Accent LC (2000-05) :: Engine Quit When Driving Down The Highway


Jul 17, 2012

Driving down the highway today, my car just all of a sudden quit. I had it towed home, and checked the spark and fuel pump. It turns over fine, there's plenty of spark, and the fuel pump works great, but I don't think fuel is getting all the way to the engine. Could the fuel line be blocked or something? Maybe the injectors?

View 3 Replies

Advertisement

Ford - Ranger :: 2000 XLT V6 Quit While Driving On Highway / Engine Is Blown

My 2000 Ford Ranger XLT 4x4 (139,XXX miles) V6 3.0, recently quit on me while driving on the highway. It will no longer start. I spoke to a mechanic and he informed me to fill the radiator (which was empty) and attempt to start the truck with the radiator cap off. He said that if radiator fluid gushed out then the engine is blown. Is this necessarily the only cause, that my engine is in fact blown.

View 19 Replies

Accent LC (2000-05) :: Speedometer Quit Working And Transmission Does Not Shift Out Of 1st While Driving

I have an 02 GS with automatic transmission. The speedometer quit working and now the transmission does not shift out of 1st while driving. CEL is on but I'm waiting for a friend to come over and get the codes. It shifts into drive and reverse fine but I'm wondering if there is a speed sensor in the speedometer that signals the tranny when to shift?

View 4 Replies

Santa FE SM (2001-06) :: 2003 - Heater Just Quit Working While Driving On Highway

Today, while driving on the highway, my heater just quit working. My car is equipped with the automatic climate controls and so I switched it to manual mode to see if the heat would come back. The heat does not seem to be mixing at all with the air.

One weird thing is that if I set the temperature to 90 degrees then the A/C mode will turn off and blow pure hot air. However, if I go to 89 degrees then the heat will stop and the A/C will turn on again. Turning off the A/C manually does not bring the heat back.

What could be wrong? I might just try unplugging and reconnecting the controls since I was messing with the radio a couple of days ago.

View 2 Replies

Accent LC (2000-05) :: Stalled While Driving - Check Engine Light Popped On

2 days ago my 2000 Hyundai accent Gl 1.5 stalled while driving i lost no power to my electrical system all my lights and stereo stayed on but i lost all engine power the check engine light popped on and i had to have a friend tow me home this has never happened to me before. I had sat in my yard for about a year before i started driving it again due to money problems. I did a tune up on it before I took it out anywhere and ran some lucas injector cleaner and changed oil added some oil additive and changed my air filter spark plugs seemed fine so I didn't replace them and it ran for almost a month just fine i have about 150k in miles on it then suddenly just died while driving home from work I am thinking its in my fuel lines filter or pump are clogged up but I am not sure. I am going to start diagnosing it tomorrow. I can't get the check engine light looked at cuz I can't get it started.

View 2 Replies

Accent LC (2000-05) :: Cold Engine Starts - Cannot Start When Warmed Up After Driving

When engine is cold it starts fine, when hot from driving (e.g. the engine's temperature display's needle is in the middle) i cannot start it unless i try 3-4 LONG keys. What can it be? Where should i start?

View 17 Replies

Accent LC (2000-05) :: Instrument Panel Won't Light Up / Quit Working

The instrument panel in my 2002 Hyundai Accent GSI quit working. I pulled the cluster and both bulbs were working (replaced them anyway). All lights and fuses work, including the dimmer. All I can see at night is the speedometer reading, lit by these two bulbs.

There are two holes, covered over, for two other bulbs. They were never installed! Hyundai dealer has no idea on what could be wrong. I can't see how the white part could have been backlit without these two bulbs. Doesn't make sense.

View 10 Replies

Accent LC (2000-05) :: Died Roughly - Sensor Quit Working?

