I have a 2000 toyota 4runner and the key will not turn in the ignition.We bought a new key from the dealer and also tried wd-40 in the ignition, still no luck.
View 5 RepliesI have a 93 4Runner, and it won't start all it will do is turn over, But won't start, my dad has tried everything we could think of It has gas, an new battery and new battery cables...
What is the location of the MASS AIRFLOW SENSOR, AND THE MAIN COMPUTER...
A few months ago I purchased a 2.7l toyota 4runner 1999 with about 144k from original owner. A few weeks later, the vehicle won't start. when I turned the key in the ignition, nothing happens. my mechanic from toyota dealership have checked or changed everything; the relay, battery, starter, switch module and neutral switch sensor. What it might be and how I can get it fixed?
View 14 RepliesI just did my winter hard top for the season, hooked up the plug for the rear heater and it works but it's cranking out cold air even when I am up to running temperature. The front heater is blowing lots of heat. Am I missing something? Is there something other than the plug I need to hook up?
View 12 Replies1999 Toyota 4 Runner's keyless entry (with new battery) will not unlock the car. The "lock" button works fine. Using the manual key for entry triggers the theft alarm. The only way to stop the alarm is by using the unlock button on the remote, which as stated, is not working. It does not make sense to me that I cannot use the standard key to enter the vehicle. In essence, I am locked out of my own car.
View 1 RepliesI have an 1990 Toyota 4Runner. V6 engine. Automatic. 4wd. Today it blew an upper radiator hose. A few seconds after the initial pop of the hose and the spew of fluids the vehicle died. I replaced the upper radiator hose and the lower hose- and refilled the antifreeze. There are no leaks as of right now.
The engine will not start. The belts spin whenever the key is turned on. But the engine will not crank. You can hear the starter trying to start it up. Jumping the vehicle was of no luck. Charging the battery was of no dice.
The vehicle makes a whirring noise (belts spinning) when key is turned, but the engine does not crank at all. The noise stops as soon as you shut the key off. The oil is clean and full still.
Some background. I have a 1998 Toyota 4Runner V6 2WD with about 150,000 miles. A few months ago the check engine light was flashing when I am travelling over 70mph. The dealership said nothing is wrong when I asked them to look into it. But I didn't get any codes from it. I read on-line that it could be a possible misfire so I changed the plugs and wires.
A few weeks ago, the check engine light came on and stayed on. I took it to a dealership to diagnosis the problem, they came up with Mass Air Flow sensor was shot. I replaced that, and reset the computer. It still comes on and flashes at highway speeds. I bought a low end computer to read the codes.
I got P300 (Random/Multiple Misfire), P302 (Cylinder 2 Misfire) and P305 (Cylinder 5 Misfire). Cylinder 5 has the coil-pack and Cylinder 2 has the wire coming off the coil-pack for Cylinder 5. So I replaced the coil-pack. The light is still coming on and flashing. How to stop the light from flashing. It comes on only when I am travelling past 70MPH. I have tried just rev'ing the engine up to the same RPM's as I am running when doing 70, but the light doesn't flash then.
89 v6 4Runner. When I turn the key forward you hear a "click" coming from the passenger side fender area. After a few turns the engine will turn over and away you go. Yesterday for the first time after a few clicks I lost all power to my instrument panel, no dash lights no gauges working and no click, nothing. Stereo, cigarette lighter still had power, even reset my dash clock so it lost all connections as well. Every few turns I would get lights back and turn the key to start and click and dead again. Eventually I bump started the engine, drove home and here I sit.
Relay box by the front fender... this is where the click is coming from, looked at a few posts from yoda tech and one person suggested cutting the no 4 line for the ignition system off the relay box and have it go directly to the pos post for the battery. This will be a closed circuit from the battery post direct to the starter relay yes?
Relay box is probably just getting old and wires are beat up. My electrical is not the best for sure. Can I just clean up the wires going to the relay box(es)?
We own a 2000 Toyota Tundra--90,000 miles--obviously not used hard. When we turn on the ignition, we hear a ticking sound--sounds like it might be coming from underneath car passenger side. The sound seems to disappear as we drive it. What it might be? Toyota service person told us it might be exhaust manifold and estimated maybe 2K to fix it.
View 1 RepliesLast night my 2007 Toyota 4Runner started up on its own. The vehicle had been completely turned off, the keys were not in the ignition, and it doesn't even have a remote start. After a little while, the vehicle then turned itself off. It continued to turn itself on and off throughout the night. What could be wrong with my SUV?
