Accent LC (2000-05) :: Car Cranks Strong But Doesn't Fire
Jan 25, 2014
About a month ago my 2002 accent started intermittently turning on. The car cranks nice and strong when it doesn't start-(until the battery loses too much power from repeated cranking). When it does start, it happens instantaneous, no issues no hard start.
I have talked to multiple people with varying amounts of automotive experience, who have given many things to try.
Things I've replaced or tested, hoping they were an issue:
-Starter and relay
-Fuel pump and filter, as well as relay for pump.
-Battery, post connectors and wires to starter
-Alternator and belt
-Multimeter tested fuel injectors and ran fuel system cleaner for last 3 fill ups
-Replaced spark plugs and wires
-Ran fuel line antifreeze every 2 tanks or so
Things I've been told might contribute to the intermittent starting, but haven't looked into
-Inconsistent fuel pressure
-water in the fuel tank
-Bad ignition switch
-MAF sensor
I live in area, currently in the icy grip of winter. I thought the cold would be a huge contributing factor, but alas, when the car has fired up the temperature has ranged from 1 to -32 degrees and has no issues starting in the deep cold.
View 9 Replies
Advertisement
My 2001 Accent GS (1.6L DOHC) wouldn't restart after a short 2 mile trip to a local store. The engine cranks fine but doesn't fire.
It has had a CEL issue for awhile and after it wouldn't start I checked the codes and got:
303
335
722
I replaced the Crank Position Sensor and Fuel Filter but it still just turns over.
I hear the fuel pump run when I turn the key on and I broke the fuel line and it is Pressurized, so I doubt it is a fuel issue.
The 722 code indicates the output speed sensor has an issue. Need to know definitively if that sensor is completely shot could this prevent the ECU from firing the engine?
I have had this car since it was brand new and I'd like to keep it going a little longer.
View 5 Replies
I have a problem with my Durango whenever i drive my car it is fine and normal. When i get to where I am at and i try to start my car again it will just turn over like it wants to start but doesnt. I just recently started driving the car for about 4 days ago and it drove fine. Until yesterday i got to my shop and tried to start it.. it will just crank. I scanned it and it turned out i had a bad crankshaft sensor. I gone ahead and replace that and the car starts up fine. I drove it around town and then this morning drove it to work and when i tried to leave for lunch it did the same thing. It cranks but does not fire up. I scanned it.. and no codes. My dad was saying something like sometimes it has sparks going to the crank and sometimes it doesn't.
View 2 Replies
My hyundai accent 2004 standard doesn't start. The engine crank, but there's no fire. I change the camshaft and crankshaft sensor. Also change my timing belt, my alternator, my starter, my control box and my computer. But if I pull the car with my pickup, it runs. While the engine is running, the computer doesn't give me any diagnostic code. I also check my fuse, relay,... Even jump start the starter to check if it was the switch.
View 4 Replies
My daughter has a 03 Accent that within the past week will not start at certain times. Some times it will some times it wont. It always cranks but doesn't catch. If she tries to start the car and it cranks, but doesn't catch, if you wait 15 -20 minutes, or longer, it will turn over and run fine. We are thinking crank position sensor or possibly fuel pump...
View 4 Replies
96 sebring 2.5l v6 non-convertibleRan terribly for 12 blocks when I bought it, then died and wouldn't start.Bought it because friend said that mechanic had told him it just needed the head gasket changedReplaced the head gasket then it would crank but not start
checked, getting spark and compression on all 6 cylindersreplaced:-ecm-crank position sensor-combination distributor/camshaft position sensor/coil-flushed fuel system and replaced gas. checked everywhere for possibly misconnected wires and possible misconnected vacuum tubes, they are all triple checked ok. Checked the timing about a dozen times. Checked for misaligned timing sprockets, all ok, no sheared keyways, valves open and close at appropriate times / correct order and crankshaft timing mark matches cyl 1 position.
Fuel pressure is great.Turns over but doesn't fire at all.
