Accent LC (2000-05) :: Clicking Noise When Decelerating And Braking
Jun 28, 2014
When decelerating and braking, there is a strange clicking noise, and it seems to be coming from the brakes in some way on my 2002 Accent. It does sound like a metal clicking. Steering doesn't affect it, it happens on a corner or on the motorway. The only way to stop it is accelerate. The clicking is faster when the car is going faster, and slower when the car is going slower. The brake pedal isn't vibrating or anything, and I cant actually feel it.
I am certain this is a braking issue as it only started just after I got new brake pads about 2 months ago. It is not transmission related or anything like that. I have had some suggestions about axle's and CV joints but I doubt it's either of those as they are in good condition, and as I said, this started directly after having new brake pads installed!
View 5 Replies
Advertisement
This start this morning on my way to work. When I took my foot off the gas I would hear a clicking knocking sound the sound slowed down as the car slowed down. Any time I took my foot of the gas this would happen. Was still there when I hit the break. If i had my foot just barely on the gas it would go way. Its an automatic 2000 Accent 156K miles.
View 20 Replies
Recently I've noticed more that when we first start the hyundai in the morning or after sitting a while and we use the brakes it grinds/ squeals a little and then doesn't after about 2 or 3 miles. Is this something to get checked out or should I spray something on my brakes to lubricate?
My next step that I though of was to get a simple automatic car wash cause it's been a bad winter in Rhode Island and the street shave been flooded with rock salt. I figure that might cause some friction under the pads.
View 1 Replies
A few months ago my automatic 2000 hyundai accent GL was having problems reversing. Some times it would, sometimes it would move a few feet then fall out of gear and stop, sometimes it would not move at all.
The reversing problem fixed itself about a month ago.
Recently i started having problems accelerating, it was noticeably slower to get to speed and had problems upshifting.
Today, it started to make a buzzing when in Drive, while decelerating after getting to speed. This buzz is nonexistent in neutral, 2nd, or low gear.
Here is a video of the sound it is making, with captions to explain what i am doing... 2000 accent transmission problem - YouTube
View 2 Replies
I have a 2002 Accent with a manual transmission with just over 100K. It has for some time had a low whine, which is getting worse. Not wheel bearings. The whine increases with speed, and seems a little louder when decelerating. Makes the sound in every gear and when in neutral (coasting at speed). Brought it into a mechanic and he thought bearings in the transmission (though I don't know why it would make the same sound when in neutral . . .). Shifts through all of the gears fine, no other odd sounds. Can't find any information out there that sounds like my situation.
View 4 Replies
We have a 2005 honda civic hybrid; there is a squealing noise coming from front passenger side, when braking, when accelerating, decelerating, but not while driving at speeds of 30 mph, straight. Also when backing up, turning wheels. It's going to the mechanic on monday for regular maintenance, 100K miles, etc.
View 3 Replies
I have an 05 accent and about 6 months ago I started to notice a clicking sound coming from the belts area ( it sounds exactly like a BBQ grill igniter when it's pressed), the sound starts as soon as I start the car and stays pretty much the whole time, I had the car lifted by my mechanic and he discovered the problem in one of the belts ( not sure what is called but it's the one at the very bottom of the belts, the first one you see when you lift the car ), the spark is seen at the edge of the pulley or where the belt sits on the pulley. The mechanic was puzzled about this, he recommended replacing the crank sensor as a first step, the car runs fine and there is no other symptoms or issues
View 2 Replies
My daughter has bought a 2003 4 door accent and on the way to work she lost most of the brakes. I could not see any fluid leaking and the level was ok. I did try pushing on the brake pedal with my hand and it was making a noise like a clicking? I was thinking it was just the brake light switch but not sure. The place she bought it from put new brakes on it when the driver side was getting really hot. I am thinking maybe air in the system? It sounded like a caliper was sticking when I test drove it but only a couple of times. You would have some brakes but you had to pump the peddle.It is in a parking lot right now but I can work on it unless it is some sort of different? I am going to try to bleed it in a little bit but was thinking I should ask around. I read that the piston could be sticking but can you just rebuild the master cylinder to fix it if that is what it is? I could pull the pedal back a little bit. I only looked at for 4 or 5 minutes kinda dark and no tools with me.
View 10 Replies
Recently, my 04 accent (97,000 miles on engine and auto trans) has started to develop a rattling or Clanking noise coming from the engine at low RPM's. I flushed the engine and changed the oil and oil filter, thinking it could be due to oil clogging the HLA, But this was a no go. The engine is still making the noise, and I think it is starting to get worse.
The noise only happens when the car is idling at low RPM's. As soon as I rev the engine past 1000-1500 RPM's, the noise stops. The noise is worse when idling in gear, either reverse or drive, however as soon as you accelerate past 1000-1500 RPM, the noise goes away, until you decelerate to low RPM again. I'll try to take a video of it and post a link to it on here tomorrow.
View 11 Replies
I started noticing the noise about a week ago, When i seem to let of the gas or even once in a wail push on the gas Hear a "CLICK" noise, this is not when pressing the brakes at all only when letting off pedal?
