Accent LC (2000-05) :: 2002 Sometimes Struggles To Start
Jun 15, 2014
My 2002 Accent sometimes struggles to start. It is generally a great reliable car and has a great service history. About 8 months ago I notice that two or three times it wouldnt start on first or second turn of the key. I got a service and the problem disappeared until recently again. Every so often (once a week or so) it will struggle to start and I will have to wait a few seconds before trying again, where it does fire up.
This is not a battery problem as I put a new battery in it 2 days ago. The fuel pump noise when turning the key also comes on. Could this simply be that the Spark Plugs ned changing? It has driven 5,000 miles since it's last service.
By the way, when I say struggles to start, it will turn over absolutely normally, but it will not ignite and actually start the engine, or "fire" up.
View 6 Replies
Advertisement
I own a manual accent from the 2000 that I have since last December. Fuel pump and battery are new, I changed them after getting the car.
The issues I have and I think they are due to the same reason, are the following.
1. Sometimes, when I turn the key to on position and before cranking, the engine light blinks and the car wouldn't start. Then I remove the key and try again until the light doesn't blink and then the car would start. This could be the second time, the third time or after several times. When the light blinks and I try to start the car, I can hear the fuel pump and the battery working, so the problem must be somewhere else. Also, this issue happens very randomly, it may doesn't happen during two weeks and then it happens one day and next day is OK again.
2. Few times it happened that even if the engine light wasn't blinking, the car started but like without enough power and then it stalled, I tried again, and it has always started OK the second time.
3. A couple of times, I was on the road and stopped the car in a red light and it stalled when I switched to neutral.
4. The car sometimes struggles with the first gear, when I'm switching from neutral to first gear to start the car (after being stopped in a red light for example). The car would start very slowly, even if I'm pushing the accelerator and don't have my foot on the clutch anymore. But after few seconds, the car runs well and I switch to second gear, third gear, etc. and runs perfect. Above 10-20 km/h the car runs perfect, I only have issues (sometimes, not always) at very low speed in first gear.
I think that's it. So far, my mechanic has checked the code problem and he coded a new key, thinking that it was a communication problem between the key and the engine, but it didn't solve the problem. I don't know where to bring the car, because every time someone checks it, they can't find the problem or a solution and I don't want to spend more money for no reason. But I'm also worried that the car breaks down one day in the middle of the road or when I'm in the field with volunteers (I need the car to do field work, but luckily it's not a remote area.
View 4 Replies
The car doesn't struggle to start at any other time just when fueling. I have a 2011 Accent and I am looking for the locations of the various components involved so I can test them to see where the problem is.
I know the purge valve is mounted on the rear of the intake manifold below the air hose. Now is the solenoid and the valve the same part? I see various diagrams pointing to the valve and labeling it solenoid. The other part is the EVAP canister. I know it's some place near the gas tank but not sure where and I can't find any diagrams online.
I am comfortable with minor repairs. I've replaced spark plugs and ignition coils and a purge valve before so would this repair be something I could do myself or would I be better off taking it to the dealership?
View 7 Replies
After getting to about 1/4 tank, I fuel up and fill the tank but when I try to start the car, it cranks for a while and then finally starts. It will idle really low so I have to rev it until the engine starts getting gas at a steady pace.
View 9 Replies
So it finally happened...One day she was working just fine and now is dead. OK, starter is working, battery is new but there's absolutely no spark on any of the spark plugs. I wonder what could it be ?
View 8 Replies
My friends have a 2002 Accent with the 1.6 DOHC that I've been puttering around with all weekend.
The door was left open a crack and the battery drained. It was brought in, didn't charge right (he said he accidentally put the cables on reverse). Tried to install it, still did not start, put it back on charger correctly, and then re-installed. It was unknown at the time, but the black cable that went from the negative post to the fuse box popped off, and then he said there was no lights in the car, but tried to start it anyway.
We tested the battery both with a voltmeter and at a parts store - its testing like a brand new battery. I've tested all the fuses in the box under the hood, and in the box by the driver's feet. I also tested continuity in the ground to the engine, ground to the body, ground to the fuse box, and the alternator to the fuse box cables. All the wires show up as less than 0.5 ohms resistance (I'm assuming since I didn't get an infinity reading that they are intact).
