Accent LC (2000-05) :: Engine Is Making A Ticking Noise
Apr 16, 2015
My engine is making a ticking noise. Louder when I start it and not as intense after it warms up but its still there. I first thought it was one of my pulleys making noise but I brought it to a friend who knows a lot more then I do and he says to check the engine valves. Did some searching online and thinking it might be the valve lash adjuster but not sure.
Anyway whats the best way to go about this? What type of oil should I be using and I also read I should be only buying Hyundai oil filters?
View 2 Replies
Advertisement
Its getting worse. Noticed it a month or so ago, very slight ticking noise when the engine was cold. It would go away after a minute or two when the engine warmed up. Kinda sounded like a lifter ticking type noise when low on oil but I was not low on oil.
Now its getting more noticeable and it doesn't go away. Very noticeable when I take off or accelerate. less noticeable when I take my foot off the gas but its still there.
What it might be? I am pretty newbie about engines and I don't want some repair outfit telling me I need a rebuilt engine if all I need is to tighten my manifold or something. Because that would be my luck.
2000, XLT, 5 Liter V8, 178K miles.
View 5 Replies
When you start the engine on my 04 hyundai accent something under the hood is making a ticking sound. Seems if you run the engine awhile the ticking decreases. What this is?
View 5 Replies
i recently changed my engine oil and filter from carquest brand to quaker state and about 500 miles later, i started having some issues like, rough idle and loud ticking and bottom engine noise. is that just a coincidence or any problems with this oil? 1.6L D.O.H.C.
View 2 Replies
I have a 2001 1.6 DOHC Accent the engine has been making a lot noise coming form just the back of the head it kinda sounds like a diesel. I pulled the valve cover off and turned the engine over by hand. I noticed that cam chain has a good amount of slack in it. Is there a tensioner to take slack out of the chain? If so can I adjust it? If not how do I replace the chain?
View 8 Replies
My engine has been making a ticking sound when it starts and when i hit the gas the ticking sounds stays there but go faster depending on my rpms and before it would go away after the engine got warm but now its here to stay. What it could it i feel like sound is hitting against the acceleration cable.
View 14 Replies
I own hyundai 2000, 1.5L. About 5 days ago the engine started making strange noise that sounds like sewing machine.
I went to my garage and they said that its the hydraulic valve lifters and that I should replace all of them(12 total).
My question is, what can happened if I wont replace them? can I postpone the replacing for a few months or it can cause damage?
By the way, I heard that the noise from hydraulic valve lifters can start due to bad oil, I had 20W50 so I changed today the oil to 15W40(manufacturer recommendation) and the oil filter and still got the noises.
View 7 Replies
I have an 03 Accent with an automatic transmission that was recently replaced. I'm getting a ticking noise and I removed the inspection cover and had a look and found that the thin plate bolted to the front of the torque converter is cracked at two of the ears where it bolts on so I suspect that is what's creating the noise.
I hate to have the trans on this car pulled again, I had it done once before because I don't have the tools here to do that. It's just an old work car that never is even driven on the freeway and I was wondering if simply welding that plate up would keep it going or is it something that will break and crack again.
View 10 Replies
I have a hyundai accent 04 when I start it up there seems to be a ticking noise under the hood. It seems if the car is warmed up the sound decreases. What's going on?
View 7 Replies
I have a 2000 F250 5.4 that has a ticking/knocking noise. After about 30-60 seconds of first starting the truck in the morning, the ticking/knocking noise appears. It sounds like its coming through the exhaust system and seems to be louder under the front passenger side wheel well. When I rev the engine up, it seems to go away. Does this engine have a cam phaser? Could it be timing chain slap?
View 11 Replies
My mom has a 2003 pontiac montana thats making a ticking noise says its low on oil but i just changed the oil 2 and half weeks ago. Why it would be ticking?
View 3 Replies
I bought a 2005 Hyundai Accent about 5-6 months ago, GS 2 Dr model, 52,000kms (69,000 on her now), and lately she has been making a weird ticking sound form the engine when idle, if you give her some gas it slowly goes away as your RPMS increase. I had my father look at it, he said it seems fine, i also had a garage look at it and they also said its fine, but too me the engine sounds different then it did when i got it, maybe the cold from the winter could be doing this? when the engine is heated up it still makes the noise.
View 4 Replies
2006 Sonata 2.4. A couple weeks back I posted about how my engine is making a slight ticking noise. It makes the noise consistently. I recorded a video of the noise. What it could be. Here's the video: [URL] ....
View 14 Replies
I bought a 02 accent base model hb 5 speed 109k miles for a winter car (have a mustang in garage.) It ran good until tonight when the timing belt snapped. I know this because while driving it made some ticking noises and then shut off and when you try to start it the noise that comes indicates no compression so the belt must've snapped and bent the valves.
