Accent LC (2000-05) :: Squeak When Releasing Brake Pedal
Sep 21, 2011
2004 Accent 1.6L 5spd
Purchased this car used with 64k miles on it. I am in the process of performing the 60k miles service items and going through typical replacement of worn parts.
I have noticed that my rear passenger brake drum assembly squeaks when I let off the brake pedal. Note that this is not noise when applying brake pressue, but after releasing the brakes. Additionally, the drum happens to be rusted very badly. It took a good amount of brute force to remove the drum in order to inspect the brake assembly. There was a lot of brake dust built up and I thought that cleaning that out would get rid of the noise.
I suspect it could be one of the springs but I cannot be for certain. The squeak does not occur when I release the parking brake.
View 3 Replies
Advertisement
Started a few months ago didn't really bother me until now. Started when I would forget the parking brake is on and would just put the car in reverse & wouldn't move until I released the parking brake. Did it about 5-7 times and now every time I brake without the parking brake on, it squeaks & is really annoying. Is there any way to fix this or is it just gonna be complicated & expensive?
View 10 Replies
The squeak is most pronounced when the brake pedal is released, but it still makes a quieter squeak when the pedal is depressed. I can't tell which side it is coming from; my guess is the middle of the rear or the left rear. I can't tell because I have to be in the car to release the brake (I guess I could tie a string around a brick and pull on it when I'm by the rear wheels). I should mention that all three of the belts are due for a change. Which part is causing the brake system squeak? The brakes work; replacing the squeaking part or parts is going to be lower on the project queue than the CD player/radio errors and replacing the belts, pulleys, etc. in the engine compartment (I've posted elsewhere on the forums about those issues).
View 5 Replies
I had 2 brake related issues. First was a honking noise when pressing/releasing the brake pedal (covered by T-SB-0363-10, attached below). Second was rear brake squeaks, particularly when backing up (T-SB-0102-11, attached below). I had the squeak issue repaired under a previous TSB a few years ago, but the noise came back after a while, and the updated TSB includes replacing the pads and other parts.
View 8 Replies
On releasing the clutch pedal, a creaking noise can be heard, which:
- sounds and feels like a rusty spring being unloaded
- occurs for the entire range of pedal travel, but worse near the bottom
- is louder outside the car than inside
- happens not only when driving, but also when stationary with the engine off
I don't think anything is wrong with the clutch itself, or any bearings, or major components... It just feels like something needs to be lubed. I've lubed the spring above the pedal inside the car, with no real effect.
View 4 Replies
I have a 2005 Murano, 96K.
In Aug 2011, I had the rear disc brakes/rotors replaced. Front ones were replaced in Feb of this year.
For the past month, whenever I release the brake, I hear squealing (no sound when I press the brake to stop). Last about 5 secs, or until I hit about 15-20 MPH. Seems to happen only after the brakes heat up. I've tried to "Google" the answer, but the answers are mostly for drum brakes.
View 3 Replies
My daughter has bought a 2003 4 door accent and on the way to work she lost most of the brakes. I could not see any fluid leaking and the level was ok. I did try pushing on the brake pedal with my hand and it was making a noise like a clicking? I was thinking it was just the brake light switch but not sure. The place she bought it from put new brakes on it when the driver side was getting really hot. I am thinking maybe air in the system? It sounded like a caliper was sticking when I test drove it but only a couple of times. You would have some brakes but you had to pump the peddle.It is in a parking lot right now but I can work on it unless it is some sort of different? I am going to try to bleed it in a little bit but was thinking I should ask around. I read that the piston could be sticking but can you just rebuild the master cylinder to fix it if that is what it is? I could pull the pedal back a little bit. I only looked at for 4 or 5 minutes kinda dark and no tools with me.
View 10 Replies
Picked up an 02 Accent with 97K for local use. The brake pedal went down half way before engaging and hardening. Front brakes were good. Rear shoes were worn and had a leaking wheel cylinder on the right side. Changed the shoes and both wheel cylinders. Bled the rear brakes with the engine off by pumping the pedal slowly and opening the bleed to make sure I got no air in. Pedal got hard just off the top and the shoes hold the brake drum tight.
Now, turn the engine on and the pedal goes all the way down before it grabs and gets hard. I was going to bleed again with the engine on to see if that makes any difference. Can't see that it's the master cylinder and the car has no abs.
View 1 Replies
I get a clunk noise when stepping on and releasing the brakes occasionally but not always. This occurs even with the engine off and the vehicle stationary. I also hear some other noise like some sort of vacuum servo thing is happening.
View 4 Replies
Bought a 2004 GX470 a few months ago. Took it into the local Toyota dealer for oil change (40+ miles to nearest Lexus)
They told me I needed to replace front brake pads, so I did that. Immediately after they finished I noticed what I would describe as a clack or clank sound when pressing or releasing the brake pedal.
This sound was not there before. I went back inside and told them, the tech came out and listened and said it would probably go away. I took the car back in a couple weeks later and they applied some type of lube which didn't work. The service rep said that the only way to remove sound was to replace some type of pin.
View 14 Replies
2000 Dodge Neon clacking noise at low rpm after releasing gas pedal. Around the 2000 rpm range letting off the gas produces a clacking noise. I have listened to the engine with a long screwdriver at idle and revving. The noise is not always present in this condition. Although when it has come up it seams to coming from behind the engine. Does not seem to be valves, connecting rod or main bearings etc.... Only at low rpm 1200 thru 2000 rpm WHEN releasing the throttle. Clacking seams to be timed with the crankshaft as it reduces the sound as the engine reduces rpm, not at the speed of the cams. Sounds fine at idle, going through gears and at freeway rpm's.