I then tried to just put the key in the 'on' position to see what I could get - no interior lights, no start, no accessories at all. It wouldn't even let me shift it with the key in. I've got no clue what left to try. I guess these don't really have a "main relay" but at any event I don't know how to properly test these relays anyhow.
This used to be my car, and last year I replaced the positive cable to the starter, and the CD player was erroring out (it kept reading that there was a CD being inserted then stopping and then turning on the radio) so I just pulled the fuse under the hood. I don't know if they would have some effect over a year after the fact.
View 4 Replies
I have a 2002 Accent...Won't start....When I turn the key on...none of the idiot lights come on...It will turn over like crazy...but nothing....Have checked all fuses and relays... Then all of a sudden the lights will all come on and it starts...ran it for awhile drove it around a bit...shut it off...then tried to restart and it did...ok then 2 days later went to start it..and same thing...No idiot lights came on....and of course will not start..Someone mentioned to me it might be the ignition switch itself that might be causing the problem?
View 3 Replies
So my 1.6 accent (140,000) decided to no longer start. Just keeps cranking but doesn't ignite. Plugged a scanner in and it's the crankshaft position sensor. How difficult is this to get to? From what I've ready its just held on one end by a 10mm bolt and the older end is just a connector, but it looks like it might be in a pain in the ass location. Does anything need to be taken off first to access? Should this take less than 30 min?
View 1 Replies
I have a 2008 accent with about 95k miles on it. I recently took it in to have the oil changed and the mechanic suggested I get a tune up and said my spark plugs needed to be changed. I didn't opt in for the tune up that day and I'm now noticing more problems with the vehicle. At first the car struggled accelerating at about 35-45 mph, but once it reached above that speed it ran fine. More recently the car has really struggled accelerating after it had come to a stop. Today I came out to start the car and it took a couple tries to get it to kick over. Once the car was on I could rev it up but when I put it in gear it struggled to get to 10mph and that's with the gas pedal pressed all the way to the ground. I let it set and came back to it about an hour ago and added transmission fluid, because it was low. The car started a little better, it wasn't shaking as hard, but it still struggles accelerating and won't push pass 30mph. When parked I can rev it all the way up, when I take my foot off the gas the car does threaten to cut off, but it only has once. I'm not sure where to start.
View 13 Replies
My car wont start properly. I have push button start & now the majority off the time the engine struggles to turn over. The starter motor is fine as it revs the engine to around 500 rpm when it toys to turn over but it seems like The engine isn't getting enough fuel or air & stutterers & hesitates. The weird thing is that once its started the car doesn't miss a beat. What it maybe? I have just replaced the sparkplugs, fuel filter & air fitter as part of my 60,000 service I have the car booked into my local dealership but they cant get me in for 2 weeks. I'm a little worried but its probably something small.
I have been lucky enough to catch the car doing it on video & here are 3 links to my youtube videos. On 2 of the videos the fuel is low, however, there is still 10 litres in the tank & this has also been happening at various fuel heels & out door temps.
VID 20130626 140221 - YouTube
VID 20130626 144651 - YouTube
VID 20130626 154933 - YouTube
I have checked a few things out but I cannot diagnose the problem. I believe the first 2 videos you will notice the car shaking a fair bit. Pay close attention to the car revs when starting.
View 10 Replies
My 2000 Corolla has been a dog from the day I bought it, a few years ago. It struggles up hills or speeding up on the highway. I took it to a local garage and was told that one of the cylinders was fouling a spark plug with oil. The owner said the cylinder would need to be machined to correct the problem. The total cost of repairs would be about $1800. My question is, would I be better off purchasing a rehabbed cylinder and having him put it in? Is this even possible? BTW, the car only has 132k miles on it, which is not a lot for a Corolla.
View 16 Replies
I have an 02 F450 with a dump bed an just under 45,000 miles (was barley used by the first owner). This maybe unrelated to my problem but is worth mentioning. This past week I noticed a small puddle where I had previously parked at a customers house so I checked the oil. I was about 2 quarts low. I followed the oil trail up and found a pool in the valley. One of the high pressure lines were loose and the seal was chewed up so I replaced it and tightened it. No more oil leak.
