I bought a 2003 Vw Gti 1.8t ... What to do or look for when something goes wrong . About a two months after driving it, it won't idle and it shuts off while in Neutral . I've done my research and i believe he didn't install the BOV in right, only bc it is not recirculates the air. Make sense? Is there ANYTHING i can do so it will run better and idle?
View 5 Replies2000 Jetta (build date 10/99) 2.8L V6
Pours out heavy black smoke.
New Air Cleaner, pulled plugs, all smell of gasoline, they don't look black, like I normally would expect gas fouled plugs to look. I read that these are prone to clogged fuel injectors? If so, all 6 at once? Also told that the timing slipping can cause this.
I have recently been getting black smoke out my tailpipes on my 1995 F350 with 7.5L at certain idles and my check engine lights comes on and off, could this be caused from my O2 sensors going bad because of my gutted cats? It seems to be running rich and my idle is way low and at the point to shutting off, prob cuz of overload of fuel...
View 4 RepliesI got my 2.0 turbo project up and running. no CEL but i did have a bad o2 code but it was erased and didn't come back.
Not only is it rough idle and smoking out the exhaust but i am also getting smoke out of my catch can vent.
The smoke looks black coming out of the tailpipe but little blue after it gets out a ways from the car. Where to look??
I did just replace a piston and install a head gasket spacer. I don't know if that could be causing it some and it will go away with some driving or what?
I have not taken it out on the road as I have some brake work to finish. so mostly it idled.
Here is a link to a video on what the car is doing : [URL] .....
Its a 01 engine code....
So i just spent over $1700 at a vw service ctr having a sched 140k timing belt replaced with thermo and fuel filter. This was 3 days ago and when i picked it up it was slower to turn over then got worse and todsy it won't turn over at all even when jumped. It cranks and blows black smoke. Problem is i'm 160 miles from that svc center and it's sunday. There is a vw svc center 14 miles away but i feel like it needs to ho back to where the work was done because it ran great before taking it there.
View 5 RepliesMy v10 Ex blowing black smoke, RPM goes up and down, when put it in gear stalls and dead, engine is shaking and all this happened after one small 80mi trip, it was perfectly running until I turn off the engine .for almost 2 minutes. So what to do ?? And there is no code .
View 6 RepliesMy VW Golf TDI 2000 has 236,000 miles on it. The other day my husband jumped on the accelerator to merge onto the freeway, and it let out a huge black cloud of smoke. Wow, we thought. Weird. Impressive. Uh oh. Then we realized it was making HUGE diesel engine noises, which just got louder by the next day. Windows down, you can't hear yourself think. It also won't accelerate past 50 mph. We've spent so much money and time fixing this car. Would love to know what might be wrong this time. Just moved, no trusted mechanics who we can call. Might we have to donate it to public radio and just be done with it? Or something my husband can repair with the manual?
View 6 RepliesOk so the wife and I were heading home, she was in her 2.0t sedan, I was in my 3.6 4motion wagon. I got stuck behind a slow driver on the highway (doing 50 in a 70 mph zone) so I get in the passing lane and I floor it to pass him. When I get home, my wife tells me she saw a good amount of black/blue smoke coming out my tail pipes when I went to pass the other driver. This is on a engine with 2400 miles.
I take a look, and the chrome exhaust tips I had installed not long ago are now all black, covered in a oily thick residue. These same exhaust tips were on my previous 07 3.6 4motion wagon for 10k miles and was still shiny when I took them off. but after about 1k miles on the 08, they are now all black. I check the oil and it still reads full.
So what could this black smoke and this oily residue on the exhaust tips be caused by? should I be concerned? Engine runs fine with the exception of sometimes stalling when trying to start it after a short stop. (VAG-COM doesn't show any error codes logged.
Well its a 1.8t pretty much stock except the previous owner added a turbo-back exhaust and has an apr tune running the 91/93 octane tune and they also deleted the stock airbox.
After the car warms up sometimes I'll get a pretty big puff of smoke on acceleration from a stop. sort of bluish in color and it happens randomly, not every time. I usually have to add oil about every week. I have taken it to a mechanic but told me it wasnt the turbo ( cause thats what i thought at first) and that it might be valve seals instead. I scanned for codes since CEL went on and i got a p0136 o2 sensor code and p0411.
My turbo started to have oil on the top of it. I don't know where it's coming from at all, it started to blow blue smoke but not all the time. You can also smell the oil burning off.. someone said maybe the pcv system but not sure. Still new to the vw world only owned the car for about 4 months. Trying to add pics but it's not working.. Will keep trying
View 3 Replies6.0. 115,000 miles. Everything stock, except bully dog intake filter.
I replaced the FICM recently, with one that I bought from the guy who makes those cool You Tube videos, Diesel Tech Ron. I also replaced the EGR valve. I also replaced the intercooler boots on the hot side. I cleaned the intercooler pipes. I cleaned the intake filter as well. I'm still blowing out black smoke, if I floor it when I need to pass someone.
Follow up question: I bought those boots from Riff Raff Diesel and I bought new clamps, too. I'm not sure if I installed correctly. It's already blown one off (it blew the top of the intercooler pipe off, by the turbo, but the boot stays on the turbo) and I put it back on and tightened it all the way down, and I've had to re-adjust 2 times, now, since it acts like it still wants to slip off. Do I simply have the other ones misaligned???
Driving home 2003 6.0 started blowing a ton of black smoke, cars wouldn't get behind me. Found an exhaust leak on the driver side up y pipe. Would that cause this much smoke? 2 codes were 0284 and 0281, I replaced those injectors about 10k ago, at the same time replaced turbo, hpop, egr valve and cooler delete, and new oil cooler.
