Accent MC (2006-11) :: 2008 - Front Brake Chirp Noise
Jul 6, 2012
I've got a strange noise coming from the front brakes. It's not the wear indicator, and it's not a worn out rotor.
When I apply the brakes firmly, they work great. No noise, good stopping power, the pedal is nice and firm. As soon as I let off the pedal, there's a little chirping noise, like a tiny bird in my wheels... I've looked at the pads and rotors, and there's no obvious sign of damage or wear.
My guess is it's the caliper pins or piston making the noise. I'm happy to take it apart and lube it, but what kind of lube is specified for this? Moly grease? Lithium grease? Some kind of oil? And do I apply it only to the caliper pins, or to the piston as well?
I looked on HMA service, but I can't seem to find anything to address this specific problem.
View 5 Replies
Advertisement
Lately I changed my front brake rotor and the new brake pad. However, When I doing back forward with applying light brake. I can hear "gara gara" noise from the front brake. Sounds like two steel material hiting each other.
Also, there is a different noise comes out when I releasing the brake after local stop. (red light stop or stop sign). I ask the mechanic when I doing the oil change. He checked and said my brake just are fine.
Probably it needs time for the pad break down with the new rotor. I used the Posi ceramic brake pads with the come with shim.
View 5 Replies
This afternoon while I was driving home from work I heard a minor squeak so I put the windows up and the radio off. t I heard my brake pedals chirp. It's a small minor squeak, but I hear it and it's bothering me. Am I over thinking this?
View 20 Replies
So I went to get my '08 Accent inspected, and we observed that the right side and the 3rd brake lights were out. Replaced the bulb on the right side and still out. Not even going to attempt the 3rd light until I can get more info, because the odds of a complete LED strip quitting all at once are, well, remote enough to be laughable.
I checked the RH tail lamp fuse - connection still good. The left side brake light still works, so I'm doubtful that this is the notorious brake light switch that was recalled - unless such an issue has indeed been reported with said switch...
View 4 Replies
Since I have this car i noticed that the brake calipers (especially the front) are very noisy. This problem is caused by caliper's floating guides that become loose and the entire brake caliper shakes. I asked at a kia mechanic who answered to me to change the calipers support. For my trusted mechanic is useless because, according to him, this type of support have this problem (he tell me that also others car have this problem like older nissan micra) and sooner or later would return noisy.
Some time ago with greasing the floating guides i temporary solved but drying up over time the problem come back.
View 6 Replies
My Hyundai Accent 2006 with 98000km has a noise when the brake is released. Braking is ok and seems to work well. This noise comes from the back when the brake is released.
View 4 Replies
Just noticed this the other day, when depressing my GF's 2011 Accent's brake pedal it made a low hissing sound, it would go away when you took your foot off the pedal, you would never hear this with the radio on, but it was enough to make me think it could be a concern.
Drove the car and it didn't affect the brake permormance, but the longer this goes, I can't imagine this being a good thing.
Car is 3 years old, and has 80-20 city/hwy driving under it.
View 7 Replies
I own a 2005 Hyundai Accent 1.3 SOHC and a while ago the front right wheel started to make a grinding noise, problem was related to the brake system..
So far I've tried replacing the rotor (disc), repaired the caliper (using a rebuild kit), replaced hoses (both), and event the master cylinder.... and the problem persists, it actually came to the point that after driving a while the front wheels will get stuck.
I've followed all the directions from the service manual and it still got the problem...
View 14 Replies
My right rear brake is making a grinding noise when the brakes are applied. I took the drum off a couple weeks ago and the shoes are just a bit worn. Just getting into the numbers printed on the side of the shoe material.
I could not see any thing that would be making the metal on metal sound. Are there any wear indicators on the OEM shoes?
View 9 Replies
Accent 2006. When I start the car and start to drive, the car rock on the driver's side. I think it's the driver's rear. Then the feeling of a flat tire is felt but the tire seems to be ok. Occasionally hear a loud noise like from the exhaust and when I stop at a stop sign or stop lights and release the brake the car does not move till the accelerator is pressed and it rocks again and moves. It has 99000 km on it.
View 1 Replies
My brake pedal is making a creaking noise when depressed and can also be heard when letting off the pedal. The noise is not coming from the brakes themselves (front/back are like new) but the pedal area or somewhere behind it. This noise doesn't start until I've driven the car for a little while. The brakes work fine for the most part but sometimes feel a bit spongy if making a sudden or hard stop. The fluid levels are fine.
I'm taking it in on Friday and hoping that the brakes just need to be bled a little or maybe the pedal just needs lube, but I'm worried it might be the booster or master cylinder---if it is one of these?
