I have an accent 2003 1.6 dohc crank but not start !!! Who do not fire and no gas ... and the check engine light is off when I turn the key on... (I test the check engine light and it is not burn).
I change the engine control relay and this is not work... I have all the wiring diagram and I check wire by wire and I don't find anything...
I have a 2000 f350 7.3 got a check engine light that turns off when rpms go up and a slow start. My mechanic said that there were no codes being blown, what is going on?
View 11 RepliesMy check engine light is on and I'd like to try to read the codes myself without the machine. Any proper link here that I can follow to read the codes? When I search I'm returning mainly threads that tell me to GO get it scanned versus pulling the codes myself.
2002 Hyundai Accent GS
If you get a f!ashing cel ,the next time you start it should it flash right away or can it go back to solid on cell? 02 Accent 1.6 130 k. What can be done to check the flex pipe for a leak? Can you spray water or what? The outside looks good. Also looks hard to check around intake manifold for leaks.
View 11 RepliesJust curious as I don't see the check engine light on my Accent 2004 GVS. Not even when I insert the key in the starter switch.
My mechanic told me this model doesn't come with a check engine light which I cant believe.
My 2001 accent 4dr will start up no problem when everything is cold, but once I let it idle for about ten to fifteen minutes and if i shut it off, it will start back up but then it stalls and wont start back up, or if i just let it run a little bit longer it also stalls, no problems with fuel pump or relay when it is cold it starts right up, but once it stalls it wont turn back on....the pump is getting power even when its hot so could it be a bad wire or should i test the coils when it gets hot or am i completely looking at the wrong thing?
View 4 RepliesMy sister-in-law just came home with a P2069 code. I can't seem to understand how to use the search feature here, every time I enter the spam code its invalid even when I am entering it correct...
View 8 Replies2 days ago my 2000 Hyundai accent Gl 1.5 stalled while driving i lost no power to my electrical system all my lights and stereo stayed on but i lost all engine power the check engine light popped on and i had to have a friend tow me home this has never happened to me before. I had sat in my yard for about a year before i started driving it again due to money problems. I did a tune up on it before I took it out anywhere and ran some lucas injector cleaner and changed oil added some oil additive and changed my air filter spark plugs seemed fine so I didn't replace them and it ran for almost a month just fine i have about 150k in miles on it then suddenly just died while driving home from work I am thinking its in my fuel lines filter or pump are clogged up but I am not sure. I am going to start diagnosing it tomorrow. I can't get the check engine light looked at cuz I can't get it started.
View 2 Replies2001 GL 1.5 Litre. Car occasionally hesitates a little with AC off, but runs pretty well. But with the air conditioner on?
Stalls about 50% of time when backing with A/C on. From stoplights, sputters all the way through intersections with A/C on, sometimes backfires. On a few occasions, the Check Engine light will blink on and off while it's doing this. After it gains a little speed/rpm, though, it's all good again, light goes back off.
Had full tune-up just before we bought it 4,000 miles ago. Air filter clean. Not sensors, because the CEL goes back off by itself. What the heck? How could the A/C cause a backfire?
I have a 2004 Accent GS. It is an automatic. I have had it for almost a year.
In early November, the check engine light came on when the temperature dropped drastically and it went off when it warmed up a bit about 3 days later. Since then it seems to come on randomly and stay on for a few days then go off (usually around once-twice a month). Then in late December I noticed that the car had trouble starting after I refueled it, the first two times I though it was because I had let the fuel get down too much. Now every time I fuel up it does this. But just the first time turning on the car and no other time after that.
The check engine light had not come on again for almost a month, and then about a week ago it came on again. I double checked all the fluids and the gas cap but that's about as far as my knowledge of cars goes. When the light has come on I have not really noticed any handling differences. However since I need to put the car through an inspection very soon it is now concerning me a bit more. What could be causing the check engine light to go on and off?
while scraping ice off the windshield this morning with the car warming up, it started to choke, engine light came on. Used my OBD reader and found only one code, that being p0740. Cleared the code and all was fine after that, it drives the same way it always has and nothing feels different, revs are the same shifts gears the same. I know it had something to do with the torque converter clutch.
