Accent MC (2006-11) :: Transmission Hesitates For 4 Or 5 Seconds Before It Engages Forward Gear
Mar 29, 2011
When cold starting the transmission shifts into reverse perfectly, then after backing up the car and shifting into drive it hesitates for 4 or 5 seconds before it engages the forward gear.
2008 Accent 4 door automatic 77,000 KM
View 4 Replies
Advertisement
I have a 1986 Volvo 240. It has a button to push on the stick shift to put it in 5th gear. It drives and works fine except when I downshift from 5th gear. ..then it seems confused and has a hard time getting back into gear, it kind of hesitates and lurches forward. It will not go into reverse after it has been in 5th gear until I turn off the ignition, and start it again.
View 2 Replies
My transmission has started acting weird. When it's cold it seems to be not as bad. First thing is when I put it in reverse it hesitates for a few seconds then goes into gear. Second it will drive great then just out of no where start shifting very hard then go back to shifting smooth again. Third when pulling a load it won't always start in 1st gear when you come to a complete stop sometimes it tries to start off in 4th.
View 8 Replies
Late build 03 f350 auto, I got a p0500 code and noticed sometimes after 2rd-3rd gear engages theres a shudder or fast vibration for few secs unless i let off, it didn't start this till i took batteries out, where is the location of the vss at, I am seeing some say at each wheel, on top rear diff, on top back of trans so not real sure?
View 7 Replies
Just bought a 2009 Accent 5 speed I have 2500 miles on it .The clutch engages when the pedal is right at the top. Is there an adjustment on this vehicle I would prefer it to engage about mid stroke.
View 9 Replies
So I have a 2006 Hyundai accent with 75000KM on it. I notice when it shifts from 1st to 2nd gear sometimes it will jerk. It feels almost as if it goes to neutral and then sifts, causing the whole car to jerk. It use to only do it when the car was cold (first 15 min of the day) but now it seems to be doing it all the time and getting worse. I have had the transmission fluid replaced, but it doesn't seem to work.
View 30 Replies
My friend told me the other day her car was in overdrive (hwy driving) and suddenly, it shifted to a lower gear. It seems no one knows why. She does have an extended warranty, but the garage might charge her $300 to open it up to see what is wrong. Another friend suggested a clogged filter. Another one, a sensor.
View 7 Replies
2007 accent GS 5 speed manual. car has 142,000 miles. Trans popping out of 5th gear under load. interstate driving 65 MPH going up hill. Pops out but goes back into 5th. Car does not pop out of the other forward gears at this time. Car has very good clutch, no slipping. Short shifter, alu. trans/shifter bushing. shifter cables are adjusted correctly. Are my sliders and dog gears for 5th worn out??? Or is my fork bent?? Or both. Do I need to pull trans?
View 2 Replies
I have a 2010 accent blue model with stick shift. been fine for 50k miles. Lately i have noticed an issue where i am in first gear and then when i push clutch in to go into second, the lever won't budge. it does eventually go in but it just isn't like it used to be. it happens say about 25% of the time. Since at higher rpms it won't do it but normal rpms it will.
Also, i just had a new short block installed, perhaps something is binding? If I sit in the car, stopped, i can shift into and out of all the gears perfectly. Maybe my 1st gear synchros are going?
View 2 Replies
I have a 2008 Accent (base model for the most part, no C/C), and my transmission seems to be slipping a bit. The symptoms are: slow acceleration, a delay in gear shifting, and after the 30MPH mark, it takes forever to get up to anything near 60. I just wanted to know if it's a simple solution such as topping off the transmission fluid, or if it's a bigger issue.
View 5 Replies
I have a 2007 Volkswagen Jetta MKIV with an automatic 4 speed transmission (m01), and the car has only 100,000 kms on it, was always maintained either by myself or at the dealer, and never abused...ever!. Recently, I noticed that the transmission, going from 2nd to 3rd gear (and only 2nd to 3rd gear) will only sometimes hesitate...meaning the engine either revs a little bit (about 100rpm...yes one hundred) right before it changes gear, or if I'm going up-hill and it happens, it struggles to find the gear from 2nd to 3rd. However, this does not happen all the time, in fact, if someone who may not be as informed about cars, drove the car, the may never notice it. I checked with VCDS and no fault codes for transmission, only 2 fault codes from the engine misfiring because I sprayed the engine bay with water a while ago, and water accumulated in the dizzy.
View 24 Replies
My wife has been using her mom's 07 Accent, the mom is 90 and hasn't been incapable of using it for a while now. I did an oil change (without paying much attention) I've never seen this type of car before. Oddly the oil level seemed outrageously over full and still dirty
Then upon driving it the automatic transmission was all wacky, not engaging at idle, then it abruptly chunking into gear...
