Buick - Parkavenue :: Temperature Gauge Needle Stuck
Nov 18, 2011
I recently had the radiator on my car replaced and wen I got it back the temperature and gas gauge needles are both blown past the HOT sign and past the full sign on my gas gauge and is sitting under the little black piece under the the cold side and under the empty side. it was obviously messed with and completely turned around but why is it like this? will it reset itself or should I take i.e., back to the mechanic to have it fixed by him?
2000 buick park avenue....
View 9 Replies
Advertisement
The needle has always stuck dead on 190f when it gets up to temp. About a week ago I took the center grill of to paint, I put it back on and the check engine light came on ... code p2433 secondary air pump problem. I figured I had just disturbed something etc. Now the coolant gauge is going up to around 240f during normal driving, the fan stays on for about a minute when I turn off the ignition.
View 16 Replies
I just bought a 2003 Ford Crown Victoria with sport package. It is similar to the P71 Police Interceptor model with stiffer springs, thicker anti-roll bars, etc. I checked the sticker on the door and found that Ford recommends 32 psi for the front tires and 35 psi for the rear tires. This is a conventional front-engine, rear-drive car. I was expecting to see 29-32 psi, and same pressure for both front and rear. I don't understand the manufacturer would recommend higher pressure in the rear for a car that is a little heavier in the front. I am thinking of keeping both the front and rear at 32 psi.
View 14 Replies
Every time I use my left turn signal it tends to get stuck and stay on...never turns off unless u get luck enough to jiggle it a little... So I have reverted to not using.. Why this could be happening? Its funny cause when it gets stuck it even stays on when i turn the car off so i end up disconnecting the battery...any way to stop this? 2000 buick park ave.....
View 9 Replies
Ok I was driving home right know from work, and looking at the speedometer, i notice that my temperature gauge turns off (the needle goes all the way down). what can it be?
View 2 Replies
Resurrecting my 940 TD after it's been sitting for a year and the temperature needle now doesn't rise as the engine warms up. Is there any trouble with sensors on these or should i be concerned about something else? It was working when I stopped using the car.
View 3 Replies
The needle is moving up and then back down. This mostly happens while at a stop and simultaneously the ac compressor kicks off.
Recently new radiator and temp gauge, plus coolant flush.
View 8 Replies
My car recently turned over 120,000 miles. I have owned her for 5 years. Currently, the engine temperature gauge needle is moving all over the place. It typically registers the correct temperature (I think), but sometimes it goes all the way over to the red, then peaks and falls back down to the midline.
Before this started happening, the needle would lie just below the midline when traveling on the highway and just above the midline when driving in town. Yesterday, it was lying between the 1/4 mark and the midline -- much lower than normal. Is this as simple as just replacing the temperature sensor?
My mechanic noticed a month ago that the transmission hoses are all swollen and in need of replacement. Is this related?One more thing, within the last week, the electrical system fails while driving, but just for a second. I can tell because the radio goes out. Once, it went completely dead, then came back on within 2 seconds. It made me think of the alternator, but it seems if that were the case it would go dead and not come back on, no?
View 8 Replies
Last fall I had my radiator flushed and at the same time my coolant overfill canister with built in temperature guage sensor was replaced with a new unit. (The service station replaced the resevoir canister with a new unit in the engine compartment, because they felt the sensor is prone to failing after 7 years.)
Ever since, my temperature gauge needle on the dash will randomly drop (even when the car is up to FULL OPERATING TEMPERATURES) showing the engine being cooler than it out to be. In other words the needle drops signifying to a much lower water temperature. After a period of time the needle will recover back to the normal full operating temperature mark on the dash gauge.
What could cause this? Inside my radiator do I have a "diafram" temperature valve that could be failing /"sticking?" In other words could a temperature valve in the radiator be sticking at odd or random times??? I also notice that my heater does not put out the usual full furnace heat that a Passat is know for. The temperature is about 1/3 cooler now that we are into winter temperatures.
Is my heater core clogged?
Could the new coolant sensor in the new coolant overfill chamber not be working well? This whole situation began AFTER my radiator was flushed, and AFTER I had the coolant reservoir canister and sensor replaced.
