1999 S10 With 4.3L V6 TBI Will Not Cold Start And Idles Too Fast
Dec 30, 2015
I have a 1991 S10 with a 4.3L V6 TBI that recently began having trouble cold starting, meaning that at a mere 40F I can crank it over and over and it will not catch. If I plug the block heater in for at least an hour, it usually will start, but at a very low, very rough idle. Once it has about 30 seconds or so to warm up, it will then idle TOO FAST at 1500 rpm, and stay that way for the first few miles of driving, which makes it rather awkward to drive, being a 5-speed. Once its been driven awhile and fully warmed up, it runs normally. (I'm running a 180F t-stat.)
The IAC valve, block temp sensor, and TPS sensor, were all replaced last year, so I'd find it hard to believe that one of those could be the problem. I put Heet treatment (red bottle) in the fuel, changed fuel filter and reset the computer. (Although it's never given a trouble code.) The problem is still there.
My local mechanic says replace the ECM, but he hasn't actually diagnosed that as the problem, so I think he may just be taking a wild guess. (He hates OBD1 systems with a passion!).
View 7 Replies
Advertisement
'99 Explorer 5.0 doesn't want to start in the cold weather, below 30. After it finally starts it runs great and will start all day. It cranks fast but it doesn't get driven every day.
View 2 Replies
1987 LeSabre v6 engine misses under load. It is a "hard" jolt, miss that happens under slight load weather warm or not. Engine also idles very fast on first start. Wondering if the problem is electrical or vacuum related (or both?). Do not think it is fuel related as pump and filter were replaced a while back. Vehicle has also stalled with difficult restart once in the past few days. Not showing any codes.
View 9 Replies
Fast idle 6.7 when cold remote start. My GM had what could be called a auto fast idle when it was cold it idle a lot faster.
It appears my 2012 f350 does not , Ford dealer said he could install a fast idle using one of the switches.
And then if I park truck with park brake on and switch on it when I start it will fast idle to around 1300.
My question is being if truck is started by remote , will not this switch be off and by being off fast idle will not work , is this not the case?
View 9 Replies
A minor but persistent (year-long) rough idle on my 1991 240 has quickly turned into a Cold Start Nightmare over the past month:
SITTING HOURS OVERNIGHT (50 to 60-degree temp. overnight) - When I attempt to start in the morning, the engine idles high for 3-5 seconds and then immediately dies. To successfully start, I must keep pressing the accelerator pedal at least half-way down for 2-3 minutes. The engine sputters, almost backfires, shakes, lopes, almost dies, etc. After 2-3 minutes, everything runs just fine.
WARM ENGINE SITTING - Once the engine is warmed up, it will consistently start without problems. Still a slightly rough idle, but OK. The car does not die.
I have changed the battery, coolant temp. sensor, and spark plug wires.
View 3 Replies
I have a 1995 ford thunderbird 3.8 l. I changed the heads according to a chilton book. The car ran well for approximately 2 weeks and all of a sudden it started Idling high. I turned the idle screw all the way off and no change.
View 7 Replies
Carburetor: Autolite 4100
Fast Idle Speed: 1250 RPM
Curb Idle Speed: 600 RPM (At normal operating temperature)
When I cold start my truck, the fast idle speed holds the throttle at 1500 RPM. I will let it idle about 30 seconds or so, and then I will tap the gas to bring the idle down.
When I do this, the idle will immediately drop all the way down, and too low for a cold engine. The engine won't stall, but it will hover just below 500 RPM, which is a bit too low to idle smoothly.
But when the engine is at operating temperature, the idle speed is 600 RPM and the engine will happily idle smoothly.
Shouldn't there be an "in between" speed? When I tap the gas pedal at 1500 RPM to bring the idle down some, shouldn't the speed drop down a little lower, like 1000 RPM since the engine is still a bit cold?
If so, what do I need to adjust? The Autolite 4100 works PERFECTLY otherwise.
