Accent LC (2000-05) :: Engine Light Flashes Quickly About 20 - 25 Times
Sep 22, 2009
My 2004 1.6 L accent does the following, no matter how much gasoline is or is not in the tank: Whenever I remove and replace the gas cap [which is brand new], as i drive away, the engine light flashes quickly about 20-25 times; rests for about 15 seconds and flashes again about 20-25 times. Thereafter it goes out for the rest of the drive. while it is flashing, the car idles roughly. This happens even if i only remove the cap to add some water absorbent or some injector cleaner. it also happens when i fill up the tank. by the way, i NEVER TOP UP. I always quit filling with gasoline when the pump goes "thunk." this has me completely stumped.
View 9 Replies
Advertisement
So I was driving home today, I had some issues a couple of weeks ago with it stalling in the rain, it was raining today. As I was driving, the truck dies and won't restart. It wasn't like it stalled, it was almost like someone shut it off. Then it wouldn't restart, and there is a clicking sound under the dash. I tried the battery pull and nothing. Ended up having it towed home.
View 7 Replies
My wife was about to go into work today and when she started the Accent she said it started rough and revved up two or three times and the check engine light flashed 5 or 6 times. The light stayed on solid after that but there was no loss of power, smoke, low gas mileage or vibrating or any other symptoms after initial start up. I plan to take it to an auto parts store tomorrow (the car is at her work about 20 miles away) and get the code read. What I may be in for? I'm hoping its something simple. I told her to check the gas cap just in case.
View 24 Replies
I just bought this car from the original owner. She didn't take that great of care of the car. First oil change was done at 8,000 miles for example. Basically if it was broken she would fix it, but didn't do much preventative maintenance.
I just replaced all 4 spark plugs and coils since one was misfiring and didn't want to have to go back in and replace one in another few months. Replaced the AC belt a few days ago since it was cracked and worn. All other belts are fine. I drove the car around for a few hours the next day and it ran great.
Today, the check engine light flashes and then stays on. The car is idling rough at stop lights and acceleration is poor. Previously, the light came on and it was the EVAP system. Not sure which component and I was told it isn't supposed to affect the way the car drives.
View 14 Replies
I go in this week to recheck my nagging check engine light. Flashes after a warm start, then stays on. Been there once already for it, it has come on too after a cold start... Last time they said it was a very vague miss fire code.... It did shake a bit... On the plus I get to drive a nice new Elantra again.... On the down, I never want my car back after driving it ...
View 2 Replies
I have a 2001 Accent GL DOHC 1.5L (which I believe is the same as your LC model).
One night it started running poorly - missing, bad acceleration - like it was only running on 3 out of 4 cylinders. It was missing whilst idling and would backfire and struggle to accelerate. I took it to a mechanic and they said I needed a new coil pack. So I bought a coil pack from a 2nd hand wreckers that looked pretty good, the car idled better but accelerated worse, like it was only running on 2 cylinders .
So I swapped it back to the old coil pack - and now it wont even start. The engine turns over once then clicks loudly a few times - I think the clicking is from the distributor.
View 3 Replies
My ABS light is on and the 4X4 light flashes about 8 times every few minutes. I thought this would be from a cracked tone ring on teh drive axle, I put the truck up on my floor jack and I did find a cracked tome ring on passenger side. Whoever has the truck used silicone to put the broken tone ring back on. In any event I replaced the drive axle with a new OEM with new tone ring. Drives like a charm but ABS and 4X4 light still on and flashing. It is AWd Is there a tone ring on the drive shaft ?
View 6 Replies
I have a 2006 mariner that the ABS light is on all the time and the 4WD light flashes 8 times and the vehicle feels like it is in four wheel drive when turning only at slow speeds and usually in reverse but only when the vehicle has sat for a while, as if you parked for a hour then pulled out of the stall and were turning the wheel.
Tone rings on all wheels are good and all speed sensors have good continuity. Have a friend that works at Ford dealership and he got a tech to scan the car for me. Scan showed the left rear wheel sensor at fault so that's what I'll replace.
View 1 Replies
I'm still trying to get a manual for my recently acquired 2004 Prius, so I can't trace down what this means....
When I start the car, recently, a "Maint Required" light comes on and flashes about three or four times, then goes away. This is after all the other dash lights during the test phase go out. When I took it to have the codes read, the device said "No Codes" stored.
What does this mean? And is it a serious problem?
View 12 Replies
I have a 03 GLI 24V VR6 6 speed and im having an issue with the brake light.. ive checked all the fuses and emergency brake sensor and they are all good, the issue is the brake light flashes 3 times then will stay on almost immediately and whenever it does the entire drive of the car changes.. without the light on the car runs fine but when it comes on its like the car goes to a limp mode and is leaning out on fuel.. it wont rev past 4k it falls on its face and basically jerks along until I get where I am going.. I've replaced ABS speed sensors, MAF, and front brakes and axles recently.. before this was an random issue that would come and go but now its almost every time and it makes it undriveable..
