Accent MC (2006-11) :: Hydraulic Assist Moving The Fork But Gears Just Won't Engage
Dec 21, 2013
2008 Accent - driving down highway, heard a pop and car acted like it was in neutral. I have clutch pressure, you can see the hydraulic assist moving the fork, but gears just wont engage. I can free shift through all the gears with the clutch pushed in or not. Manual transmission and clutch kit replaced about 6 months ago when shifting fork broke inside last transmission and tore it all apart. With car in first (and turned off), I can push the car so I know gears are not engaging.
View 6 Replies
Advertisement
own a 2005 Hyundai accent 1.6L engine. I replace the engine today. The previous engine had internal damage. The transmission I left alone. I didn't disconnect the wiring. I only removed the engine. The transmission worked flawless. When I turned on the car the engine sounds great and the transmission sshifted gears and the wheels were moving. The speedometer worked so then I turned the engine off and lowered the car down from the Jack stands and tired it shine but this time the transmission did not shift gears. I lifted the car back up and did still did not shift gears. The transmission does nothing. The checked the guild level and it's full. What can cause a transmission to suddenly stopped engaging gear?
View 2 Replies
So, I'm tired of this crap power steering. Since I just blew up my lpop on my 6 blow, apparently a thing with manual trans, replaced and she runs fine, I decided it is time to fix the screwed up worthless sloppy steering, and almost lack of any power steering at stop or slow drive. Picked up a rebuilt pump., and took out my old box with 220k.
I almost bought a cardone box, but frankly my input shaft had less play than 2 I ordered in. The only problem with my box is it has a tiny amount of play on the sectorshaft which translates to a lot of slop.
I've been looking into hydraulic ram assist steering, as I run 6" lift with 37s on a crew cab long bed. The thing has sucked at life since I bought it with wider 35s a few years back.
Is hydraulic assist worth it and if I go drop 500 on a redhead box, between this and the ram, am i going to be looking at decent steering on road in the future? I have no plans to offroad this boat anchor of a truck. I have a nice fun light 2 door turbo montero for that.
Do I do it, or just stick with a rebuilt box and pump?
View 1 Replies
My passenger side window is moving like a snail.
I tried both, the button on the driver side, and the one on the passenger side, and I get the same result. I also tried pulling on the door to give it more space, so it's not that it has too much pressure on it from the door. My car only has 27,000 miles on it, so the motor shouldn't be going out already. But I guess it's possible.
I'm pretty sure it's always been slower than the driver side window, but between today and yesterday, I noticed it's been getting dramatically slower every time I use it. I'm kinda' afraid to push the button to take it down now.
View 29 Replies
Does the 2015 GX 460 beeps when you're really near an object? Mine only alerts me when there is a moving object. I checked the lexus park assist and it's on but no alert. It doesn't alert when I'm reversing or when I'm driving forward when I'm parallel parking.
View 5 Replies
I own a out of warranty 2008 Accent manual, now on 94 000km/58 408 miles. This morning, it started to not engage 2nd gear, then when I press the pedal hard it does, then sometimes 4th gear. What could be at fault here, and how do I fix it?
View 9 Replies
My friend has a 2007 accent with a manual transmission they said that they were driving and the transmission stopped shifting gears. The clutch pedal still has pressure so I don't think it is a master or slave cylinder issue. They freaked out and turned off the car and now the car will not start up again. Have any of you experienced anything like this before or know on this car where to start looking? I think the issue with not being able to switch gears could be a pressure plate issue but this would not cause the car not to start.
View 6 Replies
So I just installed my short shifter and everything works great, all the gears engage, however, when I put my shift knob on I noticed I couldn't engage reverse because it sits down too low and doesn't allow the reverse lockout to get over the rail and engage reverse. I have to loosen the knob so it sits higher and then I can engage reverse, but it moves around, so I can't leave it like this...right now my plan is to make some sort of spacer for the knob to sit on and then put loctite on it...seems like it would solve my problem. I have a Hyundai Aluminum shift knob and the short shift is OEM so I don't see what could be wrong ...
View 8 Replies
07 accent with transmission lurching.
As the auto trans heats up, the gears begin to get sticky. This creates a jerking motion as the engine downshifts while braking. It also happens at high speeds when attempting to downshift for acceleration.
Additionally, while shifting from park at hot temperatures, the transmission will take up to 15 seconds to engage into drive, and even more time (30-40 sec) to shift into reverse.
The car has recently (approx 6-8000 miles ago) had a complete transmission flush. The auto shop in town also suggested and did replace a sensor somewhere which supposedly had gone bad. But the problem persists...