View 1 Replies
Truck idles a little too fast? I don't even have to press on the accelerator to back-up and out of my driveway, and it's a little bit uphill. (2012 Screw, 4X4 Ecoboost, 3.73) It goes into the shop in the morning for the modification to the intercooer (I think?) and a reflash of the computer.
View 10 Replies
Need this software that would be willing to run a diagnostic on my truck? I replaced all the glow plugs a year ago and the relay a month ago. It idles really rough when it's cold (first start of the day with outside temps even at 90 degrees). It has no power for about 10 minutes. Sounds like an old John Deere 2 cylinder tractor for a few minutes. I have 370K miles on it. After it warms up it runs good. Plugging it in doesn't make a difference. There is no smoke while it is warming up. I have noticed when I accelerate quickly, it blows black smoke (not heavy but when following it you see and smell it).
View 4 Replies
I have a 99 Jeep Cherokee Limited, 4.0 inline 6 cyl. When you first start it up it idles fine but after a few min. it starts to act like it is starving for fuel. If you take off down the road it pops back through the intake (backfires). After a few mins it takes off and runs just fine and gives no more trouble until you shut it off and it sits for awhile. Then at the next restart it does it again. It acts like a fuel problem but the way it backfires through the intake makes me think it is a firing problem.
View 12 Replies
1999 Savanna 1500 van. This has been a great Van, only has 70,000 miles and has never let me down until a few months ago in February when it was getting down to -20 degrees F. Seemed like it was cranking fast so I thought it was timing. Turned out there was no fuel pressure so first put the relay in, that didn't work so we dropped the tank and put a fuel pump in. This seemed like it cured the problem but I only drove it 200 miles until mid May when it did it again.
The security light wasn't staying on so we thought it must be the ignition switch. That didn't fix it either, we just got the ignition switch back together (not the actual switch but the wiring harness) and it's not starting again. It will start after some anguish and cursing at it. Seems like messing with the wires going to the fuel pump or hitting the cover over the fuel tank will cause it to start. I haven't checked it yet but I can guarantee it doesn't have any fuel pressure.
View 5 Replies
Ive been in this game 16 years have i never stumbled across this. The theft light blinks fast and no start. Ive change the key , key remote to cpu, and the cpu it self all programed properly still no start ....
View 7 Replies
My dad has a 99 F250 with a no start issue. Everything was starting and running fine one day. The next he gets a no start. Cranks fast and fine but wont fire up and start. He has a scangaugeII hooked up to it and his oil pressures and volts look fine. His tach moves when he is trying to start it. He checked the icp sensor and it had oil through it so he replaced it with a Ford part. Unplugged it and the scangauge pressure goes up but no start. He also replaced the ipr with a new Ford one just in case. He checked and is getting low pressure and high pressure oil.
I am having him check the fuel heater fuse #22 to make sure it is not blown. He had the block heater plugged in all night along with a battery charger to make sure they are topped off as well. We have gone through a couple of the checklists on this site for a no start condition but nothing has solved it yet. I think he is sitting at about 200k on the motor. No major issues or problems until now. He is currently also pulling the ICM to check it out as well. No codes are being thrown.
View 14 Replies
I have a 1999 Ford Escort SE wagon with 112k miles on it. Last week when leaving work my car started very rough. This was unusual so I killed and restarted the car about three times before letting it run it's course (~30 seconds), after which the car ran fine. About a week later on my way to work the car seemed to 'sputter' (for lack of a better word) when I pushed down on the petal looking for some power on two separate occasions. On each side of the sputters the car seemed to respond fine, but when it did sputter there was a severe lack of power. I got to and from work just fine, but while letting the car idle in the parking spot of my apartment for a minute before shutting off the engine the check engine light finally came on. The following morning the car again started rough (as if it were misfiring/running on 3 of 4 cylinders) and this time it took a good minute before smoothing out. However, after the car smoothed out I experienced no issues on the way to work, no sputtering, no loss of power, nothing. Doing some initial online research I feel that the problem may be one (or more) of the following:
-Fuel pump
-Vacuum lines
-O2 Sensor
-Spark plugs (they are original)
-Fuel Filter (it is actually past due for replacement)
I plan on getting this checked out ASAP, but that still may be 2ish weeks away with my schedule. Some similar reports say that I may be having a 'lean mixture' issue (not getting enough fuel), but I haven't had the time to check the code. My question is, how "safe" is it to continue driving my car with the current situation? Is it at a super high risk of failure/random stalling during rush hour? Will it cause any damage to the engine if there is a cylinder misfire upon start up? I was also wondering if the car would be reasonably reliable to drive on a ~400 mile road trip on an upcoming weekend, but I am making plans as if it is not.
