Accent LC (2000-05) :: Loosing Power And Could Not Accelerate As If Engine Was Not Getting Fuel
Jan 10, 2016
One morning I went to start my 2000 Accent, 1.5L Auto and the engine couldn't get going. I had road service come look at it and they said the problem was the fuel pump, I then got the car towed home. I changed the fuel pump and everything was working great again. I then changed the fuel filter, air filter, oil filter and flushed/refilled the oil. I used the car very lightly for a few days and had no problems.
Then yesterday I took the car about a 30 min drive, when on a main road my engine begun loosing power and I couldn't accelerate, as if the engine was not getting fuel. I managed to pull over safely and after about 30 mins of not getting anywhere I decided to hit around my fuel tank/pump with my club lock many times and what do you know the car starts and I manage to drive it about 25 mins, I was almost home when the same thing happened. I pulled over, waited, hit the tank and finally drove all the way home.
When I originally changed the fuel pump everything seemed fine, the plastic pump housing and everything attached to it appeared in great condition. So my hunch is that the problem would be where the fuel actually enters the engine block? The way that everything works fine until driving for roughly 25 mins makes me think the problem may be dependent on the temperature of the engine, given that's the main variable that changes?
View 1 Replies
Advertisement
Today I had to boost my car three times, once boosted, I was loosing power, my lights dimmed, and my rev-ometer had stopped working.
My father said it would be a connector cable, the battery was very corroded. I just had my cat-converter replaced wednesday. today is the first time i've had this issue, i've had the car for just over a month now.
I'm really hoping its not my alternator. Because that would suck.
View 5 Replies
What I know the truck was running normal except if I stomped the gas pedal and let off it would not respond again until I shut off keys and restarted this was a month ago now the truck sounds like it has a lope tune.
When I hit the gas pedal it blows white smoke and if I press the gas while idling or driving it floods out I did the spray bottle test on manifolds the drivers side was plenty hot the passenger side is cold you literally can touch while it's running.
The truck sounds like it's only running on 4 cylinders it has gotten so bad I parked the truck. Also this truck always had poor mpg 8 to be exact city hwy and towing nothing changed the mpg at all it used to blow out wet soot that would fall down on the truck and anyone standing near it.
Mods unknown pcu program 4in straight pipe with 12in stack harpoon mod in tank
View 8 Replies
My 2005 1.6 is losing power now and then when I accelerate. gas mileage is getting worse. I don't want to replace any unnecessary parts. wires and plugs look good.. Codes 300, 301, 302, 303 ..
View 7 Replies
I have a 1990 celica hatch automatic with 33x,xxx miles on it. the cars always had problems like it would suddenly turn off or the rev would go high but all of thats been fixed
recently the car started losing power and it cant really accelerate to a high speed and speed past 30 and the car will start to shake a lil as if it was gonna turn off and even if i floor it at high speed it doesn't really go anywhere and if i use overdrive the rpm shoots way higher then usual.
Do i need new engine or is it other problem? my friend said it could be distributor?
View 2 Replies
I own a hyundai accent 2000 GLS, i have recently replaced the ECM wiring and a brand new ignition coil, however the engine still sputters when i try to accelerate in higher gears, my mechanic told me that the engine mounting bushes need replacement. is it one of the causes? the sparks plugs are new, fuel pump is working fine.
View 7 Replies
Driving on the highway today and when I started to accelerate fast I noticed my check engine light blinking yellow and also noticed loosing boost I think I can only reach maybe 10-12 psi, I am stage 1 revo and also it was 95 degrees out, what it could be, thinking misfiring? so would that mean new coil pack and spark plugs?
View 15 Replies
I have a 2006 F250 with a 6 liter diesel I got about a hundred sixty thousand miles on it I've had it bullet-proofed haven't had too many problems with it I thought the fuel pump went out yesterday so I replaced it drove fine for a few hours then it started losing power and like it wasn't getting fuel and died I got it home took a test light and check for power at the fuel pump I don't have any positive or negative power ran a hot wire and a ground straight from the battery and hooked it up to the pump and it worked but when I plug the factory wiring back into it and turn the key on I don't have any power I checked the fuses they're fine...
View 6 Replies
Have power at fuel pump relay but no power at pump harness. Replaced fuel pump but on a budget and I dont know what else to do.
View 6 Replies
My 2000 Hyundai accent gl will not start. I have realized it is the because its not getting fuel. the fuel pump is new but not getting power.. there are 5 wires coming from the pomp which is the ground wire?
View 2 Replies
2002 accent with 70k on it the 1.6L
Here is the problem, the car sat for two years and when getting her back to life it would start so i started testing everything i could find. here what I get
Gets spark
Power to the cam and crank sensor.
All fuses and relays are good.
Found out the ecm was not grounding the engine control relay to turn on the pump and injectors so i added my own ground to the grey/orange wire and the pump turned and and it fired right up.?
so my question is what does the ecu look for to turn on this relay?
It was fine for a few days but now even with the relay grounded (activated) the car doesn't start . but let it sit and try again in ten mins and it will start every other time I come home from work and try....but i do still get power to the pump and injectors.? There might be a electrical monster in this car but I don't know what else to check.
