I have a 2002 Pontiac Aztek. I am having to do the relearn process. I was wanting to know if you can reprogram the passkey 3 key not the key fob but the actual key. It was already programmed before but I want to know if I can REprogram it.
View 1 RepliesI have a 2006 Dodge Stratus and recently lost my transponder key for my ignition. I do have a spare key cut but it doesn't have a chip in it, I can only use it to unlock the doors and open the trunk.
What I want to know... is there:
➣ A way to disable/bypass the theft prevention system so I can use the non-chipped key in my ignition?
➣ a way I can modify my key to trick the theft prevention system into thinking it is a real key?
I have a 2002 Pontiac Aztek with about 170,000 miles on it. About 3 weeks ago, it began having problems when I would hit the gas to speed up. It would hesitate, and then jerk forward and go. Then about 2 weeks ago, I was driving on the highway and the engine just suddenly stopped - as if I had turned off the key.
There was no warning, no sound, nothing. I kept hitting the gas the whole time and it started up again after a minute. I replaced the fuel filter and it ran well for a week. Then it happened again, but this time the engine completely turned off and I had to turn the key to restart the engine. The engine started with no problem.
I tried to drive to the mechanic, but the engine stopped & started again on the way, so I ended up having it towed. It is not driving roughly or idling roughly, it doesn't make any strange sounds and no warning lights come on. When the engine stops, all electrical components are still working (lights, radio, etc.). My mechanic appears to be stumped. What could be causing this?
I have a '94 Aztek that sounds like a small plane engine when driving. What is causing the noise?
View 10 RepliesMy '01 Aztek has a very odd shimmy. It only happens when turning right, at highway speeds, and when accelerating. Not when turning left, and not while just 'coasting'. Only when accelerating.
The mechanic replaced a tie rod end, and that seemed to fix things for a few hundred miles. But now it's back and is happening at lower speeds.
Just recently my wife's 2001 Pontiac Aztek GT with 100K miles started the "Disco Lights" phenomenon (sp?). When driving or parked, the lights will start flashing, the horn may (or may not) honk by itself and the dashboard lights and indications blank!. The "Security" light in the driver's info center sometimes comes on also. I've read that it may need a new "Body Control Module". Could resetting the "Security" light stop this? If so, how do you do that?
View 1 Replies2003 Pontiac Aztek ... I'm a slow stopper. I like a rolling stop. Lately when I do that my breaks will make a clicking sound (around 6 clicks) only heard inside the car. I'd i let it click, then it's fine, if I press the brake down all the way before the clicks it depresses in a jerky manner. This problem has existed for awhile now. I now an the proud owner of new abs module, wiring harness, multiple wheel housing assys, new brakes, rotors... That may be it with the break system. We just checked and bled the break line for air. I'm tired of paying several mechanics and no results.
View 10 RepliesSo my gf locked her keys in the trunk of her 2002 passat glx 4 motion... any other way to open the trunk? for some reason the trunk switch on drivers door won't pop the trunk. Gas door does pop.
View 11 RepliesI have a 2002 Nissan Pathfinder and the Car Key FOB did a strange thing last week. Car is locked, keys are INSIDE the house and [TaTa] on its own, the FOB started to "beep" like when you click it to lock the car, made that kind of sound. Funny thing and wonder if this could be a coincidence, down the street, 8th of a mile away [or less] a house was being built. Could someone have had [maybe] an alarm system or two-way Nextel phone or SOMETHING [???] that could set it off? What can be done about it BESIDES enclosing the FOB in aluminum foil? We did that. Strangely, the beeping has stopped, which gives me the idea that it MAY have been what I suggested in the first place . . . something "signaling" it from wherever to go off!
View 6 RepliesLocked my keys in my car. A locksmith came and instead of using the tool to unlock using the unlock button, he just pulled the regular lever inside with the tool to open the door while it was locked. Since then I cannot open the driver's side door from the inside. It will open, lock and unlock fine from the outside. It is unlocked when I attempt to open it from the inside. I pull the lever and nothing happens. I have to unroll the window and open the door using the outside handle or crawl over to exit from the passenger side door.
View 4 RepliesWhile car was in service they found the key defective (the panic button did not work) so they reprogrammed a new key, now the key I have at home no longer works, is there a way with VAG-COM or VAD to reprogram the 2 key remotes myself or I have to bring the car to the dealer?
View 2 RepliesI have a 2008 Infiniti G35x with a push button start. The dealer recently replaced my key fob under warranty but now wants to charge me (about 1/2 hr labor) to reset the 2nd key fob, which I did not think to bring with me when the last service was performed, and which now does not work since the key fob was reprogrammed.
Can I fix this myself? Or is this something the dealer needs to do? I have seen many references to reprogramming Nissan key fobs but all start with "insert the key 7 times" and I don't have a key.
But we have an 03 Golf GTI. And the ECM went bad. So we got a new (used) one. But the problem was that it wouldn't communicate with the VAGcom. Replaced the ECM now it communicates. But our problem is the anti-theft code. I am not sure of the secret "code" the dealer is supposed to give you. It wasn't supplied to us. Looking for info on reprogramming this part of the immobilizer?