View 6 Replies
This weekend I was one a trip in my '98 Civic, and I noticed some movement in my temperature gauge. It didn't really overheat; the needle never got near the red, but it did go a little higher than usual.
Normally, once the engine heats up, the needle on the temperature gauge doesn't move, not even a little. It sits right under the squiggly lines on the temperature gauge icon. However, on Friday, when I got off the highway, the needle rose into the upper part of the icon, to the part with the thermometer.
As soon as the car started moving, the needle on the temperature gauge went back to its normal spot, so I assumed it was a problem with the radiator fan and I kept on driving, prepared to turn on the heat if the needle on the temperature gauge started going up.
Saturday morning I took the car to a local shop in Jacksonville, and it turns out the engine needed a new fan and a new thermostat.
The first lesson that comes to mind is that keeping an eye on my temp gauge might have saved me an engine. It certainly saved me a head gasket. Since a head gasket or new engine would have been worth more than the car, catching this before it became a problem saved me from having to buy another car.
The next lesson is that my Civic had two things wrong with the cooling system, and yet it barely showed any symptoms. The air conditioner doesn't work I guess since a working A/C would probably have made it overheat. In any case, I've probably been driving without a working radiator fan for some time.
The final lesson is that if I had tried to diagnose this myself, I'd probably be driving around with a new radiator fan and a bad thermostat. I paid about $435 for a new fan, thermostat, and fresh coolant (I declined the cooling system flush) and it was worth every penny.
View 5 Replies
Car is a 2012 GTI 6MT with APR intake.
Within the last couple of days, my engine temperature gauge has been acting a little strange. The needle will fluctuate depending on if I'm accelerating or at speed. I've actually seen it go down several times before going back up to normal temp. On a couple of days, it will go up to about halfway to normal temp, and just stay there for a lot longer than it usually seems to.
There have also been times when the car is at normal operating temp, I'll go into a store for maybe 15 minutes, and when I come out, it shows the engine temperature is maybe halfway to where it should be. Then it will go back to normal after a few minutes of driving. I would think that if the engine is warm, it should stay there for more than 15 minutes, even if the car isn't on.
We haven't had any abnormally cold days lately, and I'm not getting any CEL, but I was wondering if anything to worry about, or if it's normal.
View 11 Replies
I have a 2003 Buick LeSabre Limited, and everything was going fine with it till recently. The Fuel gauge started to go haywire as in the needle would go to full, then go back down to a Quarter, then back to 3/4, then drop all the way down to Empty, this is still occurring. At first I believed it to be the fuel level sensor, but then I started to notice something else.
A warning message came on stating that the oil level was too low, but when I checked the oil level it was fine, and last night when I was driving with the air conditioner on, I hit a bump and the air conditioner stopped working. I pushed the off button, and was successfully able to make the air conditioner to come back on with out having to restart the car.
The horn has also started to go in and out, and I do not know if they are all linked together by a type of computer or if they are separate.
View 8 Replies
The needle in temp gage on my 2005 Toyota is now facing the opposite direction. This happened right after the most recent oil change. Is this a gauge or a sending unit problem?
View 11 Replies
Was on my way to my girlfriend's house and decided to do a few pulls. Noticed afterwards my rpm gauge was stuck at 6k rpms and wouldn't go any lower. The car was running fine and I was in 6th gear just cruising at 55mph. Did another pull and after that it was stuck at 8k and if I downshifted the needle would max out at the 6 o'clock position. When I arrived I turned my car off to see if it would reset itself and it got stuck at 7k rpm.
View 15 Replies
I am having problem with the gas gauge I have a full tank of gas but the gauge needle is stuck on E but when I unhook the battery and hook it back and start the car the gas gauge needle is on the full and its stays on full for like 3 days and then the gas gauge needle will drop back down to the E and stay there. This sound like something wrong in the fuel pump.
View 2 Replies
The temperature gauge in my 2006 S60 2.5 T suddenly stopped working and I noticed that the cooling fan was stuck on relatively cool Michigan weather. In addition I also noticed a 2-3 mpg reduction in average fuel economy and a reduction in overall power. I did a little research and found that the 2006 2.5T models had an ECT recall. Turns out the ECM was telling the engine to operate at overheating conditions,due to a faulty ECT.