Additional Details:-Tried charging the fuel lines (car to 'ON' then 'OFF' position 3-4 times), had no effect on the morning start-up-Commute to/from work is about 20 miles
View 13 Replies
So this is reason #345 why I should never have let my wife drive my F-350. I am in the Army, and I got a frantic call from my wife (I missed the first 7) saying that the truck died and won't start. I drive all the way to the truck, pop the hood and discover:
1) there is no coolant; and
2) there is no oil (actually just EXTREMELY low on both).
So, I do what any good Soldier does, I push the truck all the way back home (downhill mostly), buy 5 quarts of oil and a jug of 50/50 coolant, fill up both and try to start the engine.
The last time it ran out of oil (small leak on a seal that I didn't know about) in 2006, all I had to do was fill the oil, turn the key, and press the gas until it kicked over (don't judge me, I was a dumb LT). I did this again this time (now, I am a dumb CPT) but now it: 1) idles very rough; and 2) won't start unless I press down on the gas when I turn the key. There is no gauge light when it does this. I read the thread on the UVCH, but I am concerned I might have done something horrible to my truck.
2003 Ford F-350 7.3L
View 6 Replies
ok so let me start by saying, my name is Tim, I own a 1999 Ford Ranger 6 cyl, 3.0L truck, I bought it brand new in 1999 and drove it for a few years and then took it off the road for 3-4 years then last year I went to put it back on the road and I couldn't get it running.
I took it to the dealer and they replaced a key switch module. since then the ranger seems to lack power. It also idles erratically when you first start it in the morning too.
not sure whats going on here but the engine light is on,
I get codes P0171 & P0174 (too lean bank 1 and too lean bank 2)
I would also like to note that I have replaced the fuel pump, fuel filter, transmission filter, MAF sensor, IAT sensor, PCV valve, EGR valve, TPS sensor, idle control solenoid, fuel pressure regulator & new plugs. I have also checked for vacuum leaks with no avail.
View 6 Replies
I have a 1999 F150 4x4 5.4, I pulled the heads due to blown head gasket. Prior to pulling heads truck started and run fine other than miss on #1 cylinder. I timed the engine according to Haynes manual and posts on this site. Truck is now hard to start and idles very rough. I does seem to smooth out when reving the engine and seems to have plenty of power. Cant find any vacuum leaks or unplugged wires.
View 1 Replies
I have a 96 f350 that I just replaced the batteries on and now when I go to start it does not hardly turn over. Starter just barely turns motor over and definitely not fast enough to start truck. Battery connections are tight and starter was replaced about 4 months ago.
View 4 Replies
2003 7.3 excursion.. The truck starts every time revs up and idles about 3 seconds then the rpms drop and it tries to stall out catches itself then revs backup and idles rough similar to if you have got air in the fuel lines from changing the fuel filter.. About 1 in five times the truck will stall out and it starts and immediately and idles rough but the rpms and everything runs at speed and rpms don't drop again! This is a reman engine/transmission recently installed.. The mechanic who installed it was unable to figure the problem out.
View 6 Replies
I have a 98 Silverado with 5.0 liter, 2 wheel drive. When cold it idles at 30 mph plus. When warmed up it runs just fine. This can be very challenging in icy weather. I have changed the temp sensor, cleaned mass air sensor, etc.
View 4 Replies
Having this issue? Should I have it look at? Or is this normal?
View 11 Replies
