Accent LC (2000-05) :: 2004 Chugging Like A Tractor / Exhaust Also Spits And Misfires
Aug 12, 2015
My problems started at the beginning of the year when my car for no reason would cut out each time i slowed down. Had a minor service done and it seems to have gotten worse. It now chugs like a tractor.
I have replaced/done:
Sparks
Coil pack
Fuel filter
Battery
Drive belts
Coil leads
Oil pickup filter
oil filter , New oil
I have also taken out the Crankshaft sensor and its fine.
Today i struggled to get my car home because it chugged that hard it felt like the car was going to stall. Its an automatic. I left it running in my drive way for about 10 minutes and it cut out, but it started back up straight away. It still continued chugging. The exhaust also spits and misfires.
View 9 Replies
Advertisement
My accent is misfiring at startup, and randomly at stoplights. Pulling the code tells me it's the #2 cylinder. I have no trouble at highway speeds, the car really drives fine outside of stoplights and startups. The idle hovers around 900 rpm. Sometimes, once I'm on the road and driving, the CEL will go away altogether.
My main question is, is there any way to be certain that it's the 2/3 coil pack? I don't want to spend on parts that won't fix anything.
View 9 Replies
I have a 2000 lc 1.5l ... I just rebuilt the motor machine shop work and all it Will start and run for 3 seconds and then die. If I hold the gas pedal it will run but sound rough and as soon as you let go it dies I have been able to get codes multiple misfires, misfire cylinder 1, misfire cylinder 2, and misfire cylinder 4 I have put brand new plugs (copper core ngk), wires coils, crank sensor, cam sensor, iac, tps, maf and the injectors all have new orings it also has ntk o2 sensors that might have 1000 miles on them...
View 1 Replies
I recently bought a 2003 Hyundai Accent 1.6L DOHC manual transmission hatchback with 124000 miles. So far the work I have done in the car include replacing front bank 02 sensor, new flex pipe, exhaust manifold replaced with a used OEM part. Everything is going great with the car except that the check engine light is on with the P0442 and I occasionally smell gas or exhaust fumes (not sure) while driving and it goes away. My combined mpg is only about 23mpg.
I replaced the gas cap with a brand new OEM part then cleared the CEL. However, after driving 90 miles, it went back on so I brought it to my mechanic who recommended a smoke test. After the smoke test, he said the charcoal canister and the diagnostic module needs to be replaced. Is it worth replacing to fix the CEL code and if the code is related to me smelling fumes inside the car while driving. Also, I would like to know if there might be another problem causing this code instead of the charcoal canister or the diagnostic module.
View 2 Replies
I have a 4dr 2005 Hyundai Accent, CL. It has 139,927 miles on it.
Today when I was accelerating onto the Hwy, a dashboard light came on. When I checked the manual it says "Malfunction Indicator Light". It says, This light illuminates when there is a malfunction of an exhaust gas related component and the system is not functioning properly so that the exhaust gas regulation valves are not satisfied.
View 1 Replies
I've been getting bad gas mileage for the past two years or so. I also get a fume smell when I run the car for a while. I have strong suspicion there might be a leak in one of the exhaust gaskets.
I'll be changing the exhaust manifold gasket and both exhaust flange gaskets. I'll also be changing both O2 sensors. The car runs well and smooth. It's just those two things.
View 6 Replies
2000 Hyundai Accent with 180K. Runs and idles smoothly. When sitting for a few minutes at idle I get a waft of smoke when I accelerate. The car burns minimal ammount of oil and the smoke is not apparent while driving.
View 4 Replies
I have a problem that I cannot pinpoint. For at least 2 months now, I have noticed a strong odor almost like a diesel coming from the exhaust. I replaced the plugs, wires, air filter and cleaned out the throttle body but it remains. No check engine light and runs smooth. Also, noticed a significant loss of coolant from the overflow bottle. Filling it every 3 days. Took it out to inspect for holes or cracks and nothing. Not sure if all these are related. Every oil change the used oil smells like fuel. I was thinking rings going bad but don't think that would solve the coolant loss which is unseen. Everything under the hood is dry.
