Accent LC (2000-05) :: Hyundai Does Not Speed Up When Press The Accelerator
Apr 7, 2016
I'm having an issue with my transmission. When driving it shifts just fine, but I have to let it accelerate slowly. If I press to hard on the accelerator pedal the engine ron races. So I ease up and it catches and slowly accelerates. For example going up hill, I press the accelerator and the car doesn't speed up, the engine races, so I have to just let the car slowly increase in speed by lightly pressing the gas pedal, no get up and go! Only occurs in 4th and 5th gears. What could be causing this. I have already flushed the gear oil as I had to replace the output shaft seal as it was leaking.
2000 Hyundai Accent 5 Speed Manual Transmission....
View 3 Replies
Advertisement
Ford F-150, 1994 : intermittent problem. going down highway, foot on the gas. At times, will press accelerator to go faster but nothing happens, like clog somewhere. Sometimes, with foot still on gas, i will hear a popping sound coming from under the truck, (under the engine?, or drivers seat). Usually 4-5 pops, sometimes none. But after each pop, car accelerates slightly, as if it is a slight clearing, until finally, as if some clog was opened up, the car plunges forward, so i then take my foot off the gas. Sounds like either problem with fuel getting to the engine or a problem with the exhaust.
View 4 Replies
I get a strange noise when I shit gear & press the accelerator..... the sound is as if something is knocking.....
View 3 Replies
I have hyundai accent 2005 1341cc 86hp, with BRC LPG kit. When i start the car at the morning, the engine misfiring around 500rpm for a few second (5sec-10sec)...
Sometimes the engine start ok in the 1100rpm - 1200rpm and when I touch the accelerator then misfiring again!
The car have 133.000km (11.000km with LPG).
I have replace the petrol filter 2 days ago and the all electric system without multiplier. I have clean throttle valve and the injectors with stp cleaner.
View 26 Replies
I have replaced the MAF sensor, TPS sensor, and fuel filter. Like the title says...if I rev the engine ...as soon as I let off the accelerator the engine stumbles and almost dies...then settles back down. I initially pulled codes PO121 so I replaced the TPS. PO103 so I replaced the MAF sensor. PO112..did not address directly as I assumed the MAF was causing. PO1123...again I hoped the parts I replaced would solve the problem. Initially the engine would just drop out while driving just for an instant and then be fine...also I had the 4 codes mentioned above. The only code that has returned is the PO121. I just got done replacing the fuel filter and things seem to be worse.
View 1 Replies
I have a 2002 Hyundai Accent. The press button inside the car no longer works so the A/C has been stuck ON for some time now. I don't live in a hot area so going without A/C wouldn't bother me too much. Is there an easy (read cheap) way to simply turn off the A/C from under the hood? My brother says he wants to remove the A/C belt but his knowledge of cars is often dicey. Might fix the problem, might blow up the car.
View 8 Replies
My 2001 Hyundai accent hatchback with around 135000 miles is having problems with the gas pedal. I start my car and can't really push down the gas pedal smoothly. It is initially hard where I have to slightly kick the pedal to move it. Otherwise if I rest my foot on the pedal and try to press it down I end up press it down too much where my car goes flying. Every time I come to a stop I have to do that to get the pedal to move. Its not stiff once I get the pedal to push down some but once I take my foot off the pedal I have to slightly kick it back down.
View 4 Replies
I'm having Hyundai Accent GLS Model 2005. Since yesterday, My tail lamp and Third Brake light is still switched on even I turn off the light & I notice that my Auto door lock is not functioning even I press the Brake Pedal. I tried to disconnect the battery & the Fuse and place it back but it doesn't works. Currently, I just pull out the fuse.
View 6 Replies
Alright, well I have recently purchased a 2000 Hyundai Accent, 1.5l SOHC, automatic. 117k miles. The problem is, it won't shift into overdrive. It appears that the overdrive button works, as the dashboard light turns on and off, but pressing the button has no effect on the transmission, as it still doesn't go into 4th gear. It's 3rd gear all the way down the freeway, which really limits me to cruising at like 60 mph. What this could be? The fluid seems alright, and there's enough I believe.
View 19 Replies
My 2000 Hyundai Accent has no power to anything. I checked the battery and it is good. I cleaned the terminals
View 4 Replies
Have a Hyundai accent 2000 manual. The vehicle inconsistently stalls while driving. One day it will drive all day without stopping. The next it will stall while driving 10 or more times.
I`ll pull over, turn ignition off. Turn the key 1-2 times. It starts. Drive sometimes 5-10 minutes will stall again, sometimes will stall an hour later. Some days not at all.
