Accent MC (2006-11) :: Pulsating Brake Pedal When Stopped Only
Nov 3, 2015
I'm getting this checked today most likely as it's been happening for months now. No issues with vibration and stopping is fine. As a matter of fact brakes are excellent. However when I'm stopped at a light or whatnot and I depress the brake pedal there's a pulsation that occurs almost every time. It's fairly constant and only happens when I'm at a stop not when I'm stopping so I know it's not a warped rotor. What it might be?
View 4 Replies
Advertisement
I started noticing that the brakes would pulsate, or grab momentarily when almost stopped. I figured that the rotors might be warped, and as I was planning on putting on new green stuff pads and rotors I was waiting for a convenient time to change them.
Now I have noticed some type of fluid, I'm guessing grease, on the side of one spoke of one of the wheels. I recently replaced the steel wheels with SE 16" wheels. I didn't see any leaks then but I guess I wasn't looking like I should have been.
I'm trying to decide what I should be looking for. CV boot leak? Front wheel bearing seal? Brake fluid?
View 6 Replies
2003 Hyundai Accent. I will try to give a good description of the issue. Wheel was shaking (or was noticeable) at about 60 mph. Lessened after that but still bad. I had my tires changed and balanced as well as an alignment. My rear right toe is still off a bit. Now, the shaking is noticeable at 68-70 mph and higher. Pedal shakes, wheel shakes. I can feel some vibration all over including the seat, gas pedal and wheel the most. Wheel not jerking, just vibrating mildly.
It is not quite as bad as before and does not happen until 68-70, 10 mph higher than before the tire change/balance. I have put my back wheels on the front and it is the exact same condition - this would remove tire and balance as the culprit (?). I also hear an audible hum.. kind of a pulsing sound at 50 mph+. This speeds up and slows down with my speed. For instance if I am going 70.. I hear it every half second, 50 mph I hear it less often. It is pretty faint, not a thump. It seems to be coming from the front but I can't pin-point it. I feel no tire play up/down/side/side.
What is the next step here? I'm going to get the rear toe fixed but this shouldn't be the cause of the pulse/wheel + pedal vibration. Vibration/sound doesn't happen when I am braking. No rubbing shield behind rotor.
View 19 Replies
Having ABS issue with my 2004 Ford Escape XLT.
A bit of background information: every now and then (usually when decelerating from around 35-40mph), I will get a pulsating/knocking feeling from my brake pedal. At first, I thought it was the ABS, as I was told about a year ago that the ABS tone ring was broken. The more the problem manifested itself, the more I got to study it a bit. The pulsating/knocking in the pedal is usually accompanied by a very dry rubbing sound, and both the sound and the pulsating seem to be in direct relation to the motion of the wheels. I took it to the local garage this weekend and they recommended changing out the rear brakes - this made sense to me, as they haven't been changed out for as long as I have had the car.
Got the car back about an hour ago - on my way home, the pulsating came back when I was coasting into a stop light. The pulsating seems to have no affect whatsoever on the stopping distance of the car - a few times when it has happened, I have mashed the pedal, and the car comes to a quick stop just as you would want it to. After coming out of a complete stop, the brakes will work completely fine for a while - there seems to be no real rhyme or reason to what makes it happen.
View 10 Replies
Test drove an 08 V10 today. Brakes seemed to work fine and didn't lock up but I felt no pulsating in the pedal and heard no chirping of the tires like most ABS systems do. Is this normal? Anything special to look for in used late model V10s?
View 1 Replies
Ok, I changed my front brake pads and rotors last week and since then everytime I get in the truck and drive for about the first 2 or 3 miles when I push the brake pedal it feels like my ABS sytem is activating. Then it stops and the ABS light comes on but the brake pedal stops pulsating when depressed. Is my ABS going bad or did I possibly do something wrong? I have changed the rotors and pads before without problems....
View 3 Replies
Just noticed this the other day, when depressing my GF's 2011 Accent's brake pedal it made a low hissing sound, it would go away when you took your foot off the pedal, you would never hear this with the radio on, but it was enough to make me think it could be a concern.
Drove the car and it didn't affect the brake permormance, but the longer this goes, I can't imagine this being a good thing.
Car is 3 years old, and has 80-20 city/hwy driving under it.
View 7 Replies
Started a few months ago didn't really bother me until now. Started when I would forget the parking brake is on and would just put the car in reverse & wouldn't move until I released the parking brake. Did it about 5-7 times and now every time I brake without the parking brake on, it squeaks & is really annoying. Is there any way to fix this or is it just gonna be complicated & expensive?
View 10 Replies
Suddenly my brake lights quit. Press the brake and nothing. Turn on the headlights and the rear lights turn on. Press the brake and no change. It's like I am not pressing the brake. What are the first things I should check?
