Starting at about 30mph there's a humming noise that gets louder as speed increases. It doesn't seem to change if I am steering right or left and i have no steering wheel shake or any sort of noticeable bumping at 60mph. Could this just be my tires making noise, they are quite worn by now.
View 12 RepliesRecently I have been hearing a humming noise that increases with speed. I don't get it when the car stops. I think it's coming from the rear but only when the car is moving and steadily increases in volume as speed increases and comes down as speed comes down. It's not coming from engine or transmission but coming from the rear wheels. Could it be a bearing? or both bearings? Is hard to make out if it's left or right of the windows when the windows are closed. Car drives great and has mileage in the 80's
View 5 Replies2007 Camry LE 2.4
I just replaced the rear pads and rotors with no issues other than having to bang the cr@p out of the left rotor with a hammer to get it to come off. Now at pretty much all speeds I am hearing a rythmic humming-type sound that increases and decreases with vehicle speed. It's not a constant hum but more like one-hum-per-tire-revolution type of sound. It is coming from the left side as far as I can tell.
Thinking I had damaged the wheel bearing (and after searching the forums extensively) I replaced it with a brand new bearing from Advance Auto Parts. I re-checked the pads, rotors, all bolts, everything is lubricated properly, etc. Just took it out for a test drive and the noise is still there. Sometimes it gets louder when breaking but not always. I rotated tires and the sound did not follow the tire. The pads aren't stuck or rubbing excessively as far as I can tell.
This sort of thing has happened in the past on the left rear. It would sometimes happen when I swapped the summer tires for my winter tires on steelies, the left rear would make the humming sound, I'd take the wheel off and put it back on 180 degrees rotated and the sound would go away. I've done that a few times too and it has not worked.
I have an 04 Pontiac (wifes car) as you start driving you hear a humming noise that starts at about 20mph and gets louder with speed at high speeds it just stay's steady, changes when changing lanes and gets quieter as you slow down, I know its not the engine or transmission as I can rev the engine and only when the car speeds up the sound changes (louder). I've been seeing similar post and its either CV joint or bad bearings but need more of a defined answer from a mechanic who recognizes this situation. Also the sound does make a little vibration felt through the steering wheel and gas pedal but again changes when steering is turned back and forth which I think means it's somewhere in the drive shaft and axle area or steering system.
View 1 RepliesThis is a 2002 Toyota Camry 4cyl with 249157 miles. I drove it 140 miles to work, noticed no issues, parked it, and got back in after 10 hours. On the way back I noticed a noise that got louder the faster I went. It is independent of the engine revolutions (I put the car in neutral and "coasted"). The noise is completely dependent on the speed of my forward movement.
So I put the car up and in gear and around 25/30 mph, the sound shows up and gets worse as the speed increases. It does not get worse in turns. And it is very consistent- not clunking or clicking, just a steady sounds almost like strong wind over an object. I replaced the wheel bearings in both front wheel assemblies about a year and a half ago.
This week I noticed a sound that sounds low that increases then the vehicle goes faster and decreases when it slows down. It is not wheel bearing noise. Took a doctors type scope and put it on the pulleys listening for the bearing noise in each pulley and found my alternator pulley making more noise than usual, My car needs new accessory belts so I ordered 3 new belts and will be replacing them soon. I am hoping the noise is from worn belts and not the alternator. If it is the alternator its going to cost me 250 bucks for a rebuilt one. I'm not sure if I can tear the alternator apart and replace the part bearing part. Have to look into this. Is this normal for a car with 161 thousand klm for accessory belt bearings on items to start to go bad? I sure hope the water pump and power steering and ac compressor and ac tensioner last. These all have bearings in them as well.
View 10 RepliesI have a 2006 GMC Sierra z71 has 159,000 miles on it. I've already changed the front hub bearings and the tires are brand new. Brakes are in good shape as well. I also had someone check the front differential bearings too. Said the front diff was good. The noise starts at about 50-55 and keeps getting louder with speed. The noise is similar to a hub bearing noise. When you let off the throttle the noise is more pronounced then when on the throttle. I'm thinking it's te cv axles. The cv boots don't have any tears in them and I have no clicking noise. But I've also heard that cv axles can make this noise. Also the noise seems to change when I hit bumps. that's also why I'm thinking cv axles. Because cv axles are the only thing that move with the suspension and also rotate.
View 2 RepliesMy wife has an 09 accent equipped with the 1.6 and 5spd manual. When it gets cold (close to freezing and under) fourth gear starts to make a whining/growling noise that gets louder with more load. Once it is warm it completely goes away. What is going on here?
View 1 RepliesIn my 2007 Sonata, I hit a poorly placed high manhole cover in a dip in the road, in the dark, going 30MPH, whacked it good before I could adjust...
I then pulled the car over, it seemed to go dead, then the car did crank back up, the engine sounded much louder, like a loud rev/hum, not quiet like usual.
I next drove a mile to a c-store, transmission seemed OK, no leaks, did see a check engine light briefly, but it disappeared. Car cranked OK, headed home, same sound right at cranking and at moderate speed.
Finally, I jacked the car up on the front left, from research appears that the plastic engine shields got smacked good along the front and near the right tire and bent back quite a bit on the left side. There seems to be no other structural damage that my untrained eye could see, just one indention you'll see in a couple of the photos that I think is part of the car design at that spot.
Again, no leaks, no smoke, no caution lights of any kind now.
Photos are attached...
My Hyundai's engine now sounds like a Mustang! Hoping it's just the engine noise from these plastic covers now being bent/destroyed in some spots, exposing the engine and the typical noise you'd hear without them...