View 5 Replies
I recently bought a accent, changed the oil then upon starting it back up it just pours out white smoke from the exhaust. i might have put a little too much oil in, would that cause the issue? It didn't happen before the oil change either.
View 6 Replies
In my quest to get my girlfriends car working, I'm encountering several hurdles, but this one is quickly the most expensive waste if the wrong parts are installed. The car is running rich and rough, lacks power. Here is what I have
Code P2096 - Post Catalust Fuel Trim System Too Lean. The manual indicates: Faulty PCM, Faulty Cat, Faulty rear o2 sensor, or hole in the exhaust line.
When I replaced the o2 sensor, I reset the OBD system and the car ran like a dream for about a week, then same problem, started running rich and rough again, a huge loss of power as well. It doesn't smell like a bad cat, I've replaced to o2 sensor.
View 1 Replies
I just bought a 03 accent the same day i bought it the CEL came on got it read and it was cylinder 4 misfire. took it to the garage the dealer i bought it from takes it to he said there was a little water around the boot in that weird little channel area under the cover he said he cleaned it up dried all out then reset the code and it was good, for a little about 2 weeks later it comes on again i get it read and it says cy 4 misfire again but also P0133 (o2 sensor bank 1 sensor 1) and i cannot remember exactly but i think the CEL came on after the exhaust started sounding loud, like it has one of those ricer mufflers on it.
Well I jacked up the car today and looked the only thing i saw was after the first cat right before the braided flex pipe there is this weird "shield" looking piece on the underside of the exhaust pipe dunno if its really supposed to be there or what it is for but from somewhere under that piece i can see exhaust coming out(its cold right now) also the flex piece is kinda blackened like its had exhaust fumes blowing on it for a while. i cant imagine why this would be a normal thing but i have never worked on hyunda before. i am thinking if there is some sort of "leak" there that is why the o2 code is showing. i am stumped, esp on the cy 4 misfire all sparks and wires look good i pulled each wire with it running and it bogs down til i plug it back in.
View 4 Replies
2004 hyndia accent . Car starts drinking up oil like crazy, no smoke no leaks.
I added some oil one day, started to stall out. I had to jump start it. Ran for 5 minutes fine then huge white smelly smoke from exhaust. I haven't tried to start it since.
View 3 Replies
The car had no accelerating power and it was well overdue for new spark plugs and wires. I just replaced them and it's doing much better, however, the engine seems to be shaking a bit when I start it/idling, which is making the entire car shake some too ( the seats, car shifter, etc ) . It's been awhile since I've also replaced the air filter too, which I obviously should have checked but haven't yet. When I replaced the spark plugs, I noticed there was a minor amount of engine oil on the spark plug wires, where they connect to the spark plugs; more notably the front 2(of 4), left and right. I also just changed the oil and there was no oil loss really, other than any minor amounts that get burned off through the miles.
The exhaust manifolds ( y-split ) are okay, but one of the nuts seems to loosen over time, causing a minor air leak there and makes it a tad noisy. Near the back half of the exhaust system, there some water dripping at one of the connections, and at the tail pipe the exhaust smoke is chugging and isn't consistent sounding.
What is still causing this engine shaking and the chugging noises from the exhaust system. The 'Check Engine' light is on, due to other repairs I know I need to make, such as an 02 sensor and fuel level sensor; however, lately it has started blinking too.
View 7 Replies
Currently throwing both P0441 and P2096, just prior to this I was also throwing P0442.
Read around on web and decided the simplest thing it could be would be the fuel cap, may as well start there. Owners manual even recommends changing at 90k. Got a replacement from advanced (which is supposed to be built to OEM specs), re-set battery light stayed off, attempted to pass emissions but a few systems were "not ready". Was good for 80ish miles. Light came back on throwing P0441 and P2096. I re-tightened fuel cap and re-set battery, light went off.
