Accent MC (2006-11) :: 2007 GS - Transmission Popping Out Of 5th Gear
Jun 29, 2014
2007 accent GS 5 speed manual. car has 142,000 miles. Trans popping out of 5th gear under load. interstate driving 65 MPH going up hill. Pops out but goes back into 5th. Car does not pop out of the other forward gears at this time. Car has very good clutch, no slipping. Short shifter, alu. trans/shifter bushing. shifter cables are adjusted correctly. Are my sliders and dog gears for 5th worn out??? Or is my fork bent?? Or both. Do I need to pull trans?
View 2 Replies
Advertisement
I am having a issue that my transmission is popping out of 4th gear on my Accent, particularly on inclines. Have had the transmission (gear) oil checked and filled (was low) and thought that may have been the issue. Got it back from the mechanic and less than an hour later is popped out of 4th 2 times in a 5 minute period. It has only popped out of 4th gear, has not happened from any other gear. I have no check engine light or any other 'idiot' lights that come on when it happens. (Other than replacing the clutch...which I hoping I don't have to do ) cause that's a trip to the mechanic again...
2000 Hyundai Accent
1.5L 5 speed manual
240k miles
View 7 Replies
My 2007 elantra is starting to pop out of 4th gear whilst accelerating. Is there a fix for this?
View 4 Replies
So I have a 2006 Hyundai accent with 75000KM on it. I notice when it shifts from 1st to 2nd gear sometimes it will jerk. It feels almost as if it goes to neutral and then sifts, causing the whole car to jerk. It use to only do it when the car was cold (first 15 min of the day) but now it seems to be doing it all the time and getting worse. I have had the transmission fluid replaced, but it doesn't seem to work.
View 30 Replies
My friend told me the other day her car was in overdrive (hwy driving) and suddenly, it shifted to a lower gear. It seems no one knows why. She does have an extended warranty, but the garage might charge her $300 to open it up to see what is wrong. Another friend suggested a clogged filter. Another one, a sensor.
View 7 Replies
I have a 2010 accent blue model with stick shift. been fine for 50k miles. Lately i have noticed an issue where i am in first gear and then when i push clutch in to go into second, the lever won't budge. it does eventually go in but it just isn't like it used to be. it happens say about 25% of the time. Since at higher rpms it won't do it but normal rpms it will.
Also, i just had a new short block installed, perhaps something is binding? If I sit in the car, stopped, i can shift into and out of all the gears perfectly. Maybe my 1st gear synchros are going?
View 2 Replies
When cold starting the transmission shifts into reverse perfectly, then after backing up the car and shifting into drive it hesitates for 4 or 5 seconds before it engages the forward gear.
2008 Accent 4 door automatic 77,000 KM
View 4 Replies
I have a 2008 Accent (base model for the most part, no C/C), and my transmission seems to be slipping a bit. The symptoms are: slow acceleration, a delay in gear shifting, and after the 30MPH mark, it takes forever to get up to anything near 60. I just wanted to know if it's a simple solution such as topping off the transmission fluid, or if it's a bigger issue.
View 5 Replies
My wife has been using her mom's 07 Accent, the mom is 90 and hasn't been incapable of using it for a while now. I did an oil change (without paying much attention) I've never seen this type of car before. Oddly the oil level seemed outrageously over full and still dirty
Then upon driving it the automatic transmission was all wacky, not engaging at idle, then it abruptly chunking into gear...
So I check the transmission fluid level and it's not on the stick. Research here let me know SP-III is what I'd need. Then while surfing a youtube vid regarding this model's transmission it hit me in the face, I'd drained the automatic transmission fluid! Went to the Kia dealer got 3 quarts dumped it in there, drained the overfilled 5.5 quarts of old and new oil rectifying my mistake, which brings me to the reason for this post.
This 2007 car only has 24,300 miles on it and I mistook the automatic transmission fluid for outrageously dirty engine oil! I swear this stuff looks like it's fulla carbon black n burnt up. My question: is it normal for the trans-fluid to have such a degraded appearance in only 25,000 miles?
View 2 Replies
The transmission shifts into gear and when the clutch is released it starts to crawl forward. When the throttle pedal is pushed it still revs up the engine normally. But when the transmission is in gear and the throttle is pushed it revs up like it is in neutral. At first I thought this might be a transmission problem but then I figured it might be a linkage somewhere. After looking under the hood and under the car I still couldn't see anything that would cause this problem. I had this car less than a week when this happened and I had to be towed home.
