I just got a 2000 accent. The problems is that sometimes when I shift into 2nd and 3rd is notches sometimes. But it does not do it when i shift down. Also if I shift fast it will occur less often as when I shift low. When my friend drove the car it didnt do it for him. So maybe it is how i drive or something. I make sure the clutch is down all the way.
View 7 RepliesMy 1985 BMW 635, standard transmission suddenly developed shifting problem. It will not shift into 1st, 3rd or 5th gear. It will shift into reverse,2nd and 4th gear. The car is not driven on any frequent schedule, infrequently. I can't remember the last time the transmission oil was changed.There has not been any mechanical distress,grinding of gears,etc. you just cant engage those gears. They all are moving the shifter from neutral to a up position. Is it possible that sludge could be blocking the movement of the synchronize r?
View 2 RepliesI have a 2010 accent blue model with stick shift. been fine for 50k miles. Lately i have noticed an issue where i am in first gear and then when i push clutch in to go into second, the lever won't budge. it does eventually go in but it just isn't like it used to be. it happens say about 25% of the time. Since at higher rpms it won't do it but normal rpms it will.
Also, i just had a new short block installed, perhaps something is binding? If I sit in the car, stopped, i can shift into and out of all the gears perfectly. Maybe my 1st gear synchros are going?
So my accent with a manual trans has a small leak at the slave cylinder for the clutch. I am driving home and it's shifting hard. I get home pull up to where I live and push In the clutch and the car feels like the clutch is not pushed in. RPMs drop and car stalled. Look under hood and see not fluid in clutch master cylinder. Fill with fluid and pump pedal. I get some pedal back but the car will not crank. Nothing. I have accidentally cranked car when in gear in the past and there did not seem to be a safety switch as the car would move if my foot was not on brakes.
View 4 Replies2004 accent manual shift. car drives well, but when i step on the gas, it sudenly pulls to left. when i release gas, it goes back to straight driving. motor mount??? anything else come to mind??
View 1 RepliesI have a 2003 Hyundai Accent that is generating a p0713 code. I have replaced sensor and used SP3 fluid. I noticed if I clear codes everything is fine until it shifts into OD. When codes are cleared the car will not shift into OD until it hit about 60mph. The code is generated and then it shifts fine. I would not worry about it put it will not pass IM with the check engine light on.
View 1 RepliesMy car has started to do something odd. Whenever I am in 3rd gear, at about 2000-2200 rpm, the engine will revup 100 rpm or so and then back down (only for a split second). This only happens on 3rd gear and only at about 2000 rpm. Its a 2005 Hyundai Accent Hatchback with an automatic transmission with Royal Purple ATF. I also have a SRI and manga-flow muffler (if that makes any difference).
View 1 RepliesI've got a 2003 Accent and my automatic transmission went out, no reverse and the only forward gear is 1st. Was thinking of pulling it and swapping it for a used, but I have been reading on here the many, many automatic transmission problems of the accent and my next thought was to just rebuild it myself. But now I'm thinking more along the of a swap from auto to manual, as I don't want to have to rebuild a transmission that is only going to have to be rebuilt again anyway. As far as stuff like the clutch pedal, linkages, gear shifter, I can get those pretty easily. Does the Accent have a hydraulic clutch?
View 2 RepliesIt does not like to stay in 5th gear, drops out to neutral. 2001 Accent Hatchback. 1.5l 5-speed
The other day it started slipping out of 5th gear on the expressway. Held good for the first 10 to 20 minutes. Afterwards I had to hold it in 5th for it to stay in gear. While holding I noticed it pushed on the shifter when applying throttle, and let up some when I let of the gas.
I inspected the pivots at the transmission. The forward / back bushing was not installed properly by the previous owner. I rigged it up better with a fender washer and cotterpin. It previously had just a pin and the bushing had expanded out. This removed the play from shifting I had previously noticed. It also halfway fixed the popping out of gear. It stays in gear a little longer, and when I put it back into 5th it stays there for a while most of the time.
I have not inspected the lubricant level yet. Where to check next?
is it the clutch or the shifter or something else? I did have to replace the 2 shifter cables about 18 months ago as they broke, but lately, it is having a very hard time going into gear, especially 1st gear when stopped. It's so bad my wife won't drive it any more. We love our 35mpg Saturn and want to keep it running well.
