Accent LC (2000-05) :: 2001 - Died At Stop Light / Grinding Noise
Jan 9, 2014
2001 1.5 Accent. It has not been starting consistently for the last few weeks. Ive had to use the jump box on it a few times and that worked.
The other day (cold day!) it died at the stoplight after driving for about 20 mins. It made a grinding crunch sound from under the hood as it died. After several attempts on jump box it fired up and ran again for about 15 seconds and died and made sound again.
This repeated itself a few times before I got it towed home.
I removed alternator and it tested good (PASS) at two parts stores...testing 3 times each.
Battery has about 14 volts at the posts without having charged it after event.
What would cause the car to die and make the awful sound? And why would it appear to need a jump start?
I was thinking alternator but.....
View 12 Replies
Advertisement
Yesterday I was driving home and my clutch started acting up. To start I was unable to press the pedal. The pedal was super hard, then let up but didn't feel right.
I removed the slave and the pedal went down fine. Both the master and the slave have no leaking and fluid levels are good. I haven't been able to have a buddy look at the levels when I press the clutch, but....
Here is a little more, the car shifts fine with the car off, it goes into all the gears, but with the car on it will not shift into gear. Also there is a light grinding noise when I let the clutch out..
I ordered a clutch kit already, but don't want to pull the trans if I don't have to, I would love to hear the issue is with the master or slave.....
2005 Hyundai accent with 138,000 miles
View 4 Replies
I have a 2000 accent with 51000 miles on it. Since I bought it I have maybe put 75 miles on. The other day while going uptown to get lunch i was at a stop sign and i went to take off and it died. now all it does is fires for maybe a second and dies i have 50 lbs of pressure at the fuel rail. I dont have a scanner and i cant check it by jumping the pins under the dash because there is no. 15 pin.
View 11 Replies
My fiance was driving my 2001 Accent, 1.6 manual trans, when it suddenly died. Now when I try to start it, I only get a single click. I also tried popping the clutch and nothing.
View 7 Replies
So I have a 2000 Hyundai Accent, 1.5L with an automatic transmission. I'm hearing a grinding noise when I'm driving. It gets faster as the car goes faster, but the engine RPM has no effect only the speed of the car.
I got new tires, changed the CV axle shaft on both sides, and I also changed the front struts as I was told that one of the struts was bad the last time I took the car for an alignment. None of that has had any effect on the grinding noise.
Then I jacked the car up on both sides and let the wheels spin, and the grinding noise is present that way as well. Then I jacked up just one side at a time. When the driver's side wheel is spinning, the noise is audible, but not when just the passenger side is spinning.
I then disconnected the brake caliper from the driver's side and held it up with a tie wrap to keep it out of the way. The noise is still audible when the wheel is spinning, so it's not the pads or a clip or anything like that.
So now I'm down to a couple of ideas.
1) Wheel bearings
2) Something is hosed in the differential or transmission. I'm guessing that the differential is more likely, as the transmission should effect both sides the same, right?
I'm going to check the wheel bearings now, though to me it seems unlikely to be the problem.
View 10 Replies
I just bought a 2001 Accent, very well taken care of. It is the 1.6, automatic, 148,000 miles. Just before I bought it, the owners put new tires on, replaced the plugs/wires/belts/timing belt/all fluids/head gasket. I did a search on this topic and saw a lot of things, but nothing definitive.
I've noticed that when at a stop (in gear) the car shakes a good amount, and with the A/C on it's significantly worse. There is no check-engine light, and the car seems to run and shift very well. I'm not used to small cars with small engines, so I don't know if it's normal or not.
I did look at the motor mounts (front and passenger side) and from what I can tell just taking a peek, they don't look bad, but again it was just a peek. The mounts don't look like they've ever been changed, but then again the whole car looks brand new, the owners took really good care of it (the inside looks like it's never been ridden in).
I do also have noise coming from the speedometer, that goes away temporarily when the back of the cable/speedo is lubed and then comes back, but my first concern is the shaking.
View 10 Replies
Noise sounds like its coming from driver's side. It's not terrible until you hit 30-40km/h, after that its quite loud. No whistling sounds, which i was told to listen for if it were a wheel bearing (although I ma not convinced is the only sound a warn bearing makes).
The sound sometimes goes away when I am on a bend turning left (taking the weight off the drivers side wheel).
View 6 Replies
So I had all of my belts changed including timing belt and tensioner pulley as well as an oil change. After, I noticed a weird pulsating grinding/wining noise coming from the engine bay. It only can be heard once the car is warmed up. (It is much louder in real life.).
Car Noise - YouTube
View 1 Replies
Recently I've noticed more that when we first start the hyundai in the morning or after sitting a while and we use the brakes it grinds/ squeals a little and then doesn't after about 2 or 3 miles. Is this something to get checked out or should I spray something on my brakes to lubricate?
My next step that I though of was to get a simple automatic car wash cause it's been a bad winter in Rhode Island and the street shave been flooded with rock salt. I figure that might cause some friction under the pads.
View 1 Replies
I own a 2005 Hyundai Accent 1.3 SOHC and a while ago the front right wheel started to make a grinding noise, problem was related to the brake system..
So far I've tried replacing the rotor (disc), repaired the caliper (using a rebuild kit), replaced hoses (both), and event the master cylinder.... and the problem persists, it actually came to the point that after driving a while the front wheels will get stuck.
