I think I've located it on the backside of the engine near the air intake.
View 2 RepliesFor the past couple weeks my check engine light has come on due to the code reading high purge flow sensor. I checked my gas cap, lines that run from motor to the gas tank and the purge flow that's under the intake. Can't figure out what is exactly going on. And it has 53k miles and runs just fine...
View 6 RepliesI have a 2009 Prius and the check engine light came on last week. I decided to take it to a highly recommended auto repair shop instead of the dealer. The error cord was P1121 and they replaced some kind of coolant control valve. When I went to take the car home I noticed the check engine light was still on and they said there was another similar but different coolant valve that needed to be replaced. They replaced the other part and everything seemed fine.
View 10 RepliesOur 2008 Equinox with roughly 90K miles showed the "service stabilitrack" warning on a Friday, next day light was still there now paired up with "check engine" light. My husband did something to the "stabilitrack" button which made both lights go away for a couple of days. Then both of these returned. Took the vehicle to the dealer (we always do for service, we just don't know some good mechanics in our area and so far we had not had any major issues with the vehicle).
They tell my husband it is the EGR valve that supposedly needs replacement and that the reason it got to be bad is because we failed to maintain / clean the fuel injectors so those need to be washed / cleaned / serviced too so that the whole issue is resolved. No mention about the "stabilitrack" thing at all. Due to our needs of the vehicle and our lack of cars knowledge we agreed to it without looking into it further.. Lights have been off since that and we didn't think much of it.
But then this weekend we got this "recall" letter in the mail for that very same vehicle... talking about the "check engine light" being the issue and an apparent leak of gasoline (via odor or visual leak)... Maybe these are totally unrelated ...
I checked the manual for the recommended maintenance and nowhere there is mention of regular maintenance needed for the fuel injectors.. I looked online and while there seems to be varied opinions most of them agree that is something not needed; neither it is the EGR valve replacement... so now I am really wondering! Was it all for nothing? And how is one supposed to know this. Is the "check engine" light enough of an issue to maybe think this was the right thing to do?
I recently got a check engine light. I went and got it checked, the person said its the canister purge valve that needs to be replaced. Where it is located and the difficulty replacing it. The part is cheap and I want to replace it this weekend. 2007 elantra
View 2 RepliesI purchased a build Dec 05 1.3l Yaris several months ago. I recently started to get a check engine light, so I did a scan of the computer and it returned a P0012 error. Though multiple searches, I learned that this is likely due to the Camshaft Timing Control Valve Assembly or possibly the OCV filter.
Further searches haven't been able to reveal which parts I need to purchase to replace these items. I can only find details for the 1.5l engine.
The engine is: 2nz-fe, model: ncp90r-agmrkq
1. I don't even know where these parts are located on the car?
2. What part numbers do I need to purchase to replace?
I bought the little car to get off my motorcycle and its done great. But, after a couple trips around town my check engine light came on, and I imiditely noticed a change in my idle and engine performance. Im assuming my engine changed the air/fuel ratio to account for the sensor indications. My initial code read came back with four codes which said something about spark, and O2 sensor, and emissions. I went ahead put new spark plugs, gaped them as well as replaced the first O2 sensor.
After that I reconnected my battery and sure enough no engine light and my idle felt even better than before. (by the way my old plugs looked normal) But shortly down the road the light came on again. My idle did become a little different but not like my first encounter with the engine light. My power too seems a bit degraded, as well as the engine's sound. As of right now I am only reading one code P0422, which I do not see in the manual. I read online that its probably my catalytic converter or my engine is running at an improper air/fuel ratio. I am praying that it is not my catalytic converter and just my engine computer throwing things off.
Other things which may serve as clues:
Slight valve cover gasket leak (I will change the gasket when I do my timing belt job along with other seal and probably the water pump)
When pumping gas I can get about 90 cents in at a time, now more like 40 cents since the Saudis lowered our gas prices. Assuming I've got some kind of venting problem.
Car has 107K manual shift.
Have a 2012 gas powered Escape XLT, 2.5L 4 cylinder.
I need to replace the evap purge valve. Looking at youtube videos and from other posts it seems easy to replace. My problem is where is it located on this Escape?
Is it under the hood or underneath the driver's side? This is just the valve mind you, not the canister in the back.
My check engine light just came on while driving home tonight. And there seems to be a weird rattly engine noise on the passenger side.