View 2 Replies
I started to drive with my windows open and just noticed a noise every time I switch gears, and specially when I'm going up on hills or streets, the noise is just for 1 second maybe 1.5 and when I'm going up on long and elevated streets is longer specially on 3rd gear, I just did the oil change on my car a couple weeks a go (quacker state 5W20 , 3 1/2 quarts) and I was hoping to fix the "noise" with that, but is not......the "noise" is like a "click click click click" like valves hitting .......I can't say for how long the engine was doing that "noise", cause I just noticed after driving with my windows open
My car have 125,000 kilometers and the timing belt was change at 108,000 kilos, no A/C on the car
Take a look on 2:00 minutes, right after the guy release the pedal, the "click click click" noise : Sunet ciudat motor Hyundai Accent 1,4 DOHC - YouTube
View 15 Replies
MKIV jetta GLI, first two gears just won't engages as if it's still in neutral. Have to start her moving from 3rd. What could be the issue?
View 14 Replies
2011 F250 6.7L Powerstroke, automatic tranny, Electric Locking Diff
When I engage the On the Fly 4WD switch the indicator panel says "shift to 4x4H in Progress" and everything seems fine but if I am not moving forward when I shift the 4WD doesn't engage. The engine revs up but nothing happens. When I release the accelerator the transfer case bangs like it is going to rip out of the truck. In reverse it is even worse. I am lucky that I didn't gun it or I could have done allot of potential damage. All my other Ford 4WD vehicles engage immediately from a full stopped position. This is quite of troublesome because if you have to shift when your stuck in the mud, your still stuck. If I shift while moving forward it works just fine.
My question is: Does this particular model (2011 F250 6.7L Powerstroke with an automatic tranny) have to be moving forward in order for the 4WD to engage?
View 3 Replies
my 91 525i wont engage 1st gear..fluids fine..nothing smoking...fluid levels great. color correct in fluid appearance..reverse works..no funny noises from rear end..car just will not shift above 1st. i have replaced transmission filter and fluid.
View 1 Replies
148,000 miles, and yesterday my R decided it would no longer allow me to use first gear. It sort of starts to go in gear, but feels kind of mushy, not positive, and if I let out the clutch, the gears grind, but will not engage. All other gears feel and perform normally.
View 7 Replies
I have a 2001 Sport Trac. I was hooking up my boat, and went to put it into "R" and heard something that sounded like plastic break. Then, the gear selector seemed to move freely between all the gears. I know it is a pretty vague question, but what part do I ask for to repair it. Or more importantly, HOW do I repair it?
View 1 Replies
2003 Passat 1.8t FWD.
My buddy is having a wierd issue that just recently started after it's gotten cold out. The car would not start for him so he had me look at it. Attempting to start there's no sound from the starter at all. Battery is fine. When I shift in and out of a few gears, the starter engages and the car starts. Stop the car. Attempt to start it again and nothing. Shift through the gears some more and the car almost starts but quickly dies. Shift some more, start, running like a champ.
What is it about shifting through the gears that allows the starter to engage and the car to run again?
View 3 Replies
I have a 2011 sonata SE w/ 30K miles, the starter failed on me.
The motor would spin but would not engage the gears b/c of the solenoid or the rod malfunctioned.
They towed my car to the dealer for free and it was replaced but I'm concerned because the towing guy told me he towed quite a few Hyundai's b/c of this problem.
View 140 Replies
99 Passat1.8t auto, transmission doesn't engage into any gear ... Cluster shows that all gears selected ....
ATF level OK and VAGCOM doesn't show a ny codes/errors for trann When I put D or R - car revs up to 1200RPMs and thats it Checked ECU and TCU (tranny computer) no signs of water in them I don't really know history behind this vehicle but it had been sitting from 2009, had run before without problems (at least thats what previous owner told me) ...
View 7 Replies
i've got an accord 4 cylinder with an automatic transmission that does not engage any of the other gears when i shift it out of park. all indicator lights are out except for the park position on the dash.
View 1 Replies
I have 2005 Nissan Altima which I bought when nissan did an overall makeover. It has 102k miles on it. Offlate I am observing that when the car is shifting gears (automatic), I hear kind of some fluid moving through near the front passenger seat. I looked under the seat and the searched the whole car to see if there is a half empty water bottle thats making the sound. I dont see it though. Am I looking at some problem?
View 6 Replies
My 2000 Subaru Outback (75,000 miles) runs well almost all of the time. Every so often, especially when the weather is cold and I have been making many short trips, the transmission will refuse to engage into any of the forward gears (Auto-Trans). It will do reverse, no trouble, but not the forward ones. It does not do this with any sort of regularity or consistency. I have had it checked by my mechanic and he said that although it did this it sounded fine and was not shifting roughly. Thinking it might be a fluid pressure problem, he put in fluid additive to soften the seals and this worked for about a week, then back to square one. I saw enough notes posted on other forums by other Subaru owners to know that this might be an issue with this year's model--maybe some sort of quirk that I hope can be fixed without a new trans.
View 5 Replies