View 9 RepliesFound a 2004 Ex, Eddie Bauer edition says it has injector issues, blowing black smoke........ It is apart cause he thought it was the EGR. Has 245,000 on the clock. If the body is super clean I'll give him a offer, it's going to get a motor either way and I'll have my Ex back.............I really miss that truck!
View 2 Replies1988 4.0 - noticed fuel mileage going down and an occasional stumble for a while but now I am getting some black smoke more when I let off the throttle than when I going down the road if I rev the truck get all kind of black soot all over the floor otherwise runs fine idles fine the iac has been replaced air filter replaced check the fuel pressure regulator for any gas leaking into the vacuum line and its clean.
View 14 RepliesSo for the past few weeks my check engine light has been on. I have a mechanic friend that scanned the computer and says i have a running lean code.... says it could be anything. So i have been driving the car since and now the epc light and drive train lights are coming on... car revs up and down and sounds like is going to die... got the car scanned and says something about the throttle position sensor... before all the lights started coming on i got my fuel pump replaced..... could a faulty fuel pump be the cause? I had my mechanic, clean the throttle body and it ran good for a few days... now the problem is back... I have a 2004 1.8 gti. Do i have to replace the throttle position sensor? Fuel pump again? New throttle body again? I read somewhere on here that a guy replaced some wires near the ECM and the problem went away...
View 7 RepliesOk I have a 2004 f250 6.0L, has 104k on it. A little back story... truck was running well when I started to get surging on takeoff and it was blowing black smoke when it surged. After it hit 1600 rpm it would blow out and run normal. So did some research and found it could be the FCIM, I have the 4 pin and tested it and had 48.5v so it tested good. Did some more research and found symptoms leading towards the ICP so I replaced that and the ICR also.
Upon doing this my surging issue cleared up but now I'm getting a miss around 1200 + rpm weather it's in park Reving it or driving, but it is not throwing any codes, I did check with my code reader. I have also changed both fuel filters and have the EBP sensor on order as I hear they can be troublesome. My question is what should I do next or look at? I was trying to avoid the dealer so I can learn more about the truck in diagnosis.
I have just replaced the EGR cooler, Oil Cooler, professional turbo reconditioning, both dummy plug's and stand-pipe's, blue spring, fuel filters, oil changed, cleaned the EGR valve and intake manifold. I am in the process of doing a coolant flush when my issue occurred. I was on the road for about 10 minutes when I lost power and started blowing black smoke. I have normal power till about 45 mph then nothing. I can baby the truck up to 55-60 and then nothing and the whole time blowing black smoke.
I stomp on the pedal with no power. I hear the whine of the turbo. The truck idles and sounds fine. My SCT showed my oil and coolant temps within 15 degrees. I opened the hood and saw soot all over the top of the engine from the compressor to the EGR valve and all in the valley from valve cover to valve cover; but more so on the driver side to FICM. I obviously didn't connect something properly. I am just about to remove the intake manifold and reinstall, but before I do just wanted some input.
So I get back from being stationed in Korea for the past 2 years. I get my car out of storage and the check engine light is on. I scan it and get P0601. I do some searching on the Tex and see that it's the ecu. I'm tuned on APR. the question is can I take it to a local APR dealer here in Houston and get the ecu looked at?
View 6 RepliesI'm new to the VW world and just bought a 2002 Jetta 1.6SR about two weeks ago. I just realized that when I turn the ignition on before cranking, all the lights come up except the CEL and traction control light. There are no codes stored when we checked it with a scanner. I took apart the cluster today to check if someone had taped in front of the LED but there was nothing, and the LED was intact, it just won't light up! I put everything back together and when I turned the ignition on.
I realized that the traction control light came on for the first time but still nothing for the CEL. I turned ignition off and on again, this time both the traction control and CEL didn't come on. Whenever I unplug the cluster and install it again, the traction control light will come on once, then if I turn the ignition off then on again, it will stop working. I even removed the MAF sensor to test the CEL but it never came on! All the fuses are intact as well... So my question is, is this a faulty cluster, LED, or is something wrong with my ECU?
I have a 06 6.0 Powerstroke 6 Speed every time I get on it or even try to get going I have no power and I have pure black smoke blowing out the exhaust somebody told me to change the fuel filters which I did which they were pretty nasty then after I did that I seem to still have the same problem so then they told me to check the EGR valve put injector cleaner in it to clean the injectors which I have not done a gr or injector cleaner yet just wanted to know, what it could be or what I can do to prevent the black smoke I have no power either...
View 1 RepliesMy 2006 F-250 (6.0 Diesel) started blowing black smoke under acceleration yesterday. It has 181k miles on it now. No loss of power, no rough idle, no smoke unless there's a load on the engine like accelerating, but then it doesn't matter if it's 1500 or 3000RPM, just the higher the RPM the more smoke it blows from the exhaust, dark black.
The truck has ARP headstuds, no programmer. Replaced both batteries and the A/C system about 2 weeks ago. About 3000 miles ago it got new glow plugs & harnesses, new alternator, all fluids changed, new aftermarket EGR cooler, new EGR valve, new turbo & actuator, new EBP sensor, new HPOP incl pipes and IPR.
Trucks starts up just fine, runs normal, just yesterday going down the Freeway about 65mph I noticed it started smoking black going up a hill, then smoke went away going downhill... Now every time I accelerate it's smoking black. Taking off from a stop sign it made a little puff of white smoke then went back to black smoke, but that only happened once.
Where I should start looking? No codes so far. But I have an AutoXRay EZ-Scan 6000, what sensors do I need to look at?