Just took the car to the mountains (800km round trip) all highway and got back Thursday night. Didn't drive yesterday, and today I took it out for a bit and it felt sort of loose... I don't know how else to explain it. Throttle didn't seem as responsive. I've only just hit the 6000km mark on it, and had the flash done at 4000km.
What in the world is wrong with my car? And now I can't even take it in til Tuesday because of the holiday.
I got a 2012 Hyundai Accent SE manual 112000 mostly highway miles. For a month now I am getting the MIL on and P2191 code (System too lean at higher load bank1) after erasing the code it appeared again in 3-4 days. I replaced air filter check all valves and vacuum in air flow, changed to premium gas. Pipe that connected to the valve from EVAP system looks not damaged and valve works as intended. While changing spark plugs I noticed that all of them were quite charred. I am thinking to replace both O2 up/down stream sensors. Which not OEM sensors would be the best match for my Accent?
View 11 RepliesI love my car 2012 Hyundai Accent GLS but once it hit 60K miles, the engine light came on and it has been eating gas. I get up to 160 miles per tank now. My MP fluctuates from 12-25 MPG. I literally watch it jump when I fill up the car, then a few miles later, it drops again. Code P2196 always comes up. (stuck rich)
Dealer advised me to do fuel system flush.
Dealer replaced upstream o2 Sensor
Dealer replaced Check Valve
New Spark Plugs last Fall due to hearing really loud spark knocking... and also re-gapped last week. Now I can hear them slightly again.
Engine light just came back on after almost 200 miles.
Reading some other threads- apparently this seems to be a known issue for my car.
I am wondering if I should try replacing the downstream o2 sensor.... OR consider trading my car.
My accent currently has just under 17k and about two months ago displayed a cel. I plugged in my innova 3100 code scanner and it displayed p0441. saying it was incorrect purge flow. My question is.. is this covered under the factory warranty. I'm on a very tight budget and I'm trying to find out before going in and finding out. I've owned Hyundai's since 2002 and so far have never paid for an out of pocket repair. But it doesn't hurt to check ahead.. And I've already gotten the standard "it's your gas cap". Ok I'd buy that if it was 10yrs old but it's only a yr and a half old. besides it only goes half a turn then clicks. so it kind of either seals or it doesn't.
View 3 RepliesSo the day before my 20,000 mile service was scheduled my check engine light came on. I took the car into the dealer and told them the light was on. When I got the call that the car was done they said that the EGR valve was bad and they ordered me another one. They said that they cleared the code and that the part would be in this week. Since they cleared the light it has not come back on. My question is did I lose my Revo stage one tune in my TDI? The dealer never said anything so I didn't want to ask if they had reset my ECU.
View 2 RepliesI brought my 2004 Passat 1.8 in for check engine light-- After checking several things and test driving the car they said the finally found the problem-- the "combinations valve" I searched the forum and below was all I found this under that word combo-- is that the only "combination valve"? This is not something I've heard about before-- are they just saying perhaps 2 different valves?
" Turbocharging System, Overview"
For brake booster
10 - Air filter with Mass Air Flow (MAF) sensor - G70 -
11 - Pressure control valve for crankshaft housing ventilation
12 - Combination valve
Replaced this gasket that seems to be leaking oil. Looks simple enough, is there anything i should do or know before taking on this job? It's a 2002 Accent GS 1.5L ....
View 8 RepliesMy wifes 2008 prius check engine light just came on. Its the control valve sensor. My question is, does that have any serious impact on safety? I've heard mixed on what this valve does (overheating etc).
View 6 Replies2007 Chrysler Town & Country with 74K. The check engine light comes on and the parts store diagnostic says P0404, a clogged EGR valve. On my model, replacing the EGR valve involves taking out the alternator, which involves removing the passenger wheel. That's beyond my skill set.
So, can I just replace the EGR tube and pour some Sea Foam motor treatment directly into the EGR? Would that hurt anything?
The purge valve keep clicking means it is fail?
View 2 RepliesMy check engine light was throwing the code P1121 for the coolant flow valve. Toyota replaced it under a warranty enhancement (I have 134k on it), and since then my mpgs have gone from 46 to 50.
My AC is working much better now, too. My theory is that the valve can be in a semi-failure mode for a long time before throwing a code. Now that My coolant is flowing the way that it should, heat is being dissipated more efficiently.