I am getting a code for my 2003 Accent (65,000 miles). The code is P1401 and it is telling me the fix is replace Evaporative Emissions Canister. I asked my mechanic about 2 months ago about this and he wasn't too concerned.
We are not in an area where they do Emission testing. I will be driving back home to WI . and want to know if I should be concerned. The round trip is about 900 miles.
This began as a troubleshooting exercise for a P0442 code (2002 model) indicating a leak in the evap emissions system. Often caused by simple things like a loose/poorly sealing filler cap. Not this time
It's a neat design, tucked away up in the fender well. Even sports a very effective stone guard (plastic shield) which hides all that tubing from view. But the shield also traps all the road salt and mud and packs it into the crevices between the tubes where it stays from one winter till the next. Even a powerful car wash probably can't dislodge the caked on mess once solidified.
I am getting error code po457 Evaporative emissions error, I am told the canister purge valve could be bad.
View 4 RepliesI drive a 1999 Subaru Legacy Outback.I had a cracked evap canister, so I went to the junkyard and grabbed another. I installed it, but had problems filling the gas tank. It would fill a few seconds, then shut off. So, I got home, pulled the evap canister, and blew through each of the three ports. Two of them had air flow in and out to each other, the third was blocked. Checking the ops diagram, looks like that port runs to the intake manifold. Should it be blocked (has a check valve or something), or should it have airflow?
View 2 RepliesWhen I got my 60K service last weekend, the dealer called me and explained that I had a "very small internal leak fro an emissions canister that was leaking into the intake/manifold". He said something like that. He also said that it doesn't do anything to the performance of the car, but that the leak will increase over time and will throw a MIL.
View 6 RepliesMy check engine light has came on and I received these error codes
PO441 : Evaporative emissions control system incorrect purge flow.
PO 455 : Evaporative emissions control system pressure leak-large leak.
PO 446 : Evaporative emissions control system vent control circuit fault.
Also only my driver side fan is working, may be separate issue?
I have a 2000 Passat 1.8T. When I start it up in the morning I hear a loud obnoxious noise like a vacuum leak from the engine compartment. It lasts for about 1.5 minutes then runs normally. After about a minute it starts up again and only last for about 7 seconds...ish. When I drive it afterwards, less that a half block or so, the CEL light goes on after 1 beep. Also, at that time I get a messages from the instrument panel that says "Emissions Workshop 1". I've read that it could be a simple damaged vacuum hose to the secondary air pump. Definitely a huge price difference to repair.
This morning is was colder outside than usual and the dash kept beeping and flashing the "Emissions Workshop 1" code intermittently.
I need to replace the rotors and calipers on my 04 accent gl. I noticed there are 5 bolts on the back of the caliper. I know one is for the flex hose connection. Then there are 2 big hex bolts closest to the dust plate. Are those for the caliper mounting bracket? and if so will they need to be removed? Then the final two are on the outer edge, however the top one is rounded and rusted, is this normal? The one on the bottom is a hex. So what needs to be removed to change the rotors and pads? I also notice that there are two screw holes in the rotor, that I guess snug it in place against the hub, however the screws are missing. Is this bad? are they needed? and if so can I get new ones?
View 10 RepliesJust bought a 2005 accent yesterday. I new the bulb was gone, when I lifted the bottom noticed that the battery is so close to the lights I can't get my hand down there. Do I need to remove my battery to replace this bulb? Also what is the model # of the bulb?
View 2 RepliesMy 2000 Forester has 96,000 miles on it. A few months ago, the CEL came on. At first it would turn off every couple of days but would eventually pop back on. I first thought it was tied to putting gas in the car, now I think it was just a coincidence.
Over the past two months, I have replaced the catalytic converter with a aftermarket piece (done by a mom and pop muffler shop) and replaced the front o2 sensor three times. The first two times, I used Bosch sensors from an auto parts store and had the code cleared. After about 50 miles the CEL came back on. Just yesterday, I picked my car up from the dealership where they installed a Subaru fron o2. After about 30 miles, the light is back on again. Code is P0133 - heated oxygen sensor, bank 1 sensor 1, circuit slow response.
Now, the dealership is suggesting I need to replace the catalytic converter with a Subaru converter before they can source the issue.
Ok had a check engine light. It directed me to replace the IAT sensor.. After some research I found it was integrated into the MAP sensor. Purchased a new sensor and replaced. Drive about 15 miles CEL throws another code. P0106 (sensor i just replaced) faulty Map sensor.
