My Hyundai Accent 2006 with 98000km has a noise when the brake is released. Braking is ok and seems to work well. This noise comes from the back when the brake is released.
View 4 RepliesUsing mobile phone, Wife has an '06 Tucson. Noise like brakes squealing, but it occurs when you're NOT pressing the pedal.
The noise gets louder as the car goes faster, but the pitch of the squeal doesn't go up.
My ford F-150 makes a clunking noise when I release the brake at a stop light or stop sign. It sounds like it is in the transmission. It only happens when I come to a complete stop and start moving again.
View 4 RepliesI traded my 2007 Prius for the 2010 III Prius on 5/30. I had 5 wonderful days with it and on the 6th day, it started.
There is a loud creaking noise when the brake pedal is pushed and released.
The dealership contacted Toyota and did everything that was suggested to correct the problem and no luck.
A mechanic recently replaced the pads of the front brakes. After the service, the break makes squeaking noise when I release the break pedal. According to the mechanic, it is normal, and I better ignore the noise. Is it true?
View 1 RepliesVehicle is a 94 Suburban. The front brakes were done approximately 14K miles ago. Rear about 10K miles ago. Ever since the front brake job (new rotors, pads) there has been a sound, sort of like spring tension being released whenever I (quickly) release the brake pedal. I think I notice it now more than ever because I don't have working ac and the windows are usually down. The thing is, if I slowly release the pedal I hear nothing. When it does happen it is definitely coming from the front and is more predominant (I think) on the right side. So far I have yet to hear this sound coming from any other vehicle stopped beside me in traffic so something must be out of whack.
I mentioned this to the mechanic who did the brakes (only shortly thereafter) and he checked it out and said nothing was amiss. Recently I had new tires installed so I asked the (different) mechanic to check the brakes again (front and rear). Apart from cleaning out the drums and a minor adjustment on the rear they said everything was good. Now I've never had any issues with stopping and I've had a few hard braking episodes without incident but this snapping noise for want of a better description is driving me nuts. One final observation: I cannot get the 'sound' to occur when I am sitting in Park and depress and then quickly release the brake pedal.
My father purchased the 2015 GX460 this past January and the car currently has 4,500 miles. The first complementary oil change was completed in July. I feel that the brake of his GX460 is not sensitive enough, and I have to step on the brake very hard to feel the truck stopping. Does every GX460 owner feel the same way? I told my father about this, and he said I'm just not used to it. I'm thinking about taking his truck back to Lexus to check it out.
The dashboard so far doesn't indicate any ABS problem. By the way, I'm an owner of a 2014 IS350 F-Sports, and my 350's brakes are much better in my opinion. I'm not sure whether my experience of my 350, which has larger brake calipers for its size, has influenced me to draw such conclusion about the GX460 brakes.
Also, I notice that when I step on/release the GX460 pedals, I hear some noise that sounds like air. Did some research about this on the forum, and some of you have that too. I still don't understand this issue.
Just noticed this the other day, when depressing my GF's 2011 Accent's brake pedal it made a low hissing sound, it would go away when you took your foot off the pedal, you would never hear this with the radio on, but it was enough to make me think it could be a concern.
Drove the car and it didn't affect the brake permormance, but the longer this goes, I can't imagine this being a good thing.
Car is 3 years old, and has 80-20 city/hwy driving under it.
I've got a strange noise coming from the front brakes. It's not the wear indicator, and it's not a worn out rotor.
When I apply the brakes firmly, they work great. No noise, good stopping power, the pedal is nice and firm. As soon as I let off the pedal, there's a little chirping noise, like a tiny bird in my wheels... I've looked at the pads and rotors, and there's no obvious sign of damage or wear.
My guess is it's the caliper pins or piston making the noise. I'm happy to take it apart and lube it, but what kind of lube is specified for this? Moly grease? Lithium grease? Some kind of oil? And do I apply it only to the caliper pins, or to the piston as well?
I looked on HMA service, but I can't seem to find anything to address this specific problem.
My right rear brake is making a grinding noise when the brakes are applied. I took the drum off a couple weeks ago and the shoes are just a bit worn. Just getting into the numbers printed on the side of the shoe material.
I could not see any thing that would be making the metal on metal sound. Are there any wear indicators on the OEM shoes?
Accent 2006. When I start the car and start to drive, the car rock on the driver's side. I think it's the driver's rear. Then the feeling of a flat tire is felt but the tire seems to be ok. Occasionally hear a loud noise like from the exhaust and when I stop at a stop sign or stop lights and release the brake the car does not move till the accelerator is pressed and it rocks again and moves. It has 99000 km on it.
View 1 RepliesMy brake pedal is making a creaking noise when depressed and can also be heard when letting off the pedal. The noise is not coming from the brakes themselves (front/back are like new) but the pedal area or somewhere behind it. This noise doesn't start until I've driven the car for a little while. The brakes work fine for the most part but sometimes feel a bit spongy if making a sudden or hard stop. The fluid levels are fine.
I'm taking it in on Friday and hoping that the brakes just need to be bled a little or maybe the pedal just needs lube, but I'm worried it might be the booster or master cylinder---if it is one of these?