View 1 Replies
I own a 2000 Hyundai Accent with 85,000 miles on it. I recently took my car into a local shop because the pressure on my brake pedal was extremely low. I was almost pushing it to the floor. On my first trip to the shop, they replaced the rear wheel cylinders because they were leaking. This replacement didn't fix my problem.
On the second trip to the shop, they replaced my master cylinder. I did call around to other shops to do a price comparison and the price was reasonable on both jobs. This work was done about two weeks ago.
At first, this seemed to fix my problem, the pressure was perfect. Since then I've been having an intermittent problem with the brake pedal pressure changing. It would get a little hard during driving, but would correct itself after a few moments. I don't drive that often or very far, so I was waiting to see if the problem would get worse.
Last night it did. I went out and when I tried to drive my car home my pedal was extremely hard. I could barely push it. While I was driving my car home (I was close to home), it felt like I was driving with my brakes on. My car would stop as soon as I took my foot off the gas pedal, I could not coast. When I got out, I could feel heat coming from the front tires, which I didn't even have work done on. There was also a smell that I've never smelled before. It almost smelled like something burning.
I was told I should have my car towed back to the shop on a lifted bed and not rolled there and that they should fix my car at no charge because they did something wrong.
My ultimate question is did the shop do something wrong and should I take it back to them if they did? Should they be responsible for this new repair? I don't want to go demanding anything if it's possible this is a whole new problem and not their fault. Even though it does seem like an awfully big coincidence. My next question is: what could be possibly wrong with my car? I would like to know what I'm getting myself into.
View 1 Replies
I'm having Hyundai Accent GLS Model 2005. Since yesterday, My tail lamp and Third Brake light is still switched on even I turn off the light & I notice that my Auto door lock is not functioning even I press the Brake Pedal. I tried to disconnect the battery & the Fuse and place it back but it doesn't works. Currently, I just pull out the fuse.
View 6 Replies
2013 accent auto My car rolls noticeably after parking unless the ground is completely flat. Parking brakes prevents it from rolling but I don't use parking brakes every time. Another brake problem I have is thump or clunk noise I get whenever I release a brake from stop.
View 12 Replies
2000 Mercedes A-class, currently 190 Km, purchased 7 years ago with 90Km, all maintenance on time, as recommended.
If the car sits a day, no problem. If it sits a few days, then when releasing the brake and trying to move, the car lurches a bit. The longer it sits, the worse it seems.
Is this the back drums, as the dealer tells us, or is something else wrong?
View 2 Replies
I love my V8 Treg...one squeak that is troublesome...quickly releasing the brake pedal causes an annoying squeak... what I might do to resolve the issue?
View 1 Replies
I have a 2015 IS250 F Sport with brakes that squeak. First time dealer said can't replicate and suggested hard braking to burn off any residue on rotors. Second time, dealer replace rear brake calipers which resulted in mix match colors of the brake caliper and bracket. Not happy.
Well it's starting to squeak again. Not sure if moisture and or cold has anything to do with it. Washed the car yesterday and as I was moving it down the driveway (small incline) the brakes squeaked as soon as I released the brake pedal. I was able to replicate this several times yesterday.
This morning brakes squeaked as soon as I released the brake pedal. Not on an incline driveway today.
View 8 Replies
A few days ago, while on a road trip from CA to CO, I noticed a loud squeak from the engine compartment every time I pushed the brake pedal, no matter how lightly, no matter what speed. It even happened when the car was off. I have almost 60K miles on my '05.
When I arrived in Denver, I dropped the car off at a Toyota dealer for troubleshooting. They isolated the fault to a bad ABS actuator. They had to overnight the part, and spent a day and a half installing it. Sounds like a major project!
View 2 Replies
I have recently purchased a 2007 Gen 2 Prius and sometimes it emits a very annoying squeak. It occurs when the car is stationary, with the brake pedal fully depressed. When inside the vehicle it seems to be coming from behind the glove box. When on the outside and facing the car it seems to be coming from below / behind the electric motor. I have made a recording of it with the noise in question being audible for a couple of seconds at 0:13, and then again at 0:22 until the end. It could be nothing I guess, but this is my first hybrid and I am not too sure what is perfectly normal and what is not.
View 14 Replies
I'm getting a pulsing. High-pitch squeak from what sounds like the left/front wheel when making left turns and occasionally driving straight at low speeds after a left turn, usually while NOT applying the brakes. In fact, applying the brakes firmly stops the sound until I release the pedal. After that, sometimes it comes back immediately and sometimes not.
Two weeks ago I replaced the R/F cv axle and the sway bar link. Harder job than it should have been because I had a heck of a time getting the lower ball joint bolt free.
This past weekend, I replaced both front rotors because I was certain that one was warped since I was getting a very loud pulsing squeal only when braking. I also have had a tendency to over torque the lug nuts which I had read can cause warped rotors. I now use a torque wrench for that.
I've made sure that the rotor shield isn't touching anything and checked the pads for damage and unusual wear. Pads are at about 75%.
View 1 Replies
I had a question about a weird symptom that my 2008 BMW 528i is having. When I take my foot off the gas pedal when I'm going 10-30 mph, the car seems to brake/stall momentarily. It almost feels as if the car is jerking for half a second. If I slowly let off the gas pedal this doesn't happen. It also doesn't happen at high mph.
My dealer said this is normal but I have never experienced this in all my time driving a Tacoma or accord. Wondering what could possibly be wrong with the car.
View 7 Replies