View 4 RepliesGot this engine code error, how to proceed?
I have a '00 accent, just purchased a few days ago from a private party, when I bought it, I had a mechanic look it over, gave me the OK and said it passed inspection, no mechanical or obvious running problems with the car.
So I was driving around yesterday and the check engine light came on, took it to get the oil changed because I wasn't sure last time it was done, had the oil changed, light stayed on.
So I took it to auto zone to read the error code, was given this information. How to proceed?
Mystery issue with my 2001 Accent GSI (5-speed manual, 1.6 L). I'm getting a P0300 error code and the Check Engine light (the light is like an old friend, I miss it when it's not on). This happened four months ago and I replaced the ignition coil - seemed to fix things - but now the light and the error is back with a vengeance. Car stumbles and runs rough. Changed the plugs and plug wires, but no difference.
BTW, there's a small pin hole in the upper part of the gas tank (just enough to give it a gassy smell when the tank is full) but I don't think the hole would be big enough at this stage to cause the check engine light to come on in the same way it does if you leave the gas cap off or loose.
This is the infamous error code many Accent owners might have experienced it. The code refers to "Too lean intake system". People try to replace all kinds of parts like ECM, MAF, O2 Sensor, TPS, Fuel Pump, Fuel Filter, etc. according to my research. I just bought a 2001 Accent and the P2188 light came on. I wrote an email to Hyundai Corp. Asking what would be the most likely part that will cause the (P2188) check engine light to come on.
View 3 RepliesI bought the little car to get off my motorcycle and its done great. But, after a couple trips around town my check engine light came on, and I imiditely noticed a change in my idle and engine performance. Im assuming my engine changed the air/fuel ratio to account for the sensor indications. My initial code read came back with four codes which said something about spark, and O2 sensor, and emissions. I went ahead put new spark plugs, gaped them as well as replaced the first O2 sensor.
After that I reconnected my battery and sure enough no engine light and my idle felt even better than before. (by the way my old plugs looked normal) But shortly down the road the light came on again. My idle did become a little different but not like my first encounter with the engine light. My power too seems a bit degraded, as well as the engine's sound. As of right now I am only reading one code P0422, which I do not see in the manual. I read online that its probably my catalytic converter or my engine is running at an improper air/fuel ratio. I am praying that it is not my catalytic converter and just my engine computer throwing things off.
Other things which may serve as clues:
Slight valve cover gasket leak (I will change the gasket when I do my timing belt job along with other seal and probably the water pump)
When pumping gas I can get about 90 cents in at a time, now more like 40 cents since the Saudis lowered our gas prices. Assuming I've got some kind of venting problem.
Car has 107K manual shift.
Yesterday my car had a rough start (lasted all of 5 seconds) and it threw the check engine light on. Now other symptoms. It was a rough start, almost like a misfire then it idle fined, and drove my 60 mi commute home without issue. I had fine acceleration, gas mileage idle etc.
I got home and turned it off for 10 min and it then started normally and ran fine again. I'm thinking it was just a random miss that threw on the light, but I'll take it to Advance to get the code later today.
I replaced the plugs about a year ago with cheap-o plugs so it may be time for a replacement again. I thought maybe an o2 sensor but there wasn't a drop in mpg, at least anything noticeable.
And its been a few days since I've gotten gas so I'm doubting just a gas cap issue... The CEL did NOT flash, only solid the whole time.
I go in this week to recheck my nagging check engine light. Flashes after a warm start, then stays on. Been there once already for it, it has come on too after a cold start... Last time they said it was a very vague miss fire code.... It did shake a bit... On the plus I get to drive a nice new Elantra again.... On the down, I never want my car back after driving it ...
View 2 RepliesI have been experiencing some issues with my '06 rio5 (same engine as your hyundais). this forum is way more active than the kia forums, so figured id give it a shot here.
