Accent MC (2006-11) :: Chirping / Grinding Noise In 3rd - 5th Gear And Only For First 15mins Of Driving
Oct 7, 2013
2007 Manual - I am getting a chirping noise/grinding noise. It happens in 3rd-5th gear and only for the first 15mins of driving. Stops making the noise after that. It happens sometimes when releasing the clutch pedal. Sometimes it occurs while accelerating and not touching clutch pedal at all. That mostly happens in 5th gear around 60mph. Thinking it has to do with trans, possibly throw out bearing. Not sure though.
View 13 Replies
Advertisement
My car has been making this chirping noise for a couple weeks now, and I can't figure out what is causing it. It's really bothering me.
The noise is sinked in with the rpms. While in neutral or while I have the clutch in, the noise stops. The higher the rpms I'm running, the faster the sound goes. I opened the hood the other day to see if I could figure it out, but all I found out from that is it sounds like it's coming from under the engine cover.
Engine? Maybe a component near it? Maybe it's just the cold weather constricting parts to a smaller size?
View 19 Replies
So my 2010 with 20k miles on it just started to have some jingling/chirping noises around the drive belt area. It isn't all that loud but i can hear it. Could this be just a simple loose belt? Are our belts auto adjusting or manually adjusted? The noise increases with engine rpm in all gears and in neutral. Is def coming from the belt area.
One pulley does seem like it is not perfectly round and I can see some very slight run out from side to side. Nothing really obvious though - that might be normal?
View 13 Replies
Ok, so I got my car at 60k miles, and the clutch went out almost instantly so I had the entire clutch replaced, and it was working just fine until now. It has been 25k miles since I did the full clutch replacement so it shouldn't be messing up again already. It is not going in to reverse at all, it goes in to 1st gear, but only after a lot of coaxing and grinding, and the clutch feels strange. The clutch is too soft (too easy to push down), but after a while it seems to get better.
2007 Hyundai Accent GS
Manual, hatchback
85k miles
View 8 Replies
So I have a 2000 Hyundai Accent, 1.5L with an automatic transmission. I'm hearing a grinding noise when I'm driving. It gets faster as the car goes faster, but the engine RPM has no effect only the speed of the car.
I got new tires, changed the CV axle shaft on both sides, and I also changed the front struts as I was told that one of the struts was bad the last time I took the car for an alignment. None of that has had any effect on the grinding noise.
Then I jacked the car up on both sides and let the wheels spin, and the grinding noise is present that way as well. Then I jacked up just one side at a time. When the driver's side wheel is spinning, the noise is audible, but not when just the passenger side is spinning.
I then disconnected the brake caliper from the driver's side and held it up with a tie wrap to keep it out of the way. The noise is still audible when the wheel is spinning, so it's not the pads or a clip or anything like that.
So now I'm down to a couple of ideas.
1) Wheel bearings
2) Something is hosed in the differential or transmission. I'm guessing that the differential is more likely, as the transmission should effect both sides the same, right?
I'm going to check the wheel bearings now, though to me it seems unlikely to be the problem.
View 10 Replies
Occasionally the car will make load grinding noise that sounds like a garbage disposal:
[URL] ....
[URL] ....
When this happens the gas pedal is also vibrating. It will go away when the car is stopped and may not return for a few days.
It's 2008 accent SE with a performance chip.
View 14 Replies
I have a 2006 accent gls manual and when I am on the highway in 5th gear my rpms are high. if I am cruising at 110km my rpms will be almost at 3500..
View 13 Replies
My right rear brake is making a grinding noise when the brakes are applied. I took the drum off a couple weeks ago and the shoes are just a bit worn. Just getting into the numbers printed on the side of the shoe material.
I could not see any thing that would be making the metal on metal sound. Are there any wear indicators on the OEM shoes?
View 9 Replies
I am having several issues. I got the lexus dealership to service my transmission recently. I got it back with a weird smell. It smells like body odor. I had to reach out to hendrick corporate for them to address the problem without charging me. Turns out it was the fluid they used. I could smell the smell from inside if i wasn't recirculating the air. They changed the fluid again and it still smells. Is my transmission doing this because it is too hot?
This smell was never an issue until after the first transmission service. And now I'm hearing a metal grinding sound in 2nd gear past 4600 rpm. It still shifts smooth but 2nd gear might be slipping. Something just doesn't seem right. o yea they gave me my car back with my brakes sticking after stopping in traffic. I took it back and was told my brake pads in the rear lost 2mm in less than 650 miles.
By the way this sound can be heard in 1st but is more prevalent in 2nd. It is not heard in any other gears. And when in sport mode the sound instantly stops when i shift up into 3rd.
View 3 Replies
I am now getting a grinding noise when I shift from first to second gear. It sounds like the two metals rubbing each other. Its not happening all the time, but for the past two days a bit frequently
I had reported this grinding noise when I turn left a month back. Was thinking because of my worn out tyres, but apparently not.
View 8 Replies
A few days ago, my Sonata 2006 LX started making weird noises when driving at low speeds. The noise comes from the front driver's side area, they are not affected by steering or going over bumps. Usually get less intense when I accelerate or brake. At speeds around 5 mph, the noise is grinding and pretty loud. At higher speeds, it's more like banging and it's frequency increases with the speed. There was no effect other than the noise, but the last day at higher speeds, I can feel with the steering wheel a little vibration sometimes from the banging.
