2006 Impala SS - Car Stalling After Installation Of New Muffler


Jul 2, 2013

So I bought a 2006 impala SS about 2-3 months ago. After a month of having it I put flowmaster 40 series mufflers on it. Ever since I put the mufflers on I've had problems with the car stalling out at random times and then not being able to start up for around 20 mins. I took it back to the dealer and they can't seem to figure out what's wrong. It's been to the shop three different times because they thought they fixed it a couple times.

View 3 Replies

Advertisement

Impala - Chevrolet :: 2000 Stalling After Hitting Higher RPM

while at stop in netural, reve engine, it seems to want to stall after it hits higher rpm?

View 1 Replies

Ford Exhaust :: 2006 - Delete Cat Or Muffler?

I've got a 2006 6.0 350 with stock exhaust and am wanting to either delete the cat or the muffler, but not both. I'm curious how each would sound? For example, would deleting the cat make it louder than deleting the muffler, or will one make the turbo whine more audible than the other? Also, is there any benefit to deleting one over the other, performance wise? Oh, I'm not really looking for loud and obnoxious, but more turbo whine wouldn't be too bad .

View 2 Replies

Ford 6.0L Power Stroke Diesel :: 2006 F350 - White Smoke / Diesel Drip From Muffler / Poor MPG

I would like the hear what others have to say about the problems I'm having with my 2006 F-350 sd xlt 6.0 with 113,000 miles on it. It's being used as a tool truck mostly going from a shop on the property to close by buildings on the same property. In other words very short distances. Used occasionally to take a dump trailer to a close by dumping ground.

1. White smoke from exhaust. I've read this is most likely an ERG cooler that needs replacing. Any other possible causes? If I end up having to replace the cooler is there a stock cooler that is reliable or should I get the one by bullet proof?

2. Diesel is dripping from the muffler weep hole. Last full tank lasted only 60 miles. Could this be the oil cooler? Anything else? If so is the Ford replacement cooler OK or should I go with an upgraded cooler?

View 14 Replies

Impala - Chevrolet :: 2006 - Belt Squeal When Temperature Is Hot Outside

3.9L V6 Chevrolet Impala driver here. The vehicle has about 83000 miles on it. I've been driving it since 2006 and was purchased used. The belt is starting squeal. Which isn't that big of a deal since all belts do need to be replaced. However, the squeal only occurs when the temperature is hot outside or has been driven for a while. If I go on a long drive the belt won't squeal until I get to more stop and go traffic. I have sprayed pulley's while the belt is squealing and it is the power steering pulley. However, I am not sure if to replace the power steering pump or just replace the pulley. Sounds like a bad bearing in my opinion.

I replaced my belt with the recommended Gates belt. Upon inspection of the pulleys I had one that looked questionable. Here is an image of the pulley that was pulled imgur.com/a/vU8DG#0. This is the lower Idler pulley. [URL] ....

I just noticed today of 4/1/2013 that there is a slight squeal coming from the engine bay. I notice it more when accelerating then if I am just idling. This sounds like it may be the lower idler pulley.

View 9 Replies

Impala - Chevrolet :: 2006 - Intermittent No Start / Bad Ignition Switch

I have a 2006 chevy impala LT 3.9 v6. Intermittently it wont start, crank it and it does nothing. All accessories work fine. Had a new starter installed, switched the relay it works on, had the ignition switch changed (twice), had the passlock system replaced, new keys for the ignition. Had the car to the dealer four, times. It doesn't happen all the time so it cant be reproduced at will. I just keep trying to start it and it will eventually start, it can be turning the key from 4 to 40 times. there's no rhyme or reason, some times it doesn't happen for 5 days, then it happens everyday for a week.. according to the dealer when they reproduced it it was the ignition switch. I doubt i got 2 bad ignition switches so i don't believe the error is being reported correctly. According to chevy they have no other reports of this..

View 2 Replies

Impala - Chevrolet :: 2006 - Remote Control Stopped Working Suddenly?

My remote controls just stop working. 2006 Chevrolet Impala LTZ .

