2007 Pacifica with 4.0 will not fill unless you dribble the fuel into the tank. I have cleared the vent hose and know it is clean. Do I need to change the Carbon Filter and Solenoid/Evaporation Valve on the Front of the Carbon Filter?
View 7 RepliesI have a 2007 Santa Fe. If I fill the tank to full, or close to full I will have a fuel smell in the car until the tank runs under 3/4. If I keep it under 3/4 I usally do not get the smell in the car.
The dealer could not figure it out and I still have this issue. It seems the smell is more in the front of the cabin then the rear. It just could seem that way since the smell is very strong. I have to park the car with the windows open.
There are no fuel leaks, no fuel on the ground, no drips, and the no spillage when I filled the tank.
The ole 5.4l hit a snag today. I was on my way to fill her up and she started sputtering and damn near died! i filled her up and it was like nothing ever happened. Took her to AutoZone and the diagnosis was a Fuel Tank Pressure Sensor.
I have a connection with Bumper-to-Bumper to get the part for cheap but I'm not sure if i want to dive into either moving the bed or dropping the tank. I'd prefer to move the bed.
I just changed my fuel tank and now when I try to fill it up it keeps blowing back it never did this before.
View 2 Replies2007 Chrysler Town and Country, 123k.
It's had an intermittent airbag light for a few weeks now. When it does come on, it stays on until the car is shut off. When I turn it back on, sometimes it comes on and sometimes it doesn't. Sometimes it comes on at startup and sometimes it comes on in the middle of driving. I took it into the shop when the light was off and the shop said whatever's wrong with it, it wasn't storing the code and to run it back in when the light is on.
Since yesterday, the fuel has been overflowing at fill up. I get maybe a half gallon in and then it overflows. I can hear it glug-glugging in when I pull out the gas hose. The flap at the neck of the tank seems to have gone missing too.
I have an 04 Elantra GT. My gas gauge is showing full but the car is running out of gas. I try to fill the tank and I get the annoying click and after trying for a few, gas comes up the filler and overflow tube and makes a mess. At the same time, I was getting a P0449 code. I got an evap canister from the junkyard and that seems to have gone away.
Tried diagnosis but dropping the fuel tank to access the lines. When I jack the tank back up into position, you can hear gurgling sounds and as if the gas is coming up the fill tube. I also opened the access panel under the seat to see the pump assembly and when I removed the 8mm bolts, gas came pouring out. There was definitively gas in there. Checked the float on the pump assembly and it moved?
There is also something at the fuel neck at the top. Don't know what it is and if that could also be part of the problem.
My 2003 Expedition has started spraying fuel out of the fill tube whenever I fill the tank. It started 6-8 months ago. At first, I thought that maybe it was a fluke. It kept happening. I am so tired of getting fuel all over myself and my car. Not to mention the environmental impact of the fuel spill. This isn't just a little fuel dripping out of the tank and spilling on the ground. It's a full on projectile expulsion of fuel from the tank. What's happening and what I can do to fix the problem?
View 4 RepliesWe just purchased a 2004 Chrysler Pacifica with 21,000 miles. However the EVIC system does not come on. I understand you need to remove the dashboard to change the fuse, which is soldered onto the circuit board. So we need to purchase circuit board to replace a fuse??
View 3 RepliesI am having an issue with by club wagon. This vehicle has dual tanks. The front tank doesn't work (and never has since I purchased it a couple of years ago....bad fuel pump I am guessing}.
A couple of months ago the fuel pump went out on the rear tank and I had it replaced. I now have a peculiar problem. Fuel is coming out of the front tank fill spout when the engine is running. There seems to be a tremendous amount of pressure building up in the front tank...even though I am not using it.
I would seem as though fuel is being pumped out of the rear tank and into the front tank to a certain pressure point, and then on to the engine. One solution would seem to be to remove the front tank completely from the system, but I don't know how to do that, or if it should be done. After driving and coming to a stop, fuel is pouring out through the gas cap on the front tank. I. Don't need to use the front tank as I am just using this as a work truck.
Yesterday when I tried to fill up my 2007 Town and Country I found I cannot put more than about 1/2 gallon at a time before the pump shuts off. I have the problem at multiple stations/pumps so I know it is a problem in my car.
I have heard this could be a clogged charcoal canister so that the air cannot get out of the tank as the gas is going in. Where this unit is located on the Town and Country? Could there be another issue? A week ago when I filled the tank I had no problem, but yesterday it took a very long time to fill up from empty.
My 2004 Pacifica (130k miles) was left parked for 2 weeks while we were away. Upon return it didn't wqnt to back out of the parking spot. After about 1/2 revolution the wheels made a clanking sound and hung up. Rolling back and forth freed things up enough to drive the car to the mechanic (about 40 miles). And after the first mile or so everything seemed to go back to normal, with no absolutely signs of anything not wanting to turn smoothly.. The mechanic thought that the problem had been that the brakes were sticking due to the car being unused and said nothing needed to be done. However, upon examination he found that we could use new front brakes and 2 motor mounts. He said that the need for brakes and motor mounts was due to normal wear and tear, and was not related to the wheels hanging up issue.
But now, immediately after installation of 2 new front rotors and pads and 2 new motor mounts there is a vibration/shudder when braking from anything more than 20-30 mph, which was never there before. The shudder is rapid and sometimes pronounced like going over the warning groves cut into the edges of pavement on the interstate. He thinks that this may be a sign that there is a driveshaft issue, and dismisses it as due to an out of round rotor since they are new. I don't know what to think. By the way, he has always been an excellent mechanic, with a great reputation and loyal following.
My a/c has worked just fine until about 30 minutes ago. Now, there is nothing coming out of the vents in the front, but plenty is coming out of the rear vents. What could this mean?