So I check the transmission fluid level and it's not on the stick. Research here let me know SP-III is what I'd need. Then while surfing a youtube vid regarding this model's transmission it hit me in the face, I'd drained the automatic transmission fluid! Went to the Kia dealer got 3 quarts dumped it in there, drained the overfilled 5.5 quarts of old and new oil rectifying my mistake, which brings me to the reason for this post.
This 2007 car only has 24,300 miles on it and I mistook the automatic transmission fluid for outrageously dirty engine oil! I swear this stuff looks like it's fulla carbon black n burnt up. My question: is it normal for the trans-fluid to have such a degraded appearance in only 25,000 miles?
View 2 Replies
The transmission shifts into gear and when the clutch is released it starts to crawl forward. When the throttle pedal is pushed it still revs up the engine normally. But when the transmission is in gear and the throttle is pushed it revs up like it is in neutral. At first I thought this might be a transmission problem but then I figured it might be a linkage somewhere. After looking under the hood and under the car I still couldn't see anything that would cause this problem. I had this car less than a week when this happened and I had to be towed home.
View 4 Replies
I have a 2007 Chevy Equinox with 104,500 mi. For the past 20,000 miles (2-1/2 yrs.) or so the transmission hesitates when shifting from 2nd to 3rd gear. When this happens, the engine revs and the wheels lose power for a second or two, and then the shift completes.It happens anywhere from once or twice a week, to once a month.It never produces a "Check Engine Light" nor a "Code" when scoped the same day.It is more of a nuisance, although doing it while pulling into traffic could cause a nasty safety issue.I have had it checked by independent mechanics and a local Chevy Dealership and nobody has an answer.
View 5 Replies
I have had my manual 2014 four months now and still can't get used to the fact, that to engage reverse you have to move the stickshift FORWARD into the same spot as first gear. I have had a half dozen near wrecks because of this.
View 5 Replies
I've got a 2003 Accent and my automatic transmission went out, no reverse and the only forward gear is 1st. Was thinking of pulling it and swapping it for a used, but I have been reading on here the many, many automatic transmission problems of the accent and my next thought was to just rebuild it myself. But now I'm thinking more along the of a swap from auto to manual, as I don't want to have to rebuild a transmission that is only going to have to be rebuilt again anyway. As far as stuff like the clutch pedal, linkages, gear shifter, I can get those pretty easily. Does the Accent have a hydraulic clutch?
View 2 Replies
2009 Accent with 103K miles, which has been good to me so far. Over the past week or so, I've noticed that when I'm driving on the highway with the A/C on, the car occasionally hesitates, maybe every minute or two. I'm guessing this is from the A/C compressor cycling on and off, but it's never done this before. Does it seem like this is the beginning of the end for the compressor? Anything else it could be?
View 1 Replies
I have a 2002 Accent with 119,000 miles on it. Its an automatic transmission. When I am driving the car feels like it surging forward while I have the brake on...its doesn't happen all the time. But when it does it surges for half a minute, then run fine and then surges again.
View 3 Replies
I have an 05 F 250 super duty with the Triton in it. When I shift either into overdrive or reverse the transmission hesitates (does not go into either gear for about 5 to 10 seconds). After that it engages and it's fine. It does not appear to be slipping or acting up regardless of temperature or speed. Sometimes it will sort of engage and than bang into gear solid. I do not have any check engine lights. Not sure if the PCM has any codes. So I'm trying to figure out if I need to have a complete rebuild or if I have a valve / solenoid body problem Where do I start?
View 4 Replies
Early 2000 F250
Originally the truck would not go into any forward gear, but had reverse all day long. So I had a rebuild kit ordered (new bushings, seals, frictions, steels, a washer and flat bearing kit, a sprak kit, and the od piston)
After rebuilding it, taking my sweet time double checking everything, it will now go into forward gear but not reverse. So I dropped the pan. The small 3 bolt plate was torqued to spec. When I got to the third bolt in the smaller section of the valve body (upper valve body) I heard a click like maybe a valve returned to its place but I'm not sure. I removed the valve body and accumulator and all the valves were free and had tension. When I had it apart the first time one valve stuck for a split second but I never could get it to stick again.
Finding nothing there I uninstalled the tranny and took the barrel apart all the way down to the L/R piston and could not find anything wrong.
After the build and me running the truck for about 10-20 min there was metal on the magnet (part of the reason I took it all back apart) however I could not find anything worn or chewed up. Could have been the tc I prefilled with 2 quarts in stead of filling all the way.
When I initially rebuilt the 4r100 I took apart the pump to replace the bushing and seal but did not take apart the valves. I've heard the pump is directly related to reverse but I'm not sure. Could something gone wrong in the pump when I took it apart? How would I know? If I new all parts of the reverse system I could then test them.
View 14 Replies
My daughters 2006 Infinity G 35 transmission hesitates to downshift when lugging at 35mph. Is this a trait of this vehicle or a problem with the tranny or anything else?
View 2 Replies