View 7 RepliesI have a 2001 Hyundai Accent GS Hatchback, the car has about 41,6xx miles on it. When i drive it between 2nd and 3rd gear it shift violently, its almost like it shifts due to pressure, it also happens when it downshift too. Also the reverse went out, i can hear the pump running and it goes into reverse but when i press on the gas it acts like it in neutral. This is a daily driver for me.
View 9 RepliesI have a 2000 Accent that wont shift past third gear until the car is warm. The car has 140k miles. When I turn on the car and pull onto the high way it sticks in 3rd. I then have to slow down and drive through a small town. When I get on the other side of the small town and get back up to speed it will shift. Over drive is on.
View 4 RepliesWhy my car is grinding gear when I shift from 1st to 2nd, & yes the clutch is fully depleted and still grinds when I shift.
View 4 RepliesMy 2003 made a sharp mechanical noise one day, next thing I knew it lost the ability to shift out of 2nd gear....Now, it can still shift into 2nd gear when cold, but only after holding rpm for a bit and then suddenly jerking into 2nd gear. Once it's warmed up for a few minutes though, after dropping out of 2nd gear, that's it! Then it's stuck in 1st gear the rest of the time. Reverse doesn't work anymore at any time, and it gave me code P0732 to P0734 which should be gears 2 - 4. Is it possible that not being to get out of 1st means 2nd gear is broken, but the other 2 are okay and it just can't get shift past 2nd? Or might all 3 have problems after all?
View 1 RepliesI'm having a little issue with shifting into first. Once in a while it simply will not go in, like you're pushing the shifter against a brick wall. If I turn off the truck and turn it back on, it works absolutely fine. I can shift into 2nd-5th no problem at all times. Is it just the shift linkage, or...? I'm not really sure where to start.
View 7 RepliesIve been chasing a leak at the top of the trans on my 2007 Accent 2 door Hatchback. I cleaned up the area and it appears that the leak is from a seal 43126 in attached drawing. My question is can I remove the component 43801 without being in the trans, to replace this seal? Is there anything else i should inspect in there bushings, bearings etc.
View 4 RepliesI have a 2002 Accent 1.6 with 187000 km on it. I started noticing over the last month that when I shift into second gear the car seems to stop powering the wheels temporarily. Once the RPM's pick up (around 2200) the problem goes away. This seems to only happen when I originally shift into second and the RPM's are lower. If I accelerate slowly then the lag usually won't happen, but if I push down more on the gas then you can really notice the lag.
The spark plugs only have 15000 km on them, air filter is new, just replaced the fuel filter, oil was just changed (synthetic) as well as the filter, and I just recently cleaned out the throttle body. I have also seemed to notice a loss of overall power since at highway speeds since this problem started. The engine doesn't lag when I'm in 4th or 5th gear on the highway, but it seems to have less power when I'm accelerating on the highway.
I have just recently acquired an 01 Accent with the 1.6L and have had a few problems with it. It has about 112,000 miles on it and at about 109,000 it had the following services performed by the previous owner (reputable shop did the work)
-New battery
-New timing belt kit
-New water pump
-New valve cover gasket
-New plugs
-New belts
-New front pads
-New front rotors
-New rear wheel cylinders
-New front CV axles
-New tires all around
-Alignment
Now since I got it with about 111,000 miles on it, it ran and drove great until I had to put a new alternator on it as well as having to take the center console and automatic shift lever out to repair the wires for the O/D button. Car wouldn't shift into high gear. The problem I am having now is the car will crank but it will not start. Not even a sputter. I drove the car to and from work the day previous and then went out and started it to go to work in the morning and it started fine and ran fine for a minute or two then it just died like I turned the key off. No spitting or sputtering like it was running out of gas just died completely. Checked a few fuses and such and really not sure where to go from here because I don't have a code reader and don't wanna just throw parts at it, I would rather troubleshoot the problem.
I have been having an issue with my 4-5 gear shift under hard acceleration and know that a rebuild is due soon but I was wondering if any high performance kit available with all the clutches and friction discs needed to rebuild.
View 6 RepliesI have an 04 Jetta 1.8T that I recently acquired and have a problem with a noisy manual tranny. Reverse is a bit noisy (more than usual) and when I get on it in 1st and 2nd gear it sounds like an awful whining noise. I have been told it could be either a bad throw out bearing or input bearing? BTW this thing shift perfect, like butter, no grinding at all.
View 4 Replies1996 4x4, manual trans. Wants to kick out of first, and when shifting into 3rd I have no gear. Doesnt grind, just goes in as though it were neutral.
View 4 Replies