Picked up a new Engine Coolant Temperature Sensor (OEM is recommended by most authorities for replacement sensors). I replaced the ECT without even removing the engine cover, it didn't fix the problem at first. Then I pulled the fuse for the ECM, a 5 amp fuse in the box mounted on the drives side fender, and let the ECM reset for a few minutes. Then, had the temp gauge back, and had peak engine performance at operating temperature.
View 3 Replies
I have recently been having some movement in the rear of my car...I can mainly feel it when I am going under 20 mph. I have had replaced the two rear tires with other used tires cuz my original tires were going bald. Can this be the problem? Can Broken belts on the tires or "BAD TIRES" can cause this or is it another problem I should be worried about i.e sway bar links/ sway bar, etc.? 2000 buick PA 3.8
View 5 Replies
My Buick Park Ave 2000 is having an acceleration problem. It seems to be skipping at different times. It happens more often at lower speeds than higher speeds. It still happens at higher speeds though. I was on a long trip of about 180 miles and on the highway it seemed fine. What do you think is causing this? I did take it to a garage and they couldn't find anything wrong with it and of course true to form nothing happened when they took it for a spin. They did computer checks and everything was fine.
View 2 Replies
I own a 1999 Buick Park Avenue - that stalls. There is no pattern to the stalling.It stalls when I start driving, after I have been driving for a long period or when I just begin driving. It stalls when I turn a corner or on the highway, when I am at a stop sign or a red light. It is baffling. My mechanic has tried a number of solutions, including replacing the crankshaft sensor, however, it still stalls.
View 2 Replies
Get in my car, try to start it and BAM it hits me. As I turn the key, the engine cranks up quick, kinda too quick, if you ask me. As I go to adjust my radio, I feel my car start to jump around and shake pretty rough. As I look at my gauges, I see my check engine light start to flash. So instead of trying to drive away, I turn it off and try to start it again. Same thing happens!! So I try it again and finally a normal start. Whew, I thought that was close. But oddly enough my check engine light comes on and stays on this time, no more flashing and the engine feels fine. What the problem could be? Is it safe to drive my car?
2000 Buick Park Avenue 3.8 auto....
View 13 Replies
I have a 1995 Park Avenue 3.8 with 278,000 miles. Runs fine until about 3rd gear and 55mph when if under any load at all the whole car jumps and shutters. If not under load, like going up-hill, no shutter or skip and runs smooth. If accelerator pressed at all, even when running smooth the shutter begins. Normally does not shutter at lower speeds.
Thought it was the transmission, so serviced the transmission. No improvement.
Took car to local transmission repair. They drove and do not think it is the transmission. They did check pressure at the throttle body, gas flow - let gas flow into clear container, no debris or water - and pressure was in the 52 range. Dropped some on acceleration while in park.
Shop did scan the computer, no codes. Check engine light is not on. Checked fuel filter and it was good.
They also checked all the spark plug wires and indications were that all were firing and in good order. They misted the wires with a spray bottle to see if they could detect electrical leaks - did not find any.
The car is not driven that often and was very low on gas. After leaving the transmission shop, bought gas and initially the car ran great with no hesitation or shutter even at 55mph. Shutter returned within about a mile. The car acts as if it has time to fill a container with gas it runs fine until the container looses some of the gas then it runs rough, or if you are driving along and try to take more than the normal flow out of the container the car runs rough - if they makes any sense.
Bought new gas filler cap just in case. No change.
The fuel filter and fuel pump were replaced at the same time about 2 years ago.
The EGR was replaced about 1 1/2 years ago. New plugs and wires about 1 1/2 years ago.
There is sometimes, but not all the time, a loud pitched whistle which seems to be coming from the area of the gas tank. Oddly enough if the car is in park and running while the whistle is happening, if the brake is pressed, the whistle changes in pitch to a louder and fuller whistle. When the brake is released, the whistle pitch drops in volume and more of a shrill whistle. Same happens moving transmission from P to R.
I feel I have a fuel problem, however, fuel flow, pressure, etc., seem to be ok. The mechanic drove the car with pressure gauge attached to the throttle body and didn't seem to feel that the gas was the problem upon returning from the drive.
View 19 Replies