View 1 Replies
I have a 2001 mustang convertible in good cond. A 6cly that I have had very little trouble with over the past year. I put in a new battery then, just after I bought it from a dealer. The dealer had gone over it with fluids etc. and I had a friend look it over when I bought it. He said it was very clean and a good buy. So, last week I started having trouble starting it in the morning. It would crank but would not fire. I turned the key off, and then tried again, Same result, cranks but doesn't start. I turned it off again and being worried about draining the battery, I turned everything off, radio, heat and fan, lights. Then I tried to start it again and, it started. I'm thinking I need new plugs, but I ignored the problem and went to work.
A couple days later I was leaving the grocery store, turned the key and same thing again, cranks but doesn't fire. I knew what to do. Turned off everything and tried it again, it started. Ok, so now some repair, possible plugs, is on my priority list. I need to get this fixed before the bad winter weather comes. Yesterday, after a long day at work, I was ready to go home and I it happened again. This time it's terminal. No matter what I did I couldn't get it to fire. This morning it's sitting in the office parking lot and I need to deal with this today.
Could be plugs, could be the fuel pump. Before I call the dealer and pay 4x what I should for this, what do you think it could be? 3.8 6cly. The car is sitting on a slight incline, in the parking lot. Gravity pulls fuel from the engine to the gas tank, if a fuel pump is going bad this could be why I can't get it to start. I'm going to roll it to a level area and hit it with starting fluid to determine if the pump is bad. I'll also pull a couple plugs.
View 18 Replies
I have a 03 xc90 t6 came out of work the other day and it wouldn't start replaced spark plugs, both cam sensors, crank sensor. After doing all that it sounds like it wants to fire now but doesnt.
View 1 Replies
I have a 2003 Ford Ranger 4X4 4L AUTO. About once every 6 months it will not start. It cranks just fine but doesn't fire. After about 45 min. it start and runs great for an other 6 Months. I have replace the plugs, wires, distributor cap but it hasn't solved the problem. It has had this problem when it is cold and warmed up.
View 4 Replies
Sometimes my Bravada won't start. It cranks good (new battery) and I can hear the fuel pump , but it doesn't fire up. I just got it back from the repair shop.?
View 4 Replies
My 2000 Jeep Grand Cherokee Laredo won't start...It cranks strong but won't turn over..I can hear my Fuel Pump kick on from the back of the Vehicle but it won't kick on listening from the engine compartment??I checked all fuses.I had a tune up a couple of months ago..My check engine light was on before the tune up and my mechanic said that the tune up corrected the problem the car was coding out... I've been told to check the ALARM by turning the alarm on and off and also unlocking the car Via the driver door.. This didn't work.. I've been told to check the Fuel cut off switch(RESET BUTTON) for my make and year but can't seem to locate it...
View 1 Replies
My problem is with a 2000 Mountaineer V8. Once a year I have to replace the battery after the first cold snap due to low cranking amps. I can simply hook up a battery charger and it will crank and fire. My second problem is most likely related. When I replace the battery it will kick off like a brand new car with no hesitation. After a few starts it takes 5-15 seconds for the engine to fire while the engine cranks normally, and that's how it operates all year. After having this problem again this year (I've owned it 4 years) I've realized the underlying problem is not the battery. All the connections are good, and it has a good ground. No lights or warnings, and when tested with a handheld scanner there are no error codes.
View 11 Replies
2000 ford f150 4.6 auto. Will spin over but won't start. checked coil for fire, no fire. Check fuel rail for fuel, no fuel. No theft light flashing and no check engine light on. Has new battery and plenty of fuel in tank. Started fine yesterday but not today.
View 5 Replies
I am having trouble getting my 2000 7.3 (200k) to start on the colder mornings. It will crank over fast, but won't start without a lot of tries. Today it took 6 pre-heats and cranks, but on others (and colder days) it has started easier. It does seem to be getting worse though.
I have replaced the glow plug relay recently so it *shouldn't* be that unless the replacement is fried. Starts fine the rest of the day and drives fine, but not in the cooler am (it was about 34 this morning). I also tested the batteries yesterday and while they aren't new, they tested okay.
