Accent MC (2006-11) :: Transmission Stopped Shifting Gears
Feb 22, 2016
My friend has a 2007 accent with a manual transmission they said that they were driving and the transmission stopped shifting gears. The clutch pedal still has pressure so I don't think it is a master or slave cylinder issue. They freaked out and turned off the car and now the car will not start up again. Have any of you experienced anything like this before or know on this car where to start looking? I think the issue with not being able to switch gears could be a pressure plate issue but this would not cause the car not to start.
View 6 Replies
Advertisement
My 2000 Hyundai Accent, and it has started shifting gears when not traveling at the right speeds to do so.
I'll try to describe it the best I can, When driving I will be going whatever speed limit and all of the sudden it will make a winding noise (like when jumping on highway and pressing hard on gas peddle) and the RPMs will stall. It is like when shifting up, the car drives as normal but then it will shift down and pulls back (making a winding sound)
I am not sure what to do, I was told it seems like it may be the transmission is shot(I had the fluid flushed previously) and that it could cost over $1000 to get it replaced.
View 7 Replies
2006 GX470, ~65k mi. When shifting from P to R, P to D, or R to D, the transmission often (but not always) seems to have to think about it a while. When it shifts fine it takes about 1sec for the transmission to change gears. When it's being cranky it takes ~4secs. There are no other symptoms.
View 7 Replies
I have a 2006 Chevy 2500HD with about 180000 miles. All of a sudden the transmission is shifting extremely hard at times. It doesn't shift this way all the time. What could be causing this problem? It doesn't have to be under hard acceleration either when it does shift hard. It sometimes is during hard accelerating and sometimes it is under very little acceleration, but as I said it doesn't do it every time. When it does shift hard, it seems to do it in all gears.
View 1 Replies
When we got our 2006 Camry, shifting the transmission to park (P) would automatically unlock the doors, and shifting it to drive (D) would automatically lock the doors.
Up until about a year ago, shifting to park stopped unlocking the doors. Drive still locks the doors.
I always thought it was a problem with the electronics, but I recently heard from a friend that he heard it's actually something you can set with your keyless entry remote (?!).
How I can set it back so that park unlocks the doors again? I couldn't find anything in the user's manual.
View 2 Replies
My friend told me the other day her car was in overdrive (hwy driving) and suddenly, it shifted to a lower gear. It seems no one knows why. She does have an extended warranty, but the garage might charge her $300 to open it up to see what is wrong. Another friend suggested a clogged filter. Another one, a sensor.
View 7 Replies
I have a 2008 Accent (base model for the most part, no C/C), and my transmission seems to be slipping a bit. The symptoms are: slow acceleration, a delay in gear shifting, and after the 30MPH mark, it takes forever to get up to anything near 60. I just wanted to know if it's a simple solution such as topping off the transmission fluid, or if it's a bigger issue.
View 5 Replies
I have 2005 Toyota Camry LE (V4 2.4L), for some reason it stopped shifting gears, weird part that it does drive on 1st or 2nd gear but then it won't shift to the next gears, instead, it acts as if I am on neutral, doesn't matter how much gas I push or how high RMP goes the car just rolls as if I switched to neutral.
Once the RPM goes high, I stop the car, turn of the car, turn it back again and then it wouldn't even shift into first gear, it acts as if I am in neutral. Additionally, the reverse in the car works as it should, no problem there. The check engine light is not on!
What have I already done: Changed oil in transmission (just in case the oil was dirty - it was dark), unplugged battery for an hour (see if computer needed resetting after transmission oil change).
I googled the symptoms and it seems like there could be solenoid problem and that there is like four of them in V4, which type of solenoid could have failed, will cleaning it useful or is the electrical problem in the solenoid, or is there some kind of other problem.
View 6 Replies
That said my wife bought a 2001 Accent 1.6L Auto while I was overseas and it's been a great car, about 8 days ago it just crapped out. The reverse went out on her so we took it to get the codes read and on the way it went in limp mode, started hard shifting between gears and wouldn't go over 45 she says. Took it in to the stealership today and they said that the trans is shot as well as showing codes for P1527, P0732, and P0734. I know what the two slippage codes are and I can prolly just replace the speed sensors and that will be fixed but I'm not sure about the reverse and P1527.
View 4 Replies
I have a 2007 Manual drive Hyundai Elantra with 98,000 miles on it. Prior to going to Valvoline (who I know are not the best oil change places) if I was parked with foot on clutch and brake there was a tinny noise coming from the engine. I was going to have it checked out.
Fast forward I had my oil changed at Valvoline on Saturday (2 days ago) since then when parked with foot on clutch and brake the car begins to make a stuttering/shuttering noise and is shaking a bit (in time). In addition when I shift gears and go faster there is a wheezing noise.
I assume I need to bring this back to Valvoline? Is there anything that they could have done during the oil change that would cause this issue?I didn't get the air filter but it wasn't that horrible. They of course said I should get the radiator flush and the transmission flush.
View 6 Replies
I have a 2002 Saturn SL2 (automatic). A few days ago it abruptly started thumping pretty heavily when shifting gears, especially going into reverse and 4th (or possibly 5th) gear. A couple mechanics told me the transmission is going, and that it would need to be replaced (but it would cost more than the car is worth. One said that we could try replacing the computer that controls the transmission, but it would cost ~$300, and might not do any good. Another said to try Lucas Transmission Fix. I've seen mixed reviews of it online, so I'm wary. Is it a good product, or does it just briefly mask the problem? Also, I looked under the hood, and cannot tell where I would even put it.
