Driving home in my 04, and it just died, no caution lights, still have battery power, and starter is engaging but engine wont catch, like no fuel or spark. Found no burnt out fuses, and checked the fuel pump relay. Pulled out the back seat, turned key and heard the fuel pump, so that is working, replaced the crackshaft position sensor, still no engine start.
Over 130k miles, 1.6l
The car has 175,000 miles on it and is having issues starting but only sometimes. The starter turns over but the engine doesn't catch. Usually if I open the hood, pretend to know what I'm doing, and wait a bit, it will start within 10 minutes or less (sometimes it takes a few tries.) I hear a click when the starter is going and the engine isn't catching, very much like the click I hear if I'm driving with the AC on and the AC needs to draw power. I've recently had a tune-up including new fuel filter, spark plugs and wires. The mechanic can't figure out what's wrong (doesn't seem to be the battery or the battery terminals). The car even started up FINE at 40 below. I can't really see a pattern to it.
View 3 RepliesMy daughter has a 03 Accent that within the past week will not start at certain times. Some times it will some times it wont. It always cranks but doesn't catch. If she tries to start the car and it cranks, but doesn't catch, if you wait 15 -20 minutes, or longer, it will turn over and run fine. We are thinking crank position sensor or possibly fuel pump...
View 4 RepliesSo about a week ago I noticed that my 2006 6.0 with 240k miles smelled like antifreeze. I popped the hood and noticed my dega tank was empty. I added coolant to halfway between max and min. A couple days later discovered coolant had dropped to just below min fill. Went to start it this morning and the starter won't engage the flywheel. I hear the relay click and the starter is making a whirling noise. I figure I will try to manually crank it to check if it's the fly wheel. If it's not that I guess I will take the starter to get tested. And if that's not it.. I guess a mechanic.
View 1 RepliesZERO problems except that car consumes oil.
I drove around a corner and hit a minor pothole.
Engine rpms went to zero. I pulled over and car would not start. Starter is so quiet I thought it was not engaging.
I put a chalk mark on serpentine belt and it is turning but the engine shows no sign of wanting to start...no spark I suspect.
I see no blown fuses.
The car has been well maintained and has 250k miles mostly highway. 2.4l LE...
I Have a 1998 f150 4.6 XLT and recently it has been starting on and off. sometimes i will try and start it and wham! it starts right off. then other times I just here the starter hitting and engaging but nothing. Replaced the starter, solenoid and still nothing. It does have an alarm system but the alarm light doesn't come on, also had battery charged and its working fine. I am really fed up with this beautiful looking POS. Oh and the wiper motor needs replace.
View 5 Repliesl have a 2000 model accent and the air conditioner compressor clutch is not engaging . you press the 'AC 'button and the indicator comes on when a fan speed is selected which l am sure is the correct operation.l checked for 12 volts at the coil terminals of the relay and there is no 12 volts.l shorted the switch contacts of AC relay and the compressor did engage so the wiring from the relay base to the the compressor clutch is ok. l also checked the contacts of the 'AC' switch itself and it seems to be ok. l haven't had much luck with sorting out the wiring from the switch to the relay as l do not have a wiring diagram.
View 4 RepliesPicked up an 02 Accent with 97K for local use. The brake pedal went down half way before engaging and hardening. Front brakes were good. Rear shoes were worn and had a leaking wheel cylinder on the right side. Changed the shoes and both wheel cylinders. Bled the rear brakes with the engine off by pumping the pedal slowly and opening the bleed to make sure I got no air in. Pedal got hard just off the top and the shoes hold the brake drum tight.
Now, turn the engine on and the pedal goes all the way down before it grabs and gets hard. I was going to bleed again with the engine on to see if that makes any difference. Can't see that it's the master cylinder and the car has no abs.
I have a 2001 Accent with a 1.6L engine. My son drove it yesterday with no problem. This morning when he tried to start it we would get a click from the starter when he turned the key and that's all. Tried jumping it. That didn't work. So I jumped to conclusions and replaced the starter. I have the same problem. Click.
I have taken the old starter and the battery to AutoZone and had them both tested. They both work fine. (They'll let me return the new starter if I want to remove it). I've cleaned the battery terminals and cable clamps. I still get the same click. What I did notice tonight after all of this is that when I turn the key the cable end/terminal clamp on the positive terminal SMOKES!
Went to Advanced Auto to get the battery tested since it takes a few cranks for the engine to start. I thought it was the battery but after testing the battery they think maybe its the starter because the battery and alternator shows that its perfect.
I will also be taking the car to get the timing belt and drive belt replaced and the spark plugs and wires. I just want to know if you all think its the starter or should i check anything else.
I have a 91 RS 3.1 with a 5 speed that is not starting.