View 1 Replies
While driving into work today I noticed that when I turn the exhaust brake on the light flashes 4 times and turns back off. This definitely does not seem normal but it is cold outside. Could it being 9* have anything to do with this?
View 11 Replies
My standard 2002 accent is undriveable and at the mechanic right now (100,000km). For the past few weeks the car has driven very jerky. While in first and second gears if i accelerate too quickly it just jerks/slips and has very little power.
Yesterday the check engine light came on and i got codes P0300, P0302, P0303...misfire in cylinders 2 and 3. Checked this forum and decided to buy new spark plugs (last replaced plugs and wires 1.5 years ago). Got into the car and could go more than a block because it was jerking and then kept stalling. Replaced the sparkplugs and nothing changed. Had it towed to the mechanic...after a few hours he said he had cleaned the exhaust manifold and it was driving fine. I picked it up and a block away it stalled again.
The mechanic now says 3 of my fuel injectors need to be replaced and the fourth will probably go soon and it will be about $700 to fix. Does this sound right for these codes?
I called hyundai parts and they told me each injector is $236...he also told me he doubted they had to be replaced cause he has never seen an accent have fuel injectors replaced and also they rarely sell these injectors, he said it was probably something electrical.
I have found 4 injectors on ebay for $200 but is this really the problem? The mechanic says it is 100% the problem. But from reading the forum I dont think so.
Also wanted to add that i often noticed the smell of burning plastic. Smoke seems to be coming from spark plug area when i notice the smell but nothing looks burnt/melted.
View 14 Replies
Ok my dome light flashes and I get a chime first three times then one and it repeats. No other error messages or codes. What causes this?
View 6 Replies
I have a 2000 Toyota Sienna that has had a check engine light for a while. The light would come at times, and go away at others, with prolonged intervals (days, weeks, months) with or without the light.
Suddenly it started losing power, especially on hills (even a small hill). The codes I read are (I include code interpretations from internet search):
P0300: Random or multiple misfire.
P0301: Cylinder 1 misfire.
P0304: Cylinder 4 misfire.
P1130: Air fuel sensor
P1150: I have not found a problem definition for this code.
Might these codes be indicative of a particular problem, or is each problem more likely a problem with its own cause?
View 19 Replies
I have a 2005 Accent Manual, and my check engine light came on a little while ago. So far since then, my car has started to hesitate, and sputter at times. It just doesn't run like it used to. I have owned this car for four years, and it now has 117000 miles on it. I went in to one of the automotive stores in my area, and after telling the gentleman that works there about my car, he sold me some spark plugs, and spark plug wires, because I have never replaced them for as long as I have owned the vehicle. I did and it still sputters and what not. So I went back in and they hooked up their machine to my car and printed off these codes:
P2401
P2419
P2405
P0036
View 2 Replies
2001 hyundai accent, HARD TO START. I have to start the car almost 3 times plus hit the gas pedal to get it working. I already replace battery, starter, spark plugs, spark plug wires and air filter.
View 9 Replies
i have a 2000 ex,6.8 4x4.every now and then the dome light stays on.theres also a problem where theres a buzzing sound coming under dash while driving and makes the dome light flicker.these are seprate problems.lol.when the buzzing sound is present ,it stops when i open the door,running or not.but starts up again when i close it,even happens occasionaly when ignition is off and no key in ignition.electrical problems are my worst night mare!!!!!!!! My battery is dead in the morning when this is happening .oh yea,and the o.d.light flashes occasionaly as well.im totally lost.
View 6 Replies
My check engine light is on and I'd like to try to read the codes myself without the machine. Any proper link here that I can follow to read the codes? When I search I'm returning mainly threads that tell me to GO get it scanned versus pulling the codes myself.
2002 Hyundai Accent GS
View 3 Replies
i just picked up an '07 Camry XLE and every time I start the car (push start button) the horn gives me 3 quick honks. Same happens with the remote start. How to turn that off? Besides just not starting the car
View 1 Replies
If you get a f!ashing cel ,the next time you start it should it flash right away or can it go back to solid on cell? 02 Accent 1.6 130 k. What can be done to check the flex pipe for a leak? Can you spray water or what? The outside looks good. Also looks hard to check around intake manifold for leaks.
View 11 Replies
Just curious as I don't see the check engine light on my Accent 2004 GVS. Not even when I insert the key in the starter switch.
My mechanic told me this model doesn't come with a check engine light which I cant believe.
View 1 Replies
