my 91 525i wont engage 1st gear..fluids fine..nothing smoking...fluid levels great. color correct in fluid appearance..reverse works..no funny noises from rear end..car just will not shift above 1st. i have replaced transmission filter and fluid.
View 1 RepliesI have a 1995 BMW 525i and the fuse for the AC keeps blowing after a few minutes. It's #9 in the fuse box. Before the fuse blows the AC works fine. I can't find any visible problems. Is there a common problem that I can check?
View 1 RepliesRecently, the cars electrical system shut down. The central locking system, the windows, seat adjustments, interior lights and the radio quit operating. The A/C, outside mirrors, driving lights & ignition remained operative.
Removing the electrical modules in the engine compartment & re-seating them reset the system. Then the same issue recurred. Re-seating the modules did not resolve this the second time. Only when the modules under the rear seat were removed and re-installed did the systems start again. Which module is defective?
We got the car a couple days ago. It was running fine then, although suspiciously the guy we bought it from had it running when we got there, leading me to believe he knew about the problem already and didn't want us to. The problem is that after my dad drove it to work yesterday, he tried to start it up at lunch and it wouldn't start. It didn't sound like the starter was trying at all, just a bunch of electronic clicks. However, the electronics all work, dash lights, headlights, locks, etc. It just doesn't seem to be able to start up.
When we took it to a shop for an unrelated issue, a mechanic said there were wires hanging down in the trunk for a sub, and we knew this but thought it was no big deal. He told us that if it was wired wrong, it could be draining the battery, even without being hooked up to a sub. I checked the battery, and there were a few extra wires hanging off the negative terminal. However, that doesn't make sense to me, how could a couple of wires attached to just the negative terminal do anything?
I got a 99' Jetta gls 5 spd. I just replaced the transmission and now the car won't engage reverse from inside the cockpit. Reverse can be engage from inside the engine bay, but when the shift knob is depressed nothing happens. Linkag cables are in the correct spots.
View 6 RepliesMKIV jetta GLI, first two gears just won't engages as if it's still in neutral. Have to start her moving from 3rd. What could be the issue?
View 14 Repliesown a 2005 Hyundai accent 1.6L engine. I replace the engine today. The previous engine had internal damage. The transmission I left alone. I didn't disconnect the wiring. I only removed the engine. The transmission worked flawless. When I turned on the car the engine sounds great and the transmission sshifted gears and the wheels were moving. The speedometer worked so then I turned the engine off and lowered the car down from the Jack stands and tired it shine but this time the transmission did not shift gears. I lifted the car back up and did still did not shift gears. The transmission does nothing. The checked the guild level and it's full. What can cause a transmission to suddenly stopped engaging gear?
View 2 Replies148,000 miles, and yesterday my R decided it would no longer allow me to use first gear. It sort of starts to go in gear, but feels kind of mushy, not positive, and if I let out the clutch, the gears grind, but will not engage. All other gears feel and perform normally.
View 7 Replies2003 Passat 1.8t FWD.
My buddy is having a wierd issue that just recently started after it's gotten cold out. The car would not start for him so he had me look at it. Attempting to start there's no sound from the starter at all. Battery is fine. When I shift in and out of a few gears, the starter engages and the car starts. Stop the car. Attempt to start it again and nothing. Shift through the gears some more and the car almost starts but quickly dies. Shift some more, start, running like a champ.
What is it about shifting through the gears that allows the starter to engage and the car to run again?
I have a 2011 sonata SE w/ 30K miles, the starter failed on me.
The motor would spin but would not engage the gears b/c of the solenoid or the rod malfunctioned.
They towed my car to the dealer for free and it was replaced but I'm concerned because the towing guy told me he towed quite a few Hyundai's b/c of this problem.
99 Passat1.8t auto, transmission doesn't engage into any gear ... Cluster shows that all gears selected ....
ATF level OK and VAGCOM doesn't show a ny codes/errors for trann When I put D or R - car revs up to 1200RPMs and thats it Checked ECU and TCU (tranny computer) no signs of water in them I don't really know history behind this vehicle but it had been sitting from 2009, had run before without problems (at least thats what previous owner told me) ...
i've got an accord 4 cylinder with an automatic transmission that does not engage any of the other gears when i shift it out of park. all indicator lights are out except for the park position on the dash.
View 1 Replies2008 Accent - driving down highway, heard a pop and car acted like it was in neutral. I have clutch pressure, you can see the hydraulic assist moving the fork, but gears just wont engage. I can free shift through all the gears with the clutch pushed in or not. Manual transmission and clutch kit replaced about 6 months ago when shifting fork broke inside last transmission and tore it all apart. With car in first (and turned off), I can push the car so I know gears are not engaging.