I have an 00 Accent 1.5 liter 5 speed with about 192000 miles on it. I have put about a tank of gas through it since I've owned it, so I can't give a lot of background on it. When I got it the previous owner told me it was popping out of fifth gear and the clutch fluid leaked.
Upon driving it around a while I noticed it would pop out of fifth and third gears almost at random, but seemed to happen more when I applied throttle. I assumed it was an issue with the shifter not fully engaging the gears, and checked out the bushings under the hood and in the console. All looked good, and I didn't see any extra play.
I drove the car for about 30 miles straight and had to downshift and wasn't able to get the car to go into any gear but fifth. I was moving about 20 mph when this occurred. I was able to limp along to a parking lot where I let the car sit for about ten min and I shifted through the gears when stopped. I headed back home with this problem throughout the trip. There is a sound that happens on occasion (that stops when I press the clutch pedal) that sounds like a bad bearing in the clutch area.
When I'm stopped with the car in neutral and I release the clutch the car stalls like it's in gear. I was able to get the car to move some, but it really doesn't want to it acts like there is something jammed in the gears and popped really loud when I backed it up.
There is fluid for the master cylinder, and I can see the slave cylinder moving when the pedal is pressed. I jacked it up and removed the plug to check for gear oil, and it came pouring out, so I think it has fluid in the gearbox. I'm pretty sure it needs a clutch at the least. I think there may be some internal damage in the tranny, and I'm only into the car for the time it took to power wash a house and don't want to get involved in a big mess.
Had my car parked outside of work for about 12 hours yesterday, and in the NYC cold front, the parking break must have stuck on slightly. When I started to move, despite the fact I'd released the parking break, I received a warning in the MFI that said PARKING BREAK FAILURE TO RELEASE. I pulled the handle again and heard it pop just a little more off. Everything worked great after that. If I hadn't received the alert I probably would have driven off with it on. I'd probably have noticed the hesitation and checked the break again, but the alert was useful. Some of the warnings in the MFI can appear to be a pain at times, but it's amazing how thorough a job VW has done monitoring the cars systems and giving real time information if something doesn't work. You just have to make sure you don't get info overload from it all!!
View 4 RepliesMy brake pedal squeaks when I release it, for the last two weeks. Does this mean I need maintenance, repair, or some oil?
View 6 RepliesMy rear brakes developed a squeal when the brake pedal was released. My dealer replaced the rear brakes & disks at about 57000 miles. I had taken a salesman from the dealer to get an appraisal & he told me that it sounded like a simple adjustment would fix it. 2005 Elantra
View 1 RepliesMy aunt recently purchased a new 2016 sonata trim is se, I believe its the base model version, I test drove her car after she bought it home from the dealer and noticed right away that when I release the brake pedal from a dead stop, foot off the brake but not on the gas pedal yet, the engine hesitates / shakes. This happens most of the time but not all of the time. I noticed this when the car had only 100 miles on it...is this a Hyundai feature?
View 49 RepliesMy brother-in-law has an '04 with ~160K miles that we're potentially interested in picking up from him. It's been sitting for awhile with the parking brake on. When going to try it out today I released the parking brake (it seemed to release okay) but both rear wheels were stuck. I drove it a few feet and the left rear freed up but the right rear would not budge (multiple attempts.) It was dragging on their driveway and I could barely get the car back out of the way.
Looking for (videos, manual, etc.) how the parking brake works? Is there an external adjustment I can reach or some place to try to release the cable? We had an '06 that our daughter now drives but I've never had any issues with rear brakes in 200+K miles on that car.
I'm having trouble with the headlights on my 2003 Chevy Tracker. When it's light out, my headlights come on automatically when I release the parking brake, but turn off if I turn the switch that would normally turn them on. When it is dark out, or I drive under a bridge etc, they turn off and I can't manually turn them on. I can "flash" my headlights, but if I turn them on as if to leave them on, they don't turn on. This problem started about the same time that my AC blower stopped working, so I replaced the blower motor resistor and all fuses (I've heard that the blower motor resistor is also involved with the headlights). This fixed the AC, but had no effect on the headlights.
I can trick the lights into turning on at night only by shining a bright light directly on the sensor - they turn back off as soon as I remove the light. I took it to Pep Boys for a basic electrical diagnostic to see if I might be missing something silly, but once I described the problem they wouldn't even bother - told me to take it to the dealer and have the body regulator module reprogrammed.
When I release the brake pedal too fast, the brake pedal bounces back with sound which is a little bit loud to me. I feel the sound is from the spring if there's one. It's annoying so I have to remove my foot from the brake very slowly. Is it normal?
View 20 RepliesJust got the 2010 passat two days ago. As you know, when you press the accelerator, the E brake releases. When i do this, the back of the car rises up just a bit as the brake hasnt fully released, but can this wear out the brake quicker, since im effectivly driving with the e brake half on for that half second. Im pretty sure it wont as I think it uses the rear disk brake for the E brake, but curious what others think.
View 13 Replies