Starts humming at around 25mph and gets louder and higher pitched as I accelerate. Noise stops when I turn right so I assumed it was the right rear wheel bearing. I replaced the hub bearing and the noise continues. Also had the tires checked out and they seem to be fine.
View 1 RepliesI just did my winter hard top for the season, hooked up the plug for the rear heater and it works but it's cranking out cold air even when I am up to running temperature. The front heater is blowing lots of heat. Am I missing something? Is there something other than the plug I need to hook up?
View 12 RepliesThis 96 4 runner's rear wiper and rear window has stopped working. I can only assume they stopped at the same time as the truck doesn't belong to me, I was just asked to see what it would take to fix it. I've looked it over and see no fuse and don't really have a clue where to start looking for the culprit of the problem.
View 2 RepliesI brought my 4runner in to fix a rear axle seal and to see if they could isolate a clunking noise I've been having. They said the clunking was coming from the rear differential (I believe him as that's what I heard, while driving or even just putting it into gear). They have yet to call me back, but any guesses here as to whether it is a bearing (my guess, as it is most pronounced on a bumpy road) or a cracked gear or something else. I've been driving with a clunk for about a week, but have various clunk problems for the last 80k miles ....
View 14 RepliesI've had this problem for years but is now getting worse. It used to only happen when it was really cold out, subzero, but is now happening as we now approach 50 degrees out. If I hit a pothole or pop over a small curb, I get a clunk in the rear. I replaced the shocks about 3 months ago which seemed to work briefly but the problem is back and is worse than ever.
I have the original springs and it looks like the recall was done by the previous owner (rubber bumber stops installed).
230k miles. Do I need new springs?
we have just pulled out head resurfaced and put engine back together now it won't start tried the timing and checked for fuel but wont start the only way it starts now is with brake fluid in the intake but that only fires up and won't stay idle.
View 3 RepliesI have a 93 4Runner, and it won't start all it will do is turn over, But won't start, my dad has tried everything we could think of It has gas, an new battery and new battery cables...
What is the location of the MASS AIRFLOW SENSOR, AND THE MAIN COMPUTER...
89 4Runner, V6 having trouble on the start up. Seems worse on the cold start after the engine has been left idle overnight or after my shift at work. I just re-cleaned my connection to my positive post and it's nice and tidy lots of spark on the meter guage but when I go to turn it over just a click. Both the box inside the cab by the front quarter and outside I can hear clicking but just a single click no solenoid for the starter tapping away. Every once in a while it will start to pick up but it seems it's got no power and then nothing back to the single click. It's even hard to jump start at this point.
Could this be the start of my starter going? The bushings going? After I get it going and drive around to where I have to and try a restart it seems to pick up just fine.
I am due to have my timing belt and cam seals done soon could this have any effect? I just had my distributer cap and rotor done and new plugs.
My 1994 4x4 4Runner throws out a white puff of smoke at the tail pipe everytime I start it and sometimes when I'm driving. Just recently, it has no acceleration power what so ever and it can hardly go up a hill.
Is my engine total? Also, I'm leaking alot of steering fluid but, no puddles anywhere.
Is there a connection between the two or is it just time to buy a new car?
Wife complained about the noise coming from the front. She said it sounds like an engine noise. I took her car for a few days noticed the noise starting at about 25mph+ (near the driver side). Tried to put the engine in N and rev it, while driving, pretty such it is not the engine.
I do notice the noise is getting a bit louder today compared to last week...Did some google search and "it might" be the bearing. Just wonder what to do next. My wife doesn't want to drive it at this time....so she took my truck today
I have a 92 4runner with v6 5speed Manual tranny it has the A.D.D hubs ,when I put it in 4wd its not going into 4wd the 4wd indicator in dash is not coming on ,that could be a bad bulb cause it doesn't come on when you turn key on.The transfer case is working all right .Its something in the front end that's not engaging .I noticed on the front diff. there is some kind of solenoid there with vacuum hoses and a electrical connection .Does this have anything to do with it not locking into 4wd?
View 2 Replieson a 93' 4 runner that will not engage 4 wheel drive. The 4 wheel manual shifter works fine, and the linkage underneath looks fine; however, the indicator does not light up - and it definately only has rear wheel drive.