I've been having tough times renting a car during the weekend and I still drive on short distances, but I'm afraid it could be a safety issue or that I can be making things much worse to repair. The noises got worse since the beginning, but I don't think they are getting any worse anymore.
View 3 Replies
My '06 Nissan Altima suddenly started making a very loud rattling noise as soon as I put it into drive and start moving at low speeds. The noise does not go away at high speeds. It sounds like I am dragging the entire undercarriage. When breaking it grinds very loudly. All of this is sudden. Only other issue I had recently was that the motor wouldn't catch when I tried it Saturday, but it finally did after giving it a good amount of fuel. Drove it 300 miles yesterday without a problem. Woke up to a car that sounds an awful lot like a plane.
View 9 Replies
The day after I purchased the Accent I noticed that when idle I would hear a chirping/cricket sound emanating somewhere in the engine bay area, closer to the cockpit of the vehicle. As soon as I'd touch the clutch the sound would disappear, now I'm not talking about pressing it hard, the ever so slightest touch would silence the noise.
Now I asked this question here already but I thought I'd ask you directly. I was told throw out bearing and other clutch related possibilities. Now I have a two year warranty so I brought it to the dealership and of course, Murphy's law wouldn't you know it, the sound did not present itself the entire time I was there! lol Now I came to the conclusion (albeit a total hypothesis ) that it was raining, or had rained the days the sound wasn't present or diminished enough that I couldn't hear it anymore. I figured maybe it's because they need new grease perhaps and when it rains the viscosity of the current grease changed enough to lube the part properly.
Either way the dealership of course said there's nothing they could find wrong with Eleanor, and I sh!t you not the moment I brought her back home it started making the sound again! Should I be worried? Last thing I need is the clutch or something else dying and I find out I could have prevented it.
View 10 Replies
I have a chirping/ squeaking sound in the engine extremely noticeable on idle. It's not the actual belt because it continues the noise much after the car is heated up. Have no clue what it is, I have 145000 miles. Also when running the engine hard notice a hissing sound sort of like turbo at high rpms especially with ac on high.
View 3 Replies
Had the car for less than a week and I'm getting a constant chirping/cricket sound, the moment I touch the clutch even slightly it stops. Sound is gone when clutch is touched in any way or engaged. My first thought is Throw Out Bearing, or perhaps pilot bearing?
2010 GL Sport model.
View 2 Replies
So i just had my torque converter recall done yesterday but before that happened i told the dealer that iv been experiencing a chirping like noise when in gear and when tapping on the gas. It's very quick and goes away once i ease off the pedal. Anyways they told me it could be the transmission. Mind you i had my car for a year. I bought the car brand spankin new and currently have 19,000 miles. All they said was oh hey come back if you still have that noise which i do. So im thinking they didn't even look into it because its pretty obvious the noise it makes. Im wondering what this could be?
View 9 Replies
My 2006 hyundai accent makes a humming noise while driving. it gets louder the faster i accelerate. I have checked the wheel bearing but they appear to be fine. i jacked the car up and tested the wheel by pulling and pushing back and forth at the 12 o' clock position and etc. no give in either wheel. i also held the spring and spun both wheels with no vibration. I also rotated tires back to front. when i did this noise seemed to be lower.But still there. I did hit a fallen sign on the highway going 70 mph. I am wondering if this may have damaged my tires or if it still could be wheel bearing. and there is no vibration in steering wheel or while driving. just annoying humming.
View 1 Replies
Why my car is grinding gear when I shift from 1st to 2nd, & yes the clutch is fully depleted and still grinds when I shift.
View 4 Replies
When changing gears my accent grinds as if its not engaging properly? I checked my slave cylinder and the rubber was filled with silver looking fluid could me replacing the S/C fix the issue? I don't think its synchro issue i tried double clutching and still no difference. the grind sounds the exact same as it does when you accidentally release your clutch when changing gears and it hasn't engaged properly. I also changed my manual gear box oil.
View 2 Replies
I have a subaru impreza 2006 with about 100K miles on it and it makes a chirping noise--which i think might not be coming from the engine or the belts because i had the belts, transmission and stuff all replaced about 8 months ago when i got a tune-up--but I don't know.
The sound most of the time usually happens when i am making a left turn(but sometimes happens while going straight but never in reverse or right turns) while accelerating from a complete stop. However when i take my foot off the accelerator while in motion it the sound stops.
This sound occurs maybe 25-30% of the time. What is going on????
View 1 Replies
I've got a 07 accent with 90k miles on it. It has recently started slipping some (revs high, while in gear, without accelerating, especially in 5th gear). It also can be physically hard to move the shifter into gear sometimes (with my hand).
So, does this mean I need a new clutch? Or are there other possibilities? Should I replace/fix anything with the clutch? Sounds like the flywheel should be resurfaced? Will it shift more smoothly after the fix?
Is this something a newb could do himself? I can change the oil, rotate tires. Outside of that I haven't done much. My toolset for now is fairly limited: two jackstands, a trolley jack, torque-wrench and ratchet sets.
View 12 Replies