Followed procedure to replace sensor.. unhook battery cable reset ecm. After reset engine is hard to start. Followed by RPM changes (assuming its the ECM re-adjusting). Then CEL flashes 5-6 times and goes out, Drive 15 miles. Map sensor code reappears. (note i only purchased one sensor But repeated install 2 times).
My thought is against wiring. since the codes refer to different signal wires one for IAT one for MAP sensor. Faulty replacement sensor?
2002 Accent 1.6L
Got an engine light on today and had it checked at Advance Auto. It is P0442, "small leak in Evaporative emission control system". One article I read said to remove and retighten the gas cap, clear the code then see if it occurs again. If it does then replace the gas cap with a new OEM cap, and try clearing the code again to see what happens, as a first step in the troubleshooting process. I retightened the gas cap, but don't know how to clear the code and turn off the engine light.
View 3 RepliesI have a 2009 ford f150 4.6l 3v v8 standard cab with about 53k miles on it.
Recently the check engine light came on so i went to autozone to have the codes pulled for free, it says i have a small evaporative leak.
They said may be the gas cap, but the thing is, i have a quick fill cap that came in stock with truck so the gas cap isnt even needed.
I've looked under the hood, and noticed that there is little pool of oil on top of the valley of the engine on the passenger side of the engine, could it possibly be the PCV hose that is bad and be related to the evaporative leak code? or its unrelated and i have a bad gasket for the valve cover?
It isn't affecting the performance of the engine,.. yet. I have a road trip for my work coming up very soon and i wanted to try to fix it before then.
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
I have had issues for over a week now first problem check engine light not sure of the code but the mechanic said it was the spark plugs and vaccum leak hose (which I knew about the hose). $205.00 later replaced all 6 plugs and hose. Now today on way to work I'm getting that hesitation when in lower gear such as stopping and then accelerating it jerks some it was doing this alot before replacing the plugs.
We did a diagnostic code reader and it said the code P2402 I did read it could be my gas cap which I don't have a dealer gas cap on there now I did about 1 yr 1/2 ago but got a lock key gas cap instead. I have been doing some reading I would need to replace leak detection pump which apparently costly in repair.
BTW car has 119,000 miles I commute far from work 5 days a week. My car is very important part of my life! I did also read someone stated there was a recall on Mazda 6 wondering do I need to call the dealership to see if this is actual recall and I can cross my fingers get this fixed on them.
1997 Grand Prix GT N/A. 175,000. I keep getting this code about once every two weeks. I'll clear it and doesn't come back until then. I've had passengers in the back seat smell gas so I'm suspecting the vapor canister. Would a leaking canister set this code off? I checked all the vacuum lines to the purge solenoid and seem fine. Is the canister in the drivers side rear wheel well? I need to get in there and check if it's leaking. I'm having no driving issues however my gas consumption seems to be a bit more than usual. I checked the FPR and no fuel contamination.
View 2 RepliesI own a 98 f-150 5.4 with 70,000 miles. I get a check engine light (code p0455-large leak detected in evaporative emission control system).
Replaced the gas cap with an after market 'stant' ( I believe was the manufacturer) brand. The check engine light went away for 4 days then came on again.
No obvious vacuum line leaks.... Puzzled.
Twice now I've had my fuel cap/gas cap come loose and throw a CEL regarding emissions. This is fixed by screwing the cap back on and clearing the code. There is no good reason for the fuel cap to unscrew itself so I'm thinking there could be an underlying issue, possibly pressure related.
View 2 RepliesI've been getting a P0442 periodically from my 97 850 wagon (base, no turbo). I've replaced the gas cap, the electrical part of the ignition switch, and all the deteriorated rubber vacuum-hose couplings I can find under the hood, but I'm still getting the code. I want to inspect the hose couplings at the evap canister, but there doesn't appear to be any way of getting to them other than removing the canister from under the car. Is there any other access to these?
Also, I've got VIDA running on my PC, and even though I've given it the VIN, it shows me the wrong evap canister in the parts diagrams. It shows the cylindrical canister, but my 850 has the rectangular canister. Where I can view accurate diagrams showing the evap components in this car?
My Ex is throwing a P1451 Canister Vent Purge valve issue. Is the canister for the Ex hidden on the frame above the gas tank? I looked around the frame in the back of the truck but am having no luck finding it so I'm guessing ill have to drop the tank to get to it. I've read that wire chafing for this valve could be the problem.
View 3 RepliesAn MIL light came on the dash the other week while driving. Dealer cleared the error code but next morning it returned. Car is now in the shop to have the flapper motor and canister can replaced. Get it back tomorrow, Got '08 Jetta 2.5 as a loaner. I will run out of warranty in another couple of weeks(48100 mi. on it now).
View 10 Replies