Replaced fuel pump a couple weeks ago and my car was running just great. Last week, it died on me again and I discovered that I wasn't getting any spark. Removed crank position sensor and installed one from the junkyard. Fired right up and I was able to drive the car for 3 days with no problems. Then it quit again. I figured that it was the part that I got from the junkyard so I went to autozone and shelled out $80.00 for a new one. When I removed the old one, I noticed that there was motor oil on it and I am wondering if engine oil is supposed to keep it cool as there wasn't a lot of oil on it. I don't want my new sensor to quit working because it may be getting too hot and breaking down because of excessive heat.

View 13 Replies

Sebring - Chrysler :: 2000 - Quit While Driving

2000 Chrysler Sebring Convt quit while driving. Tow truck drive and a mechanic at scene of breakdown felt itt seemed like it wasn't getting gas. Replaced fuel pump, fuel filter, 2 sets of plugs ans it won't start and when it did it ran rough and then fouled out new set of plugs. Seemed like too much fuel going to cylinder.

View 1 Replies

Accent LC (2000-05) :: Random Increase In Highway RPM

So yesterday driving home from work, I was cruising at 70mph, which puts my RPM's just at 3000. Then I notice an increase in RPM by about 200-300, and I didn't even move my foot or give it more gas or anything, almost like it cam eout of overdrive. It did this about 5 times. I've got about 60k on a used tranny, so I don't think that could be the issue. Not sure what it could be...

View 8 Replies

Accent LC (2000-05) :: 2003 - Stops Accelerating On Highway

Car just stopped accelerating on highway. It starts again after about 10 minutes. Also the wheel gets stiff when it stops accelerating. What could be wrong?

View 3 Replies

Accent LC (2000-05) :: Vibration At High Speeds On The Highway

Getting some vibration at high speeds on the highway, and when I changed my wheels, I noted that there seems to be some free play in the ball joint on the end. Is this normal? Can I replace just the end of the tie rod?

View 3 Replies

Accent LC (2000-05) :: 2003 - Auto Downshifting When Let Off The Gas On Highway

Just bought this car and when I am on the highway I let off the gas and it automatically downshifts. no engine light or anything. and when I press the gas again it returns to the proper gear.

View 3 Replies

Passat (B5) :: 2000 GLS V6 Quit While Driving / Manual Transmission Went Into Neutral

2000 Passat GLS V6 Manual Transmission 102k miles

I was stopped at a light tonight making a left hand turn, I had the car in 1st gear and the my foot on the clutch. I slowly released the clutch and proceeded to make my left hand turn, halfway thru the turn the car made a noise that sounded like a pop (almost as if something came apart underneath the front end of the car and was loose) and then my manual transmission went into neutral. I slowly coasted to the side of the road and had the vehicle towed.

After I had coasted to the side, I tried putting the car into gear and the engine would rev up but the vehicle would not go forward or reverse. I tried all 5 gears and reverse. While sitting there the car would beep and the screen would say "hand brake on" and if I put the car into first this message would go off. The message only came on about 2 times in 5 minutes and never stayed on.

View 2 Replies

Accent MC (2006-11) :: High RPMs When Driving On Highway In 5th Gear

I have a 2006 accent gls manual and when I am on the highway in 5th gear my rpms are high. if I am cruising at 110km my rpms will be almost at 3500..

View 13 Replies

Accent MC (2006-11) :: High Revs When Driving At Highway Speeds

I just bought a 2011 accent 5 spd ... Quick question, when I drive it at highways speeds. (65mph) I notice that i am running around 3500 revs. Is that normal? It seems a little high to me. Every other 4 banger I had never ran that high in 5th gear at 65 mph.

View 5 Replies

Accent LC (2000-05) :: Steering Wheel Shakes Quite A Bit At Highway Speeds 70 MPH

My accent just crossed 180K mark. From last year the steering wheel shakes quite a bit at highway speeds ,say 70MPH. It's especially bad when I accelerates . Took the car to a shop, they told me two things, the CV axle of passenger side needs replacement, and the wheel hub bearings are bad(both front wheels). They quoted me $200 for replacing the cv axle, and $400 for replacing both front wheel bearings. Since I don't even think the car worth $600 right now(given high mileage), I told them I'll just do the axle(I know how to do it myself but don't have the time, plus it won't be that much cheaper DIY anyway). They said fine, but if you don't replace the bearings you may have the wheel fly off one day and that's dangerous.