View 4 Replies
My zf6 in a 2004 ford f250 6.0 powerstroke has been popping out of 4th gear (4th according to fords labeling on the shifter). It will then usually not go back into gear. At least for a little while. It does not grind when you try to put it in gear. Seems this truck likes to show its problems right before I need it for a longer trip.....go figure.
View 2 Replies
Have a 2007 Sonata limited 3.3l, have trouble code P2507 and the car is stuck in limp home mode. Already changed input and output sensors on tranny. Battery is putting out 12V and alternator is putting out 14V when running. Cleaned PCM connections and packed with dielectric grease. Not sure where to look next.
View 6 Replies
I have some noise coming from the front suspension. It is a popping/sorta creaking noise. I hear it mostly when turning, but sometimes while going straight. It is not a grinding sound, nor is it a high pitched sound. I took it to my mechanic, but they drove it and could not replicate the noise. They inspected the front end, and said everything looked fine. But I still hear the noise. The car has a little over 40k miles on it. No problems with the tires...no irregular wear, and no wandering. I looked at the front end, and didn't find anything obvious. I cannot replicate the noise just by pushing on the fenders up and down.
View 64 Replies
We have with our 2007 Elantra popping out of gear under load. The car started doing this at about 110000 ks and its getting worse. It looks like it will cost about 2 to 3k to fix or replace with a second hand one.
View 1 Replies
Not too terribly long ago I got assistance on identifying and fixing an engine misfire on my 2009 Accent. I assumed was directly connected has cropped up again - a P0497 Low Purge Flow error has come up on the car.
We recently replaced the purge flow valve, and everything seems to be running fine - there is no visible cause for the error, and I've even tried making sure I get the fuel cap as tight as possible.
The code is not popping up constantly - this is only the second time it's come up since the misfire was fixed(without obvious symptoms I always clear a code once just to make sure it wasn't a computer glitch), and the first time it popped up on it's own was the day after I fixed the misfire. Need to know what to check to find out what's wrong and, of course, how much priority I should place on fixing this issue.
View 5 Replies
I've got a 07 accent with 90k miles on it. It has recently started slipping some (revs high, while in gear, without accelerating, especially in 5th gear). It also can be physically hard to move the shifter into gear sometimes (with my hand).
So, does this mean I need a new clutch? Or are there other possibilities? Should I replace/fix anything with the clutch? Sounds like the flywheel should be resurfaced? Will it shift more smoothly after the fix?
Is this something a newb could do himself? I can change the oil, rotate tires. Outside of that I haven't done much. My toolset for now is fairly limited: two jackstands, a trolley jack, torque-wrench and ratchet sets.
View 12 Replies
I'm experiencing a really annoying issue with my 2007 3.3L sonata. Whenever I am making a right turn (with the breaks applied), I hear a knocking or "popping" sound from the driver's side front end. It's not a single "pop", but multiple "pop"..."pop"..."pop". The noise does not occur when making a right turn without the breaks applied, not does it happen when making left turns. Also, during a right turn, if I release the breaks, the sound will immediately stop. The car only has 64k KM (about 40k miles).
View 4 Replies
have had this car for 2 years with out any problems whats so ever. Drove home from work today parked in drive went to leave again and transmission is stuck in first will not shift.
View 10 Replies
I have a 2001 Hyundai Accent GL the reverse gear went out but all the forward gears work. Ive been told that I need a new transmission. I found a great deal on a transmission from a 2007 Hyundai Accent. Will this transmission work in my car?
View 1 Replies
I am having a few issues with my 2001 accent. I bought this car for around 500 bucks after my friend hit 3 deer with it. At 101,000 miles the transmission went on it and he had it replace with a new one. At about 113k he hit his third deer and parked it. I bought it off him a few years later and its been running great. It died on me one time and it was the crank position sensor. Now I have about a 156k mile on it and it will not go into overdrive.
I have gotten mis fire codes, I know it needs new O2 sensors, and also P0733 Gear 3 Incorrect ratio. The button on the shifter does nothing, If i press it on or off the light does not come on on my dash. I noticed it was not going into OD this last winter if i dropped it into low and shifted to drive it would no longer go into overdrive until i placed it in park and then drive again. Ive been searching everywhere for an answer I was reading one post that it could be the TPS sensor causing issues but i haven't had time to check the voltage.
View 5 Replies
So I tried to launch my 04 accent today, but when I threw it into 2nd, all I got was engine revs. 3rd, 4th, 5th and reverse all work fine, but 1st won't work at all, and I can only get 2nd to work if I shift into 1st before hand. My question is what broke?
View 2 Replies
