When I depress my brakes the right rear chatters, almost as if metal is on metal. Depending upon my speed when I brake the chattering will rise or fall with the speed I'm braking. Sound familiar?
View 9 RepliesI am wondering what would cause the idle on a 1992 bmw 525i to drastically rise and fall continuously.
View 5 RepliesThe car is a 2002 Accent GL LC ...
Here's my problem, The brake lights will not come on at all.
I've checked all the fuses, they're fine. Same with all the globes. I can't source a wiring diagram anywhere so I just started looking for faults.
I started with the pedal switch. There is no power getting to it at all but it earths fine. I thought the feed from the battery could be severed so I fed 12v straight to it. The switch works, but the lights are still not getting power.
To follow any of the wires in either direction from the switch, it looks like I'll have to remove the dash and that's really something I don't want to attempt without a good reason.
I recently had my '02 Accent serviced. When I picked it up, the mechanic had set the parking brake with about 15,000 lbs of force. Once I got it released, I noticed that the red parking brake dash indicator light won't go off while the car is running.
I have verified the brakes are free, and have tried wiggling the brake handle.
Is there a switch somewhere that could be bad? For the record, I do most minor maintenance myself, and have 214,000 trouble-free miles on my 1.5L SOHC Accent.
I recently had my 2002 1.8T in for clutch replacement at the dealer and they came back and said the crankshaft was bad ( the car was occasionally making noise when pushing the clutch in, they thought it was a throwout bearing) I took the car back to bring it back to an indie, and it is loud at idle and while accelerating (sounds like a chattering noise that gets faster as speed increases) It's now sitting in the parking lot. My question is, am I going to have to put in a whole new engine to fix this problem? can just a crankshaft be replaced?
View 2 RepliesWhen I'm on highway (between 90 and 120 KM/H) I heard a whistle when speed is stable. it happen frequently in the last week. I notice it happen approximately at 95 and 110 KM/H. When I remove my feet from accelerator, I don't hear the noise anymore.
(Accent 2002 hatchback).....
trying to find the speed sensor on a 03 accent manual so I can fit cruise control
View 1 Replieswe have a 2000 Windstar that has chattering brakes...what is the cause of this?
View 2 RepliesI have a 1990 Lincoln Mark VII, black on black, basically one owner, excellent condition... except one problem. While driving the car my speed dropped to 40mph, while my RPMs rose to 4000. Upon checking I found the plastic clip, which holds the linkage from the transmission to the accelerator had snapped. I replaced the part and still have the same problem...is my transmission smoked or is there an adjustment?
View 4 RepliesA few months ago my automatic 2000 hyundai accent GL was having problems reversing. Some times it would, sometimes it would move a few feet then fall out of gear and stop, sometimes it would not move at all.
The reversing problem fixed itself about a month ago.
Recently i started having problems accelerating, it was noticeably slower to get to speed and had problems upshifting.
Today, it started to make a buzzing when in Drive, while decelerating after getting to speed. This buzz is nonexistent in neutral, 2nd, or low gear.
Here is a video of the sound it is making, with captions to explain what i am doing... 2000 accent transmission problem - YouTube
The MIL light up and I got the P0501 Code. (Speed Sensor. I use a Scangauge II and the Speed is 0 KM/H at any speed. (was working before). But the in dash Speedometer work no problem. I look on the HMAservice web page and did not found where is located the Speed Sensor.
View 9 RepliesI have a '05 Accent GLS Hatchback. 5-speed, manual transmission with about 82 thousand miles on it. I bought the vehicle used about 2 years ago. Ever since I've had it, its been a little jumpy in first gear when going at very low speed. Especially during traffic jams, barely pressing on the gas will cause it to jump a little bit until you put the pedal down further. Lately its starting to do something similar when it 4th gear. When you push your foot on the pedal it jumps a little and does the same thing when you take the foot off the pedal. What may be the cause? O2 or TPS sensor maybe? It did give me a flashing check engine light for about 10 seconds this morning but it hasn't done that since.
View 5 RepliesMy hyundai accent 2005, have problem of jerks /die speed after engine get warm, also increase if AC on, when I starts car in morning it works great and no problem but after 3 or 5 km as engine get hotter speed kills,but it happens more or worst in evening at 4 when returning from office and temp is 45+ in riyadh, saudiarabia.
I change air filter, fuel filter, spark plugs, spark cables, also use fuel injector cleaner but still problem remains, I want to tell you its start when I changed engine valve cover gasket due to oil leak, as I changed this problem suddenly appeared, I went to other mechanic but he told me the problem not in valve cover gasket,it is somewhere else he clean my throttle body ,and its works for 2 day only that i felt the problem solved but after two days problem appeared again,there is no engine light power on for any electronic malfunctioning.
