Accent LC (2000-05) :: Trans Slipping Out Of 5th Gear / Drops Out To Neutral
Apr 15, 2011
It does not like to stay in 5th gear, drops out to neutral. 2001 Accent Hatchback. 1.5l 5-speed
The other day it started slipping out of 5th gear on the expressway. Held good for the first 10 to 20 minutes. Afterwards I had to hold it in 5th for it to stay in gear. While holding I noticed it pushed on the shifter when applying throttle, and let up some when I let of the gas.
I inspected the pivots at the transmission. The forward / back bushing was not installed properly by the previous owner. I rigged it up better with a fender washer and cotterpin. It previously had just a pin and the bushing had expanded out. This removed the play from shifting I had previously noticed. It also halfway fixed the popping out of gear. It stays in gear a little longer, and when I put it back into 5th it stays there for a while most of the time.
I have not inspected the lubricant level yet. Where to check next?
View 10 Replies
Advertisement
My car has started to do something odd. Whenever I am in 3rd gear, at about 2000-2200 rpm, the engine will revup 100 rpm or so and then back down (only for a split second). This only happens on 3rd gear and only at about 2000 rpm. Its a 2005 Hyundai Accent Hatchback with an automatic transmission with Royal Purple ATF. I also have a SRI and manga-flow muffler (if that makes any difference).
View 1 Replies
I just got a 2000 accent. The problems is that sometimes when I shift into 2nd and 3rd is notches sometimes. But it does not do it when i shift down. Also if I shift fast it will occur less often as when I shift low. When my friend drove the car it didnt do it for him. So maybe it is how i drive or something. I make sure the clutch is down all the way.
View 7 Replies
I've got a 2003 Accent and my automatic transmission went out, no reverse and the only forward gear is 1st. Was thinking of pulling it and swapping it for a used, but I have been reading on here the many, many automatic transmission problems of the accent and my next thought was to just rebuild it myself. But now I'm thinking more along the of a swap from auto to manual, as I don't want to have to rebuild a transmission that is only going to have to be rebuilt again anyway. As far as stuff like the clutch pedal, linkages, gear shifter, I can get those pretty easily. Does the Accent have a hydraulic clutch?
View 2 Replies
I have an 06 sonata 4 cyl automatic.Today the transmission was slipping in first gear like the car was revving in neutral.Then after restarting the car it was completely normal. Code P0731 showed up.
View 1 Replies
So ever since I picked up the truck from getting the springs swapped out the tranny has started to slip more and more. It's about at the point now where it does it at the 1-2 and 2-3 gear change every time unless I give it a little throttle so it shifts harder. It's just the normal shifting pause and then the slight jerk when the next gear starts. Time to a new torque converter, or am I looking at getting my whole thing rebuilt? If it's the converter I can give that a shot myself but if I have to have it rebuilt it's going to have to wait until January or February.
View 14 Replies
I have a 99 Ranger 3.0L automatic, ext cab, 2 wheel drive. Door sticker show code "T" which I looked up as the 4R44E. The trans seems to be slipping in 1st and 2nd. Thought it was "reared shudder", from a "limited slip" differential but mine is not limited slip. just the regular 8.8 with 373 gears.
Wanting to know what if any options I have for buying a new / rebuilt tranny? I've seen where depending upon the year and motor, Ranger can have 4r44e, 4r55e, 5r55e, etc.
View 3 Replies
I've got a 07 accent with 90k miles on it. It has recently started slipping some (revs high, while in gear, without accelerating, especially in 5th gear). It also can be physically hard to move the shifter into gear sometimes (with my hand).
So, does this mean I need a new clutch? Or are there other possibilities? Should I replace/fix anything with the clutch? Sounds like the flywheel should be resurfaced? Will it shift more smoothly after the fix?
Is this something a newb could do himself? I can change the oil, rotate tires. Outside of that I haven't done much. My toolset for now is fairly limited: two jackstands, a trolley jack, torque-wrench and ratchet sets.