View 10 Replies

Accent MC (2006-11) :: RPM Drops After New AC Compressor Installation

Just want to share my issue in my Accent 2009 model. I changed my AC compressor 2 days ago. When I had the new compressor installed, at first it was running normally. But after maybe 2 or 3 hours, when I am starting the engine then turn on the AC, RPM becomes lower. Sometimes it turns off the engine. That's why I need to press on the gas several times so the engine wouldn't turn off. Even when I am running, when I go on slow speed then shift to gear number 2, the rpm drops to less than 1000, needs to press the gas several times to increase rpm to make the car run faster.

View 3 Replies

Passat (B6) :: 2006 - Installation Of OEM IPod Connector?

I purchased an OEM VW ipod connector and need installing it to my factory radio. Looking for how to's? or pictures.

View 1 Replies

Lexus GS 2006-11 :: Satellite Radio Installation Process?

I have a 2009 GS350.

Its Satellite radio ready, meaning it has a SAT button and it has the shark fin antenna on the roof. When you push the SAT button nothing happens. I was told I need to get the unit installed. I am assuming all the wires are run through the car and its just a simple plug and play, but I'm thinking that would be too easy. Also where does the unit get installed? Where to even look to see if the wires are there.

View 14 Replies

Sonata NF (2006-10) :: HIDs Installation - Keep Blowing Fuse

I tried installing my new DDMTuning 35W 6000K HID headlights with relay harness. No issues until I went to turn the car on and actually power them up. Neither side would work. I checked my power connection, ground, in-line fuse, swapped out the relay, tried without the harness, and nothing worked. I tried putting the stock bulbs back in and I found out they wouldn't turn on either.

I found the issue to be a blown 20 amp fuse in slot 23 (see pic). I replaced it and tried to turn the car on with the HIDs and it blew again. I hooked the stock lights back up and they seem to work fine now with another new fuse. The fuse description says H/LP LO and HID LO LH. Why this fuse is blowing. I am wondering if I just need a higher amperage fuse because of the HID power (in line for harness is 30 amp) or if something else is the culprit. I'm stumped.

View 12 Replies

Sonata NF (2006-10) :: High Output Alternator Installation

What difficulties might I run into on switching in the HO alternator. Is it that hard to get the stock alt out/putting the serpentine belt back on once i get the HO alt in?

Any pictures or videos to make this job easier? The stock alt almost looks impossible to get out unless i remove the entire radiator.. Should I just bring it to a shop and have them install it?

View 5 Replies

Passat (B6) :: 2006 - After Installation Of ECS Tuning Brake Kit Squeaking

I have purchased this front brake kit from ECS tuning and installed them on My 2006 Passat, After I installed them and took for test drive and initial breaking is good better that before bat notice some squeaking when rolling slowly like before stop light, only on light applying break pedal not if I have to hard break, I said maybe they need too wear in or so... It now more that month and squeaking is becoming worse. Is it bad kit or something else that causes this problem...?

View 1 Replies

Prius (2004-09) :: 2006 - Tail Light Removal And Installation

Looking for detailed instructions to remove the RH tail light from the '06 Prius? I reviewed the '07 Prius tail light removal discussion [URL] .... but I'm stuck at the step where I need to remove the long bolt. What should I do now?

View 4 Replies

Dodge - Ram50 :: 2006 - After Installation Of New Bulb Passenger Light Won't Turn On?

ok so my passenger side headlight wont turn on installed new bulb still wont turn on. I pulled the wiring schematic and on the connector i have a h13 bulb with 3 pins for high and low beams. i have voltage when the low beans are on one wire WHT/TAN 10.9 volts (car off) and WHT/GRY is 10.99 volts (car off) the center connector is the ground, when i check the other side that is full functioning i get WHT/DR BLU 11.8 volts and WHT/ LT GRN 11.0 volts when i have the HIGH BEAMS ON THE RIGHT SIDE wires WHT/TAN IS 10.9 volts and wire WHT/GREY is 11.68 volts AND THE LIGHT IS WORKING

SO MY QUESTIONS ARE'* should i have voltage on the connector of the high beam when the high beams are not on

*what would cause the wht/gry wire to be 10.99 volts when it should be 11.8 volts
* how should i fix this could i run a parallel circuit off of the wiring on the fully functioning driver side headlight

View 6 Replies

Ford Audio/Video System :: 2006 - Flip Down Monitor Installation?

I have a 2006 F250 XLT Super Crew. I want to add an in dash double din DVD and run a flip down monitor from it for the back seat passengers. Now I can see an outline in the ceiling where the previous owner had one at one point and removed it prior to selling the truck.

