4Runner/GX470 :: Left Front Wheel / Tire Starts Shaking At About 35 Mph
Feb 1, 2010
Not so simple as an unbalanced tire. Left front wheel/tire starts shaking at about 35 mph, worsens with increase in speed up to 52 mph then quits shaking. Some residual (though minor) vibration after that. Had tire balanced already at a good shop so I don't think that's it.
Struts are due for replacement - could that be part of the problem? I've had the thing on a lift and don't see anything indicative of a ball joint or an a-frame bushing, BUT, is it possible/probable that my problem is one or more of the latter problems combined beyond the tire issue?
View 2 Replies
Advertisement
i proudly own a 1986 4runner and i loved it ever since i got it. but i noticed on the way to a buddies house, a really high pitched squeaking noise...almost like a mouse. I just set it aside and turned up the radio. well this morning it was really getting worse. it was more audible and I am sure others can hear it in the parking lot of my school.
Also, I have another problem (trying to kill two birds with one stone here) i went to start the truck the other morning and its getting really really cold, about freezing point and when i started it up, the engine was idling at about 500rpm and there was a really loud noise under the hood, it sounded exactly like a vacuum cleaner. I quickly turned it off, hoping the started didn't stick or something, but the engine stopped and the vacuum cleaner noise stayed for about 4 or 5 seconds. I waited a few minutes and tried again and started right up and idled correctly. got to school, turned it off and started it back up and started correctly. went out there in the afternoon and it did it very shortly and just idled right. it still does it just barely every morning I start it.
View 11 Replies
I have a problem with my 4runner, it ran good when I drove it before I deployed, not I got back and it will not run, it starts for about 30 seconds then dies, sounds like something is killing the fuel, I took the cap off the tank to see if it was clogged, but thats not the problem, it just will not stay running for longer than 30 seconds. Also I realized that the alternator was very hot for the 5-7 times I started it and had it run for 30 seconds? Oh it's a V6 3.0L 5SPD manual 4X4 by the way.
View 3 Replies
89 4Runner, V6 having trouble on the start up. Seems worse on the cold start after the engine has been left idle overnight or after my shift at work. I just re-cleaned my connection to my positive post and it's nice and tidy lots of spark on the meter guage but when I go to turn it over just a click. Both the box inside the cab by the front quarter and outside I can hear clicking but just a single click no solenoid for the starter tapping away. Every once in a while it will start to pick up but it seems it's got no power and then nothing back to the single click. It's even hard to jump start at this point.
Could this be the start of my starter going? The bushings going? After I get it going and drive around to where I have to and try a restart it seems to pick up just fine.
I am due to have my timing belt and cam seals done soon could this have any effect? I just had my distributer cap and rotor done and new plugs.
View 3 Replies
on a 93' 4 runner that will not engage 4 wheel drive. The 4 wheel manual shifter works fine, and the linkage underneath looks fine; however, the indicator does not light up - and it definately only has rear wheel drive.
View 5 Replies
I've been having a lot of noise coming from the front left tire, and I finally had it diagnosed as a bad wheel bearing today.
I noticed that the front wheel bearings are sold individually while the rear wheel bearings are sold as hub assemblies. Is there a certain way that the front wheel bearings have to be removed and pressed on? I'm trying to see if this is a DIY repair.
View 14 Replies
I have a craigslist nightmare vehicle in the shop today, a 98' Toyota 4runner Limited V6. Runs and drives fine, but it's got a heck of a growl in the front end over 15mph. We removed the diff and found that when it was turned it had some vibration and a ton of noise. Disassembled it and found it to be full of metal flake, and it appears the spider gears are worn and causing a good lot of the noise. The bearings seem to be alright, but I'm planning to replace those anyway while we're inside, due to the amount of metal in the fluid.
My questions are:
1. Is this a common failure?
2. Where can I purchase spider gears? Most places don't seem to list them.
3. Is there a rebuild kit that includes bearings and spider gears so I can make one part order and run with it?
View 1 Replies
Two weeks ago my front left wheel would start shaking like hell when I brake, not at first but after say may eight miles of driving. I have never been in a vehicle shaking so violently and after proceeding from a stop it would continue until it cooled down. I tore out the caliper and made sure everything was clean and lubed and also to make sure I did not put the pads on wrong. Fast forward one commute and the same crap. I could not go faster than 45 mph without feeling like it was going to disintegrate.
When I got home the damn thing was smoking. I managed to get it to the dealership this afternoon and two hours later the guy told me that the guides just needed some cleaning and grease. They did not want to charge me anything (draw your own conclusion) for it. I was told they drove it up/down hills and it was alright. I left kind of suspicious and four miles later the problem revealed itself again. My next thought it maybe axle end play, bad bearings or joints? Intermittent why? 2004 f150 lariat 4x4 ....