I've followed all the directions from the service manual and it still got the problem...
View 14 Replies
It seems that my left brake light is always on. I tried replacing the bulb, but that didn't do anything. I also had someone look at a switch underneath my break pedal.
I did had in the paste a problem with my trunk light, and got that resolved. Does any of those wires have anything to do with that light? What else it could be? Trunk light on dashboard
View 13 Replies
I have a 2001 accent 5-spd. I was on my way to work and I was making a u-turn when the car suddenly died. I tried to start it back up but it didn't even sound like it was turning over. I tried to bump start it or do a rolling start and nothing. I had to go to work. When I returned to it 8 hours later I again tried to start it and nothing. When I turn the key it makes a "whirring" or "humming" noise, kind of like a vacuum noise. When I had someone else try to turn it, I noticed the belt was turning, but the engine wouldn't crank or make any attempt to turn over. Just the belt was spinning and no engine crank. What could this be?? Could it be the crank position sensor?
View 1 Replies
I have a new problem that I only discovered a few days ago. As I come to a stop at a traffic light, turning out of somewhere or whatever if I give the car a little more gas than normal not that I punch it or anything from a stop the car bogs down and bangs a little rough like I was rear ended. The car is in drive when it happens. Its just fine any other time. I was told it could be as simple as a bad tps or as bad as a defective torque converter or tranny. Its a 2005 gls hatchback with the 1.8L. also, the engine has been running a little rough recently too if that could have anything to do with it. No warning lights are on either.
View 15 Replies
Car just died and wont start. Have checked the following..
fuel (unplugged hose at rail and no fuel with key on, only while cranking. also pulled rail off and all are spraying fuel)
spark ( all plugs are sparking, but are wet from fuel)
compression ( all had 190-210 psi)
timing belt is still in time.
Car doesn't even try to start with all of these. It does back fire out exhaust though when trying.
Also the one of the ecu fuses was blown( thought for sure that was the problem) but made no difference. What to check next. Possible ecu is bad??
View 1 Replies
I have a 2001 Accent with a auto-transmission. The engine is a 1.6 and the car has about 100,000 miles on it. I had it since about 5 years with about 48,000 miles.
While driving cross country a couple years the car developed a whining noise at about 25 mph. As speed is increased, the whining became louder. I have driven it like this ever since, moderately, never pushing it. Starting a couple months ago, the noise has become louder at 40 to 45 mph and there is considerable vibration.
I know the tranny in this car is known for many different problems. I'm just wonder what the thoughts are of others more familiar with this transmission as to what could be the issues ( a certain bearing going bad between gears?, maybe not a tranny issues ...just random ideas on my part ).
BTW, I have never had an error code develop for this transmission.
View 10 Replies
I have a 2001 accent. I have noticed recently that there is a noise coming from the rear of the car. This is a rumble type noise which changes as I speed up or slow down ( It sounds as if it is something to do with the tyres)! I have changed the rear hub assembly and had the wheels aligned but the noise is still present. I have checked the suspension (by pushing down the back of the car) and it appears to be acceptable. Where this noise may be emanating from?
View 4 Replies
My 2001 accent 4dr will start up no problem when everything is cold, but once I let it idle for about ten to fifteen minutes and if i shut it off, it will start back up but then it stalls and wont start back up, or if i just let it run a little bit longer it also stalls, no problems with fuel pump or relay when it is cold it starts right up, but once it stalls it wont turn back on....the pump is getting power even when its hot so could it be a bad wire or should i test the coils when it gets hot or am i completely looking at the wrong thing?
View 4 Replies
I own a 2.7 L v6 Santa Fe, 2004 with almost 50k miles on it.
When I accelerate and hit approximately 1.9k RPM I can hear a light grinding noise underneath the car. This happens both in 2nd and 3rd gear. So as it's accelerating up I can hear it, and when the car shifts up and the RPMs drop it will make the noise again as it passes through the same RPM range.
The noise is always there at 1.9k to approx 2.1k RPMs.
Also of note is that the sound is either gone or significantly reduced after driving around for a while. I don't notice it after freeway driving, for example.
View 2 Replies
I have a 2004 Accent. When driving on the interstate yesterday, I turned the turn signal on and my car died for a moment. After I parked it, it would not start. It did not turn over. Took the battery out to get checked. It was good. Put back in and then the car started. Drove home. The radio and clock would flicker intermittently but made it home. Today it will not start at all. Nothing comes on.
View 14 Replies
Replaced fuel pump a couple weeks ago and my car was running just great. Last week, it died on me again and I discovered that I wasn't getting any spark. Removed crank position sensor and installed one from the junkyard. Fired right up and I was able to drive the car for 3 days with no problems. Then it quit again. I figured that it was the part that I got from the junkyard so I went to autozone and shelled out $80.00 for a new one. When I removed the old one, I noticed that there was motor oil on it and I am wondering if engine oil is supposed to keep it cool as there wasn't a lot of oil on it. I don't want my new sensor to quit working because it may be getting too hot and breaking down because of excessive heat.
View 13 Replies
I have an 01 Accent GL 1.6L. It will not turn over. Battery, terminals, and wires are all new. Alternator is also good. There is a buzzing noise coming from beside the cold air intake. I'm not sure what part that is. The part that is buzzing is where the cam position sensor is connected to. It also has wires that run into the firewall.
View 21 Replies