Now my new problem. Two days later, after about 45 minutes on the interstate driving about 75 mph the truck started to rapidly lose power as if it was running out of fuel. I heard a loud ticking sound coming from the engine and the more I tried to accelerate the worse it got. I pulled over and the truck stalled. I thought that maybe my fuel gauge had crapped the bed on me because it still read a little over 1/4 tank. I called a buddy and got more deisal in it and it started right up. We'll after about 5 minutes of 60 mph it started to happen again. So to fast forward... I opened up the tank and found the the strainer had crumbled in the bottom of the tank.
So I cleaned out the screens in the sending unit and replaced the strainer, replaced the fuel filter, and reverse blew out the lines. I read about checking the hpop reservoir for oil and it is present. So to sum up, as long as I stay under 60mph or so I can get about 5 minutes of run time before the truck starts to stutter and stumble. If I shut it off for about 5minutes I can go back up to 60 again but it the cycle continues. 5 on and 5 off. If I start the truck after say 30 seconds after shutting it off it sounds like it's going to die and has no power at all. I have worked on a lot of vehicles but none with anything like this and this is my first deisal. What do I do to get this beast back to normal?
View 3 Replies
I've had a couple issues where the car struggles to start in the morning after a cold night. 2.0 ultimate, btw. It isn't a cranking issue, it just struggles to turn over. Both times its done it, it seemed like it took 2-3 seconds longer to start than it should of. Was right on the edge of turning over but wouldn't. My non professional opinion was that it seemed like it wasn't getting enough gas to turn over.
What could be the issue. I will not have time to take it in to be looked at as I'm starting a new job next week and don't get any time off. Unless it fails to start completely, I'll deal for now.
View 7 Replies
My 2009 Honda CRV struggles to start on very cold days. I need to hold the key and turn it longer than I would on most days. Is this something I should be concerned about or is it normal.
View 7 Replies
My tcm is reading codes p707, p734, p732, p745, p1529. Little information ive gathered is that my transmission only slips while OD is on and it only slips the first time it tries to reach 2nd and 4th gears after it slips the rest of the drive it shifts fine it also feels sluggish in OD as far as acceleration. I'd like to solve it with out replacing the tranny cause.
View 4 Replies
Every time I fill up my gas and put the hands free nozzle switch it clicks every time.
View 5 Replies
I have a '02 Accent with a 1.6L. Over the summer the A/C blew ice cold. I changed all the belts and after a few weeks I noticed that whenever I turned on the heat or A/C the car squeaked. After that I saw that the compressor would stop spinning whenever the squeaks happen. I sprayed the pulley and clutch with silicone spray and it worked great for a day then the same problem again. Eventually I snapped the A/C belt, replaced the idler pulley, and the tensioner bolt but still the same problem. What it could be?
View 1 Replies
The car is a 2002 Accent GL LC ...
Here's my problem, The brake lights will not come on at all.
I've checked all the fuses, they're fine. Same with all the globes. I can't source a wiring diagram anywhere so I just started looking for faults.
I started with the pedal switch. There is no power getting to it at all but it earths fine. I thought the feed from the battery could be severed so I fed 12v straight to it. The switch works, but the lights are still not getting power.
To follow any of the wires in either direction from the switch, it looks like I'll have to remove the dash and that's really something I don't want to attempt without a good reason.
View 2 Replies
I have an 02 Accent 1.5L that has a misfire on #3. I have replaced the head gasket, valve cover and gasket, intake gasket, timing belt, yes it was top dead center, MAF, Charcoal canister sensor, MAF, plugs, wires, coil pack, injector #3, and the compression in #3 is 130. What else to check. No other codes.
View 3 Replies
i have a 2002 accent 4 door and it's stuck in park, its an automatic. I removed the park override little cover thingy next to the shifter and released it out of park but when I put it back in it got stuck again.
View 5 Replies
I have a 2002 Hyundai Accent 1.6L automatic. I just bought it today. It has 171,000 miles. The car is misfiring. It does it when I give it gas. It won't misfire if I only give a little gas but if I was to drive it then it spits and sputters. I put new wires on. what are some common things on these cars. I am new to a Hyundai.
View 3 Replies