View 5 RepliesI have a problem with my 4runner, it ran good when I drove it before I deployed, not I got back and it will not run, it starts for about 30 seconds then dies, sounds like something is killing the fuel, I took the cap off the tank to see if it was clogged, but thats not the problem, it just will not stay running for longer than 30 seconds. Also I realized that the alternator was very hot for the 5-7 times I started it and had it run for 30 seconds? Oh it's a V6 3.0L 5SPD manual 4X4 by the way.
View 3 RepliesI've noticed that my brakes are very sensitive lately. I'm wondering if it has anything to do with the differential oil that got on the rear pads when the rear seals blew out about 3 months ago. The shop cleaned them off but they still looked oily to me. I'm also wondering if it is parking brake related as one or both of the bellcranks are frozen (there's no cable sag, but one of the stops has a gap and the parking brake doesn't work). Or is it brake fluid related. I am years past the point of needing to replace the brake fluid and bleeding out the old fluid.
View 5 RepliesThe transmission went out on my toyota 4 runner ...
View 1 RepliesThe son inlaw just bought a 86 4runner. It's been beat pretty good but I know Toys are good for it. My question is, it rev's just fine in every gear but 5th. Going down a flat highway and in 5th it won't rev over 2500 no matter how much gas ya give it. It has a 22re and 31-9.50's under it. My daughter had a 86 p/u with a 22r (I believe) and 33-10.50's and it had no problem hitting 90. Is there a limiter on these things? Thought i'd ask before chasing vac lines.
View 2 RepliesI have a 91 4Runner SR5 V6 3.0L that has been a great truck (like all of them?) until just recently.
Symptoms are bogging at roughly 25 mph or 2500 rpm in second to third gear. It will also sometimes not take off from a stop at a slight incline. By hammering the throttle down and forcing a downshift, the truck will rev up and then accelerate, but then again sometimes bog down until the same "forced shift" is done.
This seems prevalent when the engine is hot, however, that may be coincidental with the high temps here in So Texas lately. The truck does seem to run fine for a while after starting it. Mechanic hasn't isolated anything.
'91 4Runner, V6, 3.0, 113K miles. It has a nasty bog on takeoff, doesn't seem to clear out until over 35 mph on flat ground, and you can forget about starting from a dead stop going up any sort of incline.
It still has the stock plugs, so I figured those were up for changing anyway. While I was at the shop, I went ahead and picked up a new air and fuel filter. I decided to try one thing at a time, started with plugs, got em in fine, took it around the block, wouldn't idle, sputtered pretty bad, stalled at every stop sign.
I figured that the fuel filter was in fact clogged, and maybe the new plugs were causing it to starve for gas? Crawled under the car, and the cat converter was cherry red hot. I put in maybe half a mile, so could that be my problem? It has begun to rain, so I have not installed the fuel filter. I've heard some stuff about sensors going bad, namely the CTS, but that is getting a bit in over my head.
I have a craigslist nightmare vehicle in the shop today, a 98' Toyota 4runner Limited V6. Runs and drives fine, but it's got a heck of a growl in the front end over 15mph. We removed the diff and found that when it was turned it had some vibration and a ton of noise. Disassembled it and found it to be full of metal flake, and it appears the spider gears are worn and causing a good lot of the noise. The bearings seem to be alright, but I'm planning to replace those anyway while we're inside, due to the amount of metal in the fluid.
My questions are:
1. Is this a common failure?
2. Where can I purchase spider gears? Most places don't seem to list them.
3. Is there a rebuild kit that includes bearings and spider gears so I can make one part order and run with it?
My '98 V6 4-Runner idles roughly when AC compressor loads up. Stops when compressor unloads. Vacuum leak?
View 3 RepliesWe just bought a 1995 Toyota 4Runner that has 195,000 miles. We bought it for a 4wd vehicle to take over the passes and go hunting, but we have been driving it regularly because we like it. I read in the manual that under heavy idling conditions the timing belt should be changed every 60,000 miles but it does not say for regular driving. The previous owners had work done on the timing belt at 96,000 miles.
View 2 Replies