What I should be checking and how to go about it. Have the car booked in to get it put on the computer, but would rather do it myself especially if its just a sensor that needs replacing.
View 8 Replies
2000 Hyundai Accent with 180K. Runs and idles smoothly. When sitting for a few minutes at idle I get a waft of smoke when I accelerate. The car burns minimal ammount of oil and the smoke is not apparent while driving.
View 4 Replies
So I have a 2002 Hyundai Accent 1.5L. My car will drive 1-2 miles then it dies. After I let it sit for about 10 minutes it starts up again. I am getting to the end of what I know to do. I have replaced the ECU, Main relay, most of the sensors, Fuel pump, and fuel filter. When I bring it in to get the codes for it all I get is sensor faults even though I have replaced them. I am going to let it run for a little while and see if I can feel any heat from any relays under the dash. I like this car but not sure what else I can do.
View 4 Replies
Today my Windstar would not start, it only start if I press on the accelerator if I let go it will die, I'm thinking of gas pump?
View 2 Replies
My 2005 Santa fe has a single knock when you press the accelerator, then between 60 and 70mph there is now a shake in the steering wheel. I have been told it is probably the CV joint and just wanted more input.
View 2 Replies
2007 with 85000 miles. This noise appeaser only between 64 to 69 miles/hours, either manually pressing pedal or when crus control is on. A/C on or off. Noise goes away as soon as i let off the gas pedal. the noise is not very load it sounds like, when mechanical fuel pump stars going bad.
View 5 Replies
Car died at idle on park. Tried to start it back up and was only getting crank. I took it to a local mech and he said my timing belt failed. I paid for the repair and the car still wouldn't start. The shop said the ecu went out. I replaced the cam position sensor and main relay under the dash. Still not getting it to start. I also have a ecu from an 05 accent, would this be plug and play? What else can I do?
View 3 Replies
I have a 2006 Rav4 and every time I drive my car after it's been sitting for a while there is a very loud noise coming from the rear of the car, the noise usually lasts about 10 to 20 seconds and only happens when I press on the accelerator, and is always when I go forward, never in reverse. The noise is usually louder when it is humid or it is raining.
View 1 Replies
Had my .:R for 2 years now and just noticed other day. When you cruise in 2/3/4/5 gears about 3000 RPM and suddenly press accelerator 1/3 down RPM jump UP for a split second on tachometer. They go up by one segment (which is 200RPM) and then drop back down.
Now, DSG should not do that to my understanding as clutch pack is engaged! There should be no slip. Also, it is not a drive train shunt, as I kept the car in very slight acceleration.
View 5 Replies
I own a 2000 Hyundai Accent with 85,000 miles on it. I recently took my car into a local shop because the pressure on my brake pedal was extremely low. I was almost pushing it to the floor. On my first trip to the shop, they replaced the rear wheel cylinders because they were leaking. This replacement didn't fix my problem.
On the second trip to the shop, they replaced my master cylinder. I did call around to other shops to do a price comparison and the price was reasonable on both jobs. This work was done about two weeks ago.
At first, this seemed to fix my problem, the pressure was perfect. Since then I've been having an intermittent problem with the brake pedal pressure changing. It would get a little hard during driving, but would correct itself after a few moments. I don't drive that often or very far, so I was waiting to see if the problem would get worse.
Last night it did. I went out and when I tried to drive my car home my pedal was extremely hard. I could barely push it. While I was driving my car home (I was close to home), it felt like I was driving with my brakes on. My car would stop as soon as I took my foot off the gas pedal, I could not coast. When I got out, I could feel heat coming from the front tires, which I didn't even have work done on. There was also a smell that I've never smelled before. It almost smelled like something burning.
I was told I should have my car towed back to the shop on a lifted bed and not rolled there and that they should fix my car at no charge because they did something wrong.
My ultimate question is did the shop do something wrong and should I take it back to them if they did? Should they be responsible for this new repair? I don't want to go demanding anything if it's possible this is a whole new problem and not their fault. Even though it does seem like an awfully big coincidence. My next question is: what could be possibly wrong with my car? I would like to know what I'm getting myself into.
View 1 Replies
I'm trying to get my neice car going. .I went to move her car yesterday after a snowstorm and it idled fine but would bog down when I pressed on the accelerator. While it was running I checked to see if the air filter was dirty, it was and as soon as I pulled the snorkel off the car stalled. I put everything back in place and after running for a half hour it seemed fine. She drove to school but before she got there it started to bog down again so she pulled into a Toyota dealer. Later they changed spark plugs, new air filter and cleaned MAF sensor. Worked better until the next day, now it will crank over but will not even make an attempt to start. I tried to clean the sensor with rubbing alcohol but no luck.
View 3 Replies