View 12 Replies
I have a BMW 523i SE AUTO (1997) 2494 Petrol. In auto transmission the gears will shift from 1st to 2nd and 2nd to 3rd but won't shift any higher. In steptronic/manual transmission the gears will shift from 1st to 5th without any problems therefore suggesting that the problem isn't the gearbox itself. Only very occasionally does the shift electronics telltale light appear on the dash, yet the problem with the auto transmission is continuous. A local garage specializing in automatics suggested that it was the gearbox inhibitor. I've today had this changed but the problem still exists.
View 5 Replies
Every so often while driving in the city my car starts shifting rough between 1st-2en and 2en-3rd gears. If I stop; turn off the engine and then restart it stops. The car has 107,000 mi. and the fluid has always been changed as recomended. Do I have a shift selonoid going out somewhere?
View 2 Replies
Lately I have noticed that the transmission is not shifting smoothly in the lower gears. I have 114K on there. Spoke to my service manager and he mentioned that it may need calibration. Doesn't sound right after all the miles?
View 5 Replies
I have a 2012 Sierra 1500 SLE with a 5.3 liter engine, 6 speed transmission and about 7700 miles. I have noticed that at times the truck does not seem to be performing efficiently and will not seem as smooth and transmission shifting is sometimes not so smooth in the lower gears. I have noticed that when I let the truck warm up for about a minute before putting it in gear, that all seems to go much more smoothly, but if I crank up cold and take off right away, then it tends to run not as smooth. I have even heard a slight "slap" type noise that I think is the transmission shifting when slowing down to make a turn at about 15-20 MPH. When I go to accelerate after the turn, it will sometimes slap as if it is hunting for the right gear. Obviously, I now let it warm up for a minute before I drive it. I have not talked to the dealer, but I probably will when I take it in for its 10K checkup.
View 1 Replies
A few weeks ago, my transmission (automatic) started rumbling while shifting from 3rd to 4th and 4th to 5th gear. Shakes the whole car, like you're driving over a rumble strip. Only when the engine is hot. I read online that I should get my transmission flushed and replace the fluid, but should I be expecting the thing to go or is this a normal hiccup for the Santa Fe?
View 5 Replies
I have a 1991 bronco with a 351w and the e4od trans.. The transmission is shifting late and hard and sometimes when i let off of the gas to slow down it shifts between gears up and down by itself... The only lights on the dash that are on is the Rear Anti-lock brake light and the speedometer is not working either.. Where to start the trouble shooting to fix it?
View 3 Replies
I am coming from a 2001 Acura CL-S which is a 5 speed automatic, and that car wouldnt' change gears that quickly. I understand cars today change gears frequently to be in the best gear for fuel efficiency?
But I feel like my ES350 changes gears so much, even at the slightest speed change. Is this normal -perhaps it's because I haven't driven a new car since my 2001, 12 years ago! Even the slightest press on the pedal will downshift the car and into the lower gear, even on ECO setting. On my Acura, pressing lightly on the accel pedal didn't result in a lower gear, as I know the engine had more than enough torque.
I also love reliability, and this makes me think the transmission would have a shorter life span with all the shifting. I still haven't asked my dealer about how often to do tranny fluid changes (which I know is a different thread altogether about discussions about "lifetime" fluid).
View 11 Replies
When my 2012 Camry's automatic transmission shifts gears in the 20-30 mph range, there is a hesitation during the shifting. I had an independent automatic transmission technician test drive my Camry, and he said my transmission had "light throttle 2-3 slide." He also noted a high frequency clicking sound in the vicinity of the transmission while the engine was running, which he said may be a malfunctioning solenoid.
View 5 Replies
I bought the car about a week ago, whenever the auto tranny shifts gears there is a slight jerk that old honda autos are known for, my wife's car is a 01 celica gt which I bought 2 months ago and went through castrol import ATF 3x drain n refill method suggested by honda for their auto trany, I attempted the same thing in the gts and the shift jerk went down a little but not by much, the gt auto tranny is so smooth I can't even tell whenever it shifts up or down other then high rpm engine noise when it gets there. Is it the engine being much more powerful then the gt to cause that jerk? Should I try a different fluid? Need to know if theirs is smooth across all gears in any rpm range.
View 4 Replies
I just bought the car a week ago 90% of the time it shifts great sometimes shifting very rough and going through the gears way too fast....sometimes its jerky on the interstate as if odd kicking in and out today i jump in cold takes off great get 1.5 miles out and starts slipping the further the more it slips if you let it cool it does just fine again until 1 mile or so and repeats...
Took to auto zone and read fault codes...p0440 evap (expected that one due to its age and mileage 186000)...p0742... stuck on(paper says) tcc commanded off by the ecm-tcc slip detected after off command...p1860..pwm solenoid electrical fault(paper says).. The ecm has detected an improper voltage level on the tcc pwm solenoid circuit...
Fluid level correct and not burnt up although slightly dirty... I have added sea foam to the fluid and what the heck does pwm stand for?
View 3 Replies