Also, I read (briefly) about the CPS, but forgot to watch the tach this morning, but did notice it is pushing smoke out when turning over.
View 12 Replies
I have a problem that I cannot pinpoint. For at least 2 months now, I have noticed a strong odor almost like a diesel coming from the exhaust. I replaced the plugs, wires, air filter and cleaned out the throttle body but it remains. No check engine light and runs smooth. Also, noticed a significant loss of coolant from the overflow bottle. Filling it every 3 days. Took it out to inspect for holes or cracks and nothing. Not sure if all these are related. Every oil change the used oil smells like fuel. I was thinking rings going bad but don't think that would solve the coolant loss which is unseen. Everything under the hood is dry.
View 5 Replies
Well zipping along the highway tonight, sitting on 100KM/h, and all of a sudden the engine loses all power. As luck would have it a fuel station was just closing (the only one for half an hour either side) and kept the lights on so I could have a look. The starter is nice and lively, and the engine is trying to fire, but just wouldn't. I asked a mate of mine in town to come out and give me a hand troubleshooting.
As it turns out, when the ignition switch is set to the "ON" position, normally the fuel pump primes the lines. It's only doing it intermittently for some strange reason, and not making it past the fuel filter (despite the filter being new). The temporary buzzing in the engine bay when the car is switched off is gone now too.
Now my question is - does this sound like fuel pump? I'm only used to the older fuel pumps in carburetor vehicles, not these fingle fangle electric things!
View 4 Replies
My 04 accent will not start. I have an automatic. It cranks but will not start. First I replaced the fuel pump and relay. Still nothing. Wasn't getting fire until my friend tested to coil and i tried to crank while the tester was in the ground wire while I turned it over and it cranked. Only worked for about an hour and is still not starting but it sounds like something isn't telling it to crank?
View 1 Replies
I have a great little '01 Accent and it has been a blast. That was until it decided not to start. I was on my way home from work when I realized the car was acting sluggish. It was not accelerating like it should have and it was it did not seem like I was going as fast as it said. When I went to go use it again, it started, then died and has not started since. I checked oil, and it was low. It wasn't out, but it was low. I have checked batt, fuel filter, fuel pump, and loose wiring.
View 3 Replies
Been having issues the past month with the car taking a couple times to start. It's very sporadic. Sometimes I'll only have this issues once a week. Sometimes once every other day.
Engine cranks it's just not firing. Almost like what would happen if you were out of gas. Sometimes it takes 2-3 times. Just yesterday it took about 5-6 times. Once started though the car seems fine. Drives fine, haven't really noticed any hesitation nor has it died while driving.
1.6 automatic
130,000 miles
no CEL on
new plugs at 100,000 miles
Changed the fuel filter when i noticed it happening and ran some fuel treatment cleaner in it.
We took it into the shop and of course every time they checked it out it started up fine. even left the car there for 2 days and started up fine for them. They said they couldn't really diagnose it as it seems ok to them.
Fuel pump going bad? Fuel pressure regulator going bad? Crankshaft position sensor going bad?
View 5 Replies
My wife's 03 accent cranks over good, but won't start. It does fire some but won't start. I tried squirting starter fluid in the intake and that only made it fire less. Spark is strong on all four cylinders. At first I thought I found the problem because it had weak spark on the middle two cylinders and i replaced that coil pack and now all four are strong, but still same problem.
She drove it home and parked overnight, and in the morning it wouldn't start. I don't think it is the timing belt. I replaced it not too long ago, and I took a peak behind the top of the cover and all still appears to be as it should.
I am now at a bit of a loss. I mean it has good spark, won't start with starting fluid, so what could it be?
View 3 Replies
Went to Advanced Auto to get the battery tested since it takes a few cranks for the engine to start. I thought it was the battery but after testing the battery they think maybe its the starter because the battery and alternator shows that its perfect.
I will also be taking the car to get the timing belt and drive belt replaced and the spark plugs and wires. I just want to know if you all think its the starter or should i check anything else.
View 3 Replies
