Chevrolet S-10 :: Rats Ate Vacuum Line
Apr 15, 2013
6 cyl. vortac engine, air, 4WD utility model. The HVAC controls quit working and I just drove it - then after a few months the heater core started leaking. I had to fix that. While I was under the dash getting ready to put the new core in, I spotted a T in a vacuum line that went to an actuator on the passenger kick panel, the line to the actuator was intact. But the T went about 6 inches then thru a rubber plug (round with a cone shape on one side) hanging in space and about an inch on the side that was cone shaped the end had been chewed off.
Perhaps that is why the HVAC control quit? No other line can I find that it connected to. I have not been able to locate a vacuum diagram on the 'net. Or even find a hole somewhere within range that it might have passed thru originally. Much less the other end of the line, I guess the rats took it with 'em? where this line connects? or have a diagram??
View 8 Replies
Advertisement
2002 Passat 2.8 ATQ. Found a disconnected vacuum on my V6. Where it goes? Its the grey one in the photos below.
View 6 Replies
My Phaeton had the typical burning oil smell so I suspected the Camshaft cover gasket. However when I looked at the service history the gaskets were only just changed in 2012.
When I inspected the car closely I found the RH EGR vacuum line was disconnected (pipe cracked through).
Unlike the Audi A8, the VW 4.2 looks like it has 2 EGR valves, and not one. So I reconnected it, and so far, the burning smell is now gone!!
I am a newbie on the VW 4.2 but is a disconnected EGR a likely cause of oil leaks? (ie positive crankcase pressure). It makes me wonder if all the people whom are changing their cam cover gaskets, should be checking their PCV/EGR's instead??
View 5 Replies
My car has been missing after a recent spark plug change, so i did a smoke test and i see smoke coming from under the air cleaner and i see that the accessory vacuum line goes under there, could this be the cause of the misfire? i already checked all the sparkplug work and wires. and if this could be the problem how would i get to it 1998 Buick century 3.1.
View 2 Replies
Was wondering if it is safe to use seafoam through my brake booster vacumm line? If I drip it in SLOW can I still hydrolock my engine?
View 15 Replies
Lately I have been working a lot with my cold air intake. One of the vacuum lines keeps popping off. Today I got a check engine light and VSC and VSC off light. Is that due to the tough idle caused by the disconnected vacuum line. I erased the code and so far it has not returned.
View 1 Replies
I have a vacuum line missing on the top of intake its a 98 explorer 4.0 sohc. I don't know where it goes...
View 2 Replies
I replaced the engine computer (1346107) with one from ebay. Now it runs but sputters unless I disconnect the vacuum line (still sputters but a lot less). with it connected, the timing is off (to about 15-18 instead of 12). the distributor is rotated as far as it will go. Need to recognize these symptoms? Is there a procedure to test the ICU?
View 17 Replies
I noticed a vacuum line hanging under my 98 F 150 4x4 I traced it out to my front axle question is where does the other end go I have looked but no luck to where it goes.
View 5 Replies
Question, I have a 2003 VW Golf GLS 2.0L AHV (5 speed). The brake vacuum line is cracked after the check valve on the intake side. I looked up the part number on the hose (at work and don't have it on me at the moment), did some research and noticed some revisions to that part number. Eventually settled on [URL] ..... (I ordered a new one since I needed to order a few things). Needless to say, I am beginning to think I ordered wrong.
I noticed that the check valve on the new hose has a 3rd piece that a smaller hose looks to clamp on? The check valve that is in my car doesn't have that. Did I order the wrong part? or did I need to be a cap?
View 3 Replies
02 F150, 5.4 gas motor, about 338k miles. Bought this truck well used so I would have a truck when I needed one. Someone has removed the heater control valve. I've got a new one, but there is a port on the top for a vacuum line, but where this line plugs into.
View 1 Replies
I have a 2001 F-250 7.3 diesel with an automatic trans. Over the last couple of months it has stalled 3-4 times while driving, always when slowing down but even at speeds of 15 mph or so. I did find a burnt vacuum line the other day. It comes out of some type of relay box located behind the battery and in front of the starter solenoid relay and is mounted on the fender. It has an electrical plug in the top and two vacuum lines at the bottom. I am hoping this is the cause of the truck dropping off of the idle circuit? But I don't know what the unit is so I cannot order the correct replacement lines.
View 9 Replies
Recently I have been having a strong gas smell coming from my 1997 F150 Supercab 4.6L 2wd. It is not happening all of the time. I have also been hearing what sounds like a vacuum line leak. A loud shrill which varies with the engine rpm. This also does not happen all of the time.
View 1 Replies
I have 30k on my 97 Chevy Lumina. there is so much vacuum in the gas tank that it crushed the tank. I have replaced the tank but don't know what the problem is. Have taken it to three different shops and got three different opinions. One shop replaced the purge solenoid, no luck. Another said there is no fuel tank pressure data and want to drop the tank and check the sensor. the error code they read is p0440. The other replaced the evap canister. Am driving without the gas cap to protect new tank.I don't want to pay for another unnecessary repair and am sure I can repair it myself but want to be cartain I have it right. Also I didn't realize there was a pressure sensor in the tank. They also said I could have a restricted vent valve or canister.
View 4 Replies
Brake pedal whistles and is hard to push. Only happens intermittently. Mechanic wants to put new brake booster on. This would be 3rd brake booster in 9mos. It's gotta be something else. What does the vacuum hose connect to from the check valve; where on the intake manifold? If no PVC valve...then what else? Truck runs fine...no fast idle or rough idle and no hesitation.
View 4 Replies
I just replaced a clutch line yesterday on a 98 s10 and it failed again today it blew at the same spot....
View 19 Replies
I have a misfire in the 6 cylinder on my 98 Chevy c1500 5.7l 350 v8 2wd. I changed the spark plugs and wires, cap and rotor, and changed the spider injector i put the spider injector in from another engine I had. After doing all this the code still comes up. The truck runs fine and except it idles slight rough not bad at all and now it says I have a vacuum leak and while I'm driving you can feel the loss of power. I tried all the ways to do it like on YouTube. What is wrong with my truck?
View 10 Replies
What is the easiest (DIY) way to replace the Vacuum Actuator (switch?) in a 1995 Chev Blazer with an Automatic Transmission, 4WD?
View 2 Replies
Have a 2007 V10 and I want to put in a Magnafine tranny filter. Instructions say to plumb it in to the return line. Which one is this, top or bottom?
View 11 Replies
I have a 04 camry and this car leaks gas after i pump about line before the full line. What do i need to do?!
View 2 Replies
I have a problem today i took off the coolant line, air line, and the fuel line and when i put them back on i put the coolant line into the air line accidentally and the air line in the coolant . i started the car thinking it was normal. the car started and then when i started to back up the car turned off so i knew i screwed up the lines then i found online the right way how the lines should go put them the right way and the car just cranks in doesn't start up.
View 3 Replies