My transmission up shifts fine for the first couple of gears, but as I get to the last gear (I think it is the last gear), my transmission takes a while to up-shift. I am at 3000 RPM before it up-shifts then goes down to 2000 RPM on the next gear. Is there any fix that will not require a new tranny?
View 4 RepliesWe just bought a 1995 Toyota 4Runner that has 195,000 miles. We bought it for a 4wd vehicle to take over the passes and go hunting, but we have been driving it regularly because we like it. I read in the manual that under heavy idling conditions the timing belt should be changed every 60,000 miles but it does not say for regular driving. The previous owners had work done on the timing belt at 96,000 miles.
View 2 RepliesI was flushing the radiator on my 1995 V6, 3 Liter, 5 speed. And absent mindedly, I fired up the engine for a minute to "flush" it out, but hadn't put the water/flush in it yet.
Now, the check engine light is on, it idles at about 2000 RPMs and spits smoke. I haven't run it more than 5 minutes total like this. I refilled the radiator, fired it up, no better. I drained that and tried again, but still no better.
I just bought a 95' 3.0 V6 4 runner that had overheating issues that caused head gasket to fail. I fixed all the reasons it was blowing the gasket with a new radiator & thermo. Now, temp no longer an issue but the automatic trans is slipping but has been getting alittle better as I drive it more. I noticed the trans fluid was pretty burnned when I replaced radiator..so will replacing the trans fluid & filter fix this issue ? Or could there be another issue ? My check engine light is also on, I will check the codes soon. I am getting horrible gas mileage, but probly from the slipping trans I guess.
View 1 RepliesThe son inlaw just bought a 86 4runner. It's been beat pretty good but I know Toys are good for it. My question is, it rev's just fine in every gear but 5th. Going down a flat highway and in 5th it won't rev over 2500 no matter how much gas ya give it. It has a 22re and 31-9.50's under it. My daughter had a 86 p/u with a 22r (I believe) and 33-10.50's and it had no problem hitting 90. Is there a limiter on these things? Thought i'd ask before chasing vac lines.
View 2 RepliesThe transmission went out on my toyota 4 runner ...
View 1 RepliesAuto tranny takes a half second to go into gear. It doesn't slip just slight hesitation going into gear. This rig has 173000 miles on it and I don't know its maintenance history and don't want to stick much money in it.
View 3 RepliesI have a 98 GS4 and a 04 RX330 and one major issue I have with the RX, is the poor downshift response when slowing down, to say 5-10 mph and give it gas, the transmission takes FOREVER to realize I want first gear. If I am giving it 50% throttle at 5-10 mph after slowing and needing to get a move on, the throttle seems like it is there, but the transmission takes an eternity to realize "oh, you want first? hang on while I think about it", then it grabs first and LURCHES forward, giving everyone a very uncomfortable jerk.
My GS however, when down to those speeds is always spot on the right gear. Yeah, I know its comparing a GS to a RX, but wouldn't you think that Lexus would figure that one out?
Is the 04 worse than 05 or 06? Can I use an 05 or 06 trans controller and get some improved transmission response?
You can tell by the lurch, the throttle is responding to the driver's throttle pedal input, but the transmission isn't figuring it out till way too late. I don't get the lurch like at slower speeds and higher throttle input, but it sure makes for a poorly driving car.
I see the same problem when taking slower corners, get it down to 10-20 mph for a corner and the transmission won't downshift till AFTER the apex of the corner, despite what throttle pedal is pressed.
I've got a 92 star with a 4.0 liter engine and I think a 4ald auto trans. When I 1st start the motor it takes 3-4 minuted before it will go into gear. after that it's fine. I've tightened the 2 bolts under the dash tightening up the shifter and my fluid level is fine.
View 11 RepliesI have a 92 4runner with v6 5speed Manual tranny it has the A.D.D hubs ,when I put it in 4wd its not going into 4wd the 4wd indicator in dash is not coming on ,that could be a bad bulb cause it doesn't come on when you turn key on.The transfer case is working all right .Its something in the front end that's not engaging .I noticed on the front diff. there is some kind of solenoid there with vacuum hoses and a electrical connection .Does this have anything to do with it not locking into 4wd?