View 4 Replies
I've got some front end noise in my 09 accent gls. Its the passenger side when it goes over bumps. I've seen online it may be the sway bar end linkage? I don't have air tools or do too much work myself, I just do the typical stuff on my own, oil changes, brake replacement, stuff like that...how hard is this job?
View 11 Replies
I have a 2010 base blue. I have noticed a creaking noise somewhere in the front end with windows up when you turn the wheels left or right. It is barely noticeable but there none the less. I have tried pinpointing it and it seems to be outside the cabin but not at the wheels.
View 13 Replies
Car died while driving home. Now it wont start. The tow truck driver that towed me home swears that the timing belt is out. Car makes spinning noise when I try to start it. I plugged in my code reader and got P0342 Camshaft Position Sensor Circuit Low Input. Not sure where to go from here. Do I replace the sensor or take it in to have the timing belt done? 109,000 miles.
View 7 Replies
My 2006 hyundai accent makes a humming noise while driving. it gets louder the faster i accelerate. I have checked the wheel bearing but they appear to be fine. i jacked the car up and tested the wheel by pulling and pushing back and forth at the 12 o' clock position and etc. no give in either wheel. i also held the spring and spun both wheels with no vibration. I also rotated tires back to front. when i did this noise seemed to be lower.But still there. I did hit a fallen sign on the highway going 70 mph. I am wondering if this may have damaged my tires or if it still could be wheel bearing. and there is no vibration in steering wheel or while driving. just annoying humming.
View 1 Replies
I have some noise coming from the front suspension. It is a popping/sorta creaking noise. I hear it mostly when turning, but sometimes while going straight. It is not a grinding sound, nor is it a high pitched sound. I took it to my mechanic, but they drove it and could not replicate the noise. They inspected the front end, and said everything looked fine. But I still hear the noise. The car has a little over 40k miles on it. No problems with the tires...no irregular wear, and no wandering. I looked at the front end, and didn't find anything obvious. I cannot replicate the noise just by pushing on the fenders up and down.
View 64 Replies
Had a lift done (Rough Country, after reading through these forums) on my 04 F150 Newer Body Style 4x4. Now, sometimes the pedal gets harder to push on until it won't go down at all and the brakes (only the front) start dragging. It goes away after awhile (my rotors are shot and I'm going to have to replace them after I figure out what is going on) but always comes back. The brake lines have been bled and I'm having a shop bleed them again tomorrow (that's what they said the issue was) just in case.
View 11 Replies
Not so much hitting pot holes but hitting dips in road I get a noise up front like hard plastic cracked and hitting edges, had the front end checked all fine and he changed the sway bar links said sloppy, still noise, I went under found the front pipe bracket broken so I clamped that, still noise-could it be the strut boot? Doesn't seem to be the shock bushing they seem tight but can not really see them and the upper shock part seems secure. 2011 accent 60k miles. Where I could look next? The plastic around the wheel well is cracked but I don't think all that noise is coming from that, but the next warm dry day I will try to snug that up.
View 1 Replies
Accent 2008 (155,000 km) .... Walter pump, all belt, timing belt, pulley where changed @ 120,00Km when i bought the car.
**No code showing in dtc no check engine light**
I've been losing power uphill, RPM at 4,000 and and losing speed. I heard a loud sound coming from the front starting at 2,500 rpm and up (like if the exhaust air is struggling to get out), not sure who to explain that accelerating noise
On Flat surface it's slower accelerating up to 3,000 rpm with that loud sound. It's like the more i pressed on the gas pedal, the less acceleration i get.
**Running idle up to 4,000 rpm in park, no loud noise, engine running normal sound with no lack in acceleration in RPM**
2 weeks before I had 2 ignitions coil going bad at same time, i run it about 2 miles before changing them, and the exhaust/catalytic converter came hot and melted the plastic dust cover under the car near the catalytic converter.. Did I premature burn or plug that catalytic converter?
Would it be catalytic converter? Fuel pump? Fuel Filter..
I thought of buying a catalytic converter cleaner and put in fuel tank and up the intake..
View 21 Replies
ON smooth highway at varying speeds I can hear a rhythmic bumping/thumping noise from the front end of our 2008 Limited with 26,000 miles. It is speed sensitive but I can't tell if it would be a wheel bearing going bad or tire noise from the stock Michelins or maybe one out of balance though I don't feel anything as much as I hear something. I guess I can take it to dealer to see if they can diagnose
View 26 Replies
I changed my front rotor and brake pad with the oem parts last week. However, it has noise come out everytime when I touch the brake. Is it normal? Or does it need times for break down? Or I did something wrong in installing that cost the noise?
View 13 Replies