They replaced the axle, and the car drives a lot better now. There's still a little bit of shaking at high speed but 75% of that shake has gone away. My question is, does the worn out bearing causes car to tremble at high speed? I heard other people told me there should be a grinding or loud hawling sound if the bearings are bad, but I don't hear that. I searched the internet and some people say, to determine if the hub bearings are bad, just drive it for 10 minutes then feel the hub. If it's barely warm, the bearings are good. If it's warm to hot, then the bearings are bad. I felt it and it's warm, but not too hot to touch. I tried the rear wheels and those are barely warm indeed.

So from this method it seems the front wheel hub bearings are indeed bad. I wonder how long I can keep driving this without endanger myself. $400 is not cheap for this car and I don't have a machine to press in the bearings myself. I can disassemble the rotor and hub that's not a big deal, but I don't know how to get the old bearing out and the new bearing in. Is there a machine shop that just do the pressing? Or, is there any shop selling the hub assembly with bearing already in place? this way I just remove the old hub assembly and replace it with the new assembly, a lot easier. I searched the internet but can only find pre-assembled hub w/ bearing for the rear wheel of this car. I need the front ones.

View 4 Replies

Accent MC (2006-11) :: Smell In Car When Driving Down The Highway - Puff Of Grey Smoke Came Out Of Back

Was driving down the highway and got a smell in the car, thought it might be diesal from the truck in front. When I got off and came to a stop, car would not accelerate at first, it hesitated and a puff of grey smoke came out of the back. Stopped for a few minutes everything seemed fine then the check engine light came on. I have managed to get it up with just a couple of rattles, but the check engine light is still on. Have I killed the car by driving it home. The light was not flashing it was completely on.

View 2 Replies

Passat (B5) :: 2000 - No Boost While Driving On The Highway

So I was driving for 6 hours yesterday and about 3 hours in my boost completely cut out on the highway. I didn't get any CEL or EPC light or anything. I took a look under the hood and everything looks okay. I also thought maybe the turbo blew but it isn't smoking or anything. What it could be?? Or some way I can diagnose the problem?? I have a 6 hour drive back home and would like some boost! It is a 2000 Passat 1.8T ....

View 5 Replies

Chrysler - Cirrus :: 2000 Lxi Died While Driving On The Highway

My car died while driving on the highway. The mechanic said it was the distributor, but also that the fuel pump wasn't working. When he replaced the distributor, the car works, no fuel pump problem. Does the fuel pump shut off when the engine dies or is this going to be another problem down the road? 2000 Chrysler Cirrus Lxi...

View 1 Replies

Toyota - Camry :: 2000 - Stalled After Highway Driving

I have a 2000 Toyota Camry CE (2.2L/V4) w/ 130,000 miles on it. Just recently I have been experiencing a stalling issue after driving on the highway for 19 miles (or 20 minutes) at a speed greater than 65 mph. As soon as I exit and take my foot off the gas the car will stall as if I just turned the key in the off position. After I pull over, turn the key in the off position and wait a minute or two, the car start right up as if nothing happening. The idle seems to be ?normal?. The engine light does not come on when this happens.

If I feel the car may stall when still on the highway after slowing down, I can shift the car into neutral and hold the idle speed high enough to continue driving. However the car will eventually stall. But again and I restart it and be on my merry way without incident. I have try switching to high octane gas, but that did not work. If I disconnect the battery for a few hours the computer reboots itself and it will take a few more trips at high speeds for this issue to occur again. I have put in a fuel injector cleaner and cleaned the butterfly value (air intake). I own an Auto Xray code scanner; however it is not showing any error codes. What this issue may be?

View 1 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved