My 2009 Accent started doing the Hard/Jerky shift problem that I seen discussed in the forums. Had check engine light, scanning showed a code P0717. My question is, which sensor should install?
View 4 RepliesI inherited this car from my grandmother when she passed. It has low miles, around 40k. Since I paid zero for it, I would like to keep it. Historically I have done all my repairs, but never trans work.
Here are the symptoms. The car has issues shifting into higher gears. I have to punch the gas and then it will switch gears. It then began to do this for reverse, and now now reverse does not work at all.
At first I thought it was a speed sensor problem, but when I took it in to be read, it came up with P0734. It could be electrical (Speed sensor?), low fluid (it's not low), or 4th gear.
Is this transmission worth me fixing or paying to have it repaired, or should I move on?
P.S. If I drop the pan and find shavings, I understand that to point to 4th gear and bearing (also what the computer code read as the issue). Do shavings mean it definitely is 4th/bearing, or could it be another blown part?
I have brand new ( 800KM ) Accent with Automatic transmission and I noticed that it shifts from 1st gear into 2nd kinda rough. By this I mean that I can feel shift pretty good, and I don't feel shifts from 2 to 3 to 4. I don't rev engine high, typically shifts occur when engine revs around 2000 rpm.
I am not sure if it is a transmission defect or this is the way it shifts? May be I need to breaking my car first and it will go away?
So I recently purchased a 2007 LS460 with 115k on it. I've noticed that about a month ago the car started driving pretty weird. The transmission would shift hard and jerky almost through the first 3 gears, like driving a manual.
Also, when I tried to floor the car from maybe 40-50mph, the rpm would shoot up only 500 then downshift and accelerate causing a violent jerk. It feels like if I was driving at 50mph on 8th gear, when I floored it the car would feel like it downshifted to 7th gear for merely less than a second and downshifted again to 4th gear causing the car to jerk hard.
This is the car's history:
- Reset the ECU by disconnecting the battery (no luck)
- Auto transmission software has been updated at the dealer
- Valve springs recall has been completed
- Head covers has been changed
- Engine module has been reprogrammed by the dealer at 70k miles
- Trans fluid has been changed at 70k miles according to lexus.com service record
So at this point I really don't know what could cause this problem anymore, maybe it could be the transmission fluid?
I have a 2010 accent blue model with stick shift. been fine for 50k miles. Lately i have noticed an issue where i am in first gear and then when i push clutch in to go into second, the lever won't budge. it does eventually go in but it just isn't like it used to be. it happens say about 25% of the time. Since at higher rpms it won't do it but normal rpms it will.
Also, i just had a new short block installed, perhaps something is binding? If I sit in the car, stopped, i can shift into and out of all the gears perfectly. Maybe my 1st gear synchros are going?
My 2008 seems to be having some intermittent trouble shifting into the proper gear at a couple of speed ranges.
Occasionally I'll start it up and pull out of a parking space (or leave a stoplight) and it feels like it's stuck in 1st well after it should have switched to a higher gear (I sometimes feel the upshift at about 10* mph). If I continue accelerating and hit about 40-50 mph, once again it appears to stay in the current gear instead of shifting.
When this issue is happening, the car feels even more underpowered than usual and takes way more throttle than it should to accelerate. This results in a cruising RPM of 3.3-3.5k at 60 mph. At that speed the engine would normally be doing about 2.2k RPM. Similar power and RPM conditions exist in the lower-speed range, too.
This whole thing is usually preceded by a rough shift into gear (D or R) when I first start the car. It's always had a slight lurch in the appropriate direction as I take it out of park, but this is really noticeable.
If I stop the car and come back in an hour, it (usually) appears to have reset itself. I can drive around and the transmission control is as good as always.
This has been going on for about a month, with an episode maybe every week or two. I took it to a shop and they didn't find any problems (I told them about the weird shifting and lack of power).
Does it sound like this is what's happening (it's not getting into the right gear)? Thoughts on what I should do? I can't really remember the speeds.
So I have a 2006 Hyundai accent with 75000KM on it. I notice when it shifts from 1st to 2nd gear sometimes it will jerk. It feels almost as if it goes to neutral and then sifts, causing the whole car to jerk. It use to only do it when the car was cold (first 15 min of the day) but now it seems to be doing it all the time and getting worse. I have had the transmission fluid replaced, but it doesn't seem to work.
View 30 RepliesCheck engine light had come on, the car was running rough at idle and it would crank hard. So I threw my code scanner on it only to find out it wouldn't link. Drove it to O'Riley's and had them pull the codes. It ran rough and had next to no power on the way there. O'Riley's pulled the codes and we got a P0300 (random multiple misfire), P0301 (cylinder 1 misfire), P0302 (cylinder 2 misfire), and a P0496 (EVAP emissions system high purge flow). So once I got it back to the house, she told me that she had the codes pulled once before and that they told her it could be her gas cap so she replaced it. She also stated that she had replaced the plugs about 3 months ago.
So with new gas cap and new plugs, and these codes, I did a bit of research and come to the conclusion that it'd replace the purge solenoid. The solenoid was making a pretty loud ticking noise and when I pulled it off, it rattled so I figured that was the fix. Pulled her plugs and you can clearly see that cylinder 1 was running VERY lean and cylinder 2 was a little richer but still too lean. Plugged the plugs back into coils and laid them on exhausted. Turned the car over and we had spark. Lead me to think the misfire had something to do with the P0496 EVAP code. Put everything back together and erased the codes. Gave the car back to her and told her to let me know if the light came back on. That was Wednesday last week. Sunday she told me the light came back on and the only code that came up was the P0496 again. When I gave it back to heron Wednesday, it would still crank hard but would start.
Battery is new and checked good, alternator is pulling about 14v and checked good and the starter checked good. My dilemma is the code and the hard crank. She told me that it only cranked hard for her once so I am assuming that has gone away but we're still left with the P0496. I am not 100% sure as to how this system operates but I understand it for the most part. She told me that she had just put gas in it before the light came on. Not sure how much time had elapsed after filling it and the light coming on but I do know she put gas in it. If it's a high purge flow, that makes me think there may be a leak in the system but I'm not sure where to go from here without throwing a bunch of parts and money at it.
Our Accent has just about 86k on it now, back in November it suddenly started running real jerky/rough, misfiring kinda thing. So I was able to drive it to my local repair shop and they found a bad coil pack on #3, so they replaced that and put in new plugs while they were doing it.
Just Saturday we were shopping about 20 miles from home and cranked it up to go home and started doing it again, pretty much identical symptoms, runs out normal at certain RPMs so I knew it was probably same thing...I was able to get it home and then took it in this morning and sure enough now #1 is shot. So they are replacing that. They want about 30$ more per coil then I can order them for myself online so I didn't want to scarf up the money for the other 2 that are still original.
I turned on the car today and about a couple minutes into my drive I noticed the airbag light was on. I pulled over, turned off the car, then turned it back on. The light came on with the rest of the warning lights, turned off when they all turned off, and then came back on a couple seconds later and stayed on. The car has just been sitting in my driveway. Only thing worth noting was that last night, while walking past the car, I noticed I had left one of the windows open. Also noticed my glovebox was open since I had gotten something out of it earlier in the day but forgot to close it. I turned the ignition half way to just use the battery to close the window (without turning the car on) and went to bed.
View 29 RepliesI own an automatic transmission 2004 Hyundai Accent with about 180,000 miles. I bought it brand new, but it seems to be having trouble shifting into the right gear. Many transmission "specialists" keep telling me they can't figure out what is wrong, aside from offering to completely rebuild my transmission. The car has the following symptoms:
1. At a stop sign or red light, my car doesn't always begin idling properly. Sometimes it just won't go anywhere at all, even with the motor running.
2. As I drive down the highway, it acts like it jumps into a higher gear for no reason. It sometimes resets itself with no action on my part.
3. The car jerks back and forth, not seemingly due to shifting into gear, but randomly.
4. The check engine light does not come on often, but by the time I can use a DTC reader, the light goes off.
Everything seems to be intermittent, so I can't replicate the problem on-demand for anyone who wants to inspect the problems. Is there anything I can do? Is there an easy way to figure out what's really going on? I'm assuming this is transmission-related...
2000 ls v8 sport shifts normally exept while shifting into 2nd, it kind of pops out but then locks then shifts normally.
View 9 RepliesI have a 2003 Hyundai Accent that is generating a p0713 code. I have replaced sensor and used SP3 fluid. I noticed if I clear codes everything is fine until it shifts into OD. When codes are cleared the car will not shift into OD until it hit about 60mph. The code is generated and then it shifts fine. I would not worry about it put it will not pass IM with the check engine light on.
View 1 RepliesMy 2005 PT Cruiser (not turbo) is giving me a very frustrating P0700 code and a weird problem. First thing in the cold, autumn, the car drives perfectly fine (through still with the engine code on). Once the day warms up a little, the transmission decides that shifting past second gear is for punks and won't do it, so 30 mph has the engine revving at 3K rpm.
My morning commute is 20 minutes, and in that time, I go up to 50 mph with no issues. Driving home, or any other time of day, becomes the issue. What in the world could possibly be going wrong? I've been trying to hit up the junkyard for a PCM to see if switching that out would work, but it's been too rainy and cold to get out there.
I just wanted to see if others are experiencing a hard kinda jerky shift from 4th to 5th around 40mph while in Drive. It's not super bad but noticeable when light on the accelerator. The shift to 5th drops engine speed to around 1100rpm.
View 11 RepliesMy tranny is slipping all over the place . I recently less than 1500 miles ago changed tranny fulid, tree branch and TP filter, ford filters, and 8 to 9 quarts of mercon SP. My truck is shifting like a bucking bronco. Came up with PO671. So should I replace just the 1 solenoid. Or all the valve body? I plan to run a gauge in cab to see shift pressures for testing purposes to aid in troubleshooting for current issue... reason for fluid change is history unkown.
2004 6.0 f250 4x4 tourque shift OdO is 163,800...
So my automatic accent with 82000 KM is doing some funny things. The first, is occasionally when shifting from 1st to 2nd gear, it will shift, and then almost shift again with a bit of a jolt (double shift?). The second, is when in 4th gear, when at 2000 rpm, it will jerk, almost like if it shifts yet there is nothing to shift too (4th is the highest gear). What is going on here?
View 3 RepliesRecently my wifes 2009 Sonata limited has started having a hard "clunk" when braking. It feels like a hard shift from 3rd to 2nd (or 1st?) during deceleration. Only really occurs when moderately cold and only during the first 10 miles or so of travel. What I should check?
View 4 RepliesI noticed this week the gear shift light was out on my 2008 Accent GLS. I tapped the side of it and it came back. Next day, same behavior.
View 11 RepliesSo, back when my car was my dad's, he used to drive a lot on the freeway for his job. He said that after getting off the freeway and transitioning to in-city driving, the transmission would start to act up. It only happened when the car was hot, and it's generally fine for just driving a couple miles to work like I do, albeit the occasional rough shift every now and again, but I'd like to be able to hit the freeway if I need to without worrying about the transmission badly misbehaving.
Also, I'm not sure if it's even relevant to that issue, but I've been aware of the fact that at least two of my ignition coils are bad, a common problem in MC Accents to my knowledge, and the engine hasn't been running as smoothly as it could be for the past several months. Is it at all possible that a long-standing misfire issue could play havoc with shifting patterns when the transmission changes from freeway to in-city shifting behavior?
I have a regular mechanic that I use, except for a recent plug change. The car now feels like it is shifting awkwardly, and at speeds of between 15-25 MPH, it's as if it has a hard time choosing a gear. Can improperly installed plugs have an impact on this sort of thing?
View 1 Replies