I have another accent same year so I switch the ecu and every relay i could find over from the run ing car and i still have this problem, also changed the cam and crank sensor, so I am at a dead stop.
View 18 Replies
Friday, May 13 I brought my car to the shop because the Check Engine light came on and the engine started loosing power. $540 later they had replaced both O2 sensors. A day later the light was back on. Brought the car back on Monday and they replaced one of the sensors that was defective according to them. One day later the light was back on. Brought the car back on Wednesday and they replaced the sensor again, telling me the brand was not compatible with my car. One day later night the light came back on. Brought the car back in Friday May 20 in the morning and they have my car since. They can't figure out whats wrong. A week before all that happed I had an oil leak and they replaced the oil filter and a seal. Could that be it?
View 2 Replies
My Mother has an accent 1.3 glx on a 55 plate the problem she has is that every time she accelerates the car does a hiccup (her words not mine) the engine management light comes on and off and then its fine.
View 3 Replies
2000 Hyundai Accent with 180K. Runs and idles smoothly. When sitting for a few minutes at idle I get a waft of smoke when I accelerate. The car burns minimal ammount of oil and the smoke is not apparent while driving.
View 4 Replies
I have a 2001 accent manual transmission. Last week I noticed it is to weak NO POWER. The engine is not responding, too slow..to go 60 km or 40 miles/hour I have to shift fast to 4 gear. My car is 200,000 and my mechanic told me, I have a bad clutch...
View 12 Replies
My standard 2002 accent is undriveable and at the mechanic right now (100,000km). For the past few weeks the car has driven very jerky. While in first and second gears if i accelerate too quickly it just jerks/slips and has very little power.
Yesterday the check engine light came on and i got codes P0300, P0302, P0303...misfire in cylinders 2 and 3. Checked this forum and decided to buy new spark plugs (last replaced plugs and wires 1.5 years ago). Got into the car and could go more than a block because it was jerking and then kept stalling. Replaced the sparkplugs and nothing changed. Had it towed to the mechanic...after a few hours he said he had cleaned the exhaust manifold and it was driving fine. I picked it up and a block away it stalled again.
The mechanic now says 3 of my fuel injectors need to be replaced and the fourth will probably go soon and it will be about $700 to fix. Does this sound right for these codes?
I called hyundai parts and they told me each injector is $236...he also told me he doubted they had to be replaced cause he has never seen an accent have fuel injectors replaced and also they rarely sell these injectors, he said it was probably something electrical.
I have found 4 injectors on ebay for $200 but is this really the problem? The mechanic says it is 100% the problem. But from reading the forum I dont think so.
Also wanted to add that i often noticed the smell of burning plastic. Smoke seems to be coming from spark plug area when i notice the smell but nothing looks burnt/melted.
View 14 Replies
I have a 2003 toyota tacoma 4x4 with the 3.4l engine. Recently I have noticed that while accelerating I am losing power. I first noticed it would surge while going slowly uphill and since it has started happening all the time. I especially notice a serious dip in power during freeway acceleration at around 3000 rpm. The truck has 100000 miles on it. I have changed the plugs, run injector cleaner (the stuff you buy at the gas station), cleaned the throttle body, changed the air filter, and cleaned the mass airflow sensor. I have played a little with the throttle position sensor and that seems to have some affect on the timing of the surge but it is hard to tell. Of course toyota doesn't service the TPS for that year but rather try to sell you a new throttle body $1100.00!!! Could this be the catalytic converter or maybe a faulty injector? Also, I have not changed the timing belt yet.
View 3 Replies
Well zipping along the highway tonight, sitting on 100KM/h, and all of a sudden the engine loses all power. As luck would have it a fuel station was just closing (the only one for half an hour either side) and kept the lights on so I could have a look. The starter is nice and lively, and the engine is trying to fire, but just wouldn't. I asked a mate of mine in town to come out and give me a hand troubleshooting.
As it turns out, when the ignition switch is set to the "ON" position, normally the fuel pump primes the lines. It's only doing it intermittently for some strange reason, and not making it past the fuel filter (despite the filter being new). The temporary buzzing in the engine bay when the car is switched off is gone now too.
Now my question is - does this sound like fuel pump? I'm only used to the older fuel pumps in carburetor vehicles, not these fingle fangle electric things!
View 4 Replies
I drives grand Avega (new accent). I had a problem on my car. on instrument cluster there were no indication P,N,D,R and speedometer didn't indicate. Engine able to start normally but can't accelerate it seems like A/T transmit ion on higher shift.
Before that happened I installed a LED for additional lamp on door and I use /jumper a power from behind of fuse box.
View 8 Replies
Woke up this morning with a dead battery got a boost and realized that DRL, chime, dome light, dash lights and fuel pump are always on (can hear the fuel pump turning) even when the key is removed. The car will start but i have to remove the positive terminal to prevent a dead battery. Check all the fuses and the 2 diodes all is good. If I pull the 2 head light fuses in the engine bay the fuel pump slows down and the head light go on (The drl turn off).
View 10 Replies
I have a hyundai accent 2005 vehicle and there is no Low warning fuel indicator in the vehicle. My entire fuel tank ran dry still there was no low fuel warning light. According to my mechanic there is no low fuel indicator installed in the fuel pump
My VIN number is KMHCG41GR5U633054
View 8 Replies