My 2006 hyundai accent makes a humming noise while driving. it gets louder the faster i accelerate. I have checked the wheel bearing but they appear to be fine. i jacked the car up and tested the wheel by pulling and pushing back and forth at the 12 o' clock position and etc. no give in either wheel. i also held the spring and spun both wheels with no vibration. I also rotated tires back to front. when i did this noise seemed to be lower.But still there. I did hit a fallen sign on the highway going 70 mph. I am wondering if this may have damaged my tires or if it still could be wheel bearing. and there is no vibration in steering wheel or while driving. just annoying humming.
View 1 RepliesOver the past 2 weeks, started having a whining noise from front end. It seems to be coming from the front passenger side. The noise starts at around 30 mph and increases with speed. Very noticeable at highway speed. Sounded a bit like tire noise. I did rotate the tires, front to back, but noise persists from the front.
View 6 RepliesI recently had my 2002 1.8T in for clutch replacement at the dealer and they came back and said the crankshaft was bad ( the car was occasionally making noise when pushing the clutch in, they thought it was a throwout bearing) I took the car back to bring it back to an indie, and it is loud at idle and while accelerating (sounds like a chattering noise that gets faster as speed increases) It's now sitting in the parking lot. My question is, am I going to have to put in a whole new engine to fix this problem? can just a crankshaft be replaced?
View 2 RepliesI recently purchased new tires and rims for my Mazda 626 thinking it would get rid ot the loud tire noise (2 rims were bent). However, the noise still exists. I cannot seem top pin point the source of the noise but, it increases with speed.
View 5 Replies2003 Subaru Forester with 130,000 miles. We put new tires on two months ago and when I started hearing the wah, wah, wah noise coming from the back of the car (rhythmic - increases with speed of car) I assumed on of the new tires was bad. It isn't. Also pulled the brake drums and cleaned everything there up.... What this might be?
View 5 RepliesWhen turning in both directions, front end makes a CHEEP-CHEEP-CHEEP-CHEEP-CHEEP sound. Frequency increases when speed increases.Brakes are NOT engaged when this happens. Goes away when coming out of turn.
I am sure the problems could be multiple, but what is your first thought? Not that it matters, but its a 2002 Chevy Trailblazer.
I have the Golf 2.5 just under 5K miles with the 15" steel wheels and just recently I've noticed a clicking noise on both the drive and passenger sides. The frequency of the noise increases as I increase speed so I assume it is a tire/wheel issue. Sounds like its coming from the back but hard to tell.
View 5 RepliesMy LS 460 has a pulsing wheel/front end noise that seems to increase as the speed increases from 5 mph to about 30mph and then fades out. I brought it in for service and they test drove it twice with 1 and then 2 service techs. They could hear the noise and said to me that they think it is cupping on the tires. The tires are in great condition inside to outside.Tires have only 14000 K. I switched the back to the front. The same dut-dut-dut-dut sound increases as the speed increases to about 30mph.
I believe that the noise is something more serious. I noticed that when the suspension compresses over a high point in the road at say 20mph the sound will stop during the time the car is comming of the high point in the road. Could this be a bearing/suspention- or something with the breaking motor because I also have been using the break hold feature for several months and not sure if that could cause harm. Also I do hear more grind or grumbling when turning the wheel to the left at low speed then when turning to the right.
I recently bought a 2009 es 350, it had 88K km on it (55k miles) and i seem to have a rhythmic road noise. it increases with speed until it becomes constant. So it's obviously the tires (getting old or need balancing) or a bearing..
Being new to these cars I'm not sure and the whole car is very quiet so any noise seems to be more noticeable.
My tires are the OEM energy's...which I've heard aren't too great. They have decent thread tho, however one sidewall looks as if it's wearing away. Could it be the tires? When do the bearings wear out on these cars - I seem to think that 90K is a bit too soon for bearings..
I'm looking at a dirt cheap Explorer 4.0, has been sitting for 2 years. Runs nice, with a double "knock" noise but quieter than a rod knock. Idles smooth at 600 rpm, "knock" is consistent, but increases as engine increases speed. Has 2 year old oil, and 2 year old gas. Would a tune up support it, and revitalize it, or is the engine almost dead. Still drives, didn't push it to hard. Interior is 9/10, exterior is 10/10. I have him down to 600. 4x4 works, and feels good.
View 6 RepliesAlright so my car is up to 112k miles, other than oil change, a battery,tires, and a new ignition (tumblers fell apart somehow) its had zero maintenance really done to it. Which I know, this means its long over due for things like spark plugs, timing belt, and other mic. stuff. Its almost all highway miles, and really has no problems. I haven't put much into it because it hardly gets driven in the summer since I ride my motorcycle. The only issue is that Indiana has had a lot of rain this year so ive been driving it more.
The Problem- for months now its made a light ticking sound on start-up for about 30 seconds, and it fades away. If I rev the engine the sound gets faster, but still takes time to go away. As of Recently, the sound has gotten louder for about the first 10 seconds, and I'm worried it may become a serious issue and leave me stranded because I drive about an hour one way to work every day. So before I start throwing parts at it, where should I start?
Timing belt?
Valve Adjustment? (not sure how to do this but I'm sure there is a guide)
Plugs?
No I'm not running a FRAM Filter, its a Mobile 1, with full synthetic oil changed about every 6-7k miles. I plan to do the belt and spark plugs as soon as I get some consistent time off, but that may not be until it gets cold again.
Came off the highway just now and there's a tapping sound coming from the engine. It's louder than the ticking these engines make so believe me it's nothing I've heard before. No codes, no overheating and doesn't seem to be anything else wrong. I am due for an oil change soon and I'm wondering if that could be it?
The engine wasn't cold obviously. I did shut off the car and then back on and it still did it. Just want to make sure my engine isn't going to explode anytime soon!