View 6 RepliesI've got a strange problem with the keyfobs on my 2006 Camry. I tried replacing the batteries in both keyfobs and reprogramming them, but they still will not unlock the door. I suspect there is an issue with some computer part in the car that is preventing it from working. This was my sequence of events:
1. The key fob stopped working, so I replaced the battery. No luck.
2. Found the spare fob, didn't work either so I replaced that battery too. Still didn't work.
3. Reprogrammed both remotes using the steps (pasted below for readability). The programming was successful because the door locks cycled after adding each remote to the ecu on step 13.
However, after exiting the vehicle the locks still weren't working.
The steps I followed to reprogram the key fob:
1. Begin with the key out of the ignition.
2. OPEN and UNLOCK the DRIVER'S side door. CLOSE all other doors including the trunk.
3. Within 5 seconds INSERT the key into the ignition and PULL it out TWICE.
4. CLOSE then OPEN the DRIVER's side door TWICE.
5. Insert key INTO the ignition then REMOVE it.
6. CLOSE then OPEN the DRIVER's side door TWICE.
7. Insert the key INTO the ignition and LEAVE it in ignition.
8. CLOSE the DRIVER's side door.
9. Switch the ignition to ON then OFF.
10. REMOVE the key from ignition.
11. The door locks will now cycle to confirm the vehicle has successfully entered programming mode.
12. PUSH and HOLD the LOCK and UNLOCK button for 1.5 seconds on the first remote being programmed. As soon as you let go PUSH the LOCK button and HOLD it for 2 seconds.
13. The door locks will cycle to confirm successful programming of the remote. If you have any additional remotes to program repeat step 12 if you have no additional remotes proceed to step 14.
14. OPEN the DRIVER'S side door. Programming is now complete. [URL].................
Only had 2 cars with TPMS and the other one couldn't have the wheels rotated. So if I rotate the tires/wheels do I need to get the TPMS reprogrammed since the fronts will be on the back and vice versa?
View 20 RepliesReprogramming my key for my 1999 mk4 jetta. Recently the battery died on one of my key fobs and the other fob that i have has been dead since i bought the car. i put new batteries in them both now. I have one flip key and the only other key i have is the valet key. How I could re program my fobs?
View 2 RepliesWhile my dash and most of the interior is apart replacing dash lights and wiring up off road accessories, just had a thought. What is the location of the door code so I can reprogram the door?
View 2 RepliesBought this car from a guy who but aftermarket electric locks on the car so the keys are not factory OEM. My dingy 16yr daughter has lost one of the keys and broke the plastic off (don't ask me how the heck she managed that) the top part of the loop on the only other one we have so now it can't go on a key ring.
I went to get an oil change last week and the service guy told me it WAS a transponder key. The keys the hardware cut for me don't turn the door lock or the ignition so there might be an issue with the cutting.
I checked my manual and it says my car may not have the Engine Immobilizer system. There is supposed to be a security LED light on the dash next to the A/C knob, BUT there isn't!! This makes me think I have a plain old regular key with NO transponder?!?!
I have read but have not been able to determine for sure that the Camry LE with I-4 did NOT come with the Engine Immobilizer so therefore - NO transponder key.
I have a 2003 camry lx 4 cyl .i bought this car for a family member last year.one of the main reasons i choose this year {other than price} was the fact that all of the camry's 03 and up have transponder keys. the vehicle has a remote start feature with some aftermarket alarm fob, installed from the previous owner. im not even sure what was done. all i found was a bunch of relays under the dash. i see no actual alarm functions , heck i cant even find the alarms brain or remote start brain.
I went to home depot today to get another copy of the key. the key-maker told me that there was no transponder in the key,just to be sure i had him do a $2 copy of the key. to my surprise the basic key copy turned the car on. all this time i thought this vehicle was secure enough that i didnt have to worry that a novice car thief could take my car away.
How easy is it to bypass the transponder key ? can a remote start bypass the transponder key altogether. Is it possible that the previous owner installed a ecu from a 2002?did he just pop a fuse? I am trying to diagnose what was done.
Recently, I've been looking into making a copy of my ignition key for my 2005 Camry SE. I bought a blank on eBay, had it cut to fit my master key, and it works fine for locking and unlocking the doors. However, since it is a Transponder Key, apparently I need to program it in some way to use it for ignition.
I've been looking all over for instructions on how to do this, and have tried this commonly repeated method, with no success:
1. Simultaneously depress and release brake and accelerator pedals 1 time.
2. Insert an original Master Key into the ignition but do not turn it.
3. Within 15 seconds depress and release accelerator pedal 5 times.
4. Within 20 seconds depress and release the brake pedal 6 times and remove key.
5. Within 10 seconds insert New Key into ignition but do not turn it.
6. Within 10 seconds depress and release the accelerator pedal 1 time.
7. Now sit and wait for about one minute until the security light in the center counsel stops blinking and turns off.
8. Remove new key and depress and release brake pedal 1 time.
9. Test your key now. It should work if you followed the instructions. If not, you may want to try the following instructions:
To reiterate, these instructions have not worked for me.
Have any other 2005 Camry SE owners managed to program a key successfully? What method did you use?
how to program transponder key in 7th gen camry. There are a lot of instructions online for up to 08' year, but nothing after that.
View 3 Replies