I am experiencing a rough idle at start up while the car is low on fuel (<1/4 tank). it idles rough for a few seconds, the check engine light flashes a bit, and then it runs fine.
The car is an '06 rio5 with approx 19k miles on it, five speed manual. Also, sometimes after refueling and it will just shut off while waiting at an intersection. Not sure whether these two issues are related, but thought i would mention it just in case they were.
Having some issues with my 2003 Alero 4 cylinder. Upon start the entire engine shudders and the check engine light flashes. I have to turn it off and turn it on and it will stop most of the time. I've taken it in and the mechanics can't get it to reproduce the same issue for them. Just replaced all four plugs, boots, ignition coil.
View 1 RepliesI have a 2000 f150 4x2 5.4 168k... Check engine came on,started shaking, weather was really cold. RPM would be a little high then low then back up. Especially when I turned on heater. Felt like truck would die but never does nor does it have issue starting.
So far, I have replaced two oxygen sensors inside engine,all coils, spark plugs, fuel filter, had injectors cleaned, intake cleaned. Truck runs better but, light came on a day later again. I can feel the tiniest of shaking going on and, cold mornings still make RPMS a little unstable. I was driving truck on highway at about 60 mph when a slight tug was felt and Truck check engine came on. I feel truck heavy, once it warms up completely, a little lighter.
Codes came up at auto zone as P1151
But I'm running out of options and frankly, money to fix this truck.
Checked the MAF and looked okay.
I'm with minimal skills.
I started out with my 2000 F150 with a 5.4 V8 running rough at idle. It would idle way down slow and then rev up a little over and over. On a couple of occasions it would even die when in drive or reverse. I did finally get a Check Engine light so i put it on my diagnostic program to see what was up. Here is what I got:
P1151 Lack of HO2S21 Indicates Lean
P0171 System Too Lean Bank 1
p0174 System Too Lean Bank 2
After doing some reading up I checked all my vacuum hoses and cleaned my mass air flow sensor. I then got the same codes again after a few minutes of running. So I went to the next thing that was recommended, the upstream bank 2 O2 sensor. After changing it the truck ran fine for a couple of days, no issues. Then all of the sudden it idled a little funny again and I got a Check Engine Light again. This time:
P0171 Bank 1 Lean
P0174 Bank 2 Lean
P0300 Random/Multiple Misfire
I reset the light to see if I would get the same again later. Before the light came on again I filled my truck up with gas and it seemed to be running pretty good again. Then a day or so later it set the light again. This time:
P0171 Bank 1 Lean
P0174 Bank 2 Lean
P0136 O2 Circuit Malfunction Bank 1 Sensor 2
P0156 O2 Circuit Malfunction Bank 2 Sensor 2
P1131 Lack of Switches HO2S11 Lean
P1151 Lack of Switches HO2S21 Lean
I went ahead and drove for a few days as it had gotten really cold here and I didn't feel like messing around in my shop since it isn't heated. A couple days ago I needed gas so i filled up again. Suddenly the problem was gone again. Truck ran fine idled fine no missing or odd idling at all. That lasted a day or two before it started acting a little weird again. At that point i was down about 1/8 of a tank from full. I have read that there can be issues with the fuel pump.. I am kind of wondering if that may be it now. But I haven't had to deal with this sort of issue before so I am unsure what to check next. The truck always runs fine off idle, it only seems to have the issue when it is idling. I had reset the codes the last time and i have the light on again now. I haven't checked it yet but I am sure it is going be some combination of what i have had in the past.
I have read that the IAC valve can be an issue as well. I had a problem with mine sticking a couple years ago and when it would do it you could just tap it with a wrench and it would idle up. But it never died like it does now and it would also idle a lot slower than it does. Back then I cleaned the valve and had no more issues with it. The truck has always had times when it would act weird at idle usually after slowing down after being at highway speed. The current issue happens at all temps cold or hot.