I am thinking it could be transmission, but have read it could be a few thing, From the brake pads to CV joint to trow out bearing, Axles, Lightened flywheel, Motor mounts, etc. But i am unsure where to start, Its and O2M 6spd tranny in my 20th, with lsd installed, lightened flywheel, VFmotormounts...
View 7 Replies
I have an 2002 Hyundai Auto.
My car has the clicking noise under the following situations:
1) rolling in neutral with/without brake applied
2) rolling/decelerating without gas pedal pressed (I guess the same as rolling in neutral) with/without brake applied
The noise is the most noticeable when going at around 20 to 30mph, and would be gone under very low speed <5-10 mph. The weird thing is when I press the gas pedal and the car is accelerating, the noise is gone too.
My mechanics said it is because the wheel cylinder which is noisy. But I don't quite understand why the noise is gone when the car is accelerating.
View 8 Replies
I have a 2000 corolla ce with 51k miles I bought recently.
While going to work this morning, I had to hard brake from 50mph. The car slid several feet but came to a safe stop.
Now when I'm driving, my right wheel is clicking....like a light clicking noise. Could hard braking have damaged the wheel bearing or cv joint?
View 1 Replies
On my 2004 Accent GL 1.3, the digital clock in the center facia panel seems to always reset itself. At first, I thought it was random, but now I notice that when it does cut out, I have just started to press the brake pedal. It doesn't cut out every time I brake, but it only cuts out when I brake. It comes back at its leisure, sometimes immediately after releasing the brake pedal, and other times much later, seemingly randomly.
The wire harness going into the digital clock has 4 contacts (2 of which have two wires each). I can find no mention of this wire harness in the Body Electrical manual on hmaservice.com, so I'm not sure where the wires come from. The wire harness itself looks fine.
I would imagine that the problem is caused by a short between the +12V (actually, I'm not sure how many volts) wire going to the digital clock and the braking circuit somewhere, but I don't know.
View 7 Replies
They originally had the issue where the truck open light was on accept when braking which I traced back to the harness in there trunk, a few months ago while they were getting there oil done there mechanic said they would just remove the harness and tie the wires together without the harness to prevent the possibility of a new harness corroding as well. but after doing so there rear defogger no longer works so somewhere they did something wrong but with the harness no there anymore I cant really tell myself.
View 1 Replies
Driving along down the highway, was braking to make a turn and they car stalled on me. tried to crank it over in neutral. then pulled over put it in park and cranked it over, nothing... got a tow home and in the garage. The car will turn over till the cows come home and i can smell fuel. I pulled a spark plug out and got a spark. Check engine light stays on with the battery light.
2005 accent 1.8
148k miles on it
new spark plugs
Will I get a spark if the crankshaft position sensor is bad?
View 25 Replies
This morning I went thru a known rough patch on the road and was applying light pressure on the brakes as usual (EV doing about 20 mph). Once the wheels started bumping, a loss of deceleration occurred as expected but what I did not expect was a fairly fast clicking sound (about 30Hz). I *believe* it sounded like the click that is heard when the traction battery is engaged in READY mode, but I'm not completely sure. Where it came from since I was using the A/C and rag chewing on the ham radio. The clicking subsided once I lifted the foot from the brake pedal and reapplied the brakes. No indicator lights came on and the car continued behaving normally.
View 3 Replies
I purchased a 2011 Sonata Limited Edition TODAY. It was a lucky find as the car has less than 30k miles. As I was driving home (back roads and interstate), I heard a clicking noise every time I hit the brakes. I do not hear this noise when I back up and brake, only when the car is in drive and I am braking.
View 3 Replies
My 2005 Accent began making an odd clicking sound about two years ago when I would decrease my speed, not using the brakes. It wasn't loud, just annoying. It went on for some time until my car went into the shop to have the alternator replaced. I explained the noise to the mechanic and they checked it out. They explained they added some type of cleaning fluid somewhere under the hood, and the sound was gone. I was thrilled.
Last year, the sound returned again. Annoyed, I began saving to bring it in to the shop again. In Feb 2013, I had my timing belt and water pump replaced because my mileage of course called for it. The mechanic said he could not hear the clicking sound I was reporting (I really didn't see how.)
Two months later in April, my car decided to die on me and after 5 months I just recently got it up and running again. My differential and transmission were both completely rebuilt. Also, my CV axles have both been replaced. Now that I have my car back, the clicking sound is louder than before and also now happens when I accelerate as well. The faster I go, the faster the clicking gets until it eventually stops. When I slow down, the clicking starts again until I hit my brakes.
I want to take my car and get this noise silenced once and for all since they didn't hear it when my transmission was done last month. What fluid may have been added to what part 2 years ago when this was handled initially?
View 5 Replies
Every time I fill up my gas and put the hands free nozzle switch it clicks every time.
View 5 Replies
Just finished my second week in my PIP and I started to notice a clicking noise everytime I press the brake. Even if I'm stopped in my garage I still hear it. Not sure it was there from day 1 and I just didn't notice because I had the SAT cranked up or if it's recently started.
View 6 Replies
So I've my Prius C2 for about 4 months now. Sometimes, when I want to get into my back hatch and I know the doors are unlocked, I cannot get it open, like I have to really yank it open to make it work. Something like suction cupping together...
View 14 Replies