Did some maintenance; spark plugs, air filter, oil/filter change and replaced the leaky oil pan. Keep putting on miles hoping to get to the recommended 200 mile mark before stopping by the emissions testing facility, 105 miles after re-set same codes came back. I'm almost positive I replaced a o2 sensor 2ish years ago for emissions. Also there is an obvious exhaust leak which could be a culprit. I seem to remember reading somewhere that a weak battery can cause problems with fuel pressure... not sure if it's true or not but for what it's worth I do know my battery is on it's last leg.
I'd like to avoid unnecessary fixes, it's only my winter car so as long as it's nothing major I'm not going to dump money in it. I'm going to take a guess and say the check engine light is coming on when these systems become ready. Plan is to try this re-set one more time hope for the best and if not replace exhaust or at least repair leak. Not sure on my next step for P0441 though. Vehicle is a 2004 Hyundai accent with 86k on it.
View 1 Replies
I've recently replaced the timing chains on my sons 04 F-150 5.4. Now I'm getting a code PO174. I've changed 2 coil packs, fuel filter, MAF sensor and cleaned all the connections. Fuel filter had what looked like brown fuel coming out of the in line of the filter. I'm stressed out now, the truck does not even have enough power to drive up the driveway. Backfires, spits and sputters, has rough idle.
View 4 Replies
My accent 2006 has the check engine code p0171. AT mornings I have to start the car like 5 times until it revs up and do not stall. Also when the car is running, If I press the gas too much it starts misfiring and have really slow acceleration. I have already change the 02 Sensor, spark plugs, TPS and maf sensor, and PSV valve, cleaner the throttle. I really don't know what else to look for.
View 5 Replies
So the other day 2/3/2014 my dad and I went out during the snow storm for the people that needed assistance. That day I pulled a 95' RWD dually with a 4 car open trailer and pushed 4 people from one location. Then after I went to assist the tractor trailer driver. My truck is a 2002 F250 super duty 5.4L with 4:10 gears. I got him unstuck then pulled him a 1/2 mile up a hill.
Pulling a stuck semi out of the snow - YouTube .....
View 6 Replies
Long story, I'll try to make this short, 2000 E250 5.4L What would or could happen if the catalytic converter was removed from the exhaust system?
View 5 Replies
I have a 2000 crown vic, police interceptor..... 1st.. car started idling rough had the codes read gave misfire on 4 . So we had the boots and spark plugs replaced. Car ran fine for like 3 days then engine light came on again.. running rough... code read misfire in 8 so had the coils on 4 and 8 replaced... ran fine for all of 2 weeks. Again engine light came on... now showing a misfire on 7, but car runs fine..??. Anyways I noticed my battery gauge was marking a really low charge... but as soon as I would get on highway it would jump back up to normal...
It did this for a couple weeks, then I noticed the gauge was marking really low car was losing power... I have a new battery and alternator on car already. But still I had them tested; both tested fine... Then car kept stalling at stop signs ans red lights went ahead and exchanged alternator 4since its under warranty anyway. This cause the charge gauge was reading normal.. but car still kept dying... so replaced fuel filter... didn't replaced tps and mass air flow sensors too...but it still keeps dying on me. Now codes are coming up misfires on 4&8! Why does my car keep stalling and what would cause these random misfires especially when these coils have been replaced already???
View 5 Replies
My 04 accent will not start. I have an automatic. It cranks but will not start. First I replaced the fuel pump and relay. Still nothing. Wasn't getting fire until my friend tested to coil and i tried to crank while the tester was in the ground wire while I turned it over and it cranked. Only worked for about an hour and is still not starting but it sounds like something isn't telling it to crank?
View 1 Replies
I own a 2004 Ascent 1.6 DOHC ascent VIVA. I am the first and last Proud owner of the vehicle. From last couple of days I have noticed Both my front wheels are getting Tooo hot, resulting in Flat tyre. In last 02 day I have lost my both front Tyres.
Authorized Service Center told (10 days back) me Brake Pads (Front) needs replacement to overcome the problem. But Still problem persists.
Now He says Master Cylinder and Booster Pump needs to be replaced.
View 5 Replies