View 4 Replies
Here' the low down. I have a 90 4runner v6 4wd. It is intermittently making a loud rubbing noise in the front right of the truck. It starts randomly and sometimes stops on its own or will start when I hit a bump,it will stop when shifted into 4wd, or when I brake or turn hard to the right. but happens only a portion of the time. took it to mech, he removed front drive shaft and said prob went away, it seemed the vacuum pump or the solenoid that activates shifting out of 4wd is defective. So he manually switched off the 4wd replaced the front shaft and all good! but on my way home the noise began again. super frustrated, 3rd mechanic in a week.
View 1 Replies
I have an 03 Elantra with a slight hum coming from the front left wheel area. It starts after 35 mph, does not seem to get louder as speed increases. I have about 3500 miles on Pirelli P6 plus 195 60 15 tires all at 35 psi, front brakes are new, cv boots are not cracked or torn and I do not notice any abnormal heat coming from front left hub(wheel) bearing area.
View 1 Replies
I took my car in the other day for 4 new tires at 8am I drive home 2 miles from the place. I work nights so I sleep all day. As I was going to work at 11pm I noticed it sounded like the front drivers side tire was rubbing up against the car when I turn the wheel from left to right. I took it back to the place I got the tires from. I thought something might be adjusted wrong or something. They call me to tell me that the tires are fine and the problem is that I need a new power steering pump. There was no noise or steering problem previous to me getting the tires.
I took it to pep boys (the only place open last night). They say the pump needs to be replaced along with racks and pinions..etc. I ask if the leak can be slowed or stopped with one of those stop leak products and they say no. The fluid just drains right out. Is there something the guy that put my tires on could have messed up to cause this problem?
I spent a lot for the tires and within 5-10 miles later this problem starts. The car has over 250000 miles on it and I cant justify spending that much money to repair it but at the same time Im in a bind financially (medical bills, divorce) to get another car right now. I realize even if they did mess it up when they put the tires on, they wont admit to it anyway.
View 13 Replies
My GX470 steering wheel shakes/vibrates when I hit speeds over 50mph. What is causing it?
View 12 Replies
All of a sudden the front left lights and both fog lights stopped working. It must be a fuse or a loose connection.
View 6 Replies
I have had a wobbly wheel since I can remember, it starts at about 55. I have replaced the front tires, struts and mounts, new rotors, brakes and I cant seem to figure it out. The front end is tight and the cv axle boot is still intact and I have never seen one go out without ripping the boot. If I lift the car up the front left tire hops a bit so thats the culprit but I cant seem to narrow it down anymore. I think its the cv axle but it seems weird considering the boot isn't torn.
View 4 Replies
So I have a Toyota Corolla 2004, and 117000 miles. Just this Saturday (2 days past) I got an oil change and a tire rotation (at a Valvoline drive through service station). This morning, once I was going 50-60 miles an hour on the highway, the steering wheel began to shake (left and right, fast). The vibrations come in waves, where maintaining a constant speed, it will shake, then the shaking will smooth out, and then it will start to shake again, in ~30 second cycles.
I'm assuming that this problem has something to do with my tire rotation, since it's the first one I did in recent memory, (Thought they do this as part of where I got my care inspected?) .. What should I do?
View 2 Replies
When I turn my AC to max. power (fan) the steering wheel and the entire dash board starts shaking and vibrating. Also one can hear a "deep" humming noise which seems to be coming form the fan/fans belt etc.
View 9 Replies
I have a 92 4runner with v6 5speed Manual tranny it has the A.D.D hubs ,when I put it in 4wd its not going into 4wd the 4wd indicator in dash is not coming on ,that could be a bad bulb cause it doesn't come on when you turn key on.The transfer case is working all right .Its something in the front end that's not engaging .I noticed on the front diff. there is some kind of solenoid there with vacuum hoses and a electrical connection .Does this have anything to do with it not locking into 4wd?
View 2 Replies
we have just pulled out head resurfaced and put engine back together now it won't start tried the timing and checked for fuel but wont start the only way it starts now is with brake fluid in the intake but that only fires up and won't stay idle.
View 3 Replies
I've noticed that my brakes are very sensitive lately. I'm wondering if it has anything to do with the differential oil that got on the rear pads when the rear seals blew out about 3 months ago. The shop cleaned them off but they still looked oily to me. I'm also wondering if it is parking brake related as one or both of the bellcranks are frozen (there's no cable sag, but one of the stops has a gap and the parking brake doesn't work). Or is it brake fluid related. I am years past the point of needing to replace the brake fluid and bleeding out the old fluid.
View 5 Replies
The transmission went out on my toyota 4 runner ...
View 1 Replies
I have a 93 4Runner, and it won't start all it will do is turn over, But won't start, my dad has tried everything we could think of It has gas, an new battery and new battery cables...
What is the location of the MASS AIRFLOW SENSOR, AND THE MAIN COMPUTER...
View 2 Replies