View 12 Replies
2002 CAvalier 2.2 automatic with 123'000 miles. I was asked to look at this car for a slipping trans problem.
I drove the car about 3 miles and in 1st and Reverse it feels normal, even on a steep hill, but once it shifts into a higher gear the trans slips and you can go only about 15mph.It is shifting, because if you move the shifter into a lower gear while traveling....you can feel it downshift.
There is a code of P0502 Vehicle speed sensor. and there is no Trans fluid visible thru the filler cap on the trans top.
Previously someone else worked on this car for the slipping trans....changed some sensors....but couldn't fix the problem. The owners don't know what parts he replaced. He works for a Tire outfit and I've known him to lean towards used parts a lot.The previous mechanic convinced them that it needs a new Cluster. I presume he means instrument cluster.
I have a feeling that he just threw parts at it hoping that something would stick.
I presume that he replaced the VSS, and it didn't cure the problem.Come to think of it....the code could be from before the other persons work. I should have cleared the code and test drove it again.
I'm looking at dropping the pan, replacing the filter, refill the fluid, and replace the VSS
My questions: Could a instrument cluster have anything to do with the shifting problem.
Is the level of trans fluid supposed to be above the ledge under the filler cap, or is there a "full level" plug in the side of the trans. If he replaced the VSS with a new one....and the fluid level is good....whats my next step.
View 15 Replies
Here's my transmission problem. 2007 f150 crew lariat 4x4 with a 5.4
When my driving conditions force me to cruise at the 28-30 MPH range my transmission often hunts for an upshift, like a slipping gear hunt then it hits in firm. It must be from 2nd to 3rd gear I'm thinking. It doesn't occur at all if i am accelerating through this gear or past this shift point. under normal acceleration through and past this speed or shift point it is as smooth as can be.
I often drive some flat but winding dirt roads out in a forest area near my deer camp and it seems this is where I settle into a speed of 28-30 mph for several miles at a time. This is where it happens, the transmission seems to begin to shift but seems to slip or hunt for that next gear then it hits in fairly firmly.
Truck has 83k on it....
View 4 Replies
it's a 2000 honda civic EX. I pulled into a parking spot and slowed down, then decided to speed back up and when I accelerated it was like the car was in neutral. No gear would drive. Turned off the engine and re started and it shifted and did fine then about a 1/4 mile down the road the same thing happened. It just switched into neutral. The transmission fluid is full and clean and the filter has been changed. There was no warning signs at all.
The only caveat I can think of is last week at 15 mph my front passenger wheel fell off after someone replaced a tire. I traveled less than 10 feet on the wheel. But didn't think the transmission would be low enough to hit the ground.
At first I thought transmission clutch but it would be doing it in one direction? Then I thought maybe a pump? Or could it be a sensor or the torque converter.
View 6 Replies
my 2000 Subaru Outback Manual Transmission is stuck in neutral. I thought it might be the clutch so I pulled it out of the car and checked the clutch linkage etc. With the transmission fully removed from the car the shift lever does not move at all. My question is, if the transmission is fully removed from the engine should the shift lever function?
View 6 Replies
I was driving my 7.3 down the road and it started acting like the trans was slipping, it revved up and tried kicking down a couple times and when I slowed down and went to speed back up it just had no power coming through the trans to the wheels it just revved. I put it in neutral and it idled up for about 5 seconds. I put it in park n shut it down. I fired it back up after looking everything over and it moved about half mile down the road and no power to the wheels again. The trans is full of fluid, is there a sensor that could of went bad or just the torque converter or the entire thing shot? Only owned my truck 6 months has a trans and motor swap already from previous owner. 180k on current motor n Trans. 382k on my truck. t6 4" turbo back banks exhaust only mods I know of.