View 4 Replies2005 Chrysler Pacifica TouringWhen pressing on the brakes at speeds over 25 the steering wheel wobbles. I have had this problem in the past and it has been diagnosed as warped discs. They have been turned and it fixes it for a while then it comes back and again warped discs. I have had the discs replaced but it has come back time after time.
Just had it checked out and they are saying it again, warped discs and this time cannot be turned need to be replaced but they also showed me I need new lower arms.
What do the lower arms do? And if I do not replace them will I have the same problem later with the front discs getting warped?
I have a Chrysler pacifica 2006 .Later in 2009 I had a problem ( 'tapping noise' coming from the engine). I took the car to the dealer, since at that time I still have warranty (39,000 miles). They changed: 18 arms (6 of each type) 8 dowel pin, belt and the lifters. Last year I started hearing the same noise again. The car was with 56,000 miles. I thought it should be under the warranty (service done), but it wasn't. So I decided to have the dealership servicing the repair. This time the part changed was only one. The receipt says they changed the 'arm-inlet and exhaust valve'. Guess what ? the noise still there and they say they won't open the car without me paying for the diagnosis ( many hour of labor for sure!).What can I do?
View 1 RepliesI have 2007 explorer 4.6 v8. The check engine light is on, and i can only fill the gas tank about 3/4 full, after moving the gas nozzle all around and taking about 15 minutes. I read a few different things while searching. Like vapor canister need to be replaced. or the vent hose needs to be replaced.
View 1 RepliesSo my Pacifica, after a long road trip around a year and a half ago, had it's check engine light come on. The meter read P0305, which is cylinder 5 misfire. When I got home, my local trusted mechanic replaced the coil and wire. Since then, the same misfire has occurred at least 4 times, and 3 of which he replaced the same parts (free warranty swap of the parts). The last time, he was determined that it wasn't simply the parts going bad. I concur. It has now lasted roughly a month and the light is back on with the same code. The spans have been as little as a week between leaving the shop and the light coming back on. I personally don't feel the car riding rougher than normal, but my wife does. I don't smell gas, have odd colored exhaust, or any other issue. The only other thing, which idk if it's related, is a clicking noise from the engine, which quickens with revving, perhaps the risers. What else could it be? I read that Chrysler's go to is a valve spring retainer lock and a MAP sensor that accompanies it.
View 19 RepliesI drive a 2006 Pacifica and lately the engine has been causing me some grief. When I am in park, neutral, or in gear but stopped, the engine will sometimes rev up and my speedometer will jump accordingly sometimes as high as 30 mph. My first thought was that it might be a transmission issue, but I'm not a car mechanic so I don't know much along the lines of what to check or do. The model is an automatic 3.5L
View 1 RepliesI own a 2006 Chrysler Pacifica and during cold winter months ALL my windows ice-up significantly on the interior. To the point it is clearly a safety issue. Visibility is 0 due to the frost. I have to have the defrost on high at all times just to keep the front windshield clear, which results in making the cabin EXTREMELY uncomfortable (too hot)...for the driver and passenger. The floor mats are not saturated with water, I have NO wet towels in the car...etc. This has been happing from day one and the dealer, well...same old story...they say it's caused by my floor mats and there is nothing wrong....BUT this is NOT normal. I can send a video that shows the issue if you would like.
View 5 RepliesI am considering purchasing a 2004 Chrysler Pacifica. It seems to be in excellent shape except for one thing--it makes a very noticeable creaking noise. The noise is coming from the front end and seems to only appear at very slow speeds (like in parking lots). The seller told me up front about the noise, and explained that it didn't start until he had someone "jerk" him out of a snowdrift in Colorado. He says that was about 4 years ago. He tells me he has had the front end aligned, he has had two motor mounts replaced and has had either the tie rods, or the tie rod ends (I'm not sure which) replaced, but the noise is still there. He claims mechanics can't find anything else wrong with it, and they assure him it is safe to drive.
View 4 RepliesWe have a 2006 Pacifica which as of recent has been slow to warm in the cabin, especially after a couple hour rest (oddly enough, it warms faster after sitting overnight). Also, when checking the fluids, we noticed that the coolant reservoir was just about empty. We added more 50/50 HOAT coolant, maybe 40-50 oz to get it normal cool engine level. This was done when the engine was cold. My wife noticed that the engine has been running warmer than normal. Normal is maybe a quarter the way up on the temp gauge, where it was around the halfway point, still far from the red zone but not its normal level.
This symptom has been going on for maybe a week. After adding additional coolant, the level stayed where we filled it as the engine warmed up. The heater warmed up to a normal level from what I can tell (it is 30 degrees warmer than last week) so it didn't start with a freezing cabin. I haven't seen any leaking of coolant, since I'm sure I would notice a hot pink puddle under the car. This is pretty typical or the sign of something major. It has around 80k miles on it.
From all I can see, the fuel tank capacity on my '12 should be 17.5 gallons.
As I finish up a trip with it, I know I've "pushed the envelope" as far as fuel range is according to the guage/computer. I get the warning that I need to refuel and that I have 50 miles to empty, but I've driven 40 miles into that last range before refueling, and only been able to put 14 or so gallons into the tank.
My question is: If I were to drive until it literally runs out of gas, then fill it, would the guage/computer recalibrate or do I need to install a new fuel sensor?
I get the warning as the guage indicates just under 1/4 tank remaining, and I have yet to run it until the guage indicates that it's actually on empty (family and dog are with me so risking it is currently out). I'm hoping that the guage itself knows what the real deal is and that the computer is just not with it.... OH, FWIW full is EXACTLY on the "full" line and not over as in my Kia.