View 2 Replieson a 93' 4 runner that will not engage 4 wheel drive. The 4 wheel manual shifter works fine, and the linkage underneath looks fine; however, the indicator does not light up - and it definately only has rear wheel drive.
View 5 RepliesI have a problem with my 4runner, it ran good when I drove it before I deployed, not I got back and it will not run, it starts for about 30 seconds then dies, sounds like something is killing the fuel, I took the cap off the tank to see if it was clogged, but thats not the problem, it just will not stay running for longer than 30 seconds. Also I realized that the alternator was very hot for the 5-7 times I started it and had it run for 30 seconds? Oh it's a V6 3.0L 5SPD manual 4X4 by the way.
View 3 Replieswe have just pulled out head resurfaced and put engine back together now it won't start tried the timing and checked for fuel but wont start the only way it starts now is with brake fluid in the intake but that only fires up and won't stay idle.
View 3 RepliesI've noticed that my brakes are very sensitive lately. I'm wondering if it has anything to do with the differential oil that got on the rear pads when the rear seals blew out about 3 months ago. The shop cleaned them off but they still looked oily to me. I'm also wondering if it is parking brake related as one or both of the bellcranks are frozen (there's no cable sag, but one of the stops has a gap and the parking brake doesn't work). Or is it brake fluid related. I am years past the point of needing to replace the brake fluid and bleeding out the old fluid.
View 5 RepliesI have a 93 4Runner, and it won't start all it will do is turn over, But won't start, my dad has tried everything we could think of It has gas, an new battery and new battery cables...
What is the location of the MASS AIRFLOW SENSOR, AND THE MAIN COMPUTER...
I have a 91 4Runner SR5 V6 3.0L that has been a great truck (like all of them?) until just recently.
Symptoms are bogging at roughly 25 mph or 2500 rpm in second to third gear. It will also sometimes not take off from a stop at a slight incline. By hammering the throttle down and forcing a downshift, the truck will rev up and then accelerate, but then again sometimes bog down until the same "forced shift" is done.
This seems prevalent when the engine is hot, however, that may be coincidental with the high temps here in So Texas lately. The truck does seem to run fine for a while after starting it. Mechanic hasn't isolated anything.
'91 4Runner, V6, 3.0, 113K miles. It has a nasty bog on takeoff, doesn't seem to clear out until over 35 mph on flat ground, and you can forget about starting from a dead stop going up any sort of incline.
It still has the stock plugs, so I figured those were up for changing anyway. While I was at the shop, I went ahead and picked up a new air and fuel filter. I decided to try one thing at a time, started with plugs, got em in fine, took it around the block, wouldn't idle, sputtered pretty bad, stalled at every stop sign.
I figured that the fuel filter was in fact clogged, and maybe the new plugs were causing it to starve for gas? Crawled under the car, and the cat converter was cherry red hot. I put in maybe half a mile, so could that be my problem? It has begun to rain, so I have not installed the fuel filter. I've heard some stuff about sensors going bad, namely the CTS, but that is getting a bit in over my head.
I have a craigslist nightmare vehicle in the shop today, a 98' Toyota 4runner Limited V6. Runs and drives fine, but it's got a heck of a growl in the front end over 15mph. We removed the diff and found that when it was turned it had some vibration and a ton of noise. Disassembled it and found it to be full of metal flake, and it appears the spider gears are worn and causing a good lot of the noise. The bearings seem to be alright, but I'm planning to replace those anyway while we're inside, due to the amount of metal in the fluid.
My questions are:
1. Is this a common failure?
2. Where can I purchase spider gears? Most places don't seem to list them.
3. Is there a rebuild kit that includes bearings and spider gears so I can make one part order and run with it?
My '98 V6 4-Runner idles roughly when AC compressor loads up. Stops when compressor unloads. Vacuum leak?
View 3 RepliesI have a 2000 toyota 4runner and the key will not turn in the ignition.We bought a new key from the dealer and also tried wd-40 in the ignition, still no luck.
View 5 RepliesI've got a 99 4runner with the 3.4 engine and it's gotten to where it wants to stall in traffic. It starts right back up. Runs fine on the interstate. No check engine light. I've changed the fuel filter, cleaned the throttle body, and cleaned the MAF sensor. Not sure what to do next.
View 4 Replies