View 11 Replies
I have a 2014 f250 with the 6.2 and just turned 13,800 miles. I tend to drive in tow haul a lot, while not towing because I like the shift pattern better and saves on brakes while stopping. Last night I slowed to a stop sign, came to complete stop. Went to take off slowly like always and the truck was like in neutral, looked down and the indicator showed 5th gear. Let off and watched it go to 1st and took off no problem. This all took only half a second or so, seemed fine after that. What might of happened?
View 3 Replies
2004, 3 door Accent, 150K miles. This has been going on for many summers now (had an idea when driving from work). Well when I got home from work, gauge still read E, turned the car off, then back to ACC, still read E.
Opened the fuel cap, didn't hear any hissing noise or any indication that there was alot of pressure build up, put cap back on, turned to ACC, and gauge read normal.
So after a long story my question is this, is there a pressure regulator that when it over pressures, lets it vent, and what is it called and where is it located? I am thinking that regulator might be stuck closed.
View 1 Replies
2008 Hyunda Accent, 5 speed, with high mileage. She claims it slips out of 5th gear when she's driving. They're on vacation, the car is in the shop, the shop is saying that it can't find the problem...
Apparently it slips out under load (in constant motion).
It seems that it only occurs when the transmission is hot, meaning the oil has less viscosity. The dealership apparently is saying they can't find anything wrong and she isn't making it up since she said she drove from Michigan last week with her hand on the shifter the entire time to keep it in gear. Dealer is saying they aren't going to just drive it around and around until it happens.
How modern cars are built these days. I know older cars had some synchro things that would wear and allow the shifter to pop out of gear, but I read that some Hyundais have cable driven shifters....at a loss.
It happens in 4th sometimes, too, and will also pop out even when leaning on the shifter.
I did see this thread, but was wondering if there was any additional information: [URL] .....
View 3 Replies
i have accent 2000. RPMs goes up when car is in neutral. Why is this?
View 3 Replies
I have a 2008 Accent (base model for the most part, no C/C), and my transmission seems to be slipping a bit. The symptoms are: slow acceleration, a delay in gear shifting, and after the 30MPH mark, it takes forever to get up to anything near 60. I just wanted to know if it's a simple solution such as topping off the transmission fluid, or if it's a bigger issue.
View 5 Replies
So I bought a 2000 Hyundai Accent for my 16 year old daughter and the guy sold me a car that has a slipping trans. So I went to the Autozone and had the codes pulled and it was a P0734 code. I replaced the trans fluid and replaced the internal bearing and shim with the 42220LK kit from whatever it takes transmission parts store. Trans still slips. What else or should I just unload it?
View 3 Replies
I have a 2004 Hyundai Accent, has 167k miles on it. Transmission has 80k, put in at about 155k. Came home from Tahoe, and the next day, I tried to go to work, and the gear shift was stuck in first. Hadn't had the money to get anything fixed, but when I finally got it looked at, was told I needed a new clutch and possibly a new flywheel. Been cleaning it out to sell, and today I started it up and realized that the stick is in neutral and moves back and forth freely, but the transmission is in gear. I know that, because I had to keep my foot on the clutch to keep it running. What would cause that? I'm hoping it's something easy and cheaper to fix, because I love this car and am not ready to part with it just yet. The clutch doesn't have that many miles on it either, maybe 10-15k, if that. I've had the car for almost ten years, so it's not poor driving, on my part.
View 6 Replies
Just the other day I was driving my car till I've noticed the gears started slipping. At first it was having some issues shifting through the gears (automatic transmission btw). As soon as I got off the highway, I parked in a parking lot just to check underneath the hood. Everything looked fine, went to pull out of the parking lot, no reverse. The gears started to slip up really bad. I noticed that the RPM's kept on reving up and wouldn't go any faster than 20mph. I went to an advance auto parts to get automatic transmission fluid. Still having the same issue and no reverse either. I had to park the car at a location to get it towed back to my house. Some people are saying my transmission is bad, some say it could be a real simple fix. Where to start diagnosing this issue. The car was driving normally until last Monday. My question is where should I start to check and what can I do to see if the transmission is completely shot??
View 33 Replies