3 times now in the last week, my 2000 accent has stalled. each time it was at a low idle, slow moving speed. I was rolling up to a red light twice, and gliding into a parking spot the other. There was no coughing or sputtering. It just stopped. Each time, after about 20minutes or so, the car fires right up. it happened twice today after about 4 miles of driving. If the car sits for a day without running (on an off day from work) its a bit hard to start sometimes, but not consistently. Does this sound like a Crankshaft position sensor? or possible a fuel filter?
View 5 RepliesI have a 2001 accent 1.6 5 speed manual. When I put it into reverse it dont fully engage until I give it some gas and then it slams into reverse with a bang. I am not really sure but I think it only does this with the car is cold I may be wrong though it started this a few weeks ago.
View 3 RepliesHave replaced BOTH half axles. Clicking sound present when driving - does NOT change when turning right or left. Seems slightly affected by acceleration/deceleration - makes clicking slightly louder/quieter. Clicking is DIRECTLY proportional to speed - slows down until car stops. Transmission works fine, fluid level is correct. New trans fluid and filter. What the heck could this be? Wheel bearings seem solid - jack up car and try to wiggle wheel - solid as a rock both right and left sides. WHAT ELSE COULD THIS BE???
View 4 RepliesI'm having an issue with my transmission. When driving it shifts just fine, but I have to let it accelerate slowly. If I press to hard on the accelerator pedal the engine ron races. So I ease up and it catches and slowly accelerates. For example going up hill, I press the accelerator and the car doesn't speed up, the engine races, so I have to just let the car slowly increase in speed by lightly pressing the gas pedal, no get up and go! Only occurs in 4th and 5th gears. What could be causing this. I have already flushed the gear oil as I had to replace the output shaft seal as it was leaking.
2000 Hyundai Accent 5 Speed Manual Transmission....
I have a 2005 accent gls. I use the car for deliveries so a lot of stopping/starting. when the car is hot, the AC compressor will shut off after 5 seconds, and not re-engage until about 20 seconds, then only on for 5, so not keeping cool air. I noticed when I turn the AC on, the condenser fan (i think) kicks into high speed so I assume that's what it should do, but when the issue is happening, it does not go into high speed. the shop I went to wasn't able to determine the problem. they checked pressure and evacuated the system. when it works, it blows cold as it should.
View 3 Replies2005 hyundai accent, I've noticed something unusual with my trans, whenever I start driving at lower speeds ( which I do all the time to save gas) the transmission shifts into 2nd and 3rd just fine, but in 3rd gear ( at around 2.5 rpm ) the RPM gage goes down a little bit ( about 2.1 rmp), it almost feels like it went into 4th gear and it happens really smooth, it almost feels like its supposed to do that, the car later shifts into 4rd at around 3 rpm, there's no jerking, stalling or sounds at all, this does NOT happen when I take off at a higher speed and acceleration. This transmission has 55.000 miles on it and besides this it works perfectly fine.
View 1 Replies248k miles on it, was taken from a body shop and put on side of road, I know who took it but can't prove it. He is known for messing with ppl vehicles. . Started up just fine when found, but you can hold foot completely down on gas and it's like it is losing pressure (?) , it rumbles and shakes when running and you can watch the RPMS fall while holding gas pedal down (in park) until it just dies. It has an "egg" smell and one side will get hot while the other stays cold. It was something intentionally done to my vehicle. .already checked Cadillac converter and cleaned/removed muffler. I'm not sure where to start looking now, I'm a single mother without the money to take it to a repair shop. We could drive it onto the trailer to get it to a friend house, but barely made it up it without dying...
View 9 RepliesI have a 2004 Accent with 150,000km on it. I've done a number of jobs on it, and I find it to be a relatively DIY-friendly vehicle. A little while ago I had an issue where it would die after warming up, sometimes at a stoplight. Otherwise, it would intermittently fail to start after it had been parked for a very short time. This was fairly obviously the crank position sensor, which I replaced. At this time, I haven't had the same issue again.
Since that small repair, however, I have been noticing other issues. From inside the cabin I can hear a distinct whine that climbs 1:1 with the engine RPM, whether or not the clutch is engaged. Once the RPMs hit the power-band(ha-ha), the whine is joined by a metallic jingle. From outside the car, both whine and jingle are audible through the entire RPM range. It sounds to me like a clear case of bearing noise coming from the belt and pulley system.
Since this whine started, the car has been giving lazier starts, requiring slightly longer to fire up. The noise changes significantly when the AC/defrost system are engaged, although I'm not sure if this is because the faulty part is connected to that system, or because the RPMs drop once it's engaged, both, or neither.
I will be doing a timing belt and water pump change before the snow flies, and I would love to find the parts that I need to treat the jingle at the same time as the rest of the belt system replacements.