View 10 RepliesMy car engine wont turn over. I can hear the starter going when I turn the key but the engine wont start. My battery is old and when I read volt meter in my car the line is right in the middle. When I tried getting jump started by a friend the engine still wont turn over. I'm wondering if this is due to a bad battery that drained because of cold weather or something else. 1995 Toyota 4runner 251,900 miles...
View 9 RepliesI have a 2000 Toyota SR5 with a 6-cylinder engine. When I first start the car (cold start) in the morning it will run at high idle (1500-1800 rpm) for about 3-4 minutes. At this point, the idle will begin to drop, but then the engine starts to surge. It's a noticeable surge that bounces from around 900-1100 rpm. It almost seems like an electrical surge, but I don't believe that's the problem. After running the car for a while and it's fully warmed up to operating temperature, the surge goes away. My thoughts automatically went to the IAC (idle air control) or maybe a temp sensor?
View 3 RepliesMy 2000 4x4 4runner just after it starts up tends to have a funky idle. It rarely goes above 2000 rpm but it ranges from 300-1500 when idling after start. Also when I drive home from work it tries to idle as low as it can then if I don't rev the engine it usually dies in the middle of traffic. Once it's going it's fine though. I've already cleaned the IAC and the Mass airflow sensor. Maybe one needs to be replaced or just a tune up?
View 5 RepliesThe left turn signal blinker on Toyota works sometimes and not others. It is weird, it seems when the weather is cold, it works, warm weather it works sometimes.
The car is: 2002 Toyota 4-Runner, limited....
My 2000 4Runner will start slipping just after acceleration from a stop only after having driven it for about 5 minutes. I really don't think it's anything major because I've always been nice to the transmission and don't drive like a wild child.
View 11 RepliesDuring the cold snap over the last few months, my 1997 Toyota 4Runner has been having starting problems with the following symptoms in this order:
I turn the key and nothing happens.
I keep turning the key from off to start, and the starter eventually engages and cranks 2 or 3 times, but the engine does not turn over.
I keep trying and the starter engages and keeps cranking even after I turn the key off.
I panic, and turn the key on and off until the starter stops cranking.
I try a few more times and the starter cranks and the engine catches, but lugs until I pump a little gas.
Really weird thing. Occasionally, after the above sequence, the emergency brake light stays on even though the brake handle has been disengaged, and it feels like I have no power, then the light goes out and the car runs just fine.
The problem in intermittent. Cold seems to cause it although it doesn't cause it every time. Rain may be a factor as well. Sometimes, I only have to turn the key a few times, and then the starter will engage. I changed the battery after the trouble began, and it cranks well if and when the starter engages.
Up until this I have not had a day's trouble with this vehicle other than a little belt squeaking.
I have a 2000 Toyota 4 Runner with 115k miles on it. While in Colorado a month ago, we were driving down a snow covered hill and some guy banged on the window telling us the right rear wheel wasn't spinning. We put it in reverse and it rolled fine that way but still didn't when we headed back in drive. I goosed it a little bit and it went "bam" and drove fine after that.
We were in 4 wheel drive at the time. Last night it happened again. I put the vehicle in drive and it wouldn't budge. I goosed it a little again and it went "bam" and drove several feet until I stopped. It froze up again for a few more minutes. It was NOT in 4 wheel drive this time. Is it time to dump this thing or get a new transmission in preparation for the inevitable?
I have a 92 4runner with v6 5speed Manual tranny it has the A.D.D hubs ,when I put it in 4wd its not going into 4wd the 4wd indicator in dash is not coming on ,that could be a bad bulb cause it doesn't come on when you turn key on.The transfer case is working all right .Its something in the front end that's not engaging .I noticed on the front diff. there is some kind of solenoid there with vacuum hoses and a electrical connection .Does this have anything to do with it not locking into 4wd?
View 2 Replieson a 93' 4 runner that will not engage 4 wheel drive. The 4 wheel manual shifter works fine, and the linkage underneath looks fine; however, the indicator does not light up - and it definately only has rear wheel drive.
View 5 RepliesI have a problem with my 4runner, it ran good when I drove it before I deployed, not I got back and it will not run, it starts for about 30 seconds then dies, sounds like something is killing the fuel, I took the cap off the tank to see if it was clogged, but thats not the problem, it just will not stay running for longer than 30 seconds. Also I realized that the alternator was very hot for the 5-7 times I started it and had it run for 30 seconds? Oh it's a V6 3.0L 5SPD manual 4X4 by the way.
View 3 Replieswe have just pulled out head resurfaced and put engine back together now it won't start tried the timing and checked for fuel but wont start the only way it starts now is with brake fluid in the intake but that only fires up and won't stay idle.
View 3 Replies