View 3 Replies
Since it's "auto repair season" in my driveway, I was working on my daughter's car (2001 Accent, 1.6 GSi) and noticed that the air conditioning compressor makes a noise (like a cross between a burble and a shriek) when it cuts out. I'm assuming it's the head unloader and was wondering if it's supposed to make a noise that's quite that loud or if maybe it's getting low on refrigerant - the compressor runs quietly when it's turning and the clutch doesn't make any strange noises.
View 3 Replies
Oh where do I start. 2003 Santa Fe, V6 Auto, FWD.
The engine has been making a loud ticking noise lately, starting right after an oil change it seemed. It actually sounded a lot like a stuck lifter, so I had an engine flush done, but this did not remedy the problem. Popping the hood one day it was particularly noisy, I noticed that it sounded like it was coming from the serpentine belt tensioner (or there abouts).
Anyway, tonight, *something* finally gave. All of a sudden I heard a squealing noise, then smelled burning rubber, and my battery light came on, and I lost my power steering. I figured that the tensioner finally gave out.
I turned off the vehicle to see what I could see. A bit of melted S-belt was it. I restarted it, and the belt was turning fine again, but while it was idling, I noticed that the crank pulley was shifting in and out now and then. When it moved inward, the S-belt shifted in as well, and started to rub on the timing cover, wearing a hole right through it! Have a look at the attached photo, showing the grove worn right through.
So I'm assuming that my tensioner was fine, and it was my crank pulley all a long. I'm figuring that 3 thing will need replacing:
1. Crank Pulley (the source of the problem)
2. Serpentine Belt (since it's probably half melted)
3. Timing Cover (can't see that water getting in there would be good)
Does this sound accurate?
View 11 Replies
My daughter has bought a 2003 4 door accent and on the way to work she lost most of the brakes. I could not see any fluid leaking and the level was ok. I did try pushing on the brake pedal with my hand and it was making a noise like a clicking? I was thinking it was just the brake light switch but not sure. The place she bought it from put new brakes on it when the driver side was getting really hot. I am thinking maybe air in the system? It sounded like a caliper was sticking when I test drove it but only a couple of times. You would have some brakes but you had to pump the peddle.It is in a parking lot right now but I can work on it unless it is some sort of different? I am going to try to bleed it in a little bit but was thinking I should ask around. I read that the piston could be sticking but can you just rebuild the master cylinder to fix it if that is what it is? I could pull the pedal back a little bit. I only looked at for 4 or 5 minutes kinda dark and no tools with me.
View 10 Replies
My car is a 2002 Accent. So last weekend I replaced my timing belt and my 3 other belts. Before I did this the belts were not squeaking and I was not having any issues with my power steering. I started my car up and the power steering pump was making lots of noise, the power steering reservoir was still full. I was told it's probably the power steering pump and that I would need a new one. So I got a new one, put it on and still the same thing. I looked online and saw that it may be an air bubble in the line so I removed the cap on the reservoir and, with the car turned off and the front wheels off the ground, cranked the wheels lock to lock about 20 times. I started the car and it still makes noise. This morning the power steering felt like it was lagging as I was backing out of my driveway and the squeaking happens when I am idling and gets louder and worse up to about 2000 rpm then stops, which it has been doing since I replaced the belts. I am not sure what else to do, did I mess up the new pump by driving and not bleeding the air out?
View 2 Replies
The steering on our 02 Accent has been becoming more and more difficult. The belt on the AC compressor snapped off recently. Could this missing belt be causing a problem with the power steering belt? The power steering belt is now making a squeaking noise.
View 3 Replies
I drive a 2000 Celica GT 5 speed. I am having an issue with my 1ZZ-FE.
I am hearing a ticking/rattling noise from my engine around 2k-3k RPMS. Anything before or after that, the noise dies down. I could hear it from the interior of the car as well. I at first thought it was valve chatter. Someone said It could be a piston or rod. What parts will be needed? Worst case, ill just swap in a 03+ 1ZZ or go with a 2ZZ.
[URL] ....
View 2 Replies
I have a 2001 accent 5-spd. I was on my way to work and I was making a u-turn when the car suddenly died. I tried to start it back up but it didn't even sound like it was turning over. I tried to bump start it or do a rolling start and nothing. I had to go to work. When I returned to it 8 hours later I again tried to start it and nothing. When I turn the key it makes a "whirring" or "humming" noise, kind of like a vacuum noise. When I had someone else try to turn it, I noticed the belt was turning, but the engine wouldn't crank or make any attempt to turn over. Just the belt was spinning and no engine crank. What could this be?? Could it be the crank position sensor?
View 1 Replies