2008 Accent GLS 66,000 miles
View 23 Replies
Noticed when I press brake pedal brake lights does not work even the center one. Checked all fused in the car and the small ones under the hood. All fine. I have a long trip tomorrow. Where else i can look. Everything seems working. Reverse light is fine. Is that related to latest brake light switch recall? Cant think of anything else.
View 4 Replies
80km on my accent, the brake pedal was getting softer and brake fluid was a bit low as normal due to brake pads were worn up over time. Brake pads were never changed. I thought changing the pads would change the softness of the brake pedal. I changed the brake pads, left and right, the brake fluid in the reservoir went up as normal but I drove around but the softness of the brake pedal did not change. I still had a little less than half size on the old pads. I need to press the pedal a bit much to feel the brakes. I am wondering maybe the brake pedal was always like that when I bought the car.
View 4 Replies
Today I was informed by a passing motorist that my brake lights had stopped working. Upon checking, they were right. The lights do not come on at all when the brake is pushed, including the center one. When my headlights are on thought, they do light up, just do not brighten when the brakes are hit.
View 16 Replies
2007 Accent pedal won't depress. Bearing making noise for a few months. Is tranny snout toast or is it fixable?
View 2 Replies
My brake pedal is making a creaking noise when depressed and can also be heard when letting off the pedal. The noise is not coming from the brakes themselves (front/back are like new) but the pedal area or somewhere behind it. This noise doesn't start until I've driven the car for a little while. The brakes work fine for the most part but sometimes feel a bit spongy if making a sudden or hard stop. The fluid levels are fine.
I'm taking it in on Friday and hoping that the brakes just need to be bled a little or maybe the pedal just needs lube, but I'm worried it might be the booster or master cylinder---if it is one of these?
View 4 Replies
My taillights, reverse lights and brake lights all stopped working! What the problem is. The fuses are fine and the bulbs are good too. How to fix this or what I should look for to try to fix it?
View 1 Replies
I have a 99 Blazer 4x4 with ABS. Brake pedal just went to the floor and car stopped eventually ... a bit scary. I've checked all the brake lines and the inside of all wheels and there is no sign of fluid anywhere. All pistons seem to be where they need to be with backing plates nicely visible.
I pumped the brakes quite a few times and same result ... but I'm not pumping fluid on the ground. As expected I've also checked the reservoir and its full. Didn't see any leaks so its full. I'm guessing that the master cylinder has given up the ghost ... truck has 470,000km so things wear out.
View 5 Replies
Purchased a used 2010 Gen III a few months ago and have noticed a fast buzz, felt through the floor and brake pedal. It is intermittent but the conditions needed are:
1) Air conditioning running at high speed
2) Vehicle in Drive
3) Immediately approaching a stop, and a few seconds after stopping.
View 3 Replies
Is it normal on the 2.0T that when you are driving and stop at a red light to get vibration that you can feel in the car and hear in the motor? As soon as you let off the break it stops and the engine stops the noise. I don't drive the car enough really (my wifes) to know if it is normal or if this just started. It is an 07 and just turned 12k on the weekend trip. Also, having a problem on Sat radio with there being a high pitch hum in the back ground? [IMG] [URL] ...
View 13 Replies
When braking i would feel the pedal pulsating...figured the pads were finished. Checked them out and they were not in that great a shape so I changed them all around. I'm still getting a pulsating feeling in the brake pedal.... I just need to bleed them or are the discs warn or warped or something?
View 8 Replies
I have a Camry at 120K now. Front brake pads was placed at 85K and was told by the maintenance person at that time that brake rotors couldn't be resurfaced since they were close to the minimum thickness.
Braking seems still fine these days. I don't hear any high-pitched noise or feel obvious vibration/pulsation when the brake is applied. The brake pads are still within a good range of thickness as the last check was made a couple of months ago.
But the brake pedal is softer than before so that now I have push harder to get car stopped. It that a warning sign which indicates it is time to replace the brakes rotors and pads?
View 1 Replies
My 2015 Prius with 1,300 miles on it makes a rumble/grumble/moaning/groaning sound after I have come to a complete stop. It can be felt in/on the brake pedal. (Stop light, etc) It lasts for a few seconds then stops.This low rumble has me concerned. It has a slight vibration to it too. (again this is NOT while driving. Only once stopped and foot resting on the brake pedal) I can't confirm it has anything to do with the braking system but seems to come from the general area of the brake pedal and when foot is on the brake. So I assume it's the brake system.
I know about the typical brake servo actuator noise (which is completely normal and I am very familiar with) but thats a light unintrusive noise. Distinct from this low grown noise. (I know the difference) I hope I am correct in assuming the computer would detect if there's anything wrong and throw a light... but I'm new to Priuses. Is this a normal sound/vibration? I know these cars do a lot of electric things so if it's normal, I'll try to ignore it.
View 15 Replies