I cant do headrest monitors due to the fixed headrest. When I look at the headliner there isn't much of a flat surface to mount to the head liner has two drop down pieces, one at the dome light and one 8" or so to the rear of the vehicle.

Installing a flip down monitor in this vehicle or one similar? if so how did you get the head liner to secure to the monitor and not leave a gap? I'm looking at a 14" Tview TFT monitor from Car ID.

View 1 Replies

Ford 6.0L Power Stroke Diesel :: 2006 - Installation Of Washer Fluid Pump?

I am a new owner of a 2006 F 250 6.0.

I need to install a new washer fluid pump. My question is what is the best way to get the old one off and the new one on? Should I go from under the wheel well? Or is there another easier way to get to it? The truck didn't come with an owners Manuel and I cant find anything about how to do this.

View 2 Replies

Saab - 9-3x :: 2006 - CEL Came On / Idling And Stalling?

I have a 2006 Saab 9-3 Aero that I bought back in August. Two weeks ago, I brought car into the dealership for a 90k road service. It had some idling issues (sometimes, upon starting it up (cold or not), the car would idle and sputter, but never actually die. During the tune up, they said there was a frayed cable, which they replaced.

Fast forward 1.5 weeks later. The check engine light has come on. And the car is now sometimes idling funny just as it was before, only now it actually sputters and actually dies sometimes upon start up. After it initially dies, if I start it up again, it runs fine up on the second start.

Took into the dealership this morning and after 2 hours of diagnosis, they say the check engine read-out is indicating the fuel pump pressure sensor is going out, and that's what's causing it to idle and stall. Is this diagnosis legit?

View 8 Replies

Elantra HD (2006-10) :: 2007 - Stalling On Stop

I have a 07 Elantra, with 300k km. most times coming to a stop it will almost stall with a few maybe 1 in 10 will actually stall if I would let it. I can control this with not actually stopping, but almost stopping, and let my foot off the brake slightly and let it move ahead slowly before coming to a complete stop. I have searched the Internet for quite a while and all I could ever find was try shifting to neutral when stopping. If I shift to neutral there is absolutely no sign of stalling, but they never said what it would be or how to fix it. Other than the stalling or almost stalling upon stopping, it idles perfectly and always starts right back up and runs fine.

View 5 Replies

Nissan - Sentra :: 2006 - RPM Fluctuations / Stalling / No Codes

I have a 2006 Sentra that over the last few months on a few occasions (3-4) when driving on the highway would jolt into the next gear.

Last week, the car simply died on me waiting at a light and the dashboard lit up like a Christmas tree. The car did not start again for about a minute. It did. When I drove it home, the car accelerated slightly on its own into the driveway. I took it into the local Nissan dealer. They found no error codes of any kind. They recommended a whole bunch of things that more or less needed to get done anyways but the pertient one is that they flushed and refilled the transmission fluid and replaced the filter.

I'm pretty sure this isn't a transmission issue but... not ruling anything out. Hoping it is not a transmission issue.

So I took the car home. A week of local light driving with no issues. I got on the highway yesterday to go to a meeting and the RPMs start fluctuating wildly from 1500-3500. I got off the highway and the car stalled out on me three times on the 10 mile or so drive back to the dealership. It did start on those occassions right away.

They claim they've had multiple people test driving the car over the last couple of days and no one is experiencing what I did. Still no error codes anywhere.

I absolutely do not feel safe driving this thing on the highway at this point. What do I do? They seem to be at the end of their diagnostic capabilities and short of randomly repairing every single part on a ten year old car that might be causing this seems... silly.

View 11 Replies

Accent MC (2006-11) :: 2010 Stalling Intermittently Always When Idling

My 2010 Accent has been stalling intermittently, always when I am idling. I'll be at a stop light, and it will stall, and then it usually starts right up again. It is almost always the same stop light on my way to work, like clockwork, and likewise on my way home from work. Also, sometimes right after this stalling event, the motor will be a little rough on the highway, sputtering like it's not getting gas very well, but then it evens out after a while.

Yesterday for the first time it died and wouldn't start again. I suspected my fuel pump had gone out. I had it towed to a repair shop, but it started just fine for them and they can't re-create the problem. It doesn't give any computer codes at all.

View 3 Replies





Copyrights 2005-15 www.bigresource.org, All rights reserved