View 6 RepliesMy 2000 Subaru Outback (75,000 miles) runs well almost all of the time. Every so often, especially when the weather is cold and I have been making many short trips, the transmission will refuse to engage into any of the forward gears (Auto-Trans). It will do reverse, no trouble, but not the forward ones. It does not do this with any sort of regularity or consistency. I have had it checked by my mechanic and he said that although it did this it sounded fine and was not shifting roughly. Thinking it might be a fluid pressure problem, he put in fluid additive to soften the seals and this worked for about a week, then back to square one. I saw enough notes posted on other forums by other Subaru owners to know that this might be an issue with this year's model--maybe some sort of quirk that I hope can be fixed without a new trans.
View 5 RepliesBeen working on tightening up the 3 on the tree assembly because shifting has become troublesome; not wanting to engage gears completely, tough to go from 1st to second and so on. I have already adjusted the linkage per the shop manual with no improvement and found that it was not misadjusted. One of the first tasks is to replace the bushings from the shift rod to shift level under the hood though the bushings have some play but don't look that bad.
I have noticed the amount of play in the column when in neutral seems excessive, between 2nd and 3rd I can move the shifter about 2-3 inches up or down from center without feeling any tension toward a gear. This I think is the shift collar. Before I go tearing into the column, after replacing the shift collar was the amount of play significantly reduced?
My 1994 Subaru Legacy has been running unbelievably smoothly for the 7 years that I have had it. It has just over 160,000 miles on it, and our mechanic suggested that we change the timing belt as preventative maintenance. Since that incredible investment (worth over 50% of the car's value), I have had one problem after another. Once running, the car runs very well, but getting it started is another story. It takes several tries to start, it shakes back and forth, it makes horrible noises, and once the engine finally turns over, it is hesitant to engage the gears. The mechanic thought it may be the cam sensors, so he replaced them. That made absolutely no difference. What could be wrong with this car that was perfectly find until the timing belt was changed?
View 4 RepliesTook my 2007 Honda Pilot in on Thursday for an oil change and trip inspection to a very reputable mechanic that specializes in Japanese cars. He said he found a small amount of leakage on the rear cover of the transmission (it is a two wheel drive) so he removed the cover, resealed, and refilled the fluid. The evening after I picked it up, as I was driving up a hill, the car started rolling backwards and no gears would engage. Had it towed back to my house.
No fluid in the reservoir and the dipstick smells burnt. Obvious trans fluid on the underside of car. Is the transmission fried? Does he owe me a new transmission? No trans problems in it's history. It has been a great car and I am anal about the maintenance. I have all records since new. Should I have it towed back to him on Monday morning or towed to a dealer? The car has 89,000 mostly highway miles on it.
Been having trouble shifting into any gears on these chilly mornings in VA now... The clutch has been sticking on its way out when I release it and the gears don't want to engage unless I really push hard on the shift knob.
View 11 RepliesOn my '96 ranger with an automatic the reverse lights only come on between park and reverse, but once put into reverse they go out. The gear selector on the dash reads right, when the needle is on"P"it's in park, "R" drops into reverse and so forth. Do I need to adjust the shifter cable on the side of the transmission? If so how do I do this (I kinda need step by step with removal and adjusting, I've already tried and couldn't get it off the bracket). It's starting to drive me nuts, I've searched on the web for hours with no luck. I've even posted on other sites with zero answers.
View 7 RepliesMK7 GTI - I was driving along yesterday when I got a warning message that said "cannot engage reverse," accompanied by a CEL and the transmission downshifting into 1st gear (luckily I was only going about 20 mph.) I tried pulling over and restarting the car, and tried shifting into the different transmission and engine modes, but the transmission continued to only be able to engage 1st gear or neutral. Luckily I was five minutes from my APR dealer, and cruised over there at 15 mph so as to not over-rev the engine in 1st gear, a lot of pissed off traffic was flying by me honking.
They ran the codes, flashed it back to stock, and the codes and CEL persisted in stock mode. I drove back to my house at 15mph, took my intake off, and called roadside assistance to tow my car to the dealership. They are currently waiting on a rep to come out and authorize a new DSG most likely.
I have a 1995 Mazda Miata with a manual transmission. Lately it has been getting harder and harder to get the car into reverse, 1st, and 2nd gears, and this morning it was impossible for me to get the car into reverse. Do I need to replace the clutch? Is it something else?
View 1 Replies