The problem started with the key not engaging the starter at all, a friend who is much better at electrical and we found the security relay switch behind the kick panel is not engaging on it's own. we manually engaged the switch and now the key will spin the starter but the engine is not firing up only spinning.
does the security relay switch control anything other than the starter engaging.
There is gas in the car. using a screwdriver and spark plug wire we have verified that we are getting spark.
2012 Santa Fe all of a sudden won't engage starter. First thing in morning it usually cranks. But once I turn it off it won't crank again. When I turn the key I have full power so it's not the battery or terminals. There's no cracking or popping sound, just a whine like the starter's not engaging. Never had any problems with this car so far. I'm thinking maybe it's the starter solenoid.
View 5 Replies2003 santa fe, automatic, front wheel drive, 4 cylinder.
I had problems with the starter not cranking. took it off to the auto parts store and tested bad. I bought a new one there from called a tough one brand name. put it in, and it grinds the flywheel and sounds like it does not engage the flywheel enough. to it back to the auto parts store, and tested it, and it seemed like the gear did not shoot out like it should. they replaced it with a second starter now that tested good before i left the store, put it in and it does the same thing.
1. Can this type of starter not throw the gear far enough into the flywheel ?
2. Can a voltage drop to the starter cause the same thing. Basically is it possible my wires are bad not throwing enough juice to throw the gear all the way forward.
I pulled the starter out and jumped it with the battery and it seemed to work fine, but on the car it just grinds.
I have determined that my starter is not engaging on my car 4.2 phaeton. I removed the 433 starter relay and tried to jump the contacts to engage the starter. I get a small flow of current when I do this but no engagement of the starter, only a very faint click. Not a click like when you engage a normal solenoid. It may be a bad solenoid or a bad starter motor. I cannot reach the terminals on the solenoid to check my connections. I have read somewhere that the manual states that the engine removal is required. I tried knocking on the solenoid with no results.
View 12 RepliesI have a 2010 Accent with 106 000 km on it (Canada). A couple months ago (just as warranty expired) the car would not start. Nothing. Engine would not even turn over. Just a click of the starter solenoid. battery had a load test and is fine. Removed negative battery cable and cleaned the cable where it bolts to the body under the battery tray. Battery terminals were both cleaned at the same time.
Things worked fine for a couple weeks and the problem is back but worse. Everything in the car works fine when it won't start. If I continually turn the key to the start position it will eventually start to turn over and start fine. Sometimes it takes 20-30 turns of the key till it turns over and starts. When it does turn over and start, the engine turns over fine at the normal speed. Not slow like a weak battery.
Dealer is useless. Had a coil go a couple months back just before the warranty expired and they told us that the reason the coil went was that the car had been rust proofed by someone other than Hyundai.
I have about 26,000 Miles on it, this afternoon I tried to start it. The starter engaged and turned over and over and over, but the engine wouldn't start. Then I took the key out, waited 5 seconds, and tried again, it started. It was about 60 degrees out, so it wasn't cold. Half a tank of gas.
This may seem a little petty, but its a 2012 with only 26,000 Miles on it.
I have a 2008 Accent, automatic, with 167,000 mostly city kilometers on it. 3 times, yesterday and today, when I turned the ignition on it sounded like it was going to start but didn't catch. When I tried again the second time it started. At first, I thought I just didn't turn the key to the right long enough but with it happening 3 times, I am not so sure.
I called my mechanic and he thought it might be the fuel pump. He suggested I turn it to the right then back 2 times, then start it the third time. I have spent a lot on it lately, new tires in April, transmission fluid, also had to replace the tie rod on one front wheel and bearings on the other. If it is the fuel pump, what happens if I don't replace it soon?
I have a Toyota 87 pickup that have been working great for the longest time. Now there is a problem and I need to fix it. It is a problem with the ignition switch I think but I am not sure. When I put the key in and turn it to 1st position I can hear the electrical system turn on, as in the little hums and noises that the electrical system does on a car this age. The next position where the starter motor would engage is however silent and non working. If I where to have a bad battery this is where the relay would go tic-tic-tic but there is no sound what so ever. So Im thinking maybe bad switch, or bad relay? How do I test this the easiest. Toyota got a r22 in it.
View 9 Replies1996 SILVERADO TRUCK. Starter solenoid doesn't engage when temperature is below freezing....
View 11 RepliesI have a 2007 Jeep Compass. Driving on the freeway heard loud whine - like the starter engaging. It stopped then started again. The jeep then died. Had it towed to the shop. Starter was "melted" and was replaced. Two days later the same thing happened.
View 2 RepliesMy 09 LS w/ 65k on it wont start. last night i drove the car around to several places, and on my last stop of the day i couldnt get the car to start. finally after several tries, it fired right up. but today, no such luck.
All the lights come on (and I have charged my batery with a tender to be sure its not the battery), the steering wheel moves in to position, and I either get a click, or a buzzing sound.